Microbial fuel cell with three-dimensional electrodes for domestic wastewater treatment and electricity generation北大核心CSCD

A single chamber microbial fuel cell (MFC) with three-dimensional electrodes packed bed carbon felts was developed to treat domestic wastewater while simultaneously generating electricity. The influence of batch and continuous operation mode on treatment effectiveness and electricity production of the MFC was investigated to provide a reference for the application of the MFC. The MFC with a total working volume of 1 440 mL was operated in the fed-batch mode for 5 d repeatedly three times, and then shifted to the continuous mode. During the testing of the continuous mode, wastewater was continuously pumped into the anode compartment at a flow rate of approximately 0.2 mL/min, resulting in a hydraulic retention time of 5 d. During the batch test, the MFC obtained 91.1% chemical oxygen demand (COD) and 98.2% NH4 +-N removal, which accorded with the first criteria specified in the discharge standard of pollutants for municipal wastewater treatment plants in China (GB18918-2002). A maximum power density of 27.88 mW/m3 was achieved at a 51 Ω external resistor. During the continuous test, the COD removal efficiencies ranged from 83.2% to 97.4%. The concentration of NH4 +-N gradually decreased within 5 d and was then maintained below 9.45 mg/L, thus an enhanced removal performance of NH4 +-N was acquired. However, a low removal efficiency of total nitrogen was observed owing to the accumulation of NO3 --N in the effluent since day 11. Additionally, the MFC continually generated electricity with a maximum power density of 582.5 mW/m3 and average output voltage of 0.087 7 V during the stable period in the continuous operation mode. Moreover, 16S rRNA gene high-throughput sequencing showed that Thauera sp., Saprospiraceae-UN sp., and OPB56-UN sp. were identified as dominant populations. The results suggested that the organic matter associated with power generation was constantly utilized by the microorganisms in the reactor, which caused an excellent electricity generation performance during the continuous test. Therefore, the continuous operation mode could improve the low output voltage phenomenon in the MFC. Thauera sp., as a type of nitrate-reducing bacteria, was enriched in the autotrophic denitrifying microbial communities; therefore, bio-enrichment with denitrifying bacteria such as Thauera sp. could decrease the concentration of NO3 --N in the effluent during the continuous operation mode, which is expected to be an innovation for improvement of wastewater treatment. © 2018 Science Press. All rights reserved.     

Development of Indicators to Assess Economic Vulnerabilities to Changes in Ecosystem Services: Case Study of Counties in Maryland,USA

We develop indicators showing the relative environmental burdens that human activities place on locales for a given level of economic benefits. The main purpose is to develop tools that allow us to examine the potential vulnerabilities within economies to changes in resource conditions. The indicators of pollution emission or resource consumption per job can be used to identify potential challenges to resource and industry managers and to compare areas in terms of their ability to adapt to change. For example, if a large number of area jobs are dependent on abundant water, this indicates a vulnerability to a reduction in water availability for industrial use. We develop a case study for 23 counties and 1 city in Maryland to examine the usefulness and limitations of the indicators. Our case study demonstrates that the indicators provide an informative view into patterns of local economic activity and use of an area’s environmental goods and services. In contrast to patterns for total environmental burdens (e.g., total SO₂ emissions) that are typically reported, the rates of environmental burden per job are not simply correlated with high or low economic output. Thus, the indicators represent distinct patterns of environmental burdens per job that reflect reliance on environmental services. The indicators have some limitations when used at this fine scale because they can misrepresent conditions in counties in which economic sectors are dominated by one or a few businesses. For this reason, the indicators are best used as a regional screening tool.     

Greenhouse gas emission reductions in the post-Kyoto period: Emission intensity changes required under the 'contraction and convergence' approach

Various approaches have been proposed for allocating commitments to countries regarding the mitigation of greenhouse gas emissions. One of these methods is the ‘contraction and convergence’ approach, which defines emission permits on the basis of converging per capita emissions under a contracting global emission profile. The approach is unique in its simplicity. Only two major issues need to be negotiated and agreed upon: the target atmospheric concentration of CO₂ and the date when the entitlements are to converge at equal per capita allocations. According to the contraction and convergence approach, developing countries can continue their current emission trends, whereas industrialized countries should reduce their emissions quite dramatically. This regime represents a shift away from the current approach towards defining commitments for all parties and their evolution over the long term. This article analyses how allocation schemes determined by the contraction and convergence approach might affect certain OECD and non‐OECD countries. Results for eleven countries selected for analysis (United States, United Kingdom, Germany, France, Japan, China, Venezuela, Thailand, Brazil, India and Indonesia) reveal that trends observed in the past few decades in most industrialized countries will lead to the contraction and convergence target.     

Nutrient-Balance Modeling as a Tool for Environmental Management in Aquaculture: The Case of Trout Farming in France

The control and prevention of nutrient pollution from fish farming plays an essential role in the French regulatory framework. Assessing nutrient emissions from fish farms is important in terms of farm authorization, taxation, and monitoring. Currently employed strategies involve both water sampling and empirical modeling. This article reports the work and outcomes of an expert panel that evaluated existing methodologies and their possible alternatives. The development and evaluation of a nutrient-balance approach was assessed as a potential alternative to currently used methodologies. A previously described nutrient-balance model was suggested and parameterized using expert choice, and its validity and applicability were assessed. The results stress that the nutrient-balance model provides more robust and relatively conservative waste estimates compared to the currently used methodologies. Sensitivity of the approach to the uneven data quality available at farm level, difficulties of on-farm measurements, as well as model requirements and limitations are discussed.     

Can China control the side effects of motor vehicle growth?

Motor vehicle growth in China is the fastest in the world. This is placing great strain on the urban environment and causing a rapid increase in oil imports and motor vehicle carbon dioxide emissions. To deal with the environmental and health effects of air pollution, China has adopted a strong motor vehicle pollution control programme and imposed limits on fuel consumption of new light duty vehicles. The article will review these problems and programmes. Special focus will be given to the need to reduce sulphur levels in both gasoline and diesel fuel.     

Processing National CO2 Inventory Emissions Data and their Total Uncertainty Estimates

The uncertainty of reported greenhouse gases emission inventories obtained by the aggregation of partial emissions from all sources and estimated to date for several countries is very high in comparison with the countries’ emissions limitation and reduction commitments under the Kyoto Protocol. Independent calculation of the estimates could confirm or question the undertainty estimates values obtained thus far. One of the aims of this paper is to propose statistical signal processing methods to enable calculation of the inventory variances. The annual reported emissions are used and temporal smoothness of the emissions curve is assumed. The methods considered are: a spline-function-smoothing procedure; a time-varying parameter model; and the geometric Brownian motion model. These are validated on historical observations of the CO₂ emissions from fossil fuel combustion. The estimates of variances obtained are in a similar range to those obtained from national inventories using TIER1 or TIER2. Additionally, some regularities in the observed curves were noticed.     

1991～2000年中国森林火灾直接释放碳量估算

目前的研究表明生物圈的燃烧产物对大气有短期和长期的影响,植被燃烧会直接排放对环境有显著影响的气体,包括CO2和CH4等影响全球变化的温室气体,燃烧产生的固体颗粒物也会引起空气污染和影响天气。该文根据1991－2000的森林火灾统计数据和生物量研究结果,计算出我国森林火灾年均消耗森林地上生物量5Tg-7Tg,直接排放碳20.24Tg-28.56Tg,释放CO2和CH4分别为74.2Tg-104.7Tg和1.797Tg-2.536Tg,排放烟雾颗粒物0.999Tg-1.410Tg。1991－2000年森林火灾每年平均排放CO2量占我国总排放量（按2000年计算）的2.7-3.9%,CH4排放量占总排放量的3.3-4.7%。     

Towards global climate change mitigation: assessment of an afforestation option for Nigeria

This paper assesses the potential of an intensive afforestation program as a measure of reducing the atmospheric concentration of carbon in Nigeria. The results presented are based on the recently completed Nigerian Country Studies Program on Climate Change Mitigation. A comprehensive mitigation analysis process (COMAP) model was employed to carry out detailed cost/benefit evaluation of the mitigation option. The end-use based scenario adopted was considered the most appropriate strategy to sustainably implement the mitigation option in Nigeria.The analyses showed that the country could significantly reduce net carbon emission while at the same time meet all her essential domestic wood needs, if approximately 7.5×10⁶ ha of wasteland could be committed to an afforestation program over the 40 year period of projection. The initial cost of establishing such forest plantations, taking cognisance of the opportunity cost of land averaged at about US$500/ha, or in carbon terms, a unit cost of about $13 per tonne of carbon. In terms of carbon flow, if all the end-product based plantations considered (i.e. fuelwood, poles, pulpwood, sawlogs and veneer) were fully established and maintained, it was estimated that by the year 2030, the total carbon stored in the afforested land would be about 638.0×10⁶ t of carbon with an annual incremental rate of 16.0×10⁶ t of carbon. Other economic indicators (i.e. net present value of benefits, present value of costs and benefit for reduced atmospheric carbon) when evaluated showed that the afforestation option could be economically viable even when the investment capital was discounted at rates ranging from 9 to 33 percent for different wood products. It should be noted, however that implementation of such a program would require huge sums of money and a high degree of commitment on the part of Federal, State and Local governments if the associated financial, social and environmental benefits were to be derived.     

The Appalachian Mountains' Copper Basin and the concept of environmental susceptibility

The Copper Basin is located within the southern Appalachian Mountains primarily in extreme southeastern Tennessee, USA. It has long been known for its copper mining/smelting and associated chemical industry, as well as its severely injured environment. Virtually all previous commentary on the environmental degradation at this location have focused on human activities and their destructive impact. This article approaches the subject from a different angle, one that emphasizes the interaction between man and nature. The site's physical setting, industrial history, and environmental history are briefly reviewed. The theory then presented here is that certain of the Copper Basin's natural features made its environment unusually vulnerable to the negative impact of copper mining and smelting, especially as practiced around the turn of the century. These features are identified. This reasoning provides the basis for the concept of environmental susceptibility, which is defined and discussed. A few of its applications are mentioned. This study offers a new perspective on the Copper Basin, as well as insights for those whose work involves investigating the man/nature relationship—both past and present.     

Impacts on air pollution in urban areas

Environmental management involves controlling various forms of pollution to levels that do not pose a threat to the health of the people and the environment in general. This paper presents a framework to analyze sources of local air pollution in cities. Using an OLS model, an investigation is performed of the relationship among the concentrations of air pollutants [more precisely, concentrations of sulfur dioxide (SO₂), dust, nitric oxide (NO), nitrogen dioxide (NO₂), carbon oxide (CO) and ozone (O₃)], economic activities, and meteorology. Time series analysis leads to a model, that explains a high degree of the variance in the air pollution data. The model is applied to daily time series from three measurement stations in innsbruck, Austria. Estimation results of the model generally fit with the expected relations. Space heating influences SO₂, dust, and NO, while NO₂ levels are primarily affected by traffic. These results also indicate interdependent relations among the pollutants NO, NO₂, O₃, and CO; O₃ levels depend on temperature and sunshine.