混凝剂品种对混凝-超滤联合工艺膜污染的影响

本实验以工业化学合成聚合硫酸铁混凝剂和自制生物聚合硫酸铁为例,考察了铁系混凝剂品种对地表水浊度、TOC和UV254的去除效果,混凝剂品种对混凝-超滤联合工艺处理地表水过程中超滤膜污染的影响。混凝实验结果表明,在10 mg/L(以Fe3+计)最佳投加量下,两类混凝剂对浊度、TOC和UV254的去除率基本相同。超滤膜污染实验结果表明,生物聚合铁预处理水样通量衰减速度略大于化学聚合铁预处理水样;膜污染阻力分析结果显示,随着循环次数的增加,工业化学合成聚合铁预处理水样造成的不可逆污染阻力逐渐增加,而生物聚合铁预处理水样造成的不可逆污染阻力却略有下降;膜污染机理分析表明,2组过滤过程的膜污染类型基本相似,由最初的膜孔堵塞过渡到最终的滤饼层污染。SEM分析表明,生物聚合铁预处理水样的膜污染较为严重。     

氨/硫铵法烟气脱硫技术特点及市场前景分析

通过对我国二氧化硫污染现状及控制要求的分析,提出了氨/硫铵法作为一种资源回收型脱硫方法,具有反应速度快、工艺流程简单、吸收剂利用率高、适用范围广及可实现资源回收利用的特点;以工程案例的形式分析了氨/硫铵法的技术经济指标,并对氨/硫铵法的应用前景和市场需求进行了预测。     

厌氧滤池处理纺织印染废水的中试研究

对厌氧滤池反应器处理难降解印染废水进行中试研究。结果表明,厌氧滤池反应器水力停留时间(HRT)在8.1～14.6 h之间,进水COD浓度波动较大(500～1 000 mg/L)时,对COD平均去除率为20%。印染废水的BOD5/COD由0.23提高到0.35,废水可生化性明显改善。印染废水中硫酸根浓度略有下降,去除浓度为70 mg/L左右。厌氧滤池进出水颜色明显变化,由紫红色变为蓝黑色,紫外可见光谱分析表明废水中的有机物结构发生变化。     

林可霉素菌(Streptomyces lincolnensis)利用吡唑酮废水的研究

采用被吡唑酮废液驯化、分离、筛选后的林可霉素菌,并对其在摇瓶上利用吡唑酮废液中的硫酸铵发酵(7 d)生产林可霉素进行了研究。实验结果表明,废液加入培养基体积比都为1∶10,实验1中菌丝代谢和对照比正常,其中还原糖利用最快,在发酵后期为0.24 mg/L,林可霉素起步效价最低为2 100 IU/mL,与对照相比最后发酵效价降低了70 IU/mL;实验2发酵过程pH值偏低,全程为5.86～6.50,氨基氮代谢缓慢为40 mg/100 mL,最后林可霉素效价最低为4 480 IU/mL;实验3中废液在发酵进入48 h中后期的时候补入能促进菌丝体分泌,最后林可霉素为5 180 IU/mL,比对照发酵水平高出8.82%。可见实验3的实验设计有利于林可霉素菌利用吡唑酮废液生产林可霉素,为废物循环利用、变废为宝的可行性作了有意义尝试。     

铁盐和铝盐混凝对印染废水生化出水中溶解性有机污染物的去除特性

以三氯化铁和硫酸铝为混凝剂,印染废水二级生化出水为研究对象,并利用XAD-8/XAD-4吸附树脂联用技术将印染废水生化出水中溶解性有机物分为疏水酸、非酸疏水物质、弱疏水物质及亲水物质4类有机物,通过小试实验探讨了2种混凝剂对生化出水中各类溶解性有机物的去除效果及特点。实验结果表明,对于该印染废水的生化出水,溶解性有机物的主要成分是疏水性物质,以DOC表征时占总DOC的75%,其中疏水酸约占41%,疏水性物质也是引起色度的主要物质,所占比例以ADMI7.6表征时为89%,其中以非酸疏水物质的贡献最大,达到52%,并且非酸疏水物质中不饱和双键或芳香环有机物的含量较高。在三氯化铁和硫酸铝各自最佳的混凝条件下,均能够有效去除由疏水性物质（疏水酸和非酸疏水物质）引起的色度,但三氯化铁对弱疏水性物质以及亲水物质的去除率高于硫酸铝,这使得三氯化铁对印染废水生化出水中的溶解性有机物的去除效果优于硫酸铝。并且三氯化铁和硫酸铝混凝工艺均能明显降低生化出水的毒性。     

质子化改性交联壳聚糖的制备及其吸附硫酸根离子的性能

以壳聚糖为原料,甲醛为氨基保护剂,戊二醛为交联剂,采用反相悬浮交联法制备交联壳聚糖,再对其进行质子化改性得到质子化改性交联壳聚糖吸附剂。通过正交实验对该吸附剂的制备条件进行优化,并对其吸附水中硫酸根（SO₄^2-）的吸附等温特性和动力学进行研究,最后对制备和吸附过程进行能谱分析（EDS）并对吸附剂进行了再生实验。实验结果表明,交联反应的优化条件为：反应温度50℃、反应时间6 h、甲醛：戊二醛：壳聚糖为4.5：0.5：3（质量比）;该吸附过程符合Langmuir吸附等温模型,在25℃（298 K）下,吸附容量最大可达133.87 mg/g;吸附过程较好地符合拟二级动力学模型;EDS分析表明了交联反应、质子化改性和吸附反应均已发生;该吸附剂的再生性能良好,可以重复使用。     

ABR处理硫酸盐有机废水的BP神经网络建模

通过厌氧折流板反应器(ABR)处理硫酸盐有机废水的实验数据对BP神经网络进行训练,建立了ABR处理硫酸盐有机废水的BPNN模型,通过测试对比,找出了较优训练函数为traingda,较优训练次数为1 900.利用分割连接权值法(PCW)对影响出水SO42-和COD的主要因素进行分析,结果显示进水COD、SO42-、pH、COD/SO42-和HRT对出水SO42-和COD均产生一定影响,其中进水pH对出水SO42-和COD的影响最大,相对重要性(RI)指数分别为30.79％和23.44％;并通过样本试验数据分别建立了对SO42-和COD去除率的限制因子仿真模型,为预测硫酸盐有机废水的厌氧处理过程提供指导.     

碱式硫酸铝溶液中SO42-的测定

建立了以铬黑T为指示剂,乙二胺四乙酸二钠反滴定过量BaCl₂的碱式硫酸铝溶液中SO₄^2-的测定方法。实验确定的操作条件为：待测试样稀释后ρ（SO_4^2-）为0.025 ~0.100 g/L,BaCl₂过量率为25%~100%,并且在加入BaCl₂前将试样煮沸,三乙醇胺加入量为0.10 L/L。该法回收率在98.90%~100.72%,相对标准偏差小于1%。测定方法准确,可靠,且操作简便、快速。     

Hydrogen Sulfide Gas Treatment by a Chemical‐Biological Process: Chemical Absorption and Biological Oxidation Steps

In order to remove high concentrations of hydrogen sulfide (H₂S) gas from anaerobic wastewater treatments in livestock farming, a novel process was evaluated for H₂S gas abatement involving the combination of chemical absorption and biological oxidation processes. In this study, the extensive experiments evaluating the removal efficiency, capacity, and removal characteristics of H₂S gas by the chemical absorption reactor were conducted in a continuous operation. In addition, the effects of initial Fe^2 + concentrations, pH, and glucose concentrations on Fe^2 + oxidation by Thiobacillus ferrooxidans CP9 were also examined. The results showed that the chemical process exhibited high removal efficiencies with H₂S concentrations up to 300 ppm, and nearly no acclimation time was required. The limitation of mass‐transfer was verified as the rate‐determining step in the chemical reaction through model validation. The Fe^2 + production rate was clearly affected by the inlet gas concentration as well as flow rate and a prediction equation of ferrous production was established. The optimal operating conditions for the biological oxidation process were below pH 2.3 and 35°C in which more than 90% Fe^3 + formation ratio was achieved. Interestingly, the optimal glucose concentration in the medium was 0.1%, which favored Fe^2 + oxidation and the growth of T. ferrooxidans CP9.     

Matrix based fertilizers reduce nitrogen and phosphorus leaching in three soils

We compared the efficacy of matrix based fertilizers (MBFs) formulated to reduce NO3-, NH4+, and total phosphorus (TP) leaching, with Osmocoate 14-14-14, a conventional commercial slow release fertilizer (SRF) and an unamended control in three different soil textures in a greenhouse column study. The MBFs covered a range of inorganic N and P in compounds that are relatively loosely bound (MBF 1) to more moderately bound (MBF 2) and more tightly bound compounds (MBF 3) mixed with Al(SO4)3H2O and/or Fe2(SO4)3 and with high ionic exchange compounds starch, chitosan and lignin. When N and P are released, the chemicals containing these nutrients in the MBF bind N and P to a Al(SO4)3H2O and/or Fe2(SO4)3 starch-chitosan-lignin matrix. One milligram (8000 spores) of Glomus intradices was added to all formulations to enhance nutrient uptake. In all three soil textures the SRF leachate contained a higher amount of NH4+, NO3- and TP than leachate from all other fertilizers. In all three soils there were no consistent differences in the amount of NH4+, NO3- and TP in the MBF leachates compared to the control leachate. Plants growing in soils receiving SRF had greater shoot, root and total biomass than all MBFs regardless of Al(SO4)3H2O or Fe2(SO4)3 additions. Arbuscular mycorrhizal infection in plant roots did not consistently differ among plants growing in soil receiving SRF, MBFs and control treatments. Although the MBFs resulted in less plant growth in this experiment they may be applied to soils growing plants in areas that are at high risk for nutrient leaching to surface waters.