聚天冬氨酸对土壤吸附、解吸汞的机制研究

为揭示土壤中添加聚天冬氨酸(PASP)后其对汞的吸附、解吸过程,探究了不同PASP用量对土壤吸附解吸汞的机制及有机质、pH、汞初始浓度等因素的影响.结果 表明,PASP可显著抑制土壤对汞的吸附,促进土壤对汞的解吸,在PASP用量为300 mg时,其吸附量、解吸量分别是未添加PASP时的0.68、27倍;有机质与PASP...     

西南部分地区麻疯树种子油的理化性质及脂肪酸组成分析

从西南6个地区采集了麻疯树种子并分析比较了其生物学性状和种子油的理化性质及脂肪酸组成.所有样品的百粒重范围为41.80~71.39g,出仁率60.02%~81.43%,种仁含油率51.76%~57.93%,种子含油率31.07%~47.17%,不饱和脂肪酸含量74.89%~79.68%.其中永胜产麻疯树的种子品质最好,其出仁率为81.43%,种仁含油率57.93%,种子含油率47.17%,不饱和脂肪酸含量79.68%.攀枝花和宁南产麻疯树的种子品质次之.双柏和罗甸麻疯树的种子油酸值为0.81,在所有样品(0.81~9.46)中最低.对麻疯树种子及种子油性质的相关数据进行方差分析,结果表明,产地不同,麻疯树种子的生物学性质、种子油理化性质和脂肪酸组成都有一些差异.图2表3参18     

Abating whey organic load through ethanol and lactic acid production by kefir

Abstract

The extent to which selected ethanol and lactic acid production bioprocesses contribute to whey waste abatement was examined. Alcoholic fermentation of whey was carried out by kefir cells immobilized on grape stalks, delignified cellulosic materials, or brewer's spent grains. Lactic acid fermentation was also performed by free kefir cells with or without addition of brewer's spent grains as promoting material. Since whey fermentation rate is affected by the lactose uptake rate, ¹⁴C-labeled lactose was used to study the fermentation ability of kefir. The highest reductions in biochemical oxygen demand and chemical oxygen demand of whey, about 68% and 52%, respectively, were achieved by lactic acid fermentation in 6 h at 37 °C and pH 5.5, in the presence of 120 g brewer's spent grains. Additionally, at the same conditions, the highest ¹⁴C-labeled lactose uptake rate by kefir and consequently the highest alcoholic fermentation rate were also recorded. However, greater reductions in biochemical oxygen demand and chemical oxygen demand of whey are required prior to final disposal.     

磷钨酸光催化降解甲基橙溶液的研究

以磷钨酸为光催化刺，在紫外灯照射下。对模拟染料废水甲基橙溶液进行光催化降解，并研究了催化剂加入量、pH值、甲基橙初始浓度和外加氧化剂H2O2对光催化降解效果的影响。结果表明，磷钨酸光催化剂加入量为300mg／100mL，pH=2．5时，甲基橙溶液的降解率明显高于其他pH值的降解率；在较低浓度下，甲基橙溶液的光催化降解反应符合一级动力学方程；外加氧化剂H2O2可提高光催化反应速率。     

Decomposition of perfluorocarboxylic acids (PFCAs) by heterogeneous photocatalysis in acidic aqueous medium

Decomposition of perfluorocarboxylic acids (PFCAs) is of prime importance since they are recognized as persistent organic pollutants and are widespread in the environment. PFCAs with longer carbon chain length are particularly of interest because of their noted recalcitrance, toxicity, and bioaccumulation. Here in this study, we demonstrate efficient decomposition of three important PFCAs such as perfluorooctanoic acid (PFOA), perfluorononanoic acid (PFNA) and perfluorodecanoic acid (PFDA) by heterogeneous photocatalysis with TiO₂ as a photocatalyst in acidic aqueous solutions. The PFCAs were decomposed into shorter carbon chain length PFCAs and fluoride ions. Photoholes of excited TiO₂ generated upon UV-irradiation are found to be the oxidation sites for PFCAs. Therefore, creation and sustenance of these photoholes in the acidic aqueous medium has enhanced the decomposition of PFCAs. Heterogeneous photocatalytic treatment achieved more than 99% decomposition and 38% complete mineralization of PFOA in 7 h. The decomposition of other PFCAs was as high as 99% with a defluorination efficiency of 38% for PFDA and 54% for PFNA. The presence of perchloric acid was found to enhance the decomposition by facilitating the ionization of PFCAs. The oxygen present in the medium served both as an oxidant and an electron acceptor. The mechanistic details of PFCA decomposition and their corresponding mineralization are elaborated.     

Acute toxicity of aromatic and non-aromatic fractions of naphthenic acids extracted from oil sands process-affected water to larval zebrafish

The toxicity of oil sands process-affected water (OSPW) has regularly been attributed to naphthenic acids, which exist in complex mixtures. If on remediation treatment (e.g., ozonation) or on entering the environment, the mixtures of these acids all behave in the same way, then they can be studied as a whole. If, however, some acids are resistant to change, whilst others are not, or are less resistant, it is important to establish which sub-classes of acids are the most toxic.     

Sulfamethoxazole sorption by sediment fractions in comparison to pyrene and bisphenol A

The environmental behavior of antibiotics has attracted great research attention. However, their sorption mechanisms in soils/sediments are still unknown. Comparison of the sorption properties between the widely-studied hydrophobic organic contaminants (HOCs) and antibiotics may provide valuable insight to antibiotic sorption mechanisms. Thus, in this study batch experiments for pyrene (PYR), bisphenol A (BPA), and sulfamethoxazole (SMX) sorption were conducted on a sediment sample and its separated fractions. Our results showed the high sorption of PYR on black carbon and organic matter. Although high sorption of SMX was observed for both separated organic fractions (humic acids) and inorganic mineral particles, the original sediment particles showed relatively low sorption. Competitive sorption between SMX and dissolved humic acid on mineral particles was observed in this study. This competitive interaction is a unique process for antibiotic sorption in soils/sediments compared with apolar HOCs and may be one of the important factors controlling the antibiotic sorption.     

温度及外加碳源对生物脱氮除磷过程的影响

针对污水处理厂普遍面临的进水碳源不足及冬季低温时出水氮磷不能稳定达标的问题,研究了温度(21、15和10℃)和外加碳源(乙酸)对活性污泥缺氧条件下反硝化及释磷过程的影响。结果表明,在缺氧条件下投加乙酸,释磷与反硝化反应可同时进行,且乙酸投量的增加仅延长快速碳源反硝化阶段及缺氧释磷阶段的反应时间;温度降低为15℃和10℃时,快速碳源反硝化阶段反硝化速率及缺氧释磷速率较21℃分别降低了约29.2%、42.2%和26.1%、32.3%。当硝态氮目标去除量与磷酸盐目标释放量之比超过5时,乙酸的最优投量以满足反硝化要求为准,计算得出21、15和10℃时常州某城镇污水处理厂乙酸最优投加量计算值约为30、39和46 mg/L。     

负载壳聚糖膨润土的制备及其吸附性能的影响

以天然膨润土和壳聚糖为原料,制得一种新型水处理剂——负载壳聚糖膨润土,研究了制备条件对酸性大红印染废水处理效果的影响。实验表明,当壳聚糖的浓度为30 g/L、膨润土质量与壳聚糖溶液体积之比为0.7、浸泡时间80 min、微烘时间15 min时,壳聚糖改性膨润土对酸性大红印染废水的脱色率可达97%。对改性土进行比表面积测定、电镜扫描及X-射线衍射等结构特性分析,证明壳聚糖的引入改变了膨润土在水中的分散状态,增强了其对污染物的吸附和离子交换能力。     

O3／H2O2高级氧化技术H2O2加入量的简易控制方法

对与臭氧有着不同反应活性的3类有机污染物，探讨并建立了O3／H2O2高级氧化技术H2O2较优投加量的简易控制方法。结果表明，水中存在溶解臭氧是H2O2与臭氧降解效率具有协同作用的必要条件，另外，H2O2的较优加入量直接依赖于目标有机污染物与臭氧的反应活性。对于不同的有机物及在常规的臭氧化水处理时间内，H2O2加入量控制在单独臭氧化处理时水中溶解臭氧的20-30倍（质量比）之间为宜。这种简易控制H2O2加入量的方法对推广O3／H2O2技术在实际废水处理中的应用具有重要的意义。