柠檬酸清洁生产工艺的研究

分析了传统檬酸生产工艺存在的污染问题,提出了在柠檬酸生产过程中采用清洁生产技术的各种途径。     

钛白废酸固液分离与综合利用

介绍了湖南株洲化工集团有限责任公司钛白废酸固液分离与综合利用工艺。将钛白废酸固液分离后得到的清废酸用作磷肥生产用硫酸稀释液、钛白酸解工序硫酸稀释液和板框浸取液,取得了较好的经济效益和环境效益。     

柠檬酸生产废水处理技术

分析了柠檬酸生产废水的来源及水质特性,综述了厌氧生物法、厌氧-好氧生物组合法、乳状液膜法等在柠檬酸废水处理中的应用,介绍了中和废水回用和利用柠檬酸发酵废液开发糖化酶制剂的技术。     

PTA废液回收利用技术

介绍了从精对苯二甲酸（PTA）废液中回收醋酸,邻、对苯二甲酸,醋酸钴锰盐的回收工艺。醋酸得率为90％,邻、对苯二甲酸得率为70％,醋酸钴锰盐得率为95％。该技术成熟、合理,具有较好的经济效益和环境效益。     

Comparative Biodegradation Study of Starch- and Polylactic Acid-Based Materials

The degradation of starch- and polylactic acid-based plastic films by microorganisms extracted from compost was studied in a liquid medium. The various degradation products produced were measured throughout the duration of the experiment, and total carbon balances were estimated. For an easily biodegradable material, the evolution of the way carbon repartitioned between different degradation products was quite similar whatever the experimental condition or the type of substrate. On the other hand, for a resistant material exposed to these microorganisms, the nature of the biodegradation depended strongly on the experimental conditions. In the latter case, a differential scanning calorimetry analysis confirmed the importance of the applied norm on the state of the residual material. The consequences for improved methods of estimation of biodegradability of these materials are discussed.     

Application of a Second-Order Kinetic Model to a Complex Melt Polymerization Reaction

A novel copolymer system has been synthesized using methyl hydroquinone diacetate (MHQDA), 1,4 naphthalene dicarboxylic acid (1,4 NDCA), and polybutylene terephthalate (PBT) using the melt polymerization technique. The optimum kinetic parameters pertinent to this system are reported in this study. A simple second-order reaction sequence summarizes catalyzed and uncatalyzed reactions between MHQDA, 1,4 NDCA, and PBT. The kinetic parameters for the copolymerization reaction were determined using a new second-order model. This technique was used to compute the moles of acetic acid generated in the polymerization process. The model was compared to that of the experimentally determined data. Close comparison (percentage error of less than 5%) was obtained between the experimental and theoretical data. The kinetic data support block copolyester formation. The thermal data also supports formation of block polymers.     

A Literature Review of Poly(Lactic Acid)

A literature review is presented regarding the synthesis, and physicochemical, chemical, and mechanical properties of poly(lactic acid)(PLA). Poly(lactic acid) exists as a polymeric helix, with an orthorhombic unit cell. The tensile properties of PLA can vary widely, depending on whether or not it is annealed or oriented or what its degree of crystallinity is. Also discussed are the effects of processing on PLA. Crystallization and crystallization kinetics of PLA are also investigated. Solution and melt rheology of PLA is also discussed. Four different power-law equations and 14 different Mark–Houwink equations are presented for PLA. Nuclear magnetic resonance, UV–VIS, and FTIR spectroscopy of PLA are briefly discussed. Finally, research conducted on starch–PLA composites is introduced.     

Use of the Dynamic Model `MAGIC' to Predict Recovery Following Implementation of the Gothenburg Protocol

Reduction of sulphur deposition causesrecovery of acidified surface waters. Processes in thecatchment delay recovery. The acidification model MAGICwas applied to the Vikedal and Tovdal rivers in southernNorway. Response in water chemsitry is delayed by 10–20 yr. The delay is due to release of old sulphate atVikedal and cation exchange at Tovdal. Assuming that theGothenburg protocol is fully implemented by the year2010, much of the predicted increase of ANC will occur inthe next 10 yr with a levelling off by about 2040. Ifnitrogen leaching increases in the future, however,recovery of ANC will not be as rapid, nor as complete.Critical load for acidity calculated by steady-statemodels is confirmed by the MAGIC predictions. Futurerequirement for mitigation measures such as liming willdecrease in the future as acid deposition decreases. Bythe year 2046 the liming requirement will be reduced byabout 45% at Vikedal and 65% at Tovdal. One of the mainpurposes of the Norwegian national monitoring programmeis to provide documentation of changes in environmentalquality due to long-range transported air pollutants.Modelling applications such as this clearly show that thedata fill this purpose.     

四川省酸雨污染现状及趋势分析

本文从酸雨成因入手,根据全省降水监测数据等资料,对四川省酸雨污染现状及变化趋势进行分析,结果表明：我省酸雨法污染面积广、频率高;酸度强,近五年,酸雨频率有下降趋势,但降水酸度无明显减弱,酸雨污染形势依然严峻;降水组份中,硫酸根离子和硝酸根离子比值逐年下降,说明大气污染特征已由煤烟型转为煤烟型与机动车尾气混合型。     

烷基膦酸载体液膜中Cd(II)的传输

采用内耦合大块液膜分离技术,通过考察料液相pH值、温度、载体浓度以及解析相组成对Cd(II)迁移速率的影响,研究了以烷基膦酸为流动载体的液膜中镉的迁移规律,并建立了渗透系数与pH值、温度以及载体浓度之间的关系方程.结果表明,Cd(II)以CdR22HR(Kex值为3.58106)配合物形式在液膜中传输,增加载体浓度或升高温度,迁移速率明显升高.最佳传质条件为料液相pH值4.5～5.1、载体浓度5.0%～7.5%、温度298～308K.