微波辅助溶样方法中的问题与对策

较详细地评述了微波辅助溶样技术在实际应用中存在的挥发物渗透损失、记忆效应、残留物现象及安全操作等问题，以及实际操作对策，以期对分析人员在建立与使用微波制样方法时有所裨益。     

废干电池热解物料酸溶及溶液净化试验

文章介绍了废干电池的“热解-酸溶-同槽电解”组合工艺中的酸溶技术及溶液净化的工艺条件研究。     

不同预处理的木薯渣水解液生物酸化特性比较

木薯渣富含纤维素,是理想的沼气生产原料。由于木薯渣含水量大,颗粒分散,不易固态发酵,作为沼气生产原料需对其进行水解处理。不同的水解方式得到的水解液对后续酸化过程的产酸速率和酸分布都有很大影响。对经过酶处理和水热处理得到的木薯渣水解液进行了生物酸化处理。结果显示,与直接投加木薯渣相比,投加酶水解液、投加150℃水解液水解20min和150℃水解液水解45min后,反应器达到最大产酸量所需的时间由96h分别缩短至30,48和24h,最大产酸量由4558mg/L分别增加至5277,6209和4734mg/L,且3种水解液在酸化24h后挥发性脂肪酸(VFAs)均达到最优分布,其中乙酸和正丁酸之和占总VFAs的90%左右。根据产酸速度及酸分布情况得出,木薯渣最佳可溶化方法为150℃高温水解20min,后续生物水解酸化时间为24h。     

Evaluation of porous cup soil‐water samplers under laboratory conditions: Comparison of ceramic and PTFE cups

Three different types of soil solution samplers (two ceramic cups and PTFE) were tested in the laboratory to validate their use for collecting soil‐water samples and for monitoring the chemical composition of soil solutions. Interactions between porous materials and chemical solutions were examined under different experimental conditions for several major cations (Ca²⁺, Mg²⁺, Na⁺ and K⁺) and anions (HCO^‐ ₃, NO^‐ ₃, SO₄ ^2‐ and Cl^‐) and for several minor ions (NH⁺ ₄, NO^‐ ₄, PO₄ ^3‐and B).

The results show that ceramic cups are not inert for bicarbonate, calcium and phosphate ions. Their use is only valid for a limited number of ions such as chloride and nitrate which, however, are the most studied ions in field experiments. PTFE cups have less restrictions although their use in measuring sulphates, phosphates and ammonium presents some problems.

Choosing the appropriate type of cup depends on the objectives. In any case, laboratory experiments must be performed before installation.     

土壤中金属的生物可给性及其动态变化的研究

土壤中金属的生物可给性常应用于人体健康风险评价,如能准确地判定土壤中金属在胃肠阶段不同时间的溶出动态,研究者就可以更好地分析其对人体的健康风险。本文采集5种不同地区的重金属污染的土壤,利用改进的PBET方法,分别在胃阶段的20、40、60、80 min以及小肠阶段的1、2、3、4、5 h时取样并分析,探究土壤中8种金属元素（As、Al、Cd、Cr、Fe、Mn、Ni、Pb）的生物可给性和溶出动态,探讨造成金属溶出动态变化的影响因素,对其溶出机理进行初步探究。研究结果表明,Fe、Al的生物可给性较低,并且在胃肠阶段差异较小。与胃阶段相比,土壤中Pb、Cd的生物可给性在小肠阶段明显降低,而As、Mn、Cr、Ni的生物可给性在小肠阶段均升高。升幅最大的两个元素是Ni、Cr,其小肠阶段的平均生物可给性分别升高61.4%、29.9%。在溶出量随时间变化方面,在胃阶段,假定1 h时溶出率为100%。20 min时,土壤中Fe、Ni的平均溶出率较低,分别为59.3%、56.8%,其他6种金属元素的平均溶出率在71.2%~79.5%。As、Cd、Pb的溶出速率是先快后慢,Cr和Ni的溶出速率是先慢后快,而Fe、Mn、Al的溶出速率基本保持不变。在小肠阶段,假定4 h时溶出率为100%。Al、As、Cd、Mn的溶出率基本不变。1 h时,土壤中Cr（土壤A除外）、Ni的平均溶出率最低,分别为31.5%、32.7%,而5 h时,Fe、Cr、Ni的溶出率还在升高。由此可见,土壤中不同金属元素的生物可给性以及溶出动态是有明显差异的。     

典型含铁矿物的溶解特征

气溶胶沉降是开阔大洋可溶性铁的重要来源。矿质颗粒物在大气传输后铁可溶性显著增加,然而尚缺乏大气化学反应对铁可溶性影响的系统研究。本文探究了pH值、不同酸以及草酸盐浓度对赤铁矿、针铁矿、伊利石和蒙脱石中铁可溶性的影响。在pH=2的硫酸溶液中,铁可溶性为：伊利石(2.18%±0.14%)>针铁矿(1.68%±0.18%)>赤铁矿(0.43%±0.06%)>蒙脱石(0.20%±0.08%)。加入乙酸盐对铁可溶性无促进作用,而加入草酸盐后,铁可溶性明显增加,且草酸盐浓度增加对铁(氢)氧化物铁可溶性有促进作用,但对黏土矿物铁可溶性几乎无促进作用。在加入2 mmol·L^-1草酸盐后,铁可溶性为：针铁矿(5.38%±1.76%)>伊利石(4.19%±0.30%)>赤铁矿(3.87%±0.24%)>蒙脱石(1.83%±0.06%),草酸盐对铁(氢)氧化物中铁可溶性的促进作用大于黏土矿物。     

用于CO2捕集的Mg(OH)2粉末溶解速率

氢氧化镁是一种正在研究的用于脱除烟气中低浓度CO2的化学吸收剂。为了掌握工业用氢氧化镁粉末的溶解速率,利用缓冲溶液,在不改变溶液体积的情况下对不同悬浊液浓度、溶液温度、溶液pH值和搅拌速率情况下的氢氧化镁粉末溶解速率进行了研究。提高悬浊液浓度、提高溶液温度、降低溶液pH值和提高搅拌速率均能增大氢氧化镁的溶解速率。悬浊液浓度从0.1 mol/L增加到1 mol/L时,溶解速率增大了2.2倍;温度从23℃增加到52℃时,溶解速率增大了4.3～9.5倍;pH值从9.8降低到6.6时,溶解速率增大了78～225倍;搅拌速率从350 r/min增加到700 r/min时,溶解速率增大了1～2倍。     

Influence of liberated silver from silver nanoparticles on nitrification inhibition of Nitrosomonas europaea

The ecotoxicity of silver nanoparticles (Ag-NPs) to wastewater biota, including ammonia oxidizing bacteria (AOB), is gaining increasing interest as the number of products containing Ag-NPs continues to rise exponentially and they are expected to accumulate in wastewater treatment plants. This research demonstrated that the addition order of Ag-NP and the media constituents had a profound influence on the stability of the Ag-NP suspension and the corresponding repeatability of results and sensitivity of Nitrosomonas europaea. N. europaea, a model AOB, was found to be extremely sensitive to ionic silver (Ag⁺) and two sizes of Ag-NPs (20 and 80 nm). Ag⁺ exposures resulted in the highest level of toxicity with smaller Ag-NPs (20 nm) being more toxic than larger Ag-NPs (80 nm). The increased sensitivity of N. europaea to smaller Ag-NPs was caused by their higher rates of dissolved silver (dAg) release, via dissolution, due to a greater surface area to volume ratio. dAg was shown to be responsible for the vast majority of the observed Ag-NP toxicity, as determined by abiotic Ag-NP dissolution tests. For the sizes of Ag-NP studied (20 and 80 nm), there appears to be a negligible nanoparticle-specific toxicity. This was further supported by similarities in inhibition mechanisms between Ag⁺ and Ag-NP, with both causing decreases in AMO activity and destabilization of the outer-membrane of N. europaea. Finally, equal concentrations of total silver were found to be tightly associated to both Ag⁺ and Ag-NP-exposed cells despite Ag-NP concentrations being five times greater, by mass, than Ag⁺ concentrations.     

Dissolution of beryllium in artificial lung alveolar macrophage phagolysosomal fluid

Dissolution of a lung burden of poorly soluble beryllium particles is hypothesized to be necessary for development of chronic beryllium lung disease (CBD) in humans. As such, particle dissolution rate must be sufficient to activate the lung immune response and dissolution lifetime sufficient to maintain chronic inflammation for months to years to support development of disease. The purpose of this research was to investigate the hypothesis that poorly soluble beryllium compounds release ions via dissolution in lung fluid. Dissolution kinetics of 17 poorly soluble particulate beryllium materials that span extraction through ceramics machining (ores, hydroxide, metal, copper-beryllium [CuBe] fume, oxides) and three CuBe alloy reference materials (chips, solid block) were measured over 31 d using artificial lung alveolar macrophage phagolysosomal fluid (pH 4.5). Differences in beryllium-containing particle physicochemical properties translated into differences in dissolution rates and lifetimes in artificial phagolysosomal fluid. Among all materials, dissolution rate constant values ranged from 10⁻⁵ to 10⁻¹⁰ g cm⁻² d⁻¹ and half-times ranged from tens to thousands of days. The presence of magnesium trisilicate in some beryllium oxide materials may have slowed dissolution rates. Materials associated with elevated prevalence of CBD had faster beryllium dissolution rates [10⁻⁷-10⁻⁸ g cm⁻² d⁻¹] than materials not associated with elevated prevalence (p < 0.05).     

Variations in expression of carbon isotope fractionation of chlorinated ethenes during biologically enhanced PCE dissolution close to a source zone

The stable carbon isotope values of tetrachloroethene (PCE) and its degradation products were monitored during studies of biologically enhanced dissolution of PCE dense nonaqueous phase liquid (DNAPL) to determine the effect of PCE dissolution on observed isotope values. The degradation of PCE was monitored in a 2-dimensional model aquifer and in a pilot test cell (PTC) at Dover Air Force Base, both with emplaced PCE DNAPL sources. Within the plume down gradient from the source, the isotopic fractionation of dissolved PCE and its degradation products were consistent with those observed in biodegradation laboratory studies. However, close to the source zone significant shifts in the isotope values of dissolved PCE were not observed in either the model aquifer or PTC due to the constant input of newly dissolved, non fractionated PCE, and the small isotopic fractionation associated with PCE reductive dechlorination by the mixed microbial culture used. Therefore the identification of reductive dechlorination in the presence of PCE DNAPL was based upon the appearance of daughter products and the isotope values of those daughter products. An isotope model was developed to simulate isotope values of PCE during the dissolution and degradation of PCE adjacent to a DNAPL source zone. With the exception of very high degradation rate constants (>1/day) stable carbon isotope values of PCE estimated by the model remained within error of the isotope value of the PCE DNAPL, consistent with measured isotope values in the model aquifer and in the PTC.