生活垃圾加载介质层填埋法对初期渗滤液污染抑制效果研究

以传统卫生填埋柱R2为对照,通过往生物反应器填埋柱R1内加载可渗透反应介质层1和2进行模拟试验,主要探讨了填埋柱R1垃圾渗滤液COD、总氮、氨氮及总磷的变化趋势,探索一种新型的加载介质层垃圾填埋处理方法。试验结果表明,填埋20周后, R1柱COD浓度基本维持在40 000～45 000 mg/L间,约为R2柱的20%～30%;第24周,R1柱总氮和氨氮分别为206.5 mg/L和167.3 mg/L,在16～24周内,R1总氮和氨氮分别约为R2的14.5%～17.5%和36.2%～43.6%;18周时,R1柱总磷达最大值1.704 mg/L,至第24周降为0.673 mg/L, 整个实验过程R1柱总磷约为R2的0.15%～0.56%。     

无银催化-分光光度法测定COD的研究

以XS-LP为催化剂,探讨了改进的无银催化HACH法测定污水中COD的系列条件实验。结果表明:在药剂A,B的投配比为1∶2,投加总量为12 g/L的条件下,其准确度、精密度与国标法有较好的可比性,分别小于10%和3%;对实际废水的测量结果与国标回流法的相关系数分别高达0.9951和0.9874,可满足一般环境检测技术规范要求。     

微曝气Fenton氧化法处理模拟双酚A废水的效果及其生物验证

研究了微曝气Fenton氧化法关键工艺参数对模拟双酚A（BPA）废水处理效果的影响,并从活性污泥性质和污染物去除率两方面,采用膜生物反应器(membrane bioreactor, MBR)对微曝气Fenton氧化法的处理效果进行了实验验证,为实现BPA废水的生物处理奠定基础。结果表明,初始pH值、反应时间、H₂O₂/COD(质量浓度比)、H₂O₂/Fe²⁺ (摩尔浓度比)、反应温度及曝气量均对预处理效果有较大影响,在最佳条件下,COD去除率可达70%,BOD/COD值则由原废水的0.02提高到0.50以上。MBR处理上述出水的结果表明,经微曝气Fenton氧化处理BPA的废水,可较好地适应后续的生化处理。     

高锰酸钾降解地下水中PCE的研究

以氯代有机污染物中常见的PCE为目标污染物,以自制高锰酸钾溶液为氧化剂,采用批实验方法,探讨了高锰酸钾降解PCE的反应动力学、影响因素以及反应机理。反应结果表明,高锰酸钾降解PCE的反应符合一级动力学方程,反应活化能E为57.119 kJ/mol,在30℃条件下,反应速率常数为0.0076 min^-1,半衰期为91.20 min。在pH在3～10,离子强度在0～0.1030 mol/L之间变化时,反应速率不受明显影响。     

超细粉煤灰基成型吸附剂的动态吸附实验

以粉煤灰为原料制备成型吸附剂,对水溶液中亚甲基蓝和Cr⁶⁺进行动态吸附研究,绘制穿透曲线,利用Origin软件对实验数据分析处理,得出穿透曲线的通式C_t=A₁－A₂〖〗1+(t/t₀)^p+A₁。结果表明,初始浓度C₀=25 mg/L,填料高度不同时,达到穿透点的时间随填料高度的增加而增加;填料高度h=200 mm,初始浓度不同时,达到穿透点的时间随初始浓度的增加而减小;该吸附剂对有机染料和重金属离子均有较好的吸附性能;穿透曲线通式的回归线性相关系数表明,该通式可很好地反映超细粉煤灰成型吸附剂的动态吸附过程。     

太阳光Fenton法处理垃圾渗滤液中有机污染物

研究利用太阳光Fenton法处理垃圾渗滤液。根据太阳光辐射强度随时间的变化规律,选择重庆7、8月份的晴天,在中午12：00到下午14：00时进行试验,研究太阳光辐射时间、pH值、Fenton试剂用量对垃圾渗滤液COD去除率的影响。研究结果表明：太阳光Fenton法对垃圾渗滤液的COD有较好的去除效果,COD去除率达86.2%。太阳光Fenton法处理垃圾渗滤液的优化条件是：日光辐射时间为120 min,pH值为2.5,Fe²⁺浓度为5 mmol/L,H₂O₂浓度为570 mmol/L。同时,论文还对太阳光Fenton法处理垃圾渗滤液的动力学进行分析。研究结果显示：太阳光Fenton法处理垃圾渗滤液,其表观动力学方程为-dC/dt=2.6×10^-8×P^1.92×F^1.79×E^1.67。     

厌氧序批式反应器内挥发性脂肪酸积累特性研究

小试规模的厌氧序批式反应器（ASBR）,通过人工配水,研究了启动3个月时间以及一个运行周期内反应器内挥发性脂肪酸（VFA）的积累情况,并通过分析期间产甲烷活性的变化说明了控制VFA积累的重要性。经过近120 d的运行,乙酸和丙酸的最大比产甲烷活性分别提高了1.8和2.2倍,说明反应器的启动过程即是微生物群落的优化和选择的过程,ASBR的抗冲击的能力较强说明随启动的进行和种群的优化,活性污泥凝聚性能增强,对VFA的降解能力增强。     

Modeling potential herbicide loss to surface waters on the Swiss plateau

Lack of sufficiently detailed data often limits the applicability of complex transport-reaction models for estimating potential herbicide loss to surface waters. Therefore, there is also a need for simple models that are easy to apply but still capture the main features of the underlying processes.In this study, a simple regression model was developed to assess the vulnerability of catchments in the Swiss Plateau to diffuse herbicide loss to surface waters. The model is designed as a screening tool to rank the catchments in a relative sense and not to calculate Predicted Environmental Concentrations (PEC) of pesticides. The main goal is to capture two dominating factors controlling diffuse herbicide transport into streams and rivers. These factors are herbicide application and fast flow processes that are mainly responsible for herbicide transport. In a first step vulnerability of sites to herbicide loss is estimated based on site-specific conditions irrespective of actual herbicide application. In the second step, this vulnerability assessment is combined with actual herbicide application data to estimate the potential herbicide loss.The fast flow index (FFI), derived from discharge data using a base flow separation method, was applied as a proxy for the amount of fast flow occurring. The influence of catchment attributes (including topographic, climatic and soil data) on the FFI was analyzed using a multiple regression approach based on data from 57 catchments of the Swiss Plateau. By combining regression analysis with mechanistic knowledge, a two factor non-linear model based on river density and soil permeability as dominant input factors was selected as the best model for FFI prediction given the available data. Higher dimensional models had to be excluded because the strong correlation between the potential input factors led to unrealistic dependences while only minimally improving the quality of the fit.The spatial pattern of the predicted FFI as a measure for the vulnerability to diffuse herbicide losses shows a clearly increasing trend from the western to the eastern part of the Swiss Plateau and towards the pre-alpine/alpine regions in the south.In general the pattern of herbicide use corresponds to site conditions typical of a low FFI. However, the spatial analysis revealed exceptions, namely areas in which high actual herbicide use coincides with a high FFI.Despite the uncertainties in the model, this simple approach seems to be useful for supporting site-adapted agricultural practice whenever the higher accuracy of more detailed models is not required or too expensive to achieve. In addition, in combination with data on actual herbicide application, it can support the design of monitoring strategies by identifying critical areas of actual herbicide loss.     

Removal of Pb(II) ions from aqueous solution using activated tea waste: Adsorption on a fixed-bed column

An inexpensive and effective adsorbent was developed from waste tea leaves for the dynamic uptake of Pb(II). Characterization of the adsorbents showed a clear change between physico-chemical properties of activated tea waste and simply tea waste. The purpose of this work was to evaluate the potential of activated tea waste in continuous flow removal of Pb(II) ions from synthetic aqueous effluents. The performance of the system was evaluated to assess the effect of various process variables, viz., of bed height, hydraulic loading rate and initial feed concentration on breakthrough time and adsorption capacity. The shape of the breakthrough curves was determined for the adsorption of Pb(II) by varying different operating parameters like hydraulic loading rate (2.3–9.17 m³/h m²), bed height (0.3–0.5 m) and feed concentration (2–10 mg/l). An attempt has also been made to model the data generated from column studies using the empirical relationship based on the Bohart–Adams model. There was an acceptable degree of agreement between the data for breakthrough time calculated from the Bohart–Adams model and the present experimental study with average absolute deviation of less than 5.0%. The activated tea waste in this study showed very good promise as compared with the other adsorbents available in the literature. The adsorbent could be suitable for repeated use (for more than four cycles) without noticeable loss of capacity.     

One laptop per child,local refurbishment or overseas donations? Sustainability assessment of computer supply scenarios for schools in Colombia

With the intention of bridging the ‘digital divide’ many programmes have been launched to provide computers for educational institutions, ranging from refurbishing second hand computers to delivering low cost new computers. The fast and economical provision of large quantities of equipment is one of the many challenges faced by such programmes. If an increase is to be achieved in the sustainability of computer supplies for schools, not only must equipment be provided, but also suitable training and maintenance delivered. Furthermore, appropriate recycling has to be ensured, so that end-of-life equipment can be dealt with properly. This study has evaluated the suitability of three computer supply scenarios to schools in Colombia: (i) ‘Colombian refurbishment’, -refurbishment of computers donated in Colombia, (ii) ‘Overseas refurbishment’, -import of computers which were donated and refurbished abroad, and (iii) ‘XO Laptop’, -purchase of low cost computers manufactured in Korea. The methods applied were: Material Flow Assessment, -to assess the quantities-, Life Cycle Assessment, -to assess the environmental impacts, and the application of the Multiple Attribute Utility Theory, -to analyse, evaluate and compare different scenarios. The most sustainable solution proved to be the local refurbishment of second hand computers of Colombian origin to an appropriate technical standard. The environmental impacts of such practices need to be evaluated carefully, as second hand appliances have to be maintained, require spare parts and sometimes use more energy than newer equipment. Providing schools with second hand computers from overseas and through programmes such as ‘One Laptop Per Child’ has the disadvantage that the potential for social improvements – such as creation of jobs and local industry involvement – is very low.