膜生物反应器与传统活性污泥工艺除污特性比较

比较了膜生物反应器（MBR）和传统活性污泥工艺（CAS）在相同运行条件下对生活污水的除污特性.结果表明,MBR系统对COD、NH3-N和TN的平均去除率比CAS分别高14.4%、51.2%和37.3%.但MBR中膜的截留使系统相对比较封闭,制约了通过排放高磷污泥的生物法除磷,除磷效率仅为32.9%,低于CAS工艺（43.0%）;将MBR与化学除磷工艺相结合,MBR系统除磷效率可达93.3%.     

Treatment of a dyeing wastewater from a woolen mill using an A/O membrane bio-reactor

ＩｎｔｒｏｄｕｃｔｉｏｎＴｈｅｄｙｅｉｎｇｗａｓｔｅｗａｔｅｒｏｆｗｏｏｌｅｎｍｉｌｌｃｏｎｔａｉｎｓａｌｏｔｋｉｎｄｓｏｆｐｏｌｌｕｔａｎｔｓ,ｓｕｃｈａｓａｃｉｄｉｃｄｙｅｓ,ｄｉｓｐｅｒｓｅｄｙｅｓ,ｍｏｒｄａｎｔｄｙｅｓ,ａｕｘｉｌｉａｒｉｅｓ,ｓａｌｔｓａｎｄｓｏｏｎ .Ｔｈｅｅｆｆｌｕｅｎｔｓｆｒｏｍｗａｓｔｅｗａｔｅｒｔｒｅａｔｍｅｎｔｐｌａｎｔｓｆｏｒｔｒｅａｔｍｅｎｔｏｆｔｈｅｄｙｅｉｎｇｗａｓｔｅｗａｔｅｒｏｆｗｏｏｌｅｎｍｉｌｌｓｗｉｔｈｎｏｒｍａｌｂｉｏｌｏｇｉｃａｌｐｒｏｃｅ…     

Test of membrane bioreactor for waste water treatment in a petrochemical complex

Membrane bioreactor (MBR) used in water and waste water treatment is a developing technique for water pollution control and water reuse. This paper describes a membrane-bioreactor for treatment of waste water in a petrochemical complex. The experimental MBR was a lab scale one composed of an activated sludge bioreactor unit and an ultrafiltration membrane unit. The relationship of COD removal with MLSS and HRT in this MBR was studied. The effects of crossflow velocity, backwash interval and volume of flush liquid on the flux were discussed. The results showed that average removal of COD, oil, SS and turbidity in petrochemical waste water by the MBR was 91%, 86%, 92% and 99% respectively. The average removal of NH₃-N and total phosphorous was 85% and 82%. A coefficient of COD removal, k, was 0.017-0.080 L/(mg.d). The membrane flux maintained higher than 60 L/hm2 bar for 34 days without chemical cleaning when the velocity of crossflow was 3.5-3.9 m/s and the backwash interval was 30 minutes and backwash duration at 20 seconds. The results indicated that it is feasible for MBR technology to be used in petrochemical waste water treatment. The treated water could be considered as a source used to make up water for industrial cooling system or to be reused for other purposes.     

膜技术在挥发性有机蒸汽（VOC）处理中的应用

有机蒸汽（VOC）排放到大气中会引起健康，环境、安全等一系列问题。采用膜技术来处理VOC具有投资较小、分离效率高、能量消耗低、操作简单、不形成二次污染等优点，所以在处理VOC方面有着广泛的应用。文中介绍了膜分离技术处理有机蒸汽的原理，膜法处理有机蒸汽的过程及其工艺流程。     

污染物的微生物毒性检验

从文献报导的１０几种污染物毒性试验方法中，选择了脱氢酶活性、Ｍｉｃｒｏｔｏｘ毒性、微生物呼吸率、以及降解动力学等４种方法，系统地比较，研究了其表示污染物对微生物的毒性效应的灵敏性，准确性，可靠性和实用性，研究结果应用于焦化废水、染化废水与黄浦江水样的检验表明，ＭＴＸ方法能最好地反映污染物的微生物毒性，且操作简便，费时少，数据的解释也最为方便。     

草浆黑液中碱的扩散渗析回收与处理

研究采用扩散渗析法回收草浆黑液中的氢氧化钠,分别采用了离子交换膜和上海交通大学高分子研究所提供的疏水氟膜、亲水氟膜对草浆黑液进行处理。单位膜面积单位体积黑液下阴极室总碱量的增加用R表示。三种膜的R值分别为2.17×10-7mol/(mL·cm2)、9.20×10-8mol/(mL·cm2)、4.39×10-7mol/(mL·cm2)。可见亲水氟膜的扩散渗析效果最好。实验对原黑液及经亲水氟膜扩散渗析得到的稀碱液进行了质谱分析,结果显示只有一部分小分子有机物转移到蒸馏水一侧。从亲水氟膜处理前后的扫描电镜图可以看出亲水氟膜只有较轻微的污染。可见亲水氟膜有最好的扩散渗析效果和较好的使用寿命。     

膜生物反应器处理生活污水无泡供氧的研究

用疏水性微孔膜制成的供氧器，向水溶液或发酵液供氧时，无气泡产生，这种无泡式供氧方式突破了传统的泡式供氧模式，具有传氧效率高，无泡沫产生和动力消耗低等优点。在膜生物反应器中用无泡式供氧进行生活污水处理试验研究。结果表明，COD，BOD5、NH3－N、浊度去除率分别达95％、94％和99％，对SS和大肠杆菌去除率达100％。     

加压活性炭生物膜法处理DSD有机废水

采用加压活性炭生物膜法处理以对硝基甲苯磺酸盐为主的难降解的有机废水的研究,是在活性炭生物膜法处理有机废水基础上发展起来的新技术。本实验结果表明,在加压9.8×10~4Pa(1kgt/cm~2)的条件下,COD_(Cr)去除率为62％～70％,比常压活性炭生物膜法高20％～25％;其容积负荷Nv=1.7～2.9kgCOD/m~3·d,比一般活性污泥法高3～6倍。     

The effect of oxygen tension on colony formation and cell proliferation of amniotic fluid cellsin vitro

The effects of reduced oxygen concentrations in the gas phase over the culture medium on colony formation and cell proliferation were investigated in high and low cell density primary and secondary cultures of amniotic fluid cells. Using two standard culture methods (25 cm² plastic flasks and Leighton type tubes) a significantly reduced culture time was observed at high cell density for mass cultures by incubation within a low oxygen tension gas phase (2.5 per cent to 7.5 per cent O₂) instead of conventional air (18 per cent O₂). At low cell density colony formation was significantly enhanced in cultures grown at reduced oxygen tension. Using gas permeable membranes as support, lowering the oxygen tension from 7.5 per cent to 2.5 per cent yielded an increase in plating efficiency of cells from approximately 5 per cent to 25 per cent, whereas plating efficiency was less than 2 per cent for cells grown at ambient 18 per cent O₂. It is suggested that low oxygen tension in the gas phase is an effective means of enhancing clonal growth in amniotic fluid cell cultures, thereby reducing both culture time and risk of culture failure.