滦河流域景观格局变化及其驱动因子分析

基于遥感、地理信息系统(GIS)技术、景观生态学方法和多元统计方法,以滦河流域为研究区域,在1980～2008年的土地利用图基础上,对景观格局特征和变化及其驱动因子进行研究分析.结果表明1980～2008年间林地始终占据了景观的主导地位,约为流域的40%;近年来滦河流域除林地外其它景观类型都有显著性变化;总体上看,滦河...     

重庆市主城区生活垃圾现状调查与分析

通过对重庆主城区生活垃圾的分类调查以及成分和理化性质的分析，认为重庆市城市垃圾主要来源于居民家庭和各种商业活动。垃圾湿度和容重高于全国平均水平，热值基本满足垃圾焚烧处理要求。元素分析显示垃圾中总氮和总碳含量较高，适合进行堆肥处理。     

Hydrochemistry of Wet Atmospheric Precipitation Over an Urban Area in Northern Indo-Gangetic Plains

Rain water samples were collected to study the chemical composition of wet atmospheric precipitation (first event) over the Lucknow city in the northern Indo-gangetic alluvial plains. The samples were collected in the month of July, 2005 from different sites. The wet precipitation samples were analyzed for pH, EC, major ions (, Cl⁻, , , , F⁻, Na⁺, K⁺, Ca²⁺, Mg²⁺, ) and heavy metals (As, Cd, Al, Co, Cr, Cu, Fe, Mn, Mo, Ni, Hg, Pb, Se, Sn, Ti, V, Zn). The pH values of wet precipitation samples ranged between 6.5 and 8.7. The analysis of linear regression applied to the set of studied variables and computation of neutralization factors showed that neutralization occurred in precipitation samples and Ca²⁺ had the maximum neutralization capacity. It was found that Cl⁻, , Ca²⁺, Mg²⁺, Na⁺ and K⁺ in the precipitation samples originated mainly from crustal/anthropogenic sources in the region. On an average Fe, and Al accounted for >72% of the total concentration of trace metals in the wet precipitation samples followed by Zn (>10%). Enrichment factors calculated for heavy metals over reference background level in seawater and Earth’s crust showed relatively higher enrichment of Zn. The principal component analysis (PCA) identified the possible sources of ionic species and heavy metals in the wet precipitation samples.     

Methodology to design a municipal solid waste generation and composition map: A case study

The municipal solid waste (MSW) management is an important task that local governments as well as private companies must take into account to protect human health, the environment and to preserve natural resources. To design an adequate MSW management plan the first step consist in defining the waste generation and composition patterns of the town. As these patterns depend on several socio-economic factors it is advisable to organize them previously. Moreover, the waste generation and composition patterns may vary around the town and over the time. Generally, the data are not homogeneous around the city as the number of inhabitants is not constant nor it is the economic activity. Therefore, if all the information is showed in thematic maps, the final waste management decisions can be made more efficiently. The main aim of this paper is to present a structured methodology that allows local authorities or private companies who deal with MSW to design its own MSW management plan depending on the available data. According to these data, this paper proposes two ways of action: a direct way when detailed data are available and an indirect way when there is a lack of data and it is necessary to take into account bibliographic data. In any case, the amount of information needed is considerable. This paper combines the planning methodology with the Geographic Information Systems to present the final results in thematic maps that make easier to interpret them. The proposed methodology is a previous useful tool to organize the MSW collection routes including the selective collection. To verify the methodology it has been successfully applied to a Spanish town.     

An overview for the utilization of wastes from stainless steel industries

Significant quantities of wastes are generated as the waste materials or byproducts every day from stainless steel processes. According to the origins and characteristics, the stainless steel wastes can be mainly classified into two categories, slags and dusts. They usually contained considerable quantities of valuable metals and materials. This paper summarized and analyzed the generation, composition, characteristics and the leaching behaviors of the most of wastes obtained from the stainless steel processes. On this basis, a review of several methods for treating the various stainless steel wastes was made. It is very essential not only for recycling the valuable metals and mineral resources but also for protecting the environment.     

Human urine as a source of alternative natural fertilizer in agriculture: A flight of fancy or an achievable reality

Organically agricultural products are gaining popularities through out the world as it gives the consumer satisfaction with a basket of safer and better trusted foods. It is also well established that intensive conventional agricultural practices can introduce contaminants into the food chain with adverse affect on environment. However, organic agricultural practices give an alternative environmental friendly sustainable agriculture among the farmers. Beside this fact, organic crops contain fewer nitrates, nitrites, pesticide residues and trace elements than conventional crops. Even though, in organic systems generally have 20% lower yields than conventionally produced crops. One of the major constrains of organic farming is decrease of raw organic matters to prepare compost. Therefore, scientists are looking forward for different organic sources which are plenty in nature and available at little-to-no cost. Human urine is one of them, and has been gaining popularities as a raw material for organic cultivation. However, several important merits and demerits of application of human urine are needed to be addressed in agriculture.     

The influence of melt composition,liquidus temperature and solidus temperature on vapour explosions in melt droplet impingement experiments

For the investigation of vapour explosions, droplet impingement experiments were performed with the binary system Pb–Sn and the pseudo-binary system PbS–Cu₂S. The experiments were performed with a melt at 600 °C (Pb–Sn) or 700 °C (PbS–Cu₂S) and a water bath at ambient temperature and pressure. A hydrophone and a high-speed camera were used to study the interaction and from this data, the explosion probability and intensity were determined.The explosion probability had a single minimum around 70 wt% Sn, close to the eutectic composition. Moreover, the explosion probability increased approximately linearly with changing composition towards the pure melts, and was similar for pure tin and pure lead. On the other hand, the explosion intensity was comparable for tin and the eutectic alloy while clearly lower for lead. Almost all intermediate alloys had a reduced explosion intensity.Based on the variation in composition, the effects of the liquidus or solidus temperature and the liquidus-solidus gap on the explosion behaviour were also investigated. The explosion probability in both systems increased with increasing liquidus temperature. Also, the maximum explosion intensity in the Pb–Sn system increased with increasing liquidus temperature. Both could be related to easier triggering due to (partial) solidification. On the other hand, the explosion intensity was found to decrease with increasing gap between liquidus and solidus temperature, as was also found in literature. No significant trends for the explosion intensity were found for experiments with PbS–Cu₂S.     

Dissolution kinetics of high explosives particles in a saturated sandy soil

Solid phase high explosive (HE) residues from munitions detonation may be a persistent source of soil and groundwater contamination at military training ranges. Saturated soil column tests were conducted to observe the dissolution behavior of individual components (RDX, HMX, and TNT) from two HE formulations (Comp B and C4). HE particles dissolved readily, with higher velocities yielding higher dissolution rates, higher mass transfer coefficients, and lower effluent concentrations. Effluent concentrations were below solubility limits for all components at superficial velocities of 10-50 cm day(-1). Under continuous flow at 50 cm day(-1), RDX dissolution rates from Comp B and C4 were 34.6 and 97.6 microg h(-1) cm(-2) (based on initial RDX surface area), respectively, significantly lower than previously reported dissolution rates. Cycling between flow and no-flow conditions had a small effect on the dissolution rates and effluent concentrations; however, TNT dissolution from Comp B was enhanced under intermittent-flow conditions. A model that includes advection, dispersion, and film transfer resistance was developed to estimate the steady-state effluent concentrations.     

WASP—5系统及其述评

WASP5（The water quality analysis simulation program-5，水质分析模拟程序5），是EPA推荐使用的水质模型软件。该文介绍了WASP5的组成、功能、原理、应用步骤、适用范围、输入输出，并对其优缺点进行了评论，最后还介绍了WASP5在浦西河网水质模拟中的应用。     

云天化粉煤灰理化性能的测试及研究

利用现代分析测试技术 ,对云天化集团有限责任公司自备电厂所排粉煤灰的理化性能进行了系统的测试。这些粉煤灰的化学成分以Fe2 O3含量高为特征 ,残留碳含量较低 ;物相较简单 ,未发现高温相的莫来石 ,玻璃微珠也较少见 ;颗粒呈不规则碎屑状 ,平均粒径较细 ,需水量比值较高 ;其所含的微量元素和放射性元素种类较多 ,但与国家的相关标准相比较 ,均未超标