城市道路沉积物氮、磷溶出特性

国内外众多研究表明,城市不透水表面沉积物是雨水径流中污染物的重要来源。以北京市某道路沉积物为研究对象,对城市道路沉积物的粒径分布进行了分析,并通过批量实验,研究了不同粒径道路沉积物中氮、磷营养物及有机物(COD)的溶出特性。实验结果表明,粒径较大的沉积物中氮含量较高,而粒径较小的沉积物中磷含量较高;虽然TP、PO3-4、TN、NO-3、NH+4、COD的溶出浓度、溶出速率变化特征各不相同,但总体趋势是粒径越小氮、磷及COD溶出浓度和溶出速率越大,且最大溶出速率都出现在前5 min。因此,为实现对城市雨水径流污染的有效控制,应采用源头控制措施对小粒径道路沉积物和初期雨水进行有效控制。     

MCM-41介孔分子筛的合成及其对铜离子的吸附性能简

以微硅粉为硅源,CTAB和PEG-6000为模板剂,合成MCM-41介孔分子筛。采用XRD、N₂吸附-脱附曲线、FTIR以及TEM表征了其结构、比表面积、孔径分布及晶体形貌,并且以该样品为吸附剂,对含Cu²⁺的溶液进行了静态吸附实验。结果表明,以微硅粉为硅源成功合成了具有典型六方排列孔道结构的MCM-41,其比表面积为869.5 m²/g,孔容为0.97 cm³/g,平均孔径为3.3 nm;溶液pH为5~6时,MCM-41对Cu²⁺的去除效果最好;MCM-41对Cu²⁺的最大吸附吸附容量36.3 mg/g;MCM-41对Cu²⁺的吸附性能符合Langmuir吸附方程的特征。动力学研究表明,该过程符合准二级动力学模型。     

负载型Mn-Ce/TiO2催化剂的制备及其低温脱硝活性简

以成型TiO₂作为载体,通过浸渍法制备了Mn-Ce/TiO₂低温SCR催化剂,并系统研究了制备方法、煅烧条件、活性组分担载量、Mn含量等参数对催化剂催化还原NO性能的影响。结果表明,煅烧温度的升高会促使活性组分结晶度的提高,从而引起催化活性的降低,在500℃和600℃下所得Mn-Ce/TiO₂催化剂活性组分为无定型态,表现出较高的脱硝活性。活性组分担载量的增加有利于催化活性的提高。Mn含量对Mn-Ce/TiO₂催化剂的活性有较大影响,当Mn/（Mn+Ce）摩尔比为40%和85%时,催化剂活性最高。     

突变灰盖鬼伞过氧化物酶降解刚果红的响应面法优化分析简

酶法降解偶氮染料刚果红是一个复杂的过程,受温度、pH、酶量、刚果红浓度和双氧水浓度显著影响。为研究各因素及因素间交互作用对刚果红降解影响,提高刚果红的降解率,分别使用单因素法和响应面分析法对刚果红降解条件进行了优化。单因素实验结果显示灰盖鬼伞过氧化物酶降解刚果红的最适条件为：pH 5.0、32℃、酶量4.98 U、双氧水0.1 mmol/L、刚果红20 mg/L,此时刚果红最高降解率为34.84%。然后选双氧水浓度、刚果红浓度和灰盖鬼伞过氧化物酶量作为3个因素,通过中心组合设计实验,用响应面法对刚果红降解进行优化分析,最后得到一个拟合度良好的二次多项方程模型（R²=0.9900）。方差分析结果显示,刚果红浓度和酶量是影响最显著的因素,双氧水与酶以及染料与酶之间的交互作用极显著。响应面分析优化后的反应体系为：双氧水浓度0.15 mmol/L,刚果红浓度为27.21 mg/L,酶为2.0 7 U,在此条件下,刚果红降解率达58.13%。     

甲苯对UASB反应器中溶解性微生物产物的影响

以乙酸钠为外加碳源,考察了UASB反应器内甲苯对可溶性微生物产物（SMP）的影响。实验结果表明：低质量浓度（20~70 mg/L）的甲苯对微生物有刺激作用,使得污泥增殖速率变小,SMP的质量浓度也逐渐减少,经过一段时间的驯化后,系统COD和TOC的去除率分别达到93%和94%以上,下降趋势较小;较高质量浓度（70~200 mg/L）的甲苯对微生物有抑制作用,污泥活性下降,反应器运行状况开始恶化,SMP的质量浓度也逐渐增大,经过一段时间的驯化后,系统COD和TOC的去除率分别维持在81%和83%以上;当甲苯质量浓度超过200 mg/L时,表现为污泥活性严重下降,对COD的去除效果极差。     

Investigation into the effect of high concentrations of volatile fatty acids in anaerobic digestion on methanogenic communities

A study was conducted to determine whether differences in the levels of volatile fatty acids (VFAs) in anaerobic digester plants could result in variations in the indigenous methanogenic communities. Two digesters (one operated under mesophilic conditions, the other under thermophilic conditions) were monitored, and sampled at points where VFA levels were high, as well as when VFA levels were low. Physical and chemical parameters were measured, and the methanogenic diversity was screened using the phylogenetic microarray ANAEROCHIP. In addition, real-time PCR was used to quantify the presence of the different methanogenic genera in the sludge samples. Array results indicated that the archaeal communities in the different reactors were stable, and that changes in the VFA levels of the anaerobic digesters did not greatly alter the dominating methanogenic organisms. In contrast, the two digesters were found to harbour different dominating methanogenic communities, which appeared to remain stable over time. Real-time PCR results were inline with those of microarray analysis indicating only minimal changes in methanogen numbers during periods of high VFAs, however, revealed a greater diversity in methanogens than found with the array.     

Estimation of building-related construction and demolition waste in Shanghai

One methodology is proposed to estimate the quantification and composition of building-related construction and demolition (C&D) waste in a fast developing region like Shanghai, PR China. The varieties of structure types and building waste intensities due to the requirement of progressive building design and structure codes in different decades are considered in this regional C&D waste estimation study. It is concluded that approximately 13.71 million tons of C&D waste was generated in 2012 in Shanghai, of which more than 80% of this C&D waste was concrete, bricks and blocks. Analysis from this study can be applied to facilitate C&D waste governors and researchers the duty of formulating precise policies and specifications. As a matter of fact, at least a half of the enormous amount of C&D waste could be recycled if implementing proper recycling technologies and measures. The appropriate managements would be economically and environmentally beneficial to Shanghai where the per capita per year output of C&D waste has been as high as 842 kg in 2010.     

假单胞菌好氧降解四溴双酚A的特性

为了解四溴双酚A(TBBPA)的好氧降解特性,采用选择富集法从活性污泥中分离出一株能够高效降解四溴双酚A的菌株。根据其形态、生理生化特性及16S rDNA核苷酸序列分析,该菌株被鉴定为假单胞菌属(Pseudomonas sp.)。研究结果表明,该菌株可通过好氧共代谢方式实现四溴双酚A的降解,葡萄糖是四溴双酚A降解的最佳碳源,其最优降解条件为葡萄糖8 g/L,牛肉膏0.5 g/L,pH值为7.0,培养温度为35℃,摇床转速为150 r/min。在该条件下其生物降解过程符合一级动力学模型,6 d后的降解率高达95.6%。LC-MS结果表明,四溴双酚A在好氧降解过程中会生成异丙苯酚类物质。     

利用白云石石灰去除与回收污泥厌氧消化液中氮和磷

以白云石石灰为实验材料去除与回收污泥厌氧消化液中的氮磷,通过小试实验研究不同投药固液比S/L、初始pH值、反应温度、搅拌速度及反应时间对去除与回收氮磷效果的影响。实验结果表明,在最佳投药固液比S/L为300mg/L,最佳初始pH值范围为8.5~9.5,反应温度为25.0℃,搅拌速度为150 r/min,反应时间为24 h条件下,氨氮(NH+4-N)和磷(PO3-4-P)的去除率分别为37.26%和89.60%。利用X射线衍射仪(XRD)、扫描电镜(SEM)对沉淀产物进行了表征,通过分析可知沉淀产物中含有磷酸铵镁(MAP),可实现废水中氮磷经济有效的回收。     

循环流化床锅炉燃煤技术热电厂生命周期评价

运用生命周期评价方法,应用Gabi5.0软件对采用循环流化床锅炉燃煤技术的热电企业进行资源耗竭和环境影响分析,计算各生产单元生命周期清单的全球变暖潜值、酸化效应潜值、富营养化潜值、非生物资源耗竭潜值、人体毒性潜值以及光化学烟雾和臭氧生成潜值等主要环境影响类型,对燃煤发电过程进行生命周期评价。结果表明,全球变暖和非生物资源耗竭为发电运行过程中主要的环境影响因素,分别占53%和15.05%;锅炉燃烧阶段的环境影响最重,占整个生命周期影响值的77.12%,并且除生物耗竭潜值外的其他5项指标均为发电运行阶段各个单元中最高。采用SNCR脱硝技术减少燃烧过程中NOx的排放量,并对该技术方案进行生命周期评价,比较方案实施前后的环境影响。