Kinetic and thermodynamic studies on partitioning of polychlorinated biphenyls (PCBs) between aqueous solution and modeled individual soil particle grain sizes

The significance of soil mineral properties and secondary environmental conditions such as pH, temperature, ionic strength and time in the partitioning of eight selected polychlorinated biphenyl(PCB) congeners between aqueous solution and soil particles with different grain sizes was studied. The mineral properties of a model soil sample were determined, and Brunauer–Emmett–Teller(BET) adsorption–desorption isotherms were employed to observe the surface characteristics of the individual modeled soil particles.Batch adsorption experiments were conducted to determine the sorption of PCBs onto soil particles of different sizes. The results revealed that the sorption of PCB congeners onto the soil was dependent on the amount of soil organic matter, surface area, and pore size distribution of the various individual soil particles. Low pH favored the sorption of PCBs,with maximum sorption occurring between pH 6.5 and 7.5 with an equilibration period of 8 hr.Changes in the ionic strength were found to be less significant. Low temperature favored the sorption of PCBs onto the soil compared to high temperatures. Thermodynamic studies showed that the partition coefficient(K_d) decreased with increasing temperature, and negative and low values of ΔH° indicated an exothermic physisorption process. The data generated is critical and will help in further understanding remediation and cleanup strategies for polluted water.     

Effect of air masses motion on the rapid change of aerosols in marine atmosphere

The impact of air masses motion on marine aerosol properties was investigated using an on-board single particle mass spectrometer(SPAMS) deployed for the determination of single particle size resolved chemical composition over Southeast China Sea. Two aerosol blooms(E1 and E2) were observed during the cruise. High average particle number count occurred in E1(7320), followed by E2(5850), which was more than 100–150 times of the average particle number count during normal periods. Particles were classified as four major sources, including continental source, shipping source, marine source, and transport source based on the mass spectral similarity. Transport source was identified as those particles with high particle number count occurred only during aerosol bloom period. Three sub-types of EC-Ca, OC-Ca, and Al-rich were classified as transport source.EC-Ca was the dominant particles of the transport source, accounting for more than 70%of the total particles in aerosol bloom events. A uni-modal size distribution in the size range of 0.1–2.0 μm was observed during normal period, while a bimodal distribution with a tiny mode(0.3 μm) and a coarse mode between 0.4 and 0.6 μm was present during aerosol bloom. The variation of aerosol source is consistent with air masses back trajectories, for the reason that most of the long-range air trajectories are from the ocean,while short air trajectories originate in the continental regions, which means that air masses have a significant impact on the aerosol physical–chemical properties along their tracks.     

颗粒冲蚀对注射法制备C/C-ZrC-SiC复合材料 抗烧蚀性能的影响研究

目的采用ZrC和SiC复相陶瓷对C/C复合材料进行改性,研究改性后的复合材料受到颗粒冲蚀破坏的烧蚀行为。方法采用注射法将ZrC和SiC复相陶瓷前驱体引入到等温化学气相渗透法(ICVI)制备的低密度C/C复合材料中,再通过高温热处理、ICVI的方法制备出ZrC和SiC复相陶瓷改性的C/C(C/C-ZrC-SiC)复合材料,随后对制备的复合材料进行高速颗粒冲击实验破坏,并对破坏后的试样进行氧乙炔火焰烧蚀,研究其烧蚀行为。结果改性后的复合材料线冲蚀率和质量冲蚀率分别为253.1μm/s和79.8 mg/s,相较于同孔隙率的C/C复合材料分别降低了49.2%和61%。颗粒冲蚀破坏后C/C-ZrC-SiC复合材料的线烧蚀率和质量烧蚀率分别为4.26μm/s和1.44 mg/s,相比于同孔隙率的C/C复合材料,分别降低了37%和39%。结论由于引入的ZrC和SiC陶瓷相的硬度大于碳基体,C/C-ZrC-SiC复合材料在受到高速颗粒的冲击时,能通过硬质陶瓷相起到抗冲击作用,使得改性后的复合材料抗冲蚀性能大幅度提高。受到颗粒冲蚀破坏后的C/C-ZrC-SiC复合材料内部仍存在超高温陶瓷相,烧蚀过程中能够形成ZrO2骨架结构和SiO2球形颗粒,进而有效保护碳纤维和热解碳基体。     

Formation and growth of indoor air aerosol particles as a result of d-limonene oxidation

Oxidation of d-limonene, which is a common monoterpene, can lead to new aerosol particle formation in indoor environments. Thus, products containing d-limonene, such as citrus fruits, air refresheners, household cleaning agents, and waxes, can act as indoor air aerosol particle sources. We released d-limonene into the room air by peeling oranges and measured the concentration of aerosol particles of three different size ranges. In addition, we measured the concentration of d-limonene, the oxidant, and the concentration of ozone, the oxidizing gas. Based on the measurements we calculated the growth rate of the small aerosol particles, which were 3–10 nm in diameter, to be about , and the losses of the aerosol particles that were due to the coagulation and condensation processes. From these, we further approximated the concentration of the condensable vapour and its source rate and then calculated the formation rate of the small aerosol particles. For the final result, we calculated the nucleation rate and the maximum number of molecules in a critical cluster. The nucleation rate was in the order of and the number of molecules in a critical-sized cluster became 1.2. The results were in agreement with the activation theory.     

乌鲁木齐市冬季近地逆温特点及其与可吸入颗粒物浓度的相关关系分析

总结了乌鲁木齐市冬季逆温的形成及其特点,着重分析逆温强度等与可吸入颗粒物浓度的相关关系,最终得出线性方程,并做出线性拟合图。     

基于证据理论的煤矿瓦斯涌出组合预测

为提高煤矿瓦斯涌出量预测的准确度,引入证据理论组合预测方法。根据瓦斯涌出量及其主要影响因素间的实验数据,采用3个不同的粒子群神经网络模型对涌出量进行初步预测。并由BP、RBF网络对预测误差及预测点的影响因素进行分析建模,以获取每个模型的可信度。再利用证据理论对其进行合成,确定组合模型的权值,最终实现对瓦斯涌出量的组合预测。实例结果表明,该组合预测方法的平均绝对误差、均方误差分别为18.5%、5.8%,均小于神经网络组合法及等权平均法的相应预测误差,适用于煤矿瓦斯涌出量预测。     

循环流化床烟气悬浮脱硫技术中试及机理分析

设计了新的循环流化床烟气悬浮脱硫中试装置,其烟气处理量达3500m³/h.首先进行了进料钙硫比(Ca/S)、过饱和温度对装置脱硫效率影响实验,进一步研究了脱硫塔内固体颗粒物循环和烟气流速等因素对脱硫装置性能的影响.对比实验研究表明:在Ca/S=1.2时,固体颗粒物的循环使系统脱硫效率提高15% 左右;脱硫塔内烟气设计流速可以偏高一些.本文同时对系统脱硫过程进行了机理分析,指出了延长脱硫剂有效停留时间的途径.     

综合拉底、扩漏和出矿全过程的底部结构安全性颗粒流模拟技术研究

为探明自然崩落法从拉底崩落至出矿全过程中底部结构节理连续扩展过程与破坏过程规律，采用PFC2D软件，结合RocLab软件反演节理岩体参数，建立229 m×129 m的岩体扩大模型，对拉底崩落至出矿过程进行连续综合计算。研究结果表明:模拟结果及破坏现象与现场监测结果相近，建模与细观参数反演方法适用于该类岩体工程研究；裂纹扩展贯通导致岩体失稳破坏，破坏过程与裂纹扩展具有相对应的阶段特征，裂纹扩展分为崩落前稳定扩展期，崩落与聚矿槽开挖过程加速扩展期和后续持续扩展期；结构破坏分为蕴育过程，扰动失稳过程和宏观破坏过程；较大范围的宏观破坏主要在出矿阶段。该模拟方法与结果可为底部结构维护以及节理岩体长期稳定性研究提供参考。     

RBF神经网络可靠度分析方法在边坡稳定性研究中的应用

针对边坡稳定性可靠度分析,当状态函数无法显式表达且传统计算方法求解复杂问题困难时,提出一种基于ABAQUS和粒子群优化径向基函数神经网络的可靠度分析方法。基于ABAQUS的强度折减方法计算所选随机变量对应的安全系数,利用径向基函数神经网络的数据拟合功能,建立模型并映射出安全系数和随机变量之间的关系,构造响应面功能函数;利用蒙特卡罗生成的大量随机样本代入功能函数得到相应的安全系数,进而计算边坡的失稳概率和可靠度指标来反映边坡稳定性。研究结果表明:相对于传统方法,本文方法计算效率更高、误差更小,适合实际工程应用。     

惰性粉体对蔗糖粉尘最小点火能的影响研究

为了预防蔗糖粉尘爆炸,利用1.2 L哈特曼管研究了NH₄H₂PO₄与Al(OH₄对蔗糖粉尘爆炸的抑制作用。在蔗糖粉尘质量分数一定的条件下,通过改变 NH₄H₂PO₄与Al(OH)₄的粒径和质量分数,测定其对蔗糖粉尘爆炸的抑制效果。结果表明:随着NH₄H₂PO₄和Al(OH)₄质量分数的增加,粒径的减小,蔗糖粉尘的最小点火能均逐渐增大,当惰性粉体增加到一定质量时,蔗糖粉尘被完全惰化,在蔗糖粉尘中分别加入粒径为48~74,38~47,25~37 μm的NH₄H₂PO₄和Al(OH)₄,3种粒径的NH₄H₂PO₄使蔗糖粉尘完全惰化的质量分数分别为40%,35%,30%,3种粒径的Al(OH)₃使蔗糖粉尘惰化的质量分数均为60%。因此(NH₄)H₂PO₄抑制蔗糖粉尘爆炸的效果比Al(OH)₃更显著。