低温A/O-MBR工艺启动试验研究

研究了A/O-MBR工艺低温(水温在5~12℃)启动效能,结果表明,低温下A/O-MBR工艺启动迅速,活性污泥的培养驯化时间较短。启动过程中根据出水水质情况,逐渐提高负荷,运行34 d,系统对COD的去除率能达到90%以上,系统对氨氮的去除率能达到96%以上,至稳定运行后氨氮的负荷平均可达到0.419kg/(m3.d),反硝化效果系统去除率基本能稳定在60%左右。     

电渗析法再生CO_2电还原电解液的研究

探索了电渗析法再生CO2电还原电解液的可行性。以HCOOK溶液作为CO2电还原反应后的模拟液,采用单室电渗析装置对其进行再生,考察了电流、时间、温度等操作条件对电流效率和再生率的影响,研究结果表明:在常温条件下,操作电流低于极限电流时,采用电渗析法再生CO2电还原电解液具有高的电流效率和再生率。     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

Effect of platinum on the photocatalytic degradation of chlorinated organic compound

TiO2 nanoparticles, doped with di erent Pt contents, were prepared by a modified photodeposition method using Degussa P-25 TiO2, H2PtCl6 6H2O and methanol as the solvents. The physicochemical properties of Pt/TiO2 were investigated by the nitrogen adsorption and desorption isotherm measurement technique, X-ray di raction analysis and photoluminescence spectra, respectively. Reaction rates from photocatalytic removal of dichloromethane over Degussa P-25 TiO2 and Pt/TiO2 were evaluated. The average diameter and BET surface area of the TiO2 catalyst particles were 300 nm and 50 m2/g, respectively. The degradation e ciency was 99.0%, 82.7%, 55.2%, and 57.9% with TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. And the degradation e ciency was 99.3%, 79.7%, 76.5%, and 73.4% with a 0.005 wt.% Pt/TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. In addition, we found that the photoluminescence emission peak intensities decreased with increases in the doping amount of Pt, which indicates that the irradiative recombination was weakened. Furthermore, the results showed that the UV/0.005 wt.% Pt/TiO2 process was capable of e ciently decomposing gaseous DCM in air.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

Arbuscular mycorrhizal fungi alter the response of growth and nutrient uptake of snap bean（Phaseolus vulgaris L.） to O_3

The effects of arbuscular mycorrhizal fungi (AMF) Glomus mosseae on the responses to elevated O3 in growth and nutrition of snap bean (Phaseolus vulgaris L. cv Guangzhouyuan) were investigated. Exposure was conducted in growth chambers by using three O3 concentrations (20 (CF), 80 (CFO1) and 120 nL/L (CFO2); 8 hr/day for 75 days). Results showed that elevated O3 slightly impacted overall mycorrhizal colonization, but significantly decreased the proportional frequency of hypha and increased the proportional frequency of spores and vesicles, suggesting that O3 had significant effects on mycorrhizal structure. Elevated O3 significantly decreased yield, dry mass and nutrient contents (N, P, K, Ca and Mg) in both non-mycorrhizal and mycorrhizal plants. However, significant interactive effects were found in most variables due to that the reduction by O3 in the mycorrhizal plants was less than that in the non-mycorrhizal plants. Additionally, AMF increased the concentrations of N, P, Ca, and Mg in shoot and root. It can be concluded that AMF alleviated detrimental effects of increasing O3 on host plant through improving plant nutrition and growth.     

神奇的哈尼稻田

云南红河州是哈尼梯田的"故乡",也是梯田文化重要的发源地之一。哈尼梯田是以哈尼族为主的红河州各族人民倾注了数十代的智慧与心力,历经1300多年开垦而成的生态农业奇观,它不仅是一幅气势恢宏的农耕山水画卷,更是世界农耕文明的典范和宝贵遗产。在2010年百年不遇的大旱面前,哈尼梯田依然保持了青山绿     

响应面法优化复合微生物吸附剂对低浓度Cr3+的吸附

根据已有4种微生物吸附剂的吸附基团存在的差异特征,将其复配成复合吸附剂,借助统计学方法研究其对低ρ(Cr3+)废水的吸附性能.在单因素试验基础上,利用P-B(Plackett-Burman)法筛选出吸附过程4个主要影响因素分别为pH,初始ρ(Cr3+)及微生物吸附剂XB和TQ的投加量,应用最陡爬坡试验接近主要因素最优水平,采用Box-Behnken试验设计和响应面分析得到对低浓度Cr3+吸附过程的二阶模型.结果表明,最优吸附条件为pH 4.0,初始ρ(Cr3+)为4.86mg/L,XB和TQ的投加量分别为0.20和0.13 g/L,实际吸附率达到87.54%,与理论预测值(87.68%)接近,且高出单一吸附剂吸附率7.79%～17.35%.FT-IR扫描显示,复合微生物吸附剂性能提高与表面基团增多有关.通过响应面分析法优化复合微生物吸附,吸附性能明显提高.     

保持清醒 切实加强 确保核电机组建设质量——李干杰副部长在岭澳核电厂3号机组商运论坛上的讲话

在这丹桂飘香、秋风送爽的丰收季节,我们迎来了全国电力装机容量突破九亿千瓦的历史时刻,迎来了我国新一轮核电建设首台机组投入商运。这是我国“积极发展核电”政策的第一枚硕果,其中凝聚了无数核电人的辛劳与汗水,标志着我国核电建设进入了一个新的阶段。