Preparation of rare-earth metal complex oxide catalysts for catalytic wet air oxidation

Catalytic wet air oxidation (CWAO) is one of the most promising technologies for pollution abatement. Developing catalysts with high activity and stability is crucial for the application of the CWAO process. The Mn/Ce complex oxide catalysts for CWAO of high concentration phenol-containing wastewater were prepared by coprecipitation. The catalyst preparation conditions were optimized by using an orthogonal layout method and single-factor experimental analysis. The Mn/Ce serial catalysts were characterized by Brunauer-Emmett-Teller (BET) analysis and the metal cation leaching was measured by inductively coupled plasma torch-atomic emission spectrometry (ICP-AES). The results show that the catalysts have high catalytic activities even at a low temperature (80°C) and low oxygen partial pressure (0.5 MPa) in a batch reactor. The metallic ion leaching is comparatively low (Mn<6.577 mg/L and Ce<0.6910 mg/L, respectively) in the CWAO process. The phenol, COD_Cr, and TOC removal efficiencies in the solution exceed 98.5% using the optimal catalyst (named CSP). The new catalyst would have a promising application in CWAO treatment of high concentration organic wastewater. Translated from Techniques and Equipment for Environmental Pollution Control, 2005, 6(2): 40–44 [译自: 环境污染治理技术与设备]     

中国对流层二氧化硫光化学氧化过程的数值研究

利用一个三维非静力区域大气化学输送模式与中尺度气象模式MM5相连接构成一个数值模拟系统，模拟了中国地区对流层臭氧与其前体物的分布以及二氧化硫转化为硫酸盐的过程，模式扬地面源排放、大气输送和扩散、干沉积、气相化学反应和云雨过程。结果表明：日间，O3浓度主要由NOx和NMHC的源排放和光化学反应过程支配，大气辐射是光化学反应强弱的决定因子，其强度可使SO2、O3和SO4^2-的生成浓度呈现不同的日变化和季节变化，结果表明高浓度的O3对二氧化硫转化为硫酸盐的化学过程有很大的促进作用，然而，这种作用受NMHC浓度的影响很大，较高浓度的NMHC使O3浓度上升，但同时增加了对OH等自由基的消耗，使SO2的转化率降低。     

LPWCO method for the treatment of high concentrated organic wastewater

Based on wet air oxidation (WAO) and Fenton reagent, thispaper raises a new low pressure wet catalytic oxidation(LPWCO)which requires low pressure for the treatment of highlyconcentrated and refractory organic wastewater. Compared withgeneral wet air oxidation, the pressure of the treatment(0.1-0.6MPa) is only one of tens to percentage of latter(3.5-10MPa). Inaddition, its temperature is no more than 180℃.Compared withFenton reagent, while H2O2/COD(weight ratio) less than 1.2, theremoval of COD in the treatment is over twenty percents more thanFenton's even the value of COD is more than 14000mg/L. In thispaper, we study the effect factor of COD removal and the mechanismof this treatment. The existence of synergistic effect (catalytic oxidation and carbonization) for COD removal in H2SO4-Fenton reagent system under the condition of applied pressure and heating (0.1-0.6MPa, 104-165℃) was verified. The best condition of this disposal are as follows:H2O2/COD(weight ratio)=0.2-1.0, Fe2+ 0.6×10-3 mol, H2SO4 0.5mol, COD>1×104mg/L, the operating pressure is 0.1-0.6MPa and temperature is 104-165℃. This method suit to dispose the high-concentrated refractory wastewater, especially to the wastewater containing H2SO produced in the manufacture of pesticide, dyestuff and petrochemical works.     

含柠檬酸盐电镀废水的处理

对含柠檬酸盐电镀废水的几种处理方法的比较表明,氯化钡添加法能较好地使柠檬酸盐沉淀,操作简便,处理效果理想,其柠檬酸根离子的去除率达98％以上。     

含酚废水治理方法的研究

根据含酚废水的性质，用ClO2氧化除酚，ZL—1和聚丙烯酰胺(PAM)混凝沉降除悬浮物的方法处理该废水。实验结果表明，经处理后废水中的主要污染物酚、焦油和悬浮物等去除率都很高，该水可以满足循环使用的要求。     

微电解-水解酸化/接触氧化工艺处理染化废水的研究

采用微电 解 Ｈ／ Ｏ 工艺对染 料化 工 废水 进行 了 处理 研究 ，结 果表 明 以微 电解 和 水解 酸 化作预处理 ，可使废 水的 Ｂ Ｏ Ｄ５／ Ｃ Ｏ Ｄ Ｃｒ 的比由 ０２５ 提高 到０５ ０ 左 右，平 均 增加 ５０ ％ 。通 过加 酸， 可提高微电 解的去除 效果，在 进水 Ｃ Ｏ Ｄ Ｃｒ 为４ １００ ～４ ３００ ｍ ｇ／ Ｌ，色度 为３ ４００ ～３ ６００（ 倍） 范围内 ，系统对 Ｃ Ｏ Ｄ Ｃｒ 和色度 的去除效 果分别 可达到９７ ５ ％ 和９８３ ％     

两段接触氧化法处理生活污水的工程实例

本污水厂设计规模 70 0 0m3 d ,进水CODCr3 0 0mg L ,BOD515 0mg L ,SS 2 0 0mg L ,采用两段接触氧化法处理工艺 ,运行结果表明 ,出水水质达到GB8978 1996污水综合排放标准中的二级标准     

硫酸法钛白生产水洗工序清洁生产技术初探

通过开展水洗工段用水审计并试验了温度、偏钛酸ξ电位和漂白工艺对水洗的影响效果，从实践和理论上探讨了为其提高钛白质量改进水洗工艺的清洁生产方案的可行性和合理性。     

A/O和A2/O法除磷脱氮工艺影响因素及除磷动力学的研究

重点介绍A/O除磷工艺和A~2/O除磷脱氮工艺,以及影响除磷脱氮工艺因素和除磷动力学的研究。工艺研究采用了动态与静态实验方法,采用色质联机研究了有毒有机物的降解情况。试验结果表明,A/O、A~2/O工艺的BOD_5去除率近于二级污水处理厂,A~2/O法TP去除率近于三级污水处理厂,且去除难降解有毒有机物的效率高于传统的活性污泥法。动力学公式的修正使之更适于低碳源的情况。八种影响因素的研究为工艺的设计与运行提供了依据。     

利用脉冲澄清池补充处理生化后废水的运行结果和分析

通过对脉冲澄清池在综合废水处理中运行效果的跟踪分析,确定出利用脉冲澄清池补充处理生化后废水(悬浮物、COD_(cr)、BOD_5等)的影响程度,为其在综合废水处理工艺中的应用及其局限性,提供了必要的参考依据.