用平板双分子层脂膜模拟研究锌离子跨细胞膜的传递过程

制备了氧化胆固醇-卵磷脂（脑磷脂）平板双分子层脂膜，研究了膜配方对双分子层脂膜的稳定性和离子传递性能的影响，得到了最佳制膜工艺，并建立了锌离子跨卵（脑）磷脂膜的吸附-扩散模型，其计算值与实验值基本吻合．     

无机分离膜与环境保护

本文综述了无机分离膜的制备方法及其在环境保护领域中的应用现状，并对无机分离膜在工业废水和工业废气治理中的应用前景进行了展望。     

Gas separation using porous cement membrane

Gas separation is a key issue in various industrial fields. Hydrogen has the potential for application in clean fuel technologies. Therefore, the separation and purification of hydrogen is an important research subject. CO2 capture and storage have important roles in ＂green chemistry＂. As an effective clean technology, gas separation using inorganic membranes has attracted much attention in the last several decades. Membrane processes have many applications in the field of gas separation. Cement is one type of inorganic material, with the advantages of a lower cost and a longer lifespan. An experimental setup has been created and improved to measure twenty different cement membranes. The purpose of this work was to investigate the influence of gas molecule properties on the material transport and to explore the influence of operating conditions and membrane composition on separation efficiency. The influences of the above parameters are determined, the best conditions and membrane type are found, it is shown that cementitious material has the ability to separate gas mixtures, and the gas transport mechanism is studied.     

生物法降解养殖场臭气中H2S的反应器启动

畜禽养殖场臭气成分复杂,完全去除较为困难。生物法是目前应用较广泛的脱臭方法,其中能否将生物膜附着在填料上是影响生物法去除恶臭气体效率的重要因素。本实验采用定时定量投加Na2S的方式驯化活性污泥,并选用MLSS浓度和SO42-浓度增量变化2个指标作为污泥驯化成熟的指标,比传统的以MLSS作为污泥驯化成熟的指标更准确。采用循环污泥的挂膜方式,运行2 d后,通入新鲜的空气和H2S气体,2周后反应器启动成功。     

基于Donnan分离的磷酸盐离子迁移与膜内分布

基于Donnan分离原理,研究磷酸盐离子在无电压条件下通过阴离子交换膜的迁移过程以及膜内磷酸盐的分布。结果表明,阴离子交换膜采用NaCl溶液浸泡预处理后,促进磷酸盐离子的第1步迁移过程,磷酸盐离子的迁移去除效果提高5%。受体液NaCl浓度是阴离子交换膜内磷酸盐含量的控制因素,其浓度从0.001 mol/L增加至0.1 mol/L时,膜内磷酸盐含量由0.077 mg/cm2降至0.002 mg/cm2。受体液NaCl浓度较高时,有利于促进磷酸盐离子的第3步迁移过程,且2层膜内磷酸盐含量的分布由给体液至受体液呈递减趋势。温度升高,低浓度受体液条件下膜内磷酸盐的含量增加,对高浓度受体液条件下膜内磷酸盐的含量几乎无影响。     

磷钼酸/聚乙烯醇复合纤维膜光降解甲基橙

运用静电纺丝技术制备了磷钼酸(H3PMo12O40)/聚乙烯醇(PVA)复合纤维膜,并对复合纤维膜光催化降解甲基橙模拟废水进行了研究。红外(FT-IR)测试显示,磷钼酸在复合纤维膜中仍保持Keggin结构。通过扫描电镜(SEM)可以看出,磷钼酸的质量分数为29.4%时,复合纤维的直径最小。紫外测试表明,将磷钼酸固载于PVA复合纤维上比直接使用具有更高的光催化活性,磷钼酸质量分数为25.0%,甲基橙溶液p H=2时,甲基橙的脱色率最高。复合纤维膜热处理后在水中稳定性较好,易于回收并循环使用,循环使用10次,甲基橙的脱色率无明显变化。     

Fabrication and characterization of electrospun porous cellulose acetate nanofibrous mats incorporated with capric acid as form-stable phase change materials for storing/retrieving thermal energy

Electrospun cellulose acetate (CA) nanofibrous mats incorporated with capric acid was studied to fabricate form-stable phase change materials (PCMs) for storing/retrieving thermal energy. Electrospun CA nanofibrous mats with different porous structures and specific surface areas were firstly prepared through regulating the volume ratio of mixture solvent of acetone/dichloromethane (DCM). Effects of different volume ratio of mixture solvent and mat thickness on the morphological structure, specific surface area, and absorption capacity of CA nanofibrous mats were systematically investigated. The results indicated that CA nanofibrous mats were highly porous on the surface; hence, they were capable of absorbing a large amount of capric acid. The maximum absorption capacity of CA mats via electrospinning with volume ratio of acetone/DCM being 5/5 was ~95.8 wt%, due to its higher specific surface area of ~17.1 m²/g. The specific surface area and capric acid absorption capacity of CA nanofibrous mats increased with the increases of mat thickness. As the thickness of nanofibrous mats increased from 10 to 85 μm, the corresponding specific surface area and capric acid absorption capacity of mats increased respectively from 7.2 to 29.0 m²/g and 92.1 to 98.5%. Morphological structures, as well as the properties of thermal energy storage and thermal insulation of the fabricated form-stable PCMs, were studied by scanning electron microscopy, differential scanning calorimetry, and measurement of freezing times, respectively. The results indicated that the resulting form-stable PCMs could well maintain their phase transition characteristics and demonstrated great thermal energy storage capability and temperature regulation ability.     

纳滤膜对脂肪族及杂环有机物的截留特性

分别选用NF90、NF270和NF-型号的纳滤膜测定了20种脂肪族及杂环有机物的截留率®,并分析了纳滤膜截留效果的影响因素.结果表明,脂肪族及杂环有机物的R受到分子结构和膜特性的影响:对于同分异构体,分枝结构越多,R越高;环状有机物与分子量相近的直链有机物相比,R明显偏高;孔径越小的纳滤膜R越高.利用遗传算法(GA)结合偏最小二乘回归(PLS)和人工神经网络法(ANN)建立了脂肪族及杂环物质的R与其结构的定量关系模型,2种方法建立的模型相关系数可分别达到0.8809和0.9944,通过2种模型进一步分析了R的影响规律,并对几种物质的R进行了有效的预测.从预测结果来看,GA-ANN模型的预测精度要好于GA-PLS模型.     

TMV或宁南霉素处理对烟草叶片及类囊体膜蛋白组成的影响

对烟草花叶病毒(TMV)侵染、宁南霉素钝化处理的烟草叶片进行了叶片全蛋白多肽组分、类囊体膜蛋白组成的分析.结果表明,TMV侵染或钝化实验的烟草叶片中均出现TMV衣壳蛋白;但是与对照相比,TMV侵染叶片中Rubisco大亚基减少、小亚基增加,类囊体膜蛋白中PsaA、PsaB和Mr=33×103蛋白含量减少.表明TMV侵染要同时影响叶片细胞核基因组和叶绿体基因组的基因表达,从而影响光合作用碳代谢和类囊体膜光系统Ⅰ和Ⅱ.宁南霉素对TMV病毒短时间内具有钝化作用,而较长时间的作用效果不同,10 min钝化样品的蛋白组分保持较为完整,而30 min钝化样品的多肽缺失较为严重.图5表1参11