工业废气污染状况与脱硫除尘技术

对工业废气污染状况进行分析讨论,综述了工业废气的多种脱硫除尘技术。并指出应选择脱硫除尘效率高,运转可靠,不产生二次污染的方法。     

冶金污泥稳定化/固化处理工艺研究

冶金工业在生产过程中产生大量酸性废水.对这类废水目前通常采用石灰中和沉淀处理.文章中通过研究采用水泥和工业废渣作固化基材固化处理冶金工业酸性废水用石灰混凝所产生的含铜、砷的污泥,分析了影响固化块抗压强度的多种因素,采用固体废物浸出毒性浸出方法对浸出率进行实验探讨.     

电凝聚处理轧制乳化废水的研究

用电凝聚法处理轧制乳化废水,探讨了影响破乳的各种因素,确定了最佳处理条件。研究结果表明:该法处理轧制乳化废水的效果很好,浊度去除率可达99.6%,COD去除率达99.5%。此外,还发现电凝聚法的处理效果优于药剂絮凝法。     

壳聚糖/PVA微粒上Cu2+的吸附平衡与动力学

采用粒径＜200μm、在酸碱介质中溶胀率小且能稳定存在的壳聚糖/PVA微粒对Cu2+的吸附进行了研究,结果表明,在pH 6,室温条件下,其饱合吸附量达56.0mg/g,随温度升高,吸附量降低.通过计算不同温度下各热力学参数△G0、△H0和△S0,证实该吸附为自发的放热过程.对实验数据运用相关数学模型拟合,显示等温吸附平衡符合Langmuir模型,吸附过程动力学更适合二级反应,被吸附在壳聚糖/PVA微粒上的Cu2+,可被0.01mo/L的EDTS或HNO3溶液快速地脱附出来,其洗脱率分别为85.3%和65.9%.     

纳米TiO_2光催化降解酸性红B的实验研究

采用偶联剂法在聚丙烯多面球表面负载化纳米TiO2,在高压汞灯照射下,以酸性红B染料为研究对象,采用光催化氧化法进行降解处理;研究了溶液初始浓度、H2O2和Fe3+投加量、pH以及光照强度等因素对酸性红B染料降解效果的影响。     

天津市环境空气SO2污染现状及分析

天津环境空气SO2的年均浓度始终超过国家二级标准。年均浓度超标主要因为采暖期SO2浓度过高所至，采暖期SO2平均浓度是非采暖期浓度的3倍左右；在2002--2005年的三个采暖期里，SO2污染逐年加重，导致了年均SO2浓度的逐年升高。天津SO2污染与采暖期增多的低烟囱排放、不利的气象条件有关，也与流动源的隐性排放、能源利用效率低下有关。结合天津经济发展速度、每年煤耗增量、现有环境治理手段来做预测，空气SO2浓度要在未来几年内达到国家二级标准仍是不可能的。     

Effects of acid,acid-ZVI/PMS,Fe(Ⅱ)/PMS and ZVI/PMS conditioning on the wastewater activated sludge(WAS)dewaterability and extracellular polymeric substances(EPS)

The effects of four conditioning approaches:Acid,Acid-zero-valent iron(ZVI)/peroxydisulfate(PMS),Fe(Ⅱ)/PMS and ZVI/PMS,on wastewater activated sludge(WAS) dewatering and organics distribution in supernatant and extracellular polymeric substances(EPS) layers were investigated.The highest reduction in bound water and the most WAS destruction was achieved by Acid-ZVI/PMS,and the optimum conditions were pH 3,ZVI dosage 0.15 g/g dry solid(DS),oxone dosage 0.07 g/g DS and reaction time 10.6 min with the reductions in capillary suction time(CST) and water content(Wc) as 19.67% and 8.49%,respectively.Four conditioning approaches could result in TOC increase in EPS layers and supernatant,and protein(PN) content in tightly bound EPS(TB-EPS).After conditioning,organics in EPS layers could migrate to supernatant.Polysaccharide(PS) was easier to migrate to supernatant than PN.In addition,Acid,Acid-ZVI/PMS or Fe(Ⅱ)/PMS conditioning promoted the release of some polysaccharides containing ring vibrations v P=O,v C-O-C,v C-O-P functional groups from TB-EPS.ESR spectra proved that both radicals of SO_4~-· and·OH contributed to dewatering and organics transformation and migration.CST value of WAS positively correlated with the ratios of PN/PS in LB-EPS and total EPS,while it negatively correlated with TOC,PN content and PS content in TB-EPS,as well as PS content in supernatant and LB-EPS.BWC negatively correlated to zeta potential and TOC value,PN content,and HA content in supernatant.     

Enhanced activity of ZnS(111) by N/Cu co-doping:Accelerated degradation of organic pollutants under visible light

High-efficiency photocatalysts are of great significance for the application of photocatalytic technology in water treatment.In this study,N/Cu co-doped ZnS nanosphere photocatalys(N/Cu-ZnS) is synthesized by a hydrothermal method for the first time.After doping,the tex ture of nanosphere becomes loose,the nanometer diameter is reduced,making the specific surface area of catalyst increased from 34.73 to 101.59 m²/g.The characterization results show that more ZnS (111) crystal planes a...     

Heterojunctioned CuO/Cu2O catalyst for highly efficient ozone removal

In recent years, near surface ozone pollution, has attracted more and more attention, which necessitates the development of high efficient and low cost catalysts. In this work, CuO/Cu₂O heterojunctioned catalyst is fabricated by heating Cu₂O at high temperature, and is adopted as ozone decomposition catalyst. The results show that after Cu₂O is heated at 180°C conversion of ozone increases from 75.2% to 89.3% at mass space velocity 1,920,000 cm³/(g·hr) in dry air with 1000 ppmV ozone, which indicates that this heterojunction catalyst is one of the most efficient catalysts reported at present. Catalysts are characterized by electron paramagnetic resonance spectroscopy and ultraviolet photoelectron spectroscopy, which confirmed that the heterojunction promotes the electron transfer in the catalytic process and creates more defects and oxygen vacancies in the CuO/Cu₂O interfaces. This procedure of manufacturing heterostructures would also be applicable to other metal oxide catalysts, and it is expected to be more widely applied to the synthesis of high-efficiency heterostructured catalysts in the future.     

PVC包装材料中酞酸酯增塑剂残留的ASE-GC-MS分析

针对PVC包装材料中酞酸酯（PAEs）增塑剂残留，采用加速溶剂萃取（ASE）和GC／MS联用技术分析5种PAEs（DMP，DEP，DBP，BBP，DEHP），结果表明加速溶剂萃取用于PVC包装材料中PAEs的提取，最佳温度条件为120℃，最佳循环次数为3次。方法检出限达到0．1mg／kg，回收率达到95．5％-99．8％；并且具有很好的重现性和精密度。