Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

UV/TiO_2/H_2O_2法对高浓度有机废水降解的应用研究

用UV TiO2 H2 O2 法对高浓度有机废水降解的实验表明 ,当TiO2 、H2 O2 的投加量分别为 2 0g与 1% ,反应时间为3h时 ,CODCr、Oil、Ar OH、NH3 N、S2 - 的平均去除率分别达到 73 %、83 %、86%、5 0 %、10 0 %。此处理工艺具有除臭、除色、快速高效、不产生污泥等优势。实验过程探索了TiO2 、H2 O2 的用量对各污染物降解率的影响 ,并设计了有实用意义的反应器     

2-萘酚生产废水综合治理与资源化利用工程实例

针对2-萘酚生产废水p H值低、色泽深,亚硫酸盐和萘磺酸盐高、COD浓度高的特点,采用酸化脱硫-两级络合萃取-氧化絮凝工艺处理,介绍了专利工艺的流程设计,给出了主要工艺设计参数及投资运行成本。工程运行结果表明,该工艺设计合理、技术成熟、处理效果稳定,2-萘酚生产废水经处理后达到GB 8978—1996《污水综合排放标准》一级排放标准要求;回收的萘磺酸钠固体可返回2-萘酚生产系统套用;反萃取黑液经蒸发浓缩,合成的减水剂产品各项指标达到或超过GB 8076—2008《混凝土外加剂》高效减水剂指标要求。     

NOx光解测量装置的设计与测试

根据二氧化氮的光解反应原理,自主设计、装配了一套氮氧化物光解反应装置,并将其与Thermo 42系列氮氧化物分析仪的化学发光检测室联用,进行了不同条件下(分别为标气流量、臭氧流量、光源温度、功率、样品湿度)NO2光解转化效率的测试.结果表明:进样流量为100~200 mL·min-1、光源温度为20℃、光源功率约为60 W(光密度约26 W·mL-1)的条件下,可得到较高的光解转化效率(约80%);臭氧流量及样品相对湿度对转化效率影响不大.在上述最佳转化效率的条件下,将其与PLC860-CLD88p(ECO PHYSICIS)进行了为期8 d的比对实验.结果显示:二者的NO2实际测量结果趋势基本一致:[NO2]ECO=0.908×[NO2]PKU+1.913(R2=0.955),初步证实了该套自主设计光解装置应用于实际观测的可靠程度.     

粉煤灰负载Fe2O3脱除气态单质汞的试验研究

在固定床反应器中研究了利用燃煤电厂固废粉煤灰(FA)负载Fe2O3所制备的Fe2O3/FA催化剂对气态Hg0的脱除情况,发现Fe2O3/FA具有较高的脱除Hg0的能力.同时,考察了Fe2O3负载量、温度、空速、Hg0浓度、烟气成分等对Fe2O3/FA脱除Hg0的影响.结果表明,Fe2O3/FA对Hg0的脱除能力随Fe2O3负载量(1%~10%)的增加和温度(120~200℃)的升高而增强;Fe2O3/FA在较低的空速和Hg0浓度条件下表现出了更高的脱除Hg0的活性;HCl和O2促进了Fe2O3/FA对Hg0的脱除,而SO2和H2O抑制了Fe2O3/FA对Hg0的脱除.逐级化学提取实验结果证实,Fe2O3将Hg0氧化为Hg2+的化合物并吸附在FA上,这是Fe2O3/FA具有较高的脱除Hg0能力的原因.     

“十一五”期间太原市环境空气质量及影响因素分析研究

依据太原市环境空气质量监测数据,采用Daniel趋势检验法,综合污染指数法和回归分析法研究了“十一五”期间太原市的环境质量变化趋势和影响因素.结果表明,从年均浓度值分析来看,除NO2外,SO2和PM10都存在超标现象,长期来看,三种污染物浓度下降趋势明显,这与太原市环境保护行动密切相关.月际间浓度值差异除PM10在春季出现波动外,SO2和NO2均呈现“U”型曲线,这种规律与气象条件密切相关.三种主要大气污染物污染指数都有所下降,但太原市区空气污染仍以SO2和PM10为主,说明烟煤型污染的空气污染特征没有改变.主要大气污染物的空间浓度分布不均与地形和气象特征以及城市布局和污染源排放有直接关系.太原市“十一五”期间大气环境质量整体改善,但形势依然严峻.     

京津冀区域生产和消费CO2排放的时空特点分析

区分消费和生产二氧化碳排放是对开放的经济区域进行排放责任划分的基础,日渐受到政策制定者的关注.利用经济投入产出-生命周期分析模型,对京津冀区域1997年、2002年和2007年的消费和生产二氧化碳排放时空特征及二氧化碳排放平衡进行分析.结果表明,京津冀区域消费和生产二氧化碳排放呈约4%的年均增长;贸易隐含二氧化碳排放比例为30%~83%,并以国内贸易隐含二氧化碳排放为主;河北的消费和生产二氧化碳排放占区域主导,增速和二氧化碳排放强度高于北京和天津;京津冀区域为二氧化碳排放净流入区域,存在部分排放责任转移;京津为二氧化碳排放净转入地区,冀为二氧化碳排放净转出地区;京津冀三地二氧化碳排放关键部门分布集中且相似度较高,可以考虑区域联合控制.其中,电力、蒸汽、热水生产和供应业和金属冶炼及压延加工业对二氧化碳排放的依赖性最大,承担较大的其他部门的二氧化碳排放责任.投入产出分析解析了地区生产和消费二氧化碳排放情况,有利于区域减排的精细化管理和制定相应对策,并促进区域减排合作.     

我国对大湄公河次区域国家投资与贸易环境影响的估算研究

本文运用改进的IPCC延伸法,将资源环境要素引入投资与贸易核算,将经济价值量引入排放因子,将CO2排放量作为环境影响的一个指标,从国家层面估算投资贸易的环境影响。结果表明:我国对大湄公河次区域国家投资与贸易带来的环境影响,总体利好,各国有差异。     

Review of the progress in preparing nano Ti02： An important environmental engineering material

TiO2 nanomaterial is promising with its high potential and outstanding performance in photocatalytic environmental applications, such as CO2 conversion, water treatment, and air quality control. For many of these applications, the particle size, crystal structure and phase, porosity, and surface area influence the activity of TiO2 dramatically. TiO2 nanomaterials with special structures and morphologies, such as nanospheres, nanowires, nanotubes, nanorods, and nanoflowers are thus synthesized due to their desired characteristics. With an emphasis on the different morphologies of TiO2 and the influence factors in the synthesis, this review summarizes fourteen TiO2 preparation methods, such as the sol-gel method, solvothermal method, and reverse micelle method. The TiO2 formation mechanisms, the advantages and disadvantages of the preparation methods, and the photocatalytic environmental application examples are proposed as well.     

Potential bioremediation of mercury-contaminated substrate using filamentous fungi isolated from forest soil

The use of filamentous fungi in bioremediation of heavy metal contamination has been developed recently. This research aims to observe the capability of filamentous fungi isolated from forest soil for bioremediation of mercury contamination in a substrate. Six fungal strains were selected based on their capability to grow in 25 mg/L Hg2+-contaminated potato dextrose agar plates. Fungal strain KRP1 showed the highest ratio of growth diameter, 0.831, thus was chosen for further observation.Identification based on colony and cell morphology carried out by 18S rRNA analysis gave a 98%match to Aspergillus flavus strain KRP1. The fungal characteristics in mercury(Ⅱ) contamination such as range of optimum pH, optimum temperature and tolerance level were 5.5–7 and 25–35℃ and 100 mg/L respectively. The concentration of mercury in the media affected fungal growth during lag phases. The capability of the fungal strain to remove the mercury(Ⅱ) contaminant was evaluated in 100 mL sterile 10 mg/L Hg2+-contaminated potato dextrose broth media in 250 mL Erlenmeyer flasks inoculated with 108spore/mL fungal spore suspension and incubation at 30℃ for 7 days. The mercury(Ⅱ) utilization was observed for flasks shaken in a 130 r/min orbital shaker(shaken) and nonshaken flasks(static) treatments. Flasks containing contaminated media with no fungal spores were also provided as control. All treatments were done in triplicate. The strain was able to remove 97.50%and 98.73% mercury from shaken and static systems respectively. A. flavus strain KRP1 seems to have potential use in bioremediation of aqueous substrates containing mercury(Ⅱ) through a biosorption mechanism.