丙烯腈生产废水中聚合物的资源化利用

以丙烯腈生产废水中的丙烯腈低聚物为原料制备聚丙烯酰胺。通过正交实验考察了水解反应条件和交联反应条件对反应的影响。FTIR表征结果显示,丙烯腈低聚物中的氰基已完全水解为酰胺基,产物聚丙烯酰胺中含有酰胺基和羧基。实验结果表明,在自来水加入量100 m L、水解反应温度95℃、m(Na OH)∶m(丙烯腈低聚物)=2.0、水解反应时间3 h的最佳水解反应条件,交联反应温度60℃、质量分数37%~40%的甲醛加入量6 m L、交联反应时间2 h的最佳交联反应条件下,处理20 g丙烯腈低聚物,可得到产物聚丙烯酰胺14.50 g,聚丙烯酰胺的水解度为21.1%、相对分子质量为2.7×106。产品性能满足Q/SH 0046—2007《钻井液用聚丙烯酰胺技术要求》中部分水解聚丙烯酰胺的性能要求。     

MCM-41分子筛负载铁铈催化降解甲基橙

采用等体积浸渍法制备了负载型有序介孔Fe-Ce/MCM-41催化剂。研究了该催化剂降解甲基橙的适宜工艺条件,并采用XPS,XRD,TEM技术对该催化剂进行了表征。实验结果表明,该催化剂Fenton氧化降解甲基橙的较适宜工艺条件为:溶液pH 5.0、甲基橙溶液初始质量浓度100 mg/L、催化剂加入量2.0 g/L、H_2O_2浓度20 mmol/L,在此适宜条件下反应120 min时,甲基橙去除率接近100%。表征结果显示:Fe-Ce/MCM-41催化剂主要由铁、铈、氧、碳4种元素组成;铁与铈的摩尔比接近3∶1;铁和铈主要以Fe_3O_4和CeO_2的形态存在于催化剂表面。     

Multi-response optimization of Fenton process for applicability assessment in landfill leachate treatment

Fenton process, as a pretreatment method, was found to be effective in the primary treatment of mature/medium landfill leachate. However, the main problem of the process is the large amount of produced sludge that requires an accurate feasibility evaluation for operational applications. In this study, the response surface methodology was applied for the modeling and optimization of Fenton process in three target responses, (1) overall COD removal, (2) sludge to iron ratio (SIR) and (3) organics removal to sludge ratio (ORSR), where the latter two were new self-defined responses for prediction of sludge generation and applicability assessment of the process, respectively. The effective variables included the initial pH, [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage. According to the statistical analysis, all the proposed models were adequate (with adjusted R² of 0.9116–0.9512) and had considerable predictive capability (with prediction R² up to 0.9092 and appropriate adequate precision). It was found that all the variables had significant effects on the responses, specifically by their observed role in dominant oxidation mechanism. The optimum operational conditions obtained by overlay plot, were found to be initial pH of 5.7, [H₂O₂]/[Fe²⁺] ratio of 17.72 and [Fe²⁺] of 195 mM, which led to 69% COD removal, 2.4 (l sludge/consumed mole Fe²⁺) of SIR and 16.5 (gCOD removed/l produced sludge) for ORSR in verification test, in accordance with models-predicted values. Finally, it was observed that [H₂O₂]/[Fe²⁺] ratio and Fe²⁺ dosage had significant influence on COD removal, while Fe²⁺ dosage and [H₂O₂]/[Fe²⁺] ratio had remarkable effects on SIR and ORSR responses, respectively.     

Stabilization of heavy metals in MSWI fly ash using silica fume

The objective of this work was to investigate the feasibility and effectiveness of silica fume on stabilizing heavy metals in municipal solid waste incineration (MSWI) fly ash. In addition to compressive strength measurements, hydrated pastes were characterized by X-ray diffraction (XRD), thermal-analyses (DTA/TG), and MAS NMR (²⁷Al and ²⁹Si) techniques. It was found that silica fume additions could effectively reduce the leaching of toxic heavy metals. At the addition of 20% silica fume, leaching concentrations for Cu, Pb and Zn of the hydrated paste cured for 7 days decreased from 0.32 mg/L to 0.05 mg/L, 40.99 mg/L to 4.40 mg/L, and 6.96 mg/L to 0.21 mg/L compared with the MSWI fly ash. After curing for 135 days, Cd and Pb in the leachates were not detected, while Cu and Zn concentrations decreased to 0.02 mg/L and 0.03 mg/L. The speciation of Pb and Cd by the modified version of the European Community Bureau of Reference (BCR) extractions showed that these metals converted into more stable state in hydrated pastes of MSWI fly ash in the presence of silica fume. Although exchangeable and weak-acid soluble fractions of Cu and Zn increased with hydration time, silica fume addition of 10% can satisfy the requirement of detoxification for heavy metals investigated in terms of the identification standard of hazardous waste of China.     

激发剂作用下的盐石膏废渣的水化过程

运用Kondo模型,研究了在激发剂硫酸钠作用下盐石膏废渣的水化过程.盐石膏废渣的水化过程分为3个阶段,第1、第3阶段受扩散作用控制;第2阶段受相边界反应控制.分别研究了激发剂溶液浓度和温度对相边界反应阶段水化速率的影响,结果表明,在0—0.60 mol.L-1范围内,增大激发剂溶液浓度可使水化速率常数k增大,在12℃≤...     

粉尘爆炸反应工程学简要综述

１９９３年在波兰召开的第五届国际粉尘爆炸学术会议上，邓煦帆曾在论文中提议建立粉尘爆炸反应工程学，并提出学科的目的意义、性质、主要组成部分和研究方法。本文拟将国内外有关本学科范围内的贡献，加以简要综述，以期能逐渐形成本学科的自身体系和特点。     

含氯苯和对邻硝基氯苯农药废水的混凝—氧化预处理

采用混凝沉淀 -芬顿试剂氧化对含氯苯和对邻硝基氯苯农药废水进行预处理 ,探讨了不同条件下农药废水的处理效果。结果表明 ,废水经混凝处理后可去除 46 .2 %的COD ,BOD5/COD值有一定程度的提高 ;废水经芬顿试剂氧化处理后可去除 5 0 .9%的COD ,BOD5/COD值可从 0 .0 4提高到 0 .1     

C6H12N4+Mg+KClO4+SrSO4系统的振荡控制和安全分析

从实验和数值分析两方面研究了C6Hl2N 4+Mg+KClO4+SrSO4反应系统的振荡燃烧现象,并对反应机理进行了深层次的分析.结果表明,振荡燃烧是由化学动力学的非线性反馈引起的,即:反应系统中镁的三相与氧气的相互竞争反应造成系统的非线性化学振荡燃烧.氧化剂和可燃剂的比值,以及频率调节剂等吸热物质可调节气相镁的生成速率,能有效地控制药剂的振荡频率.选取适当的控制参数,可以使反应按照预定的、安全的过程进行,避免爆燃的产生.本文的研究结果对化工、军事等领域的安全控制具有重要意义.     

大气中SO2的液相氧化研究

大气中ＳＯ２液相氧化是形成酸雨的重要途径，降雨中含有各种无机离子和有机物质，它们可能催化或抑制液相氧化反应的进行。本文根据四川酸雨样品组成，进行了ＳＯ２在模拟雨水及实际雨水中的氧化实验，考查了Ｖ，Ｆｅ，Ｍｎ等离子对ＳＯ２氧化的催化作用，Ｈ２Ｏ２对ＳＯ２的氧化以及降水中有机物质甲醛对各反应的影响。实验结果为了解酸雨的成固，研究酸雨控制对策提供了科学依据。     

Miscibility and Biodegradability of Poly(Butylene Succinate)/Poly(Butylene Terephthalate) Blends

As one of the biodegradable polymers, the blend of poly(butylene succinate) and poly(butylene terephthalate) is dealt with in this study. In our previous work, it was demonstrated that PBS and PBT are immiscible not only from the changes of T _g but also from logG–log G plots. It is expected that the biodegradability of the blends could be improved by enhancing the miscibility. We tried to induce the transesterification reaction between two polyesters with various time intervals to enhance the miscibility of the blends. The extent of transesterification reaction was examined by ¹H-NMR. We utilized a dynamic mechanical thermal analyzer and a rotational rheometer to investigate the changes in miscibility. We also verified the biodegradability of PBS/PBT blends after the transesterification reaction by the composting method.