Evaluation of multiple reactions in dilute benzoyl peroxide concentrations with additives using calorimetric technology

Benzoyl peroxide (BPO) is a typical organic peroxide widely used in food processing, particularly flour bleaching. Due to the unstable nature of the oxygen-oxygen bond in BPO, it readily reacts under even mid-low-temperature conditions. Lower concentrations of BPO are also potentially explosive, even when combined with acid or alkaline additives. Given the history of both potential and documented industrial accidents, this study investigates the thermal stability of various BPO concentrations when mixed with acid or alkaline solutions. In addition, differential and integral kinetic models were applied to verify that the apparent activation energy data from the differential scanning calorimetry experiments were valid. The results of autocatalysis reactions and nth-order reaction simulations presented characteristics consistent with the experimental findings. The findings in this paper can be used as a reference for BPO products that are mediated with either an acid or an alkaline solution during production, storage, transportation, or use.     

考虑驾驶员反应时间的车辆碰撞预警模型

为了保证车辆在行驶过程中的安全性,提出了一种考虑驾驶员反应时间的车辆碰撞预警模型,改进了传统模型中驾驶员反应时间定值化的缺点。首先,依据车辆的制动过程分析了驾驶员反应时间对制动距离的影响。其次,设计驾驶员反应时间的模糊推理算法,选取驾龄、疲劳强度和应变能力3个主要因素作为评价指标来计算反应时间。最后,采用分等级的预警策略建立考虑驾驶员反应时间的碰撞预警模型,并通过Carsim-Matlab/Simulink联合仿真与传统模型进行对比分析。结果表明,设计的预警模型可以对不同类型的驾驶员进行差异化碰撞预警,在30 km/h和80 km/h两种车速下实际停车距离与理论值的最大误差为8%。     

Removal of ofloxacin antibiotic using heterogeneous Fenton process over modified alginate beads

The aim of this work is to study the heterogeneous oxidative degradation of ofloxacin antibiotic using a composite material prepared from sodium alginate and cyclohexane dinitrilo tetraacetic acid(CDTA). The characterization tests indicated the successful incorporation of metal chelator and iron. It was also demonstrated that the synthesized beads are mesoporous. The influence of several experimental parameters(i.e.: H2O2 dose,working temperature, beads loading and initial drug concentration) on the process performances was evaluated. The reaction temperature significantly affects the drug conversion efficiency. It was also observed that the synthesized material was efficient toward the target antibiotic degradation in the presence of small quantities of hydrogen peroxide. Under optimum conditions(0.05 g of granules, initial drug concentration = 10 mg/L,25 μL of 10 mmol/L H2O2), conducted in a batch reaction, 94% degradation of ofloxacin was reached. The results also indicate that the composite material showed a reasonable stability;a relatively low decrease of activity after four successive runs(only 9%) and a negligible iron leaching(0.8%) have been observed. The synthesized composite material offered interesting advantages in terms of simplicity, good stability, ease of recovery from the liquid medium after use and its efficiency in the presence of low quantities of oxidant. It constitutes a good candidate in the water treatment area.     

响应曲面法优化镍转炉渣氧压选择性浸出工艺

为了优化镍转炉渣加压条件下H₂SO₄选择性浸出Co、Ni、Cu,抑制Fe浸出的工艺,采用响应曲面法的中心组合设计原理,建立影响选择性浸出率的二次多项式数学模型,研究浸出温度、c(H₂SO₄)及液固比及上述因素两两交互作用对提高Co、Ni、Cu浸出率及减少Fe浸出率的影响规律. 结果表明:浸出温度和c(H₂SO₄)对浸出率影响最显著,液固比次之. c(H₂SO₄)越高,Co、Ni、Cu和Fe的浸出率越高,而提高浸出温度有利于降低Fe浸出率. 响应曲面法优化获得的最佳工艺条件:浸出温度为210 ℃、c(H₂SO₄)为0.38 mol/L、液固比为4.25 mL/g,在该条件下,Co和Ni的浸出率均大于98%,Cu浸出率大于96%,Fe浸出率小于0.4%. 浸出控制参数优化后提高了有价金属的浸出率,同时也降低了Fe浸出率,实现了镍转炉渣中有价金属的回收及其与Fe的高效分离.      

利用天然磁黄铁矿去除水中As (V)的研究

考察了时间、pH、温度、吸附剂投加量、无机阴离子等因素对磁黄铁矿去除As(V)过程的影响.同时,对去除过程的动力学和等温线进行分析,并探究了动态去除的效果.结果显示:磁黄铁矿对As(V)的去除在24 h达到平衡;在pH值3~9范围内去除率都达到80%以上;温度升高和吸附剂用量增加都对As(V)去除具有促进作用;PO_4~(3-)、SiO_3~(2-)、CO_3~(2-)对吸附有较强的抑制作用;在As(V)初始浓度为2 mg·L~(-1)时动态吸附出水浓度在150个吸附床体积(BV)内能达到国家饮用水标准;吸附去除过程符合拟二级动力学方程和Langmuir等温方程.能谱仪和X射线电子能谱分析表明,去除过程是一个自发吸热的配位离子交换反应.本实验表明,天然磁黄铁矿是一种有潜力的除砷吸附剂.     

纳米Fe_3O_4强化混凝-Fenton氧化预处理垃圾渗滤液

采用纳米Fe_3O_4与Fe Cl3制备复合混凝剂,利用混凝沉淀-Fenton氧化工艺预处理垃圾渗滤液原水,研究其处理效果。结果表明:在纳米Fe_3O_4投加量为2 g/L,Fe Cl3投加量为1.4 g/L时制备的复合混凝剂,在p H值为6.5,转速为300 r/min下快速搅拌1 min,转速为100 r/min下慢速搅拌30 min,沉淀时间为30 min的条件下,COD去除率为56.8%,ρ(COD)可由5 240 mg/L降低到2 264 mg/L;利用Fenton氧化处理混凝处理出水,在H_2O_2的投加量为5.5 g/L,n(H_2O_2)∶n(Fe2+)=4,p H值为6,反应时间为80 min,反应温度为25℃的最佳条件下,COD和氨氮的去除率分别为55.7%和40.1%,最终出水ρ(COD)和ρ(氨氮)分别为1 003 mg/L和670 mg/L;该组合工艺对垃圾渗滤液有较好的处理效果,COD、色度和氨氮的去除率分别为80.8%、59.5%和76.2%。     

高压电晕-臭氧协同作用处理难降解有机废水技术进展

利用高压电晕-臭氧的协同作用来处理废水是一项新技术。高压电晕和臭氧均能在水溶液中产生·OH。·OH能无选择地氧化有机污染物如苯乙酮、石炭酸、对氯苯酚等,处理效率高、无二次污染。高压电晕产生的紫外线和高能电子能促进臭氧产生·O和·OH,臭氧气泡的局部放电使电晕产生更多的·OH,二者联用具有很好的协同性。因此该技术在难降解有机废水的处理方面具有较大的优越性。     

氯氟烃替代物大气化学研究

大气平流层臭氧（大气臭氧层）由于能够吸收太阳辐射中的高能量紫外线,对人类和生物起着非常重要的保护作用,氯氟烃类化合物（ＣＦＣｓ）已被认为是造成大气平流层臭氧耗损的主要原因,淘汰ＣＦＣｓ和使用替代物日趋紧迫,目前,最有应用前景的替代物是含氢氧氟烃类化合物（ＨＣＦＣｓ）和氢氟烃类化合物（ＨＦＣｓ）,其中有些已投入工业使用,本文总结 了ＨＣＦＣｓ和ＨＦＣｓ在气中的光化学降解机制及其产物,以及产物对环境的     

二甲基硫醚光解及二甲基二硫醚生成速率研究

用低压汞灯照射二甲基硫醚（ＤＭＳ）,在２０ｍ的长光池中用富里叶红外光谱仪测量其光解产物,结果表明二甲基硫醚光解生成二甲基二硫醚（ＤＭＤＳ）和乙烷。测量其不同光照时间的光解产物,结果表明Ｉｎ＾ｃ０／ｃｔ在直解坐标上是一条直线,说明了二甲基二硫醚生成按生一极反应进行,其生成的速率常数为８．７０×１０＾－５ｓ＾－１用低压汞灯照射ＤＭＳ＋Ｈ２Ｏ２体系,富里叶红外光谱检测其产物,在有足够的Ｈ２Ｏ２情况下,生