Removal of polycyclic aromatic hydrocarbons from different soil fractions by persulfate oxidation

Removal of polycyclic aromatic hydrocarbons (PAHs) from different soil fractions of contaminated soil was investigated by using activated persulfate oxidation remediation in our research. The results showed that the light fraction, which accounted for only 10% of the soil, contained 30% of the PAHs at a concentration of 4352?mg/kg. The heavy fraction contained more high-molecular-weight PAHs, and the total PAH concentration was 625?mg/kg. After being oxidized, the removal rate of PAHs was 39% in the light fraction and nearly 90% in the heavy fraction. Among the different fractions of the heavy fraction, humic acid contained the highest concentration of PAHs, and consequently, the highest removal efficiency of PAHs was also in humic acid. Compared with the light fraction, the heavy fraction has more aromatic compounds and those compounds were broken down during the oxidation process, which may be the removal mechanism involved in the oxidation of high-ring PAHs. Similarly, the enhancement of C = C bonds after oxidation can also explain the poor removal of high-ring PAHs in the light fraction. These results imply that different fractions of soil vary in composition and structure, leading to differences in the distribution and oxidation efficiencies of PAHs.     

基于微生物相互作用机理的完全耦合活性污泥模型研究

根据微生物生长机理,推导出微生物的耦合作用机理并在该机理的基础上改进了ASM3 Bio-P模型.假设活性污泥系统中有机物氧化过程、生物硝化过程、生物反硝化过程、生物除磷过程可同时存在,在ASM3 Bio-P模型上添加相关的开关函数,推导出完全耦合活性污泥模型(FCASM).基于计算机程序进行数值模拟,并将FCASM模拟结果与实测值以及ASM3 Bio-P模型模拟值进行对比.结果表明,完全耦合活性污泥模型对氨氮模拟的稳态出水值为1.90 g·m-3,ASM3 Bio-P模型模拟的氨氮稳态出水值为0 g·m-3,而实测的氨氮稳态出水值为1.50 g·m-3,完全耦合活性污泥模型的结果更接近真实值.     

An autotrophic nitrogen removal process：Short-cut nitrification combined with ANAMMOX for treating diluted effluent from an UASB reactor fed by landfill leachate

A combined process consisting of a short-cut nitrification (SN) reactor and an anaerobic ammonium oxidation upflow anaerobic sludge bed (ANAMMOX) reactor was developed to treat the diluted effluent from an upflow anaerobic sludge bed (UASB) reactor treating high ammonium municipal landfill leachate.The SN process was performed in an aerated upflow sludge bed (AUSB) reactor (working volume 3.05 L),treating about 50% of the diluted raw wastewater.The ammonium removal efficiency and the ratio of NO 2 N to NOx-N in the effluent were both higher than 80%,at a maximum nitrogen loading rate of 1.47 kg/(m 3 ·day).The ANAMMOX process was performed in an UASB reactor (working volume 8.5 L),using the mix of SN reactor effluent and diluted raw wastewater at a ratio of 1:1.The ammonium and nitrite removal efficiency reached over 93% and 95%,respectively,after 70-day continuous operation,at a maximum total nitrogen loading rate of 0.91 kg/(m 3 ·day),suggesting a successful operation of the combined process.The average nitrogen loading rate of the combined system was 0.56 kg/(m 3 ·day),with an average total inorganic nitrogen removal efficiency 87%.The nitrogen in the effluent was mostly nitrate.The results provided important evidence for the possibility of applying SN-ANAMMOX after UASB reactor to treat municipal landfill leachate.     

单级SBR生物膜中全程自养脱氮的研究

研究了具有全程自养脱氮作用的生物膜中无机碳源浓度、pH值、溶解氧(DO)对全程自养脱氮的影响.结果表明,当NaHCO3浓度从1.75g/L上升到2.50g/L时,反应体系中的pH值从7.6～8.0上升到8.8左右,氨氮转化率和总无机氮去除率分别急剧下降到53%和48.8%.在进水氨氮负荷为60g/(m³·d)时,最佳DO应控制在0.5～0.7mg/L,此时氨氮转化率达到90%以上.     

蒽醌修饰石墨毡电极预处理头孢合成废水

以钛涂钌电极为阳极、自制蒽醌修饰石墨毡电极为阴极,对头孢合成废水(COD=25 000~30 000 mg/L、ρ(NH3-N)=850~1 300 mg/L、色度为2 300~2 680度)进行了电化学氧化预处理,优化了电解条件,并对电化学体系的动力学和稳定性进行了分析。实验结果表明:蒽醌的存在可改善电化学氧化降解效果;在电解时间50 min、电流密度0.14 A/cm2、Na2SO4浓度0.1 mol/L、极板间距2 cm、初始废水p H 7.0的条件下,废水的COD、色度、NH3-N的去除率分别可达45.3%,66.9%,33.6%;BOD5/COD由处理前的0.27增至0.40,可生化性得到改善;COD、色度、NH3-N的电化学氧化降解过程均近似符合一级动力学方程;且该电化学体系的应用稳定性良好。     

催化湿式氧化乐果农药废水及催化剂的研究

通过共沉淀法制备了用于湿式氧化乐果农药废水的Cu/Mn复合氧化物催化剂,研究了沉淀剂种类、沉淀温度、焙烧温度和活性组分配比等因素对Cu/Mn复合氧化物催化剂的活性及稳定性的影响,确定了最佳制备条件,利用BET比表面积测定和XRD对催化剂进行了表征。结果表明:优化条件制备的Cu/Mn复合氧化物催化剂催化湿式过氧化氢氧化处理乐果农药废水时,具有较高的催化活性和稳定性。催化剂用量以6 g/L,反应温度80℃,过氧化氢加入量为12.0 g/L,反应时间60 min,COD去除率为89.5%,活性组分溶出量较小。     

EGSB-BAF集成系统实现厌氧氨氧化、甲烷化和短程硝化反硝化

将膨胀颗粒污泥床(EGSB)和曝气生物滤池(BAF)集成,EGSB出水进入BAF进行短程硝化,BAF出水外回流至EGSB反应器为后者提供亚硝态氮,在不需外部投加亚硝态氮的条件下,实现厌氧氨氧化、甲烷化和短程硝化反硝化的耦合, 系统地处理ρ(氨氮)为50 mg/L和ρ(COD_Cr)为500 mg/L的合成废水.结果表明:当外回流比为200%时,系统CODCr,氨氮和总氮的去除率分别为92.4%,97.4%和80.6%;出水ρ(氨氮),ρ(亚硝态氮),ρ(硝态氮)和ρ(COD_Cr)分别为1.05,4.30,2.56和35.3 mg/L;COD_Cr,总氮和氨氮的去除负荷速率分别为1.770,0.137和0.164 kg/(m3·d). 与传统的活性污泥过程相比,EGSB-BAF集成系统回收甲烷1.03 　L/d,占系统COD_Cr去除量的37.0%;在系统总氮的去除过程中,厌氧氨氧化途径占35.9%,短程反硝化途径占47.4%,全程反硝化途径占16.7%.      

硝化过程中影响亚硝酸盐积累的因素

采用间歇式批试验法,改变pH值、DO浓度和温度,试验发现:当pH值分别为8.2、7.5、9.2、6.5和5.0,DO分别为1.0mg/L、2.0mg/L、4.5mg/L和温度为30℃、25℃、35℃和10℃时,氨氧化速率依次减小。进水氨氮浓度为50mg/L～250mg/L,保持pH值为8.0±0.2时,游离氨浓度为4.45mg/L～22.68mg/L左右,最大HNO2浓度远<0.2mg/L,游离氨和HNO2对好氧氨氧化菌的影响较小。结果表明,pH值、DO浓度和温度对好氧氨氧化菌的富集有显著影响。在富集过程中,控制pH值、DO浓度和温度是关键因素,游离氨和HNO2进行适当控制,以保证抑制亚硝酸盐氧化菌而不抑制好氧氨氧化菌。     

Fenton氧化处理剩余污泥的作用机制

大量集中式城市生活污水处理厂的建设,减轻了水体污染;但是,产生的大量城市污泥的处理处置又成为污水处理面临的另一个瓶颈难题。各种物理、化学、生物等方法被应用于污泥处理,高级氧化技术-Fenton氧化在剩余污泥的处理中逐渐受到研究者的重视。文章重点介绍了Fenton氧化在剩余污泥处理中的作用机制,分析了Fenton氧化处理剩余污泥的主要影响因素;并根据Fenton氧化剩余污泥处理优势,对其今后的应用进行了展望。     

高效烃类降解菌在稠油污水生化处理中的应用

从稠油污水中筛选出四株高效烃类降解菌株,经初步鉴定HD-1、HD-2、HD-4为假单胞菌属,HD-3为芽孢杆菌属。研究了菌株对高温高盐环境的耐受性,采用正交试验法确定了最佳降解效果时各菌的投加量。同时采用生物接触氧化工艺进行了室内模拟实验,探索了高温环境下所筛选菌株对稠油污水的处理效果,重点研究菌株对含油量和COD的去除能力。通过逐渐缩短停留时间,最终将停留时间缩短为8h,发现这种条件下,出水的含油量<1mg/L,达到了高压注汽锅炉用水的标准,对COD的去除率达到70%,去除效果也非常显著。