拜耳法赤泥粒径分级预处理的研究

赤泥是从铝土矿中提取氧化铝的过程中产生的工业废渣.分析了拜耳法赤泥的粒径分布,以及主要化学组成和矿物组成在不同粒径赤泥中的变化规律.在此基础上,提出先将赤泥粒径分级预处理,然后根据粗细粒径赤泥的差异分别进行回收利用的思路.研究结果表明,赤泥中粒径大于0.075 mm的粗颗粒以铁、硅、钙为主,实践证明可以通过磁选或重选工...     

餐厨垃圾厌氧消化中硬脂酸钙的形成及作用

在稳定运行的餐厨垃圾单相厌氧消化体系中,出现白色颗粒状物质,且随着负荷的提高,其数量和粒径不断增加。利用能谱技术分析白色颗粒的元素组成,结合傅里叶红外光谱和13C核磁共振技术分析白色颗粒中的官能基团。经过研究分析认为,该白色颗粒的主要成分为长链羧酸钙盐,具体为硬脂酸钙。同时,对其形成过程进行了分析。该物质的形成对餐厨垃圾中油脂的去除提供了新的思路和途径。     

活性炭纤维(ACF)应用于有机废气回收和净化的进展

活性炭纤维(ACF)有比普通活性炭吸附量大、吸附和脱附速度快等优点,因此应用于有机废气的回收和净化,具有良好的经济、环境和社会效益。文中介绍了ACF的微观结构、表面化学以及吸附性能,并综述了近年来ACF在有机废气回收和治理方面的国内概况。     

A hybrid method for quasi-three-dimensional slope stability analysis in a municipal solid waste landfill

Limited space for accommodating the ever increasing mounds of municipal solid waste (MSW) demands the capacity of MSW landfill be maximized by building landfills to greater heights with steeper slopes. This situation has raised concerns regarding the stability of high MSW landfills. A hybrid method for quasi-three-dimensional slope stability analysis based on the finite element stress analysis was applied in a case study at a MSW landfill in north-east Spain. Potential slides can be assumed to be located within the waste mass due to the lack of weak foundation soils and geosynthetic membranes at the landfill base. The only triggering factor of deep-seated slope failure is the higher leachate level and the relatively high and steep slope in the front. The valley-shaped geometry and layered construction procedure at the site make three-dimensional slope stability analyses necessary for this landfill. In the finite element stress analysis, variations of leachate level during construction and continuous settlement of the landfill were taken into account. The "equivalent" three-dimensional factor of safety (FoS) was computed from the individual result of the two-dimensional analysis for a series of evenly spaced cross sections within the potential sliding body. Results indicate that the hybrid method for quasi-three-dimensional slope stability analysis adopted in this paper is capable of locating roughly the spatial position of the potential sliding mass. This easy to manipulate method can serve as an engineering tool in the preliminary estimate of the FoS as well as the approximate position and extent of the potential sliding mass. The result that FoS obtained from three-dimensional analysis increases as much as 50% compared to that from two-dimensional analysis implies the significance of the three-dimensional effect for this study-case. Influences of shear parameters, time elapse after landfill closure, leachate level as well as unit weight of waste on FoS were also investigated in this paper. These sensitivity analyses serve as the guidelines of construction practices and operating procedures for the MSW landfill under study.     

Emergy analysis of the recycling options for construction and demolition waste

Construction and demolition (C&D) waste is becoming a major contributor to environmental pollution. In Shanghai, China, the quantity of C&D waste is 2.11E+07 t/yr, which accounts for 45% of the total quantity of solid waste. There has been a growing promotion of recycling C&D waste as an effective way to solve this waste problem. However, the evaluation of the efficiency of recycling C&D waste as a potential source of resources is largely based on traditional economic analysis. The economic analysis emphasizes money instead of the harmony between economic benefit and environmental effects. There is a need for a new strategic approach to investigate the efficiency of recycling C&D waste to achieve the integration between economic, social and environmental effects. Emergy theory can be employed to analyze different recycling options for C&D waste. With reference to the Chinese construction industry, this paper demonstrates that the close-loop recycling option is better than the open-loop recycling option for C&D waste in terms of the integration of social, environmental and sustainable aspects. To evaluate different technology solutions for C&D waste recycling, the emergy theory and method is not limited to a cost-benefit balance but can include economic, social, environmental and sustainable effects.     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.     

三苯类废气处理进展

综述了近年来三苯类废气处理所采用的方法,如吸收法、吸附法、催化氧化法、生物法、光催化法和低温等离子体法等,对各种方法的处理机理、处理效果以及优缺点进行了概括和分析,并指出联用技术将是未来的发展方向.     

垃圾焚烧中抑制二恶英二次生成的方法探讨

根据生活垃圾焚烧技术中二恶英的生成机理,余热锅炉的烟气在低温区急冷可以避免二恶英在低温区的再次合成,但目前在余热锅炉烟气低温区急冷是不可行的。提出一种从垃圾焚烧系统设计上进行烟气的急冷,从而抑制二恶英低温区二次生成的新方法。     

乌鲁木齐市工业固体废物资源化现状、趋势及建议

分析了乌鲁木齐市工业固体废物产生现状及其资源化利用情况,预测了＂十二五＂期间乌鲁木齐市工业固体废物产生量及资源化利用量。针对乌鲁木齐市工业固体废物资源化利用存在的问题,提出了实施工业固体废物资源化利用过程中,应该减少工业固体废物排放总量、扩大资源化利用途径、推进资源回收和资源化利用的产业化进程、加强工业固体废物监督管理工作等建议。     

把握机遇乘势而为全力推进再生资源回收体系建设——对温家宝总理关于建立废旧商品回收体系重要指示的理解

2011年9月22日,国务院总理温家宝主持召开国务院常务会议,部署建立完整、先进的废旧商品回收体系。在深刻学习、理解会议精神的基础上,提出了全力推动再生资源回收体系建设向纵深发展,必须要做到“四个坚持,一个加强”。