内置转盘式膜-生物反应器处理污水的工艺条件研究

对内置转盘式膜-生物反应器(SRMBR)处理污水工艺进行了研究.进水COD 160～368 mg/L时,出水COD在运行1d后降低到20 mg/L以下,去除率大于90%;转盘式膜组件的转速在0～25 r/min范围内,平衡膜通量随转速增大而快速增加,继续增大转速则平衡膜通量的增加变得不显著;在一定范围(0～1min)内延长停抽时间有助于缓解膜污染;SRMBR在较低的气水比(15∶1)下运行,也可达到较高的平衡膜通量.研究表明,SRMBR在最佳组合操作条件(转速为25r/min,抽/停为9min/1min,气水比为15∶1,抽吸压力为25kPa)下运行,其平衡膜通量高达53.75L/(m²·h).     

好氧膜生物反应器的硝化性能研究

以含有高浓度氨氮的垃圾渗滤液为对象,针对好氧膜生物反应器的硝化性能进行了研究。结果表明:当进水氨氮<1000mg/L和负荷<1.5kgNH4+-N/m3d时,氨氮去除率保持在80%～99.7%之间,表明好氧MBR具有良好的硝化性能;硝酸菌在进水氨氮浓度>600mg/L时受到了抑制,而亚硝酸菌在进水氨氮浓度>1200mg/L时才受到抑制;在试验过程中,MBR污泥经历了由以异养细菌为主到自养细菌为主的转型过程。以硝化菌为主的污泥具有良好的沉淀性能,污泥的SV和SVI分别稳定在20%～30%之间和40～70mL/g之间。     

操作条件对超滤膜运行经济稳定性能的影响

采用正交实验的方法对棕榈油生产废水二级处理出水的超滤工艺条件进行考察和优化,并用膜通量衰减系数、平均跨膜压差及产水量各自加权相加所得综合指标来表征不同超滤操作条件下膜运行的经济稳定性能。正交试验结果表明,减小膜表面流速和产水率,提高处理废水温度均有利于系统经济稳定地运行;各运行参数对综合指标影响的大小顺序为:膜表面平均流速>产水率>温度;在保证出水质量的前提下,最佳组合操作条件为膜表面平均流速0.7m/s,产水率80%,废水温度30℃。     

无过氧化氢添加Fenton氧化法降解有机物的可行性研究

Fenton反应可以氧化分解有机物,在反应中的关键氧化剂羟基自由基(HO·)是通过亚铁离子与过氧化氢作用生成的,因此,传统的Fenton氧化必须由外部添加过氧化氢.研究了一种新的方法,即采用Nafion膜固定化亚铁离子,并通过光催化反应提供Fenton氧化所需的过氧化氢,使得Fenton反应在不添加过氧化氢的条件下也能够连续进行.结果表明,以甲酸为代表有机物,该方法可以在不添加过氧化氢的条件下起到分解甲酸的作用.而且,通过对负载亚铁离子Nafion膜的再生,可以使该方法的降解能力保持在稳定的范围.     

Mitochondrial toxicity and in vitro biological effects of ambient PM2.5 from an urban site in China

Abstract

The roles of PM_2.5-induced mitochondrial damage and oxidative stress on mast cell degranulation were examined in vitro. Mast cells were treated with suspensions of PM_2.5 in Dulbecco’s modified Eagle’s medium at concentrations from 25 to 200?mg/L in the absence or presence of 10?mmol/L N-acetyl-L-cysteine. Biological effects and mitochondrial function were assessed by determining cell viability, β-hexosaminidase release, interleukin-4 secretion, reactive oxygen species generation, adenosine triphosphate production, potential alteration of mitochondrial membrane, and activities of mitochondrial electron transport chain complexes I and III. Exposure of mast cells to PM_2.5 induced reduction of adenosine triphosphate production, collapse of mitochondrial membrane potential, and inhibition of the activity of complex III. Co-treatment of mast cells exposed to PM_2.5 with N-acetyl-L-cysteine attenuated cytotoxicity and the production of reactive oxygen species, and decreased the release of β-hexosaminidase and interleukin-4. Evidently, PM_2.5-induced oxidative stress plays an essential role in mitochondrial toxicity and mast cell activation.     

Thermal decomposition mechanism of 65% lysine sulfate powder and its thermal stability based on thermal analysis

Lysine is widely used in the fields of food, medicine and feed, which generally appears in the form of lysine sulfate or lysine hydrochloride dust because of the high instability of the free L-lysine. The L-lysine Sulfate is in high risk of decomposition, spontaneous ignition and even the dust explosion, because the control temperature in its production process is high up to 90 °C. Thus, the thermal behaviors and its thermal stability of 65% lysine sulfate are experimentally explored in Air and Nitrogen using the simultaneous TG-DSC measurements. Results show: (1) the decomposition of 65% lysine sulfate can be divided into three stages both in the atmospheres of air and nitrogen, and most of the weight loss occurred in the first two stages, which are related with the decarboxylation and deamination process. (2) The effects of atmosphere on the decomposition of 65% lysine sulfate mainly occur at the third stage. In this stage, the weight loss in nitrogen is only 14.2%, which is much lower than that in air (34.3%), which is related to the oxidative degradation at high temperature. Besides, the active energy is slightly increased in nitrogen compared to that in air. (3) The initial temperatures of the decomposition of the 65% lysine sulfate are 145 °C and 155 °C, for the air and nitrogen atmosphere, respectively, which are much lower than that (260 °C) of the pure lysine.     

Metabolic uncoupler, 3,3′,4′,5-tetrachlorosalicylanilide addition for sludge reduction and fouling control in a gravity-driven membrane bioreactor

• Effects of metabolic uncoupler TCS on the performances of GDMBR were evaluated. • Sludge EPS reduced and transformed into dissolved SMP when TCS was added. • Appropriate TCS increased the permeability and reduced cake layer fouling. • High dosage aggravated fouling due to compact cake layer with low bio-activity. The gravity-driven membrane bioreactor (MBR)system is promising for decentralized sewage treatment because of its low energy consumption and maintenance requirements. However, the growing sludge not only increases membrane fouling, but also augments operational complexities (sludge discharge). We added the metabolic uncoupler 3,3′,4′,5-tetrachlorosalicylanilide (TCS) to the system to deal with the mentioned issues. Based on the results, TCS addition effectively decreased sludge ATP and sludge yield (reduced by 50%). Extracellular polymeric substances (EPS; proteins and polysaccharides) decreased with the addition of TCS and were transformed into dissolved soluble microbial products (SMPs) in the bulk solution, leading to the break of sludge flocs into small fragments. Permeability was increased by more than two times, reaching 60–70 L/m²/h bar when 10–30 mg/L TCS were added, because of the reduced suspended sludge and the formation of a thin cake layer with low EPS levels. Resistance analyses confirmed that appropriate dosages of TCS primarily decreased the cake layer and hydraulically reversible resistances. Permeability decreased at high dosage (50 mg/L) due to the release of excess sludge fragments and SMP into the supernatant, with a thin but more compact fouling layer with low bioactivity developing on the membrane surface, causing higher cake layer and pore blocking resistances. Our study provides a fundamental understanding of how a metabolic uncoupler affects the sludge and bio-fouling layers at different dosages, with practical relevance for in situ sludge reduction and membrane fouling alleviation in MBR systems.     

烟气脱碳技术进展

介绍了吸收法、吸附法、低温法、膜分离法回收烟道气中CO2的研究和应用现状,并对这些方法进行了比较,指出了适用范围。     

有机废气中VOC的回收方法

介绍了炭吸附法、冷凝法和膜分离法回胥机废报中ＶＯＤ的原理、工艺流程和工业应用情况，并对这些方法进行了比较，指出了适用范围。     

TiO_2光催化对微滤去除腐殖酸的膜污染控制研究

着重研究了不同紫外灯光源和照射时间条件下,TiO_2光催化(PCO)对微滤去除腐殖酸过程中的膜污染控制,并探讨了膜污染的控制机理。研究结果表明,TiO_2光催化能有效提高微滤对腐殖酸的去除,同时降低膜通量的下降,起到有效控制膜污染的作用。进一步的实验分析表明,TiO_2光催化控制膜污染的主要机理在于将腐殖酸降解为易于被TiO_2吸附的小分子量物质,吸附腐殖酸降解产物后的TiO_2聚合颗粒粒径增大,易于在膜表面形成更为松散的沉积层,并使膜污染从以膜孔堵塞和沉积层污染为主转化为以沉积层污染为主的可逆性污染。