火灾环境下具有弹性支座钢构件的稳定性能

根据弹性稳定理论原理研究了具有弹性支座钢结构构件在火灾环境下的静力特性问题 ,导出了高温下钢构件的静力稳定临界荷载和长度计算式 ,并讨论了温度、杆件的侧向弹簧刚度、杆长、保护层厚度等因素对杆件静力稳定临界荷载和长度的影响 ,分析表明 ,杆件的侧向弹簧刚度、杆长、保护层厚度对杆件的稳定承载力影响较大 ,并探讨了在实际工程中如何减小结构失稳的问题。     

Soybean-Oil-Based Polyisocyanurate Rigid Foams

Polyisocyanurate foams were prepared from polymeric 4,4-diphenylmethane diisocyanate (MDI), soy polyol and polypropylene oxide polyol by varying isocyanate index from 110 to 350. The higher isocyanate index produced polyisocyanurate foams with higher thermal stability, improved flame resistance, tensile strength, higher modulus, and higher glass transition. Soy-based foams displayed better thermal stability, lower flammability, higher rigidity (modulus) and higher compression strength than those based on the propylene oxide polyols of the same molecular weight and functionality.     

Sampling of airborne polycyclic aromatic hydrocarbons with semipermeable membrane devices

Semipermeable membrane devices (SPMDs) are nowadays used as passive samplers of organic pollutants. The knowledge of the sampling rate values (R_S) of each substance trapped on membranes is necessary to calculate their average concentration. Here we calculate R_S values for 16 polycyclic aromatic hydrocarbons using the comparison of active sampling method results and the amounts sequestered by SPMDs at varying exposure times.Selected article from the Regional Symposium on Chemistry and Environment, Krusevac, Serbia, June 2003, organized by Dr. Branimir Jovancicevic.     

Carbon Molecular Sieving Membranes Derived from Lignin-Based Materials

Carbon molecular sieving membranes were prepared by pyrolysis of lignocresol derived from lignin by the phase-separation method. Lignocresol membranes formed by a dip process on a porous -alumina tubing were carbonized at 400–800°C under nitrogen atmosphere. The thickness of the membrane formed on the outer surface of the substrate was about 400 nm judging from SEM observation. Gas-evolving behavior of lignocresol was measured using thermogravimetry-mass spectrometry (TG-MS). The gaseous products evolved from lignocresol included a number of fragments with higher molecular weights; whereas those from phenolic resin are mainly due to phenol and methylphenol. These evolved pyrolysis fragments effectively contribute to micropore formation of carbonized lignocresol membranes. Gas permeation rates through the membrane decreased in the order of increasing kinetic molecular diameter of the penetrant gas, and the membrane behaved like a molecular sieve. The permeation properties were dependent on heating conditions, and a pyrolysis temperature of 600°C gave the best membrane performance. Gas selectivities of the membrane prepared at 600°C were 50, 8, 290, and 87 for CO₂/N₂, O₂/N₂, H₂/CH₄, and CO₂/CH₄ at 35°C, respectively.     

弃土场边坡稳定性和可靠性的多工况对比分析

弃土场堆积体的物理力学性质是影响弃土场边坡稳定性的关键因素.由于弃土场边坡的特殊性,其坡体物理力学指标存在明显的变异性.基于可靠性理论,考虑关键指标的不确定性,将其作为随机变量,一定程度上可克服传统边坡稳定性分析中关键参数取值难以把握的缺陷.以贵州山区平罗高速公路某弃土场边坡为例,采用Spencer法、Morgenst...     

一体式膜-生物反应器的水动力学特性

以研究一体式膜 -生物反应器的水动力学特性为目的 ,通过试验测定了反应器中膜间液体错流流速的分布和大小 ,建立了描述错流流速的计算模型 ,并考察了曝气量和反应器结构对错流流速的影响 .曝气量为 40 m³/h时 ,膜组件中部的错流流速为0.36～ 0.4³m/s,比膜组件 2边的流速约大 6.2%～ 21%.错流流速实测值与模型计算值吻合良好 .曝气量为 20～50 m³/h时 ,错流流速随曝气量的升高而增大 ,当曝气量大于 50 m³/h后错流流速逐渐趋向平稳 ;反应器高度越高 ,上升流通道越窄、下降流道和底部流道越宽 ,在同样曝气量条件下 ,可获得越大的错流流速 .     

燃烧、爆炸过程复杂性行为的非线性动力学—突变燃烧学、突变爆炸学(Ⅱ)(上)

针对燃烧,爆炸学中存在的大量非连续性现象,提出了突变燃烧学和突变爆炸学的概念,指出了突变燃烧学和突变爆炸学的基本任务和主要研究内容。提出了单颗碳粒着火和熄火现象的突变机理。     

水消毒处理中膜技术的应用

本文较全面地评述了膜技术在水消毒处理中的应用 ,包括消毒机理、效果及影响因素 ,展望了应用前景     

电渗析技术的新进展

电渗析技术是膜分离技术之一 ,由于具有高效、低能耗等特点已经被多个行业广泛使用。本文阐述了几种新的电渗析技术 ,包括无隔板电渗析、填充床电渗析、双极膜电渗析等 ,并探讨和综述其研究现状和发展前景。     

EFFECTS OF URBANIZATION ON CHANNEL INSTABILITY1

ABSTRACT: Channel instability and aquatic ecosystem degradation have been linked to watershed imperviousness in humid regions of the U.S. In an effort to provide a more process‐based linkage between observed thresholds of aquatic ecosystem degradation and urbanization, standard single event approaches (U.S. Geological Survey Flood Regression Equations and rational) and continuous hydrologic models (HSPF and CASC2D) were used to examine potential changes in flow regime associated with varying levels of watershed imperviousness. The predicted changes in flow parameters were then interpreted in concert with risk‐based models of channel form and instability. Although low levels of imperviousness (10 to 20 percent) clearly have the potential to destabilize streams, changes in discharge, and thus stream power, associated with increased impervious area are highly variable and dependent upon watershed‐specific conditions. In addition to the storage characteristics of the pre‐development watershed, the magnitude of change is sensitive to the connectivity and conveyance of impervious areas as well as the specific characteristics of the receiving channels. Different stream types are likely to exhibit varying degrees and types of instability, depending on entrenchment, relative erodibility of bed and banks, riparian condition, mode of sediment transport (bedload versus suspended load), and proximity to geomorphic thresholds. Nonetheless, simple risk‐based analyses of the potential impacts of land use change on aquatic ecosystems have the potential to redirect and improve the effectiveness of watershed management strategies by facilitating the identification of channels that may be most sensitive to changes in stream power.