Management of hazardous road derived respirable particulates using magnetic properties of tree leaves

The magnetic properties of tree leaves along with their ecological, economical and aesthetic importance can be used to control road derived respirable particulates. Isothermal remanent magnetization (IRM₃₀₀ mT) of three different tree leaves viz. Mango (Mangifera indica), Sisso (Dalbergia sisso) and Banyan (Ficus benghalensis) were determined and IRM₃₀₀ mT normalized for the leaf area. The normalized 2-D magnetization of leaves as shown by results is dominantly controlled by leaf morphology and traffic density. F. benghalensis (Banyan) leaf has highest 2-D magnetization and D. sisso (Sisso) leaf having least 2-D magnetization suggesting greater ability of F. benghalensis (Banyan) tree leaves to reduce magnetic particulates. The particle size of the magnetic grains falls in the category of PM2.5, a particle size hazardous to human health due to its capacity to be inhaled deeply into the lungs.     

Biomagnetic monitoring of industry-derived particulate pollution

Clear association exists between ambient PM₁₀ concentrations and adverse health outcomes. However, determination of the strength of associations between exposure and illness is limited by low spatial-resolution of particulate concentration measurements. Conventional fixed monitoring stations provide high temporal-resolution data, but cannot capture fine-scale spatial variations. Here we examine the utility of biomagnetic monitoring for spatial mapping of PM₁₀ concentrations around a major industrial site. We combine leaf magnetic measurements with co-located PM₁₀ measurements to achieve inter-calibration. Comparison of the leaf-calculated and measured PM₁₀ concentrations with PM₁₀ predictions from a widely-used atmospheric dispersion model indicates that modelling of stack emissions alone substantially under-predicts ambient PM₁₀ concentrations in parts of the study area. Some of this discrepancy might be attributable to fugitive emissions from the industrial site. The composition of the magnetic particulates from vehicle and industry-derived sources differ, indicating the potential of magnetic techniques for source attribution.     

Change of magnetic properties due to fluctuations of hydrocarbon contaminated groundwater in unconsolidated sediments

Sediments affected by fluctuations of hydrocarbon contaminated groundwater were studied at a former military site. Due to remediation, groundwater table fluctuation (GWTF) extends over approximately one meter. Three cores were collected, penetrating through the GWTF zone. Magnetic parameters, sediment properties and hydrocarbon content were measured. We discovered that magnetic concentration parameters increased towards the top of the GWTF zone. Magnetite is responsible for this enhancement; rock magnetic parameters indicate that the newly formed magnetite is in a single domain rather than a superparamagnetic state. The presence of hydrocarbons is apparently essential for magnetite to form, as there is clearly less magnetic enhancement in the core, which is outside of the strongly contaminated area. From our results we conclude that the top of the fluctuation zone has the most intensive geomicrobiological activity probably responsible for magnetite formation. This finding could be relevant for developing methods for simply and quickly detecting oil spills.     

Applications of magnetic nanoparticles in surface-enhanced Raman scattering (SERS) detection of environmental pollutants

Environmental pollution, a major problem worldwide, poses considerable threat to human health and ecological environment. Efficient and reliable detection technologies, which focus on the appearance of emerging environmental and trace pollutants, are urgently needed. Surface-enhanced Raman scattering(SERS) has become an attractive analytical tool for sensing trace targets in environmental field because of its inherent molecular fingerprint specificity and high sensitivity. In this review, we focused on the recent developments in the integration of magnetic nanoparticles(MNPs) with SERS for facilitating sensitive detection of environmental pollutants. An overview and classification of different types of MNPs for SERS detection were initially provided, enabling us to categorize the huge amount of literature that was available in the interdisciplinary research field of MNPs based SERS technology. Then, the basic working principles and applications of MNPs in SERS detection were presented. Subsequently, the detection technologies integrating MNPs with SERS that eventually were used for the detection of various environmental pollutions were reviewed. Finally, the advantages of MNP-basedSERS detection technology for environmental pollutants were concluded, and the current challenges and future outlook of this technology in practical applications were highlighted. The application of the MNPsbasedSERS techniques for environmental analysis will be significantly advanced with the great progresses of the nanotechnologies, optics, and materials.     

Reuse of Fenton sludge as an iron source for NiFe2O4 synthesis and its application in the Fenton-based process

The potentially hazardous iron-containing sludge from the Fenton process requires proper treatment and disposal, which often results in high treatment cost. In this study, a novel method for the reuse of Fenton sludge as an iron source for the synthesis of nickel ferrite particles(NiFe_2O_4) is proposed. Through a co-precipitation method followed by sintering at 800°C, magnetic NiFe_2O_4 particles were successfully synthesized, which was confirmed by powder X-ray diffraction(XRD), scanning electronic microscopy(SEM), energy dispersive spectroscopy(EDS), Fourier transform infrared spectroscopy(FT-IR) and Raman spectroscopy. The synthesized NiFe_2O_4 could be used as an efficient catalyst in the heterogeneous Fenton process. In phenol degradation with H_2O_2 or NiFe_2O_4 alone, the phenol removal efficiencies within the reaction time of 330 min were as low as 5.9% ± 0.1% and 13.5% ±0.4%, respectively. However, in the presence of both NiFe_2O_4 and H_2O_2, phenol removal efficiency as high as 95% ± 3.4% could be achieved, indicating the excellent catalytic performance of NiFe_2O_4 in the heterogeneous Fenton process. Notably, a rapid electron exchange between_Ni II and_Fe III ions in the NiFe_2O_4 structure could be beneficial for the Fenton reaction. In addition, the magnetic catalyst was relatively stable, highly active and recoverable, and has potential applications in the Fenton process for organic pollutant removal.     

Synthesis, characterization and application of Lagerstroemia speciosa embedded magnetic nanoparticle for Cr(VI) adsorption from aqueous solution

Lagerstroemia speciosa bark (LB) embedded magnetic nanoparticles were prepared by co-precipitation of Fe²⁺ and Fe³⁺ salt solution with ammonia and LB for Cr(VI) removal from aqueous solution. The native LB, magnetic nanoparticle (MNP), L. speciosa embedded magnetic nanoparticle (MNPLB) and Cr(VI) adsorbed MNPLB particles were characterized by SEM–EDX, TEM, BET-surface area, FT-IR, XRD and TGA methods. TEM analysis confirmed nearly spherical shape of MNP with an average diameter of 8.76 nm and the surface modification did not result in the phase change of MNP as established by XRD analysis, while led to the formation of secondary particles of MNPLB with diameter of 18.54 nm. Characterization results revealed covalent binding between the hydroxyl group of MNP and carboxyl group of LB particles and further confirmed its physico-chemical nature favorable for Cr(VI) adsorption. The Cr(VI) adsorption on to MNPLB particle as an adsorbent was tested under different contact time, initial Cr(VI) concentration, adsorbent dose, initial pH, temperature and agitation speed. The results of the equilibrium and kinetics of adsorption were well described by Langmuir isotherm and pseudo-second-order model, respectively. The thermodynamic parameters suggest spontaneous and endothermic nature of Cr(VI) adsorption onto MNPLB. The maximum adsorption capacity for MNPLB was calculated to be 434.78 mg/g and these particles even after Cr(VI) adsorption were collected effortlessly from the aqueous solution by a magnet. The desorption of Cr(VI)-adsorbed MNPLB was found to be more than 93.72% with spent MNPLB depicting eleven successive adsorption–desorption cycles.     

Newly developed Fe3O4–Cr2O3 magnetic nanocomposite for photocatalytic decomposition of 4-chlorophenol in water

Chlorophenols, typically 4-chlorophenols are highly toxic and non-biodegradable organic contaminants which pose serious threat to the environment, particularly when released into aqueous medium. The removal of these pollutants by efficient method has received worldwide concern in recent past. A new Fe_3O_4–Cr_2O_3 magnetic nanocomposite was synthesized by wet chemical method under ultrasonic irradiation. Microstructure and morphology of the nanocomposite were characterized by powder X-ray diffraction(XRD),Fourier transform infrared(FT-IR), and a transmission electron microscope(TEM). Magnetic and optical properties were studied by a vibrating sample magnetometer(VSM) and an ultraviolet–visible(UV–Vis) spectrophotometer respectively. The magnetic nanocomposite(MNC) was used as photocatalyst for effective decomposition of 4-chlorophenol in water under ultraviolet(UV) irradiation.     

铁磁形状记忆合金研究进展与展望(Ⅲ):应用研究

阐述了铁磁形状记忆合金(Ferromagnetic Shape Memory Alloy,简写为FSMA)在智能材料及其应用领域的优越性.重点介绍了FSMA装置研发和基于FSMA装置的体系分析理论的发展历程和研究现状.仔细分析了各种FSMA装置频率、输出力和最大位移等关键技术指标,讨论了基于电磁学、热力学和力学原理的包...     

Do geomagnetic storms change the behaviour of the stingless bee guiruçu (Schwarziana quadripunctata)?

Six behavioural experiments were carried out to investigate the magnetic field effects on the nest-exiting flight directions of the honeybee Schwarziana quadripunctata (Meliponini). No significant differences resulted during six experiment days under varying geomagnetic field and the applied static inhomogeneous field (about ten times the geomagnetic field) conditions. A surprising statistically significant response was obtained on a unique magnetic storm day. The magnetic nanoparticles in these bees, revealed by ferromagnetic resonance, could be involved in the observed effect of the geomagnetic storm.     

Exposure to electromagnetic fields in the magnetic resonance imaging environment in South Africa

Occupational exposure to radiofrequency (RF) and static magnetic fields at magnetic resonance imaging (MRI) suites is of continuing concern to personnel who routinely work in this environment. Questions regarding the levels of occupational RF and static field exposure have increased with the increasing demand for anesthetics to be administered in this environment. The present study was thus designed towards addressing the above-mentioned problem by gaining information regarding exposure levels of clinical personnel at MRI units in South Africa. Three 1.5 MRI units in Bloemfontein, South Africa were utilized to evaluate the exposure of clinical personnel to the electromagnetic fields present in the MRI environment over a period of time and during different clinical MRI procedures. Three rounds of measurements of RF fields in the MRI environment were done. All the three measurement rounds were focused on the low frequencies, 5 Hz–32 kHz, as well as on the high frequencies, 300 kHz–40 GHz. First round measurements were done to establish the background of the RF fields in and around the magnet room during an MRI examination. Second round RF field measurements were done at a specific location, 1 m away from the bore on the right-hand side of the bed, in the MRI room. The third round measurements were of the same format as the second round, but the specific location was against the magnet bore. Two pieces of Narda Safety Test Solution instruments, the EFA-300 and EMR-300, were used to measure the electromagnetic and magnetic exposure fields generated from the MRI scanners. Results of the measurements indicate that the electromagnetic fields measured during different clinical procedures do not exceed the International Commission on Non-Ionizing Radiation Protection (2000) guidelines in these units. Results from round two and three showed that the RF and gradient exposure 1 m and up against the bore entrance does not exceed these guidelines (rms average over 6 min). Ongoing new developments in MRI scanning create the need for continuously monitoring exposure of patients and workers to the EMF fields in the MRI environment.