绿色阻垢剂聚天冬氨酸的液相优化制备

在分析国外多种合成聚天冬氨酸(PASP)的方法的基础上,采用马来酸酐与氨水进行溶液聚合的方法制备聚天冬氨酸,并对产物的阻垢率、黏均相对分子质量、生物降解性等性能指标进行了评价.采用静态阻垢法评价产物的阻垢率;采用极限黏度法测定聚琥珀酰亚氨的聚合度,然后计算PASP的黏均相对分子质量;采用摇床法通过对比降解前后的COD检测PASP的生物降解性能.同时,根据性能指标的变化分别对原料的物质的量配比、聚合温度和聚合时间进行了单一条件的筛选.经实验确定的合成PASP的最佳条件是:原料物质的量配比1∶1.1,聚合温度160℃,聚合时间1 h.在此条件下合成的PASP阻垢率超过95%,生物降解性能达到70%.     

碳源变化对降解2,4-D的好氧颗粒污泥性能及形态的影响

在长期运行的序批式生物反应器(SBR)中,考察了以葡萄糖和2,4-二氯苯氧乙酸(2,4-D)为混合碳源培养的好氧颗粒污泥在转换为2,4-D唯一碳源废水后,其形态、结构及对目标污染物去除功能的变化.结果表明,基质转换为2,4-D单一碳源后,好氧颗粒污泥仍保持了对目标污染物高效的去除能力.当进水2,4-D浓度为361～564mg/L,其去除率为99.2%～100%,COD平均去除率达到85.6%.混合碳源向2,4-D单一碳源转换对原好氧颗粒结构产生一定破坏作用,使其发生部分解体,粒径由513μm下降到302μm.但好氧颗粒污泥良好的耐负荷冲击使其保持了颗粒主体,通过一段时间适应调整后能够重新聚集生长,最终获得能够利用2,4-D为唯一碳源生长并具有良好沉降性(SVI20～40mL/g)的好氧颗粒污泥,粒径为489μm.扫描电子显微镜(SEM)观察结果表明,混合碳源转向单一碳源使好氧颗粒生物相丰富度降低.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Sedimentary record of polycyclic aromatic hydrocarbons in Lake Erhai, Southwest China

The temporal distribution of polycyclic aromatic hydrocarbons (PAHs) was investigated in a sediment core from Lake Erhal in Southwest China using gas-chromatography/mass spectrometry (GC/MS) method.The total organic carbon (TOC) normalized total PAHs concentrations (sum of US Environmental Protection Agency proposed 16 priority PAHs) ranged from 31.9 to 269 μg/g dry weight (dw),and were characterized by a slowly increasing stage in the deeper sediments and a sharp increasing stage in the upper sediments.The PAHs in the sediments were dominated by low molecular weight (LMW) PAHs,suggesting that the primary source of PAHs was low- and moderate temperature combustion processes.However,both the significant increase in high molecular weight (HMW) PAHs in the upper sediments and the vertical profile of diagnostic ratios pointed out a change in the sources of PAHs from low-temperature combustion to high-temperature combustion.The ecotoxicological assessment based on consensus-based sediment quality guidelines implied that potential adverse biological impacts were possible for benzo(ghi)perylenelene and most LMW PAHs.In addition,the total BaP equivalent quotient of seven carcinogenic polycyclic aromatic hydrocarbons (BaA,CHr,BbF,BkF,BaP,DBA and INP) was 106.1 ng/g,according to the toxic equivalency factors.Although there was no great biological impact associated with the HMW PAlls,great attention should be paid to these PAH components based on their rapid increase in the upper sediments.     

Groundwater contamination and natural attenuation capacity at a petroleum spilled facility in Korea

As a remedial option, the natural attenuation capacity of a petroleum contaminated groundwater at a military facility was examined. Hydrogeological conditions, such as high water level, permeable uppermost layer and frequent heavy rainfall, were favorable to natural attenuation at this site. The changes in the concentrations of electron acceptors and donors, as well as the relevant hydrochemical conditions, indicated the occurrence of aerobic respiration, denitrification, iron reduction, manganese reduction and sulfate reduction. The calculated BTEX expressed biodegradation capacity ranged between 20.52 and 33.67 mg/L, which appeared effective for the reduction of the contaminants levels. The contribution of each electron accepting process to the total biodegradation was in the order: denitrification > iron reduction > sulfate reduction > aerobic respiration > manganese reduction. The BTEX and benzene point attenuation rates were 0.0058-0.0064 and 0.0005-0.0032 day^-1, respectively, and the remediation time was 0.7-1.2 and 2.5-30 years, respectively. The BTEX and benzene bulk attenuation rates were 8.69 × 10^-4 and 1.05 × 10^-3 day^-1, respectively, and the remediation times for BTEX and benzene were 7.2 and 17.5 years, respectively. However, most of the natural attenuation occurring in this site can be attributed to dilution and dispersion. Consequently, the biodegradation and natural attenuation capacities were good enough to lower the contaminants levels, but their rates appeared to be insufficient to reach the remediation goal within a reasonable time frame. Therefore, some active remedial measures would be required.     

一株氯苯降解新菌株的分离鉴定及其降解特性研究

采集某净化氯苯废气的生物滴滤床填料表面的生物膜,分离纯化后得到1株能高效降解氯苯的菌株L2,基于菌株生理生化特征、16S rDNA序列系统学分析和Biolog鉴定,可确定该菌株为皮氏罗尔斯顿菌(Ralstonia pickettii),其为新发现的具有氯苯降解性能的菌株.该菌株最佳生长温度和pH分别为30 ℃和7,在最...     

武汉市长江北岸耕地中多环芳烃垂向与纵向分布特征

文章对武汉市长江北岸农用耕地中多环芳烃的含量进行了调查。结果表明除紧靠马路边一个点位的荧蒽浓度高于荷兰制定的土壤修复标准之外,其余各点各类多环芳烃均在此标准值之内;随着点位距污染源越远多环芳烃的含量越来越低;并且多环芳烃在垂直方向上的迁移存在色谱效应。通过分析不同采样点土壤中的多环芳烃含量,分析得出结论汽车尾气所排放的...     

Removal of polycyclic aromatic hydrocarbons from aqueous solution by raw and modified plant residue materials as biosorbents

Removal of polycyclic aromatic hydrocarbons （PAHs）, e.g., naphthalene, acenaphthene, phenanthrene and pyrene, from aqueous solution by raw and modified plant residues was investigated to develop low cost biosorbents for organic pollutant abatement. Bamboo wood, pine wood, pine needles and pine bark were selected as plant residues, and acid hydrolysis was used as an easily modification method. The raw and modified biosorbents were characterized by elemental analysis, Fourier transform infrared spectroscopy and scanning electron microscopy. The sorption isotherms of PAHs to raw biosorbents were apparently linear, and were dominated by a partitioning process. In comparison, the isotherms of the hydrolyzed biosorbents displayed nonlinearity, which was controlled by partitioning and the specific interaction mechanism. The sorpfion kinetic curves of PAHs to the raw and modified plant residues fit well with the pseudo second-order kinetics model. The sorption rates were faster for the raw biosorbents than the corresponding hydrolyzed biosorbents, which was attributed to the latter having more condensed domains （i.e., exposed aromatic core）. By the consumption of the amorphous cellulose component under acid hydrolysis, the sorption capability of the hydrolyzed biosorbents was notably enhanced, i.e., 6-18 fold for phenanthrene, 6-8 fold for naphthalene and pyrene and 5-8 fold for acenaphthene. The sorpfion coefficients （Kd） were negatively correlated with the polarity index [（O＋N）/C], and positively correlated with the aromaticity of the biosorbents. For a given biosorbent, a positive linear correlation between logKoc and logKow for different PAHs was observed. Interestingly, the linear plots of logKoc-logKow were parallel for different biosorbents. These observations suggest that the raw and modified plant residues have great potential as biosorbents to remove PAHs from wastewater.     

滴水湖及其水体交换区沉积物和土壤中PAHs的分布及生态风险评价

采用GC-MS联用技术分析了滴水湖及其水体交换区23个表层沉积物和土壤中16种多环芳烃(PAHs)的含量,探讨其分布特征及来源并对其生态风险进行评价.结果表明,滴水湖沉积物中16种PAHs含量范围是11.49~157.09 ng·g-1,平均含量为66.60 ng·g-1,湖区沉积物中PAHs含量比入湖区低,但比出湖区高.湖区外的沉积物和土壤中PAHs组成主要以中、高分子量PAHs(4环、5~6环)为主,而湖区内表层沉积物中PAHs组成则以低分子量PAHs(2~3环)和高分子量PAHs(5~6环)为主.通过特征化合物分子比值法、主成分分析及多元线性回归模型判源,表明湖区外沉积物和土壤中PAHs来源主要为燃烧源,而湖区内沉积物中PAHs来源为燃烧源和石油类产品泄漏的混合来源.生态风险评价显示,滴水湖及其水体交换区沉积物和土壤中PAHs生态风险较低.     

厌氧水解酸化处理含高浓度聚丙烯酰胺污水

运用厌氧瓶和厌氧折流板反应器(ABR)对含部分水解聚丙烯酰胺(HPAM)的污水进行厌氧水解酸化生物处理.选取PAM-F1和PM-2两株厌氧菌为HPAM降解菌,并优化了单株菌和混合菌的降解条件.结果发现,最佳降解条件为降解9 d,连续活化3次,温度35~40℃,初始pH=7.5.此时,混合菌对500 mg·L-1HPAM污水的降解效果最好,降解率可达到40.69%.通过生理生化特征和16S rDNA分析,确定PAM-F1为红球菌(Rhodococcus sp.).混合菌降解前后的HPAM傅里叶-红外光谱图分析表明,细菌能够降解并利用HPAM的部分胺基和碳作为生长所需的氮源和碳源,并推断出HPAM的降解过程发生在厌氧水解酸化阶段.扫描电镜(SEM)图片显示,ABR中形成了能有效促进HPAM生物降解的颗粒污泥.而经过ABR处理的HPAM污水,CODCr去除率和HPAM降解率可分别达到89.96%和75.48%.研究表明,厌氧水解酸化法是一项能够有效处理含高浓度HPAM污水的技术.