烧结烟气氨-Fe(Ⅱ)NTA法同时脱硫脱硝

研究了烧结烟气氨-络合法同时脱硫脱硝。实验结果表明,氨-络合法可以实现烧结烟气同时脱硫脱硝,脱硫脱硝效率最高可达99%和40%。最佳运行条件为:Fe(NTA)浓度为0.075 mol/L,p H为5~6,停留时间为1.24 s(350 L/h的烟气流量)及55℃运行温度。     

高碘酸钾分光光度法测定电解锰渣中的Mn（Ⅱ）

实验定量研究了存在Ca2＋、Mg2＋和Fe3＋时,应用高碘酸钾分光光度法测定Mn2＋的准确性,旨在探讨应用该方法准确测定电解锰渣中Mn（Ⅱ）的可行性。结果发现Ca2＋浓度超过320 mg/L时,测定过程中会产生大量絮状乳白色沉淀,对Mn2＋的测定结果产生干扰。经过16 h的自然沉降,干扰被彻底消除。Mg2＋在浓度为0~192 mg/L范围内对Mn2＋浓度的测定不产生干扰。同时,Fe3＋的存在对Mn2＋浓度的测定产生灵敏的干扰,使用掩蔽剂氟化钾可以减少Fe3＋的干扰,但却不能彻底消除Fe3＋的干扰。提出了在电解锰行业中,没有彻底地消除Ca（Ⅱ）或Fe（Ⅲ）的干扰因素前,需要更为精确地测定Mn（Ⅱ）的浓度,不建议使用高碘酸钾分光光度法。     

Mg/Fe水滑石吸附水中磷的动力学及热力学研究

以MgCl2和FeCl3为原料通过共沉淀法制备了Mg/Fe水滑石,并对其进行焙烧得到了焙烧态Mg/Fe水滑石。采用X射线衍射(XRD)和傅里叶红外光谱(FTIR)对所得产物进行了结构表征。利用焙烧前后的水滑石作吸附剂吸附处理含磷废水,比较了两者对磷的吸附能力,并在不同温度和pH条件下进行了吸附动力学实验。结果表明,焙烧前后的水滑石对磷都具有很好的吸附能力,但300℃焙烧后水滑石的吸附能力提高了约5%。动力学实验表明,水滑石对磷的吸附可很好地用准二级动力学方程进行描述,其线性相关系数达0.999以上。在15~35℃下进行了等温吸附实验,结果发现水滑石对磷的吸附更符合Langmuir方程。经热力学研究发现,标准吸附焓变(ΔH0)0J/mol、标准吸附自由能(ΔG0)0J/mol和标准吸附熵变(ΔS0)0J/(mol·K),说明水滑石对磷的吸附反应是自发的吸热反应,且是一个熵增加的过程。     

Effects of Mn(II) and Fe(II) on microbial removal of arsenic (III)

Goal, scope, and background  Arsenic contamination in groundwater creates severe health problems in the world. There are many physiochemical and biological methods available for remediation of arsenic from groundwater. Among them, microbial remediation could be taken as one of the least expensive methods, though it takes longer treatment time. The main objective of this research was to study the improvement on remediation by addition of some essential ion salts such as Mn and Fe. Materials and methods   Staphylococcus aureus, Bacillus subtilis, Klebsiella oxytoca, and Escherichia coli were taken as model microbes from Dhulikhel, 30 km east from Kathmandu, Nepal. Results and discussion  Microbes used in this study showed different abilities in their removal of As(III) with and without addition of Mn and Fe salts. The trend of remediation increased with time. S. aureus was found to be the best among the microbes used. It showed almost 100% removal after 48-h culture, both with and without Fe and Mn salts. Rate of removal of As increased with addition of Fe and Mn for all microbes. Removal efficiency was found to increase by about 32% on average after addition of salts in 24-h cultures of S. aureus.     

Iron isotopic fractionation in industrial emissions and urban aerosols

A study on tropospheric aerosols involving Fe particles with an industrial origin is tackled here. Aerosols were collected at the largest exhausts of a major European steel metallurgy plant and around its near urban environment. A combination of bulk and individual particle analysis performed by SEM–EDX provides the chemical composition of Fe-bearing aerosols emitted within the factory process (hematite, magnetite and agglomerates of these oxides with sylvite (KCl), calcite (CaCO₃) and graphite carbon). Fe isotopic compositions of those emissions fall within the range (0.08‰ < δ⁵⁶Fe < +0.80‰) of enriched ores processed by the manufacturer (−0.16‰ < δ⁵⁶Fe < +1.19‰). No significant evolution of Fe fractionation during steelworks processes is observed. At the industrial source, Fe is mainly present as oxide particles, to some extent in 3–4 μm aggregates. In the close urban area, 5 km away from the steel plant, individual particle analysis of collected aerosols presents, in addition to the industrial particle type, aluminosilicates and related natural particles (gypsum, quartz, calcite and reacted sea salt). The Fe isotopic composition (δ⁵⁶Fe = 0.14 ± 0.11‰) measured in the close urban environment of the steel metallurgy plant appears coherent with an external mixing of industrial and continental Fe-containing tropospheric aerosols, as evidenced by individual particle chemical analysis. Our isotopic data provide a first estimation of an anthropogenic source term as part of the study of photochemically promoted dissolution processes and related Fe fractionations in tropospheric aerosols.     

Effects of root anatomy and Fe plaque on arsenic uptake by rice seedlings grown in solution culture

Hydroponic experiments were carried out to investigate the effects of root anatomy, induced by aeration and stagnation, and Fe plaque on arsenic (III&V) uptake and translocation by rice plants. The results showed that As uptake in rice plants (Gui Chao-2) treated by aeration was decreased due to lower root specific surface area. Rice roots with larger specific surface area tended to form more Fe plaque, and Fe plaque affected As uptake kinetics by changing As influx curves from linear to hyperbolic for As(III) and from hyperbolic to S-curve for As(V). Fe plaque increased As(III&V) adsorption and minimized the effects of root anatomy characteristics on As uptake into roots and subsequently translocation to shoots. Fe plaque increased As(III) uptake rate at As(III) concentrations of 0.5∼8 mg L⁻¹, reduced As(V) uptake rate at low As(V) concentrations (<2 mg L⁻¹), but increased As uptake rate at high As(V) concentrations (>6 mg L⁻¹).     

活性炭负载Fe^3＋催化H2O2氧化邻苯二甲酸二甲酯

将Fe3＋负载在活性炭上制得载铁催化剂Fe/AC,并研究了该催化剂对邻苯二甲酸二甲酯（DMP）的催化降解性能。通过正交实验和单因素实验,探讨了催化剂投加量、H2O2投加量、溶液pH值和反应温度对水中DMP降解率的影响,同时对DMP矿化度进行了分析。实验结果表明,制得的载铁催化剂具有较高的催化活性;降解效果的影响顺序是反应温度〉催化剂投加量〉H2O2投加量〉溶液pH值;在反应温度为80℃、催化剂投加量为4 g/L、H2O2投加量为20 mL/L和溶液pH值为3的条件下反应120 min后,质量浓度为10 mg/L的DMP降解率最高可达97.73%;在优化的实验条件下反应150 min,DMP矿化度可达62.73%;催化剂反复使用5次仍具有较好的催化活性,DMP降解率仍可达到77%以上;反应过程中溶液Fe3＋浓度的变化维持在1.07 mg/L左右,且可推测催化降解DMP主要是由非均相和均相催化氧化反应共同作用的。     

Comparison of Diuron degradation by direct UV photolysis and advanced oxidation processes

The rates of Diuron elimination by some advanced oxidation processes (AOPs) such as Fe(III)/UV, Ferrioxalate/UV, Fe(III)/H(2)O(2)/UV, Ferrioxalate/UV/H(2)O(2) and Fe(III)/H(2)O(2) have been compared. Experiments have been conducted at pH=2.3+/-0.1 with a batch reactor equipped with a low-pressure mercury lamp emitting mainly at 253.7nm. Data obtained under the following experimental conditions ([H(2)O(2)](0)=10(-3)M, [Diuron](0)=5x10(-5)M and [Fe(III)](0)=10(-3)M) have shown that rates of Diuron oxidation were higher with the systems Fe(III)/H(2)O(2)/UV and Ferrioxalate/UV/H(2)O(2) than with Fe(III)/UV and Fe(III)/H(2)O(2). On the other hand, Fe(III)/UV was found to be very efficient in mineralization of Diuron solution in comparison to direct UV photolysis. The experimental results showed that radical ()OH is the major pathway in the process of Diuron degradation.     

Contribution of water hyacinth (Eichhornia crassipes (Mart.) Solms) grown under different nutrient conditions to Fe-removal mechanisms in constructed wetlands

Severe contamination of water resources including groundwater with iron (Fe) due to various anthropogenic activities has been a major environmental problem in industrial areas of Sri Lanka. Hence, the use of the obnoxious weed, water hyacinth (Eichhornia crassipes (Mart.) Solms) in constructed wetlands (floating aquatic macrophyte-based plant treatment systems) to phytoremediate Fe-rich wastewaters seems to be an appealing option. Although several studies have documented that hyacinths are good metal-accumulating plants none of these studies have documented the ability of this plant grown under different nutrient conditions to remove heavy metals from wastewaters. This paper, therefore, reports the phytoremediation efficiencies of water hyacinth grown under different nutrient conditions for Fe-rich wastewaters in batch-type constructed wetlands. This study was conducted for 15 weeks after 1-week acclimatization by culturing young water hyacinth plants (average height of 20+/-2cm) in 590L capacity fiberglass tanks under different nutrient concentrations of 1-fold [28 and 7.7mg/L of total nitrogen (TN) and total phosphorous (TP), respectively], 2-fold, 1/2-fold, 1/4-fold and 1/8-fold with synthetic wastewaters containing 9.27Femg/L. Another set-up of hyacinths containing only Fe as a heavy metal but without any nutrients (i.e., 0-fold) was also studied. A mass balance was carried out to investigate the phytoremediation efficiencies and to determine the different mechanisms governing Fe removal from the wastewaters. Fe removal was largely due to phytoremediation mainly through the process of rhizofiltration and chemical precipitation of Fe2O3 and FeOH3 followed by flocculation and sedimentation. However, chemical precipitation was more significant especially during the first 3 weeks of the study. Plants grown in the 0-fold set-up showed the highest phytoremediation efficiency of 47% during optimum growth at the 6th week with a highest accumulation of 6707Femg/kg dry weight. Active effluxing of Fe back to the wastewater at intermittent periods and with time was a key mechanism of avoiding Fe phytotoxicity in water hyacinth cultured in all set-ups. Our study elucidated that water hyacinth grown under nutrient-poor conditions are ideal to remove Fe from wastewaters with a hydraulic retention time of approximately 6 weeks.     

Catalytic reductive dechlorination of p–chlorophenol in water using Ni/Fe nanoscale particles

Nanoscale bimetallic Ni/Fe particles were synthesized from the reaction of sodium borohydride （NaBH4） with reduction of Ni^2＋ and Fe^2＋ in aqueous solution. The obtained Ni/Fe particles were characterized by TEM （transmission electron microscope）, XRD （X-ray diffractometer）, and N2-BET. The dechlorination activity of the Ni/Fe was investigated using p-chlorophenol （p-CP） as a probe agent. Results demonstrated that the nanoscale Ni/Fe could effectively dechlorinate p-CP at relatively low metal to solution ratio of 0.4 g/L （Ni 5 wt%）. The target with initial concentration ofp-CP 0.625 mmol/L was dechlorinted completely in 60 rain under ambient temperature and pressure. Factors affecting dechlorination efficiency, including reaction temperature, pH, Ni loading percentage over Fe, and metal to solution ratio, were investigated. The possible mechanism of dechlorination ofp-CP was proposed and discussed. The pseudo-first- order reaction took place on the surface of the Ni/Fe bimetallic particles, and the activation energy of the dechlorination reaction was determined to be 21.2 kJ/mol at the temperature rang of 287-313 K.