云桌面终端电源端传导骚扰和辐射骚扰整改案例

某云桌面终端在进行中国强制性认证(CCC)时,电磁兼容试验项目电源端传导骚扰、辐射骚扰测试均出现超标现象。将重点从PCB板级电路EMC设计方面剖析其测试不合格原因,并给出相应的整改措施,最后对此案例进行总结,给出类似电子产品在PCB设计时的注意事项,以期能给PCB设计工程师提供一些参考意见。     

人工生物蓄水过滤系统对雨水的滞留与过滤功效

通过人工构建3个不同沙土配比的生物蓄水过滤系统,对人工系统滞留雨水时间和净化雨水的功效进行了研究。首先,根据自然降雨特点将雨水地表径流按照不同水量与进水时间引入系统,然后测定系统出水水量、时间、水质以及土壤湿度,比较植物层和整个系统滞留雨水径流的效果以及系统过滤雨水的功效。结果表明,(1)人工生物蓄水过滤系统有显著的滞留雨水的作用。其中植物层滞留雨水时间4.72~11.50 h,整个系统滞留雨水时间为5.17~13.80 h,人工系统比植物层滞留雨水时间显著延长,且进水量越大,差异越显著。(2)系统出水流速平缓,蒸发与植物蒸腾耗水量比例低于6%;壤土含量越高,滞留雨水时间越长。(3)经系统过滤,系统出水酸碱度平均增加0.81,氨氮含量平均降低0.42 mg/L。     

AF+BAF深度处理PCB生产废水的试验研究

针对PCB废水难降解及含重金属铜的特点,在经过一系列的物化处理的基础上,采用AF+BAF组合工艺对其进行深度处理。试验研究中,通过控制污水在反应器中的停留时间,使得废水在AF中水解酸化,以增加废水的可生化性,在此基础上利用BAF的生物膜来去除污水中剩余的有机物。试验结果表明,试验系统对PCB废水中的COD、Cu2+去除效果良好,出水COD、Cu2+的含量分别稳定在10~50mg/L和0.02~0.1mg/L,达到排放标准。     

水力停留时间对膜生物反应器复合工艺污水处理特性的影响

开发了厌氧-多级好氧/缺氧-膜生物反应器复合工艺,在不同水力停留时间(HRT)下,考察了系统对污染物去除效果及其膜污染的特性.结果表明,在试验选定的HRT范围内,系统对TN和TP的去除率随着HRT的降低而升高,当HRT为8.70、6.96、4.97 h时,系统对TN和TP的平均去除率分别为73.15%、79.76%、81.98%和67.79%、80.99%、92.16%.但是,较低HRT条件下膜通量较高,会加剧膜污染进程.解决这一问题的措施是增加膜组件个数,从而在不提高膜通量的情况下使系统保持较低的HRT,保证系统高效稳定的污染物去除效果.     

Modelling Phosphorus Retention in Lakes and Reservoirs

Steady-state models for the prediction of P retention coefficient (R) in lakes were evaluated using data from 93 natural lakes and 119 reservoirs situated in the temperate zone. Most of the already existing models predicted R relatively successfully in lakes while it was seriously under-estimated in reservoirs. A statistical analysis indicated the main causes of differences in R between lakes and reservoirs: (a) distinct relationships between P sedimentation coefficient, depth, and water residence time; (b) existence of significant inflow–outflow P concentration gradients in reservoirs. Two new models of different complexity were developed for estimating R in reservoirs: , where τ is water residence time (year), was derived from the Vollenweider/Larsen and Mercier model by adding a calibrated parameter accounting for spatial P non-homogeneity in the water body, and is applicable for reservoirs but not lakes, and , where [P_in] is volume-weighted P concentration in all inputs to the water body (μg l⁻¹), was obtained by re-calibrating the OECD general equation, and is generally applicable for both lakes and reservoirs. These optimised models yield unbiased estimates over a large range of reservoir types.     

运用QSPR预测有机磷农药的色谱保留值

通过计算43种有机磷农药的各种结构参数,运用多元线性回归分析方法比较了适用于有机磷农药色谱保留值的定量关系表达式,建立了有机磷农药结构参数对色谱保留值的QSPR模型.模型分析表明:磷酸酯与硫逐磷酸酯两类有机磷农药的模型非交叉验证相关系数R2分别为0.991和0.998,标准误差SE分别为0.0539和0.2874,交叉验证相关系数Q2分别为0.976和0.990,标准偏差Scv分别为0.086和0.610.在已知磷酸酯与硫逐磷酸酯两类有机磷农药结构参数的情况下,此模型可有助于有机磷农药的色谱分析.     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

HRT对固定床厌氧反应器运行效果的影响

为了考察水力停留时间(HRT)对炭纤维载体固定床厌氧反应器运行效果的影响,在进水COD分别为20 000~25 000 mg/L和40 000~45 000 mg/L2个浓度范围下,研究了不同HRT对反应器运行效果的影响。结果表明,通过HRT的调整,在达到相同有机负荷(OLR)下,进水COD为20 000~25 000 mg/L的COD去除率和产气量,明显比进水COD为40 000~45 000 mg/L的运行效果好;进水COD为20 000~25 000 mg/L,HRT为14 h,相应的OLR为41.09 kgCOD/(m3.d)时,COD去除率仍然维持在68%以上,沼气容积产气率达到14.55 m3/(m3.d)。炭纤维载体固定床厌氧反应器具有较高的COD去除率、产气效率以及抵抗低pH、高负荷冲击的能力,运行过程中没有发生反应器堵塞的现象。     

Dioxins, PCBs, and HCB in soil and peat profiles from a pristine boreal catchment

The aim of this study was to explore how atmospherically derived soil pollution is affected by environmental processes at two typical boreal catchment landscape type settings: wetlands and forested areas. Measurements of hydrophobic organic compounds (HOCs) in forest soil and peat from an oligotrophic mire at various depths were performed at a remote boreal catchment in northern Sweden. HOCs in peat were evenly distributed throughout the body of the mire while levels of HOCs in the forest soil increased with increased amount of organic matter. Evaluation of HOC composition by principal component analysis (PCA) showed distinct differences between surface soils and deeper soil and peat samples. This was attributed to vertical transport, degradation and/or shifting sources over time. The calculated net vertical transport differed between surface layers (0.3%) and deeper soils (8.0%), suggesting that vertical transport conditions and processes differ in the deeper layers compared to the surface layers.