Evaluation of the field dissipation of fungicides and insecticides used on fruit bearing trees in northern Italy

The dissipation of the fungicides captan, cyprodinil, fludioxonil, dithianon, and tebuconazole and of the insecticides chlorpyrifos, fenitrothion, and malathion was studied, following a single treatment of different cultivars of pears, apples, and peaches. The study was conducted in northern Italy, over two successive growing seasons (2004 and 2005). The treatments were performed by the farmers involved, in line with their usual practice. At various time intervals from treatment to harvest, representative samples of fruit were collected and analyzed for pesticide residues. In some cases, concentrations lower than the maximum residue levels (MRLs) were found immediately after treatment. In all trials a rapid decline in pesticide concentrations was observed leading to residues at harvest greatly below the MRLs.     

The effect of soil:water ratios on the induction of isoproturon, cypermethrin and diazinon mineralisation

The rate of pesticide biodegradation does not remain constant with time, and is dependent on the physico-chemical properties of the soil and of the pesticide as well as on the biology of the soil. Prolonged or repeated contact between soil microbes and pesticides has been shown to result in an increase in the rate and extent of biodegradation. This work assessed the impact of the soil:water ratio on measurement of catabolic induction for ¹⁴C-isoproturon, ¹⁴C-diazinon and ¹⁴C-cypermethrin. Slurrying (1:1 and 1:3 soil:water) with agitation resulted in significantly higher rates and extents of mineralisation than the non-slurried system (P ? 0.05; 1:0 soil:water), except for the mineralisation of ¹⁴C-diazinon where the greatest extent of mineralisation occurred in non-slurried soil. Slurrying without agitation resulted in the significant lower mineralisation in all cases (P ? 0.05). There was a significant interaction between the soil:water ratio and length of contact (P ? 0.05). Whilst the use of slurried systems can enhance the extent and rate of mineralisation, there is no improvement in reproducibility, and so for the measurement of catabolic induction, the use of field conditions will lead to a more environmentally relevant measurement.     

Determination of chloramphenicol, enrofloxacin and 29 pesticides residues in bovine milk by liquid chromatography-tandem mass spectrometry

A sensitive method for determination of chloramphenicol, enrofloxacin and 29 pesticides residues in bovine milk by high-performance liquid chromatography-tandem mass spectrometry (HPLC-MS/MS) was developed. Residues of the targets were extracted from milk with acetonitrile, cleaned up by C₁₈-SPE cartridge, and then determined by HPLC-MS/MS. The MS detection was operated in positive or negative ionization mode, depending on the compounds. For confirmation of each target compound, two precursor ion > product ion transitions were selected by multi-reaction monitoring mode (MRM). The method showed good linearity for all the tested compounds over the studied concentration range with correlation coefficient higher than 0.9910. Recoveries for the studied compounds at three spiked levels (0.05, 0.10, 0.19 mg kg⁻¹) in bovine milk were in the range of 71-107% with RSDs not larger than 13.7%, except that recoveries of trifluralin ranged between 62% and 70% at the spiked levels. Limits of quantitation for the analytes were estimated to range between 0.03 × 10⁻³ and 14.5 × 10⁻³ mg kg⁻¹. The proposed method was applied for the determination of the analytes residues in real samples. The found levels of the analytes in milk samples were lower than maximum residues levels (MRL).     

Effects of salinity, DOM and metals on the fate and microbial toxicology of propetamphos formulations in river and estuarine sediment

Toxicity studies tend to use pure pesticides with single organisms. However, natural systems are complex and biological communities diverse. The organophosphate pesticide propetamphos (PPT) has been found exceeding regulatory limits (100 ng L⁻¹) in rivers. We address whether solution properties affect the fate of Analar (Analar-PPT) or industrial PPT (PPT-Ind) propetamphos formulations and whether propetamphos and metal toxicant effects are additive, antagonistic or synergistic? The sorption, desorption, biodegradation and microbial toxicology of Analar-PPT and PPT-Ind were investigated in Conwy River and estuary sediment. Results showed elevated salinity enhanced PPT sorption, while higher salinities increased PPT-Ind retention. Higher dissolved organic matter (DOM) and low salinity slowed Analar-PPT biodegradation (1.9 × 10⁻³ h⁻¹). Analar-PPT and PPT-Ind biodegradation was further reduced by low salinity, high DOM and dissolved Zn and Pb (6.3 × 10⁻⁴ h⁻¹, 1100 h t_½ for Analar-PPT; 7.5 × 10⁻⁴ h⁻¹, 924 h t_½ for PPT-Ind). Toxicity effects of PPT, Zn and Pb in equitoxic ratio were higher for PPT-Ind (4.7 μg PPT-Ind g⁻¹; 581 μg Zn g⁻¹; 395 μg Pb g⁻¹) than for Analar-PPT (34.6 μg PPT g⁻¹; 312 μg Zn g⁻¹; 212 μg Pb g⁻¹) whilst a toxicant ratio 1:100:10 suggested small quantities of Analar-PPT (EC₁₀ = 0.06 μg g⁻¹) affected microbial communities. The combined toxicity effect was more than additive. Thus, industrial formulations and pollutant mixtures should be considered when assessing environmental toxicity.     

Response of diazotrophic cyanobacterium Nostoc carneum under pesticide and UV-B stress

A study was under taken, under controlled laboratory conditions, to investigate the influence of non-ionizing radiation (UV-B) and an organochlorine pesticide on the growth, photosynthetic pigments, protein content and DCPIP photoreduction of a cyanobacterium Nostoc carneum. Test algae was isolated from rice field soils of Sambalpur, Western Orissa, India and grown in nitrogen free BG 11 culture medium. Culture of algae from log phase of growth was treated with 5 ppm of the insecticide, Endodhan and UV-B (20 mW m⁻²) for 2 h daily, separately and in combination of insecticide and UV-B radiation. Algal samples treated with UV-B and pesticide separately showed distinct inhibitory effects on growth, pigments, protein content and DCPIP reduction of the test samples. However, when pesticide treated samples were subjected to UV-B exposure, the effect showed additive as well as synergetic effect. Experiment conducted to check the ability of the organism to recover from the stress, exposed for various time periods, suggest their ability to partially recover from the stress.     

Accumulation levels and characteristics of some pesticides in human adipose tissue samples from Southeast China

This paper presents a comprehensive study of pesticide levels and bio-accumulation characteristics in human adipose tissues among residents of Southeast China. A large number of adipose samples (n = 633) were selected for 58 pesticides and were analyzed by high sensitive Gas Chromatography-Tandem Mass Spectrometry (GC-MS/MS). The results showed that POPs pesticides were frequently detected, including 2,4′-DDD, 2,4′-DDE, 2,4′-DDT, 4,4′-DDD, 4,4′-DDE, 4,4′-DDT, α-HCH, β-HCH, γ-HCH, δ-HCH, hexachlorobenzene (HCB), and mirex. Other detected pesticide species were dicofol, methamidophos and chlordimeform, which have rarely been reported. Comparing to different countries, the concentrations of total DDT and HCH in these three Chinese southeastern sites were in the middle range, whereas the HCB and mirex were in the lower end. A significant correlation was observed between region as well as age and POPs pesticide levels. Some pesticide residue levels were also found significantly correlated to occupation. However, there was no significant correlation between gender and pesticides. Meanwhile, it is interesting to find that mortality of malignant tumors tends to associate with the pesticides levels in human adipose tissue. More importantly, the measured data presented in this study provide realistic information which is useful for assessing human exposure to pesticides in the general population of Southeast China.     

The Costs of Meeting the Environmental Objectives for the Baltic Sea: A Review of the Literature

The environmental targets of the recently agreed Baltic Sea Action Plan (BSAP) targets are likely associated with a considerable cost, which motivates a search for low-cost policies. The following review shows there is a substantial literature on cost-efficient nutrient reduction strategies, including suggestions regarding low-cost abatement, but actual policies at international and national scale tend to be considerably more expensive due to lack of instruments that ensure a cost-efficient allocation of abatement across countries and sectors. Economic research on the costs of reducing hazardous substances and oil spill damages in the Baltic Sea is not available, but lessons from the international literature suggest that resources could be used more efficiently if appropriate analysis is undertaken. Common to these pollution problems is the need to ensure that all countries in the region are provided with positive incentives to implement international agreements.     

Recent developments of safer formulations of agrochemicals

The primary objectives of formulation technology are to optimise the biological activity of the pesticide, and to give a product which is safe and convenient for use. However, because of the wide variety of pesticide active ingredients which are available, many different types of formulations have been developed depending mainly on the physico-chemical properties of the active ingredients. In the past most formulations were based on simple solutions in water (SL), emulsifiable concentrates in a petroleum-based solvent (EC), or dusts (DP) and wettable powders (WP). The presence of petroleum-based solvents in EC formulations and dusty powders in DP and WP formulations can lead to safety hazards in use and a negative impact on the envirnoment generally. Most government and regulatory authorities are now demanding formulations which are cleaner and safer for the user, have minimal impact on the environment, and can be applied at the lowest dose rate. Developments in formulation technology and novel formulation types, sometimes in special packaging such as water-soluble packs, can also give products a competitive advantage, add value or extend the lif-cycle of active ingredients. There is also a demand from government authorities and consumer groups to use safer formulation additives and adjuvants, and to minimise the residues of pesticides on food crops after spraying. All of these aspects are putting increasing pressure on the development of improved formulation and adjuvant technologies. Pesticide formulations for spray application and for seed treatment are discussed, along with developments in bioenchancement.     

Spray optimization through application and liquid physical property variables–I

One of the most important considerations when optimizing a spray application for maximum efficacy and minimum drift is the selection of the optimum droplet size spectrum (Hewitt, A. J., 1997. The importance of droplet size in agricultural spraying. Atomization and Sprays, 7(3), 235–244). Applicators are faced with an extensive selection of nozzle types, tank mixes and adjuvants. The present paper discusses the way that the tank mix and application variables interact to produce specific spray characteristics of droplet size spectrum, coverage and performance in total spray efficiency. Experimental data investigating the effects of liquid physical properties such as dynamic surface tension, shear and extensional viscosity are described. Spray formation from emulsions, surfactants and oils is also discussed. Atomization studies conducted in wind tunnels using a wide range of atomizer and nozzle types under different operating conditions are discussed. Empirical models for predicting atomization and drift of sprays are described with emphasis on their development and practical use for spray optimization.