白银矿区土壤重金属及可培养细菌重金属耐受性研究

对白银矿区土壤重金属进行分析研究,分离、筛选和鉴定了受污染土壤中的可培养细菌,并考察其对土壤中重金属胁迫的耐受性。结果表明：白银矿区王岘镇尾渣堆和东大沟河沟土壤重金属污染Pb＞Zn＞Cu;从污染最严重的土壤中分离、筛选出砖红色微杆菌（Microbacterium testaceum）、特基拉芽孢杆菌（Bacillus tequilensis）和解单端孢菌素微杆菌（Microbacterium trichothecenolyticum）3种细菌,其中菌株M1（Microbacterium testaceum）对Pb、Zn、Cu、Cd的胁迫具有明显的耐受性。     

北京市某废弃焦化厂不同车间土壤中多环芳烃（PAHs）的分布特征及风险评价

以北京市某废弃焦化厂为研究对象,系统采集了6个车间0～4m深的26个土壤样本,利用GC/MS检测了U.S.EPA优控的16种多环芳烃(PAHs)的含量,分析了PAHs在焦化厂不同车间表层土壤的污染状况和深层土壤中的垂直分布特征并对土壤污染风险进行了评估.结果表明,1)该废弃焦化厂不同车间表层土壤(0～20cm)总PAHs(∑PAHs)的残留量介于672.8～144814.3ng·g-1之间;污染程度排序为:回收车间>老粗苯车间>焦油车间>炼焦车间>水处理车间>制气车间.2)该厂未受扰动的土壤样品显示PAHs主要聚集在表层土壤,并随着土壤深度的增加而迅速减少;其他样点由于土壤扰动,∑PAHs含量最大值出现在第三层土壤(80～180cm);该厂4m深底层土壤仍有高浓度PAHs,∑PAHs含量最高值出现在炼焦车间,达12953.1ng·g-1.3)焦化厂土壤PAHs污染主要集中在3环和4环的PAHs单体上,分别占到污染总量的51.3%和31.7%.4)根据Maliszewska-Kordybach的PAHs总量标准及加拿大土壤PAHs单体治理标准,该厂回收、老粗苯、焦油和炼焦车间表层和深层土壤PAHs含量均达到重污染水平,并对其周围土地带来较大风险,需要治理.     

Retrospective Estimation of Radiation Load and Its Effect on Some Biological Parameters of Reindeer (Rangifer tarandus) from Wrangel Island

The results of the electron paramagnetic resonance (EPR) analysis of pure tooth enamel and the data on the radionuclide content in bones were used for estimating the radiation load on reindeer that lived on Wrangel Island in the 1970s and early 1980s. Based on the measurements of the lower jaws, some biological parameters of the Wrangel reindeer population were estimated and compared with those in the Novaya Zemlya and Taimyr populations. Changes in only two of these parameters—the degree of root cementum resorption and animal life span–might be attributed to the effect of the radiation load.     

4种重金属污染对稻田土反硝化细菌的影响

在实验室条件下,研究Cd²⁺、As⁵⁺、Cu²⁺和Pb²⁺处理黄松稻田土、紫色稻田土和红壤稻田土后,4周内重金属污染对反硝化细菌种群数量及其反硝化活性的影响.结果表明,在1kg干土中加入0.5mg Cd²⁺、30mg As⁵⁺、50mg Cu²⁺和200mg Pb²⁺时,对稻田土反硝化细菌种群数量及其活性有促进作用,加入Cd²⁺、As⁵⁺、Cu²⁺和Pb²⁺分别超过1.0,60,500,400mg/kg干土时,对稻田土反硝化细菌种群数量及其活性有明显抑制作用.但反硝化细菌种群数量及其活性能逐渐恢复并接近对照水平,重金属污染越重,恢复所需的时间也越长.同一种重金属元素对不同水稻田土的反硝化细菌种群数量及其活性的影响也有差异.     

In situ sequential treatment of a mixed contaminant plume

Groundwater plumes often contain a mixture of contaminants that cannot easily be remediated in situ using a single technology. The purpose of this research was to evaluate an in situ treatment sequence for the control of a mixed organic plume (chlorinated ethenes and petroleum hydrocarbons) within a Funnel-and-Gate. A shallow plume located in the unconfined aquifer at Alameda Point, CA, was found to contain up to 218,000 μg/l of cis-1,2 dichloroethene (cDCE), 16,000 μg/l of vinyl chloride (VC) and <1000 μg/l of 1,1 dichloroethene (1,1 DCE), trans-1,2 dichloroethene (trans-1,2 DCE) and trichloroethene (TCE). Total benzene, toluene, ethylbenzene and xylenes (BTEX) concentrations were <10,000 μg/l. Contaminated groundwater was funneled into a gate, 3.0 m wide, 4.5 m long and 6.0 m deep (keyed into the underlying aquitard) where treatment occurred. The initial gate segment consisted of granular iron, for the reductive dechlorination of the higher chlorinated ethenes. The second segment, the biosparge zone, promoted aerobic biodegradation of petroleum hydrocarbons and any remaining lesser-chlorinated compounds, stimulated by dissolved oxygen (DO) and carbon dioxide (CO₂) additions via an in situ sparge system (CO₂ was used to neutralize the high pH produced from reactions in the iron wall). Groundwater was drawn through the gate by pumping two wells located at the sealed, downgradient, end. Over a 4-month period an estimated 1350 g of cDCE flowed into the treatment gate and the iron wall removed 1230 g, or 91% of the mass. The influent mass of VC was 572 g and the iron wall removed 535 g, corresponding to 94% mass removal. The other chlorinated ethenes had significantly lower influent masses (3 to 108 g) and the iron wall removed the majority of the mass resulting in >96% mass removal for any of the compounds. In spite of these high removal percentages, laboratory column tests indicated that at these levels of chlorinated contaminants, surface saturation of the iron grains likely contributed to lower than expected reaction rates. In the biosparge zone, mass removal of cDCE appeared to occur predominantly by biodegradation (65%) with volatilization (35%) being an important secondary process. The dominant removal process for VC was volatilization (70%) although significant biodegradation was also indicated (30%). Laboratory microcosm results confirmed the potential for aerobic biodegradation of cDCE and VC. When average influent field concentrations for cDCE and VC were 220,000 and 46,000 μg/l, respectively, the sequential treatment unit removed 99.6% of the total mass and when the influent concentrations decreased to 26,000 and 19,000 μg/l for cDCE and VC, respectively, >99.9% removal within the treatment gate was attained. BTEX compounds were found to be significantly retarded in the iron treatment zone. Although they did eventually break through the granular iron, and into the gravel transition zone, none of these compounds was detected in the biosparge zone. No noticeable interferences between the anaerobic (reductive) and aerobic parts of the system occurred during testing. The results of this experiment show that in situ treatment sequences are viable, although further work is needed to optimize performance.     

Application of arsenic baselines in the assessment of soil contamination in Finland

In Finland, a new Government Decree on the Assessment of Soil Contamination and Remediation Needs (214/2007) came into force on 1 June 2007. According to the Decree, natural baseline concentration levels should be taken into account when assessing potential soil contamination and the need for remediation. This applies particularly in the case of toxic metallic elements, since baseline concentrations may naturally be rather high. The new decree prescribes soil screening values for 52 substances or groups of substances. The natural baseline concentrations have been taken into account in the definition of the screening values for inorganic pollutants. The Geological Survey of Finland (GTK) carried out a nation-wide geochemical mapping of till on a reconnaissance scale in 1983 and on a regional scale during 1984–1992. These surveys have provided information on natural elemental distribution in subsoils of the glacial till. However, some important trace elements in regional mapping such as arsenic are missing from the analysis, and subsoil samples do not reflect the diffuse anthropogenic input. Thus, GTK has continued the survey work by determining geochemical baselines around suburban areas. Samples have been taken from humus, topsoil and subsoil layers, and the soil parent material has covered sandy soils, glacial tills and fine-grained sediments. According to the studies, a regional difference in the levels of arsenic and some other trace elements can be clearly seen, especially in minerogenic soils. The results illustrate the importance of information on regional baseline concentrations while assessing potential soil contamination.     

Health risks of heavy metals in contaminated soils and food crops irrigated with wastewater in Beijing, China

Consumption of food crops contaminated with heavy metals is a major food chain route for human exposure. We studied the health risks of heavy metals in contaminated food crops irrigated with wastewater. Results indicate that there is a substantial buildup of heavy metals in wastewater-irrigated soils, collected from Beijing, China. Heavy metal concentrations in plants grown in wastewater-irrigated soils were significantly higher (P相似文献   

Microbial degradation of the benzonitrile herbicides dichlobenil, bromoxynil and ioxynil in soil and subsurface environments--insights into degradation pathways, persistent metabolites and involved degrader organisms

The benzonitriles dichlobenil, bromoxynil and ioxynil are important broad-spectrum or selective herbicides used in agriculture, orchards and public areas worldwide. The dichlobenil metabolite 2,6-dichlorobenzamide is the most frequently encountered groundwater contaminant in Denmark, which suggests that the environmental fate of these three structurally related benzonitrile herbicides should be addressed in detail. This review summarises the current knowledge on microbial degradation of dichlobenil, bromoxynil and ioxynil with particular focus on common features of degradation rates and pathways, accumulation of persistent metabolites and diversity of the involved degrader organisms.     

重金属污染土壤接种丛枝菌根真菌对蚕豆毒性的影响

采用盆栽实验的方法,研究了重金属(包括Cu、Zn、Pb和Cd)复合污染和接种丛枝菌根真菌(arbuscular mycorrhizal fungi,AMF)Glomus mosseae对蚕豆(Vicia faba)生长及DNA损伤的影响.结果表明,虽然接种菌根真菌对蚕豆生物量的影响并不显著,但是却显著影响植物对重金属的吸收,接种菌根真菌对蚕豆吸收4种重金属元素的作用有差异.采用单细胞凝胶电泳(single cell gel electrophoresis,SCGE)法研究接种菌根真菌对蚕豆叶片的DNA损伤的影响,与重金属吸收的结果相吻合.结果表明,接种处理可显著增加蚕豆叶片的DNA损伤程度,这与接种处理可提高植物的重金属吸收相一致.     

Risk assessment and prioritisation of contaminated sites on the catchment scale

Contaminated sites pose a significant threat to groundwater resources worldwide. Due to limited available resources a risk-based prioritisation of the remediation efforts is essential. Existing risk assessment tools are unsuitable for this purpose, because they consider each contaminated site separately and on a local scale, which makes it difficult to compare the impact from different sites. Hence a modelling tool for risk assessment of contaminated sites on the catchment scale has been developed. The CatchRisk screening tool evaluates the risk associated with each site in terms of its ability to contaminate abstracted groundwater in the catchment. The tool considers both the local scale and the catchment scale. At the local scale, a flexible, site specific leaching model that can be adjusted to the actual data availability is used to estimate the mass flux over time from identified sites. At the catchment scale, a transport model that utilises the source flux and a groundwater model covering the catchment is used to estimate the transient impact on the supply well. The CatchRisk model was tested on a groundwater catchment for a waterworks north of Copenhagen, Denmark. Even though data scarcity limited the application of the model, the sites that most likely caused the observed contamination at the waterworks were identified. The method was found to be valuable as a basis for prioritising point sources according to their impact on groundwater quality. The tool can also be used as a framework for testing hypotheses on the origin of contamination in the catchment and for identification of unknown contaminant sources.