Effects of Cu（Ⅱ） and humic acid on atrazine photodegradation

This work was designed to explore the characteristics of photodegradation of herbicides in the copper-polluted water body. The results showed that Cu(II) alone could induce a photo Fenton-like reaction to enhance the degradation of atrazine, in which hydroxyl radical ( OH) was a main active species. Humic acids restrained atrazine degradation, nevertheless, when introducing Cu(II), the photodegradation was accelerated, in which singlet oxygen (1O2) replaced OH acting as the prevailing species. A feasible mechanism for the photochemical process was also proposed, which is helpful for better understanding the environmental photochemistry of atrazine in the copper-polluted water.     

Modification of Ce02-ZrO2 catalyst by potassium for NOx-assisted soot oxidation

Potassium-modified ceria-zirconia catalyst was synthesized by wetness impregnation method. The ageing treatment was performed in static air at 800℃ for 20 hr to evaluate the thermal stability of the catalyst. The catalysts were characterized by X-ray diffraction,BET surface area, oxygen storage capacity, NOx-temperature programmed desorption and soot-temperature programmed oxidation measurements. By introduction of potassium, the maximum soot oxidation rate temperature (Tm) of the ceria-zirconia based catalyst decreased from 525 to 428℃ in the presence of NO under a loose contact mode. The shift of Tm of the K-modified catalyst after ageing is only 15℃. The enhanced activity of the aged catalyst mainly lies in the promotional effect of potassium on the NOx/oxygen storage cacity as well as the soot-catalyst contact.     

好氧颗粒污泥处理青霉素废水研究

青霉素在其生产过中产生大量的废水,其COD值较高,生化性较差,成分复杂,微生物难以降解,其处理技术是世界性难题。文章采用以葡萄糖模拟废水培养的好氧颗粒污泥为接种体,经青霉素废水逐步驯化后,使其完全处理青霉素废水。实验结果表明,应用好氧颗粒污泥技术,处理青霉素废水,COD,NH3_N,TP去除率较高,具有很好的处理效果。     

五日生化需氧量测定的影响因素

五日生化需氧量是一种表间接表示水体中有机物含量,是水质监测的一个重要参数。本文对水样的保存、溶解氧、pH值、温度、接种稀释水和稀释度等影响测定五日生化需氧量成败的因素进行探讨,并提出相应的解决方法。     

V2O5/TiO2催化剂脱除NO的研究

采用了等体积浸渍法制备二氧化钛负载钒氧化物催化剂（V2O5/TiO2）,研究了V2O5负载量、反应温度、烟气流量、氨氮比以及运行时间各因素对NH3选择性催化还原NO反应（SCR）效率的影响.研究结果表明：经过500℃温度下煅烧,烟气流量为200ml/min,负载量为7wt％的V2O5/TiO2催化剂,在400℃温度下反应,NO脱除率可达70.5％.     

Vibrational energy loss analysis in battery tab ultrasonic welding

In ultrasonic metal welding processes, high-frequency ultrasonic energy is used to generate friction and heat at the interface between weld parts to produce solid-state bonds. It has been observed that sufficient energy is required to produce proper bonding, while excessive energy can cause such quality issues as weld fracture and perforation. Therefore, it is important to have a product/process design in ultrasonic welding to ensure efficient energy conversion from ultrasonics to welding energy, minimizing energy loss in the process. In this work, vibrational energy loss associated with the longitudinal and flexural vibrations of the Cu coupon during ultrasonic welding is studied by applying one-dimensional continuous vibration models. To facilitate our modeling, experimental results from the free response of Cu coupon were obtained to determine the damping characteristics of the Cu coupon in the welding process. Our analysis shows that substantial energy loss can occur during welding due to the flexural vibration of the Cu coupon, especially when the overhang (the upper part of the Cu coupon extended from the anvil) of the Cu coupon resonates at or close to the welding frequency (about 20 kHz), degrading the weld quality of battery tabs. This study contributes to understanding the fundamental dynamics of the Cu coupon during ultrasonic welding and its impact on weld quality.     

千岛湖溶解氧的动态分布特征及其影响因素分析

基于2011~2012年1~12月千岛湖6个站点的溶解氧浓度实时监测数据,分析了千岛湖溶解氧的垂直分布以及时空分布特征,并探讨了影响水体溶解氧动态分布特征的影响因子.结果表明,溶解氧分布特征有明显的垂向差异以及季节差异.冬季,平均溶解氧值较高,除大坝前站点,其余各站点溶解氧无显著垂向差异;夏季,溶解氧垂向差异显著大于春秋两季.水深较深的小金山、三潭岛和大坝前站点其夏季溶解氧最大值出现在真光层,分别达到11.59、12.52和10.96 mg·L-1.千岛湖表层溶解氧最大值出现在春季,而最小值出现在秋季.相关性分析结果表明,溶解氧与水温、pH、叶绿素a浓度的相关性存在季节性差异.夏季,水温与溶解氧存在极其显著的线性相关,温度热力分层是影响溶解氧在夏季垂直分布的关键因素.春夏季,pH、叶绿素a浓度与溶解氧的相关系数较高,主要与浮游植物光合作用有关.     

胞外聚合物磷酸盐形态对生物除磷过程的影响研究

以不同DO条件下污泥龄(SRT)分别为10 d和30 d的两组实验室A/O-SBR反应器活性污泥为研究对象,探讨了胞外聚合物(EPS)磷酸盐形态对生物除磷过程的影响.结果表明,污泥絮体中的磷主要分布于EPS中,PO3-4-P和聚磷酸盐(Poly-P,包括低分子量聚磷酸盐LMW PolyP和高分子量聚磷酸盐HMW Poly-P)是EPS磷的主要形态;EPS对生物除磷的影响明显大于细菌细胞,EPS磷的厌氧降低量和好氧升高量为胞内磷变化量的2.8~6.4倍.EPS中的LMW Poly-P和HMW Poly-P含量均表现厌氧降低和好氧升高的变化规律;对于相同SRT的污泥,中DO(2.5~3.5 mg·L-1)条件较低DO(0.7~1.0 mg·L-1)条件下EPS的LMW Poly-P和HMW Poly-P有更大的厌氧降低量和好氧升高量,对应着更明显的生物除磷过程,说明EPS不仅是生物除磷过程的中转站,而且参与了生物聚磷过程.     

紫色丘陵区不同弃土弃渣下垫面入渗特征及影响因素

采用环刀法研究了紫色丘陵区不同碎石含量弃土弃渣下垫面的入渗特征及影响因素.结果表明,不同弃土弃渣下垫面入渗性能随碎石含量的增加而差异显著,其中,碎石含量为40%的弃土弃渣下垫面初始入渗率、稳定入渗率及平均入渗率分别是土质弃渣下垫面的1.30、1.13和1.54倍.不同下垫面初始入渗率和稳定入渗率与弃渣初始含水率、容重呈显著负相关,与下垫面总孔隙度、非毛管孔隙度呈显著正相关.其中,初始入渗率与初始含水率相关系数在-0.689~-0.912之间,稳定入渗率与容重相关系数为-0.745~-0.999,且稳定入渗率随非毛管孔隙度增加而显著提高.Horton模型对不同弃土弃渣下垫面入渗率与时间拟合的可决系数在0.899以上,且Horton模型计算入渗率与实测入渗率的相对误差在0.07%~6.60%之间,是紫色丘陵区分析不同弃土弃渣下垫面入渗过程的适宜性模型.研究结果可为紫色丘陵区弃土弃渣水土流失量预测和评价提供技术参数.     

提高快速法测定C OD准确度及精密度的方法

介绍了用快速法测定COD分析中提高准确度及精密度的方法。