The persistence of insecticidal chemicals in soils treated with granular formulations of disulfoton and their uptake by potato plants

Abstract

Potatoes were grown from cut seed in Plainfield sand treated in‐furrow with disulfoton (Di‐Syston 15G, 3.36 kg Al/ha) in 1983 and from whole seed in similarly treated loam in 1991. Soils were contained in 2 m² field plots. Soil, seed potato and foliage were analyzed for the insecticide and its sulfoxide and sulfone metabolites during the 8–12 wk following planting. Disulfoton disappeared at different rates from the two soils (k_sand=0.024 day^‐1, k_loam=0.056 day^‐1) with partial conversion to the sulfoxide and sulfone in both. Larger quantities of the three insecticidal components were absorbed by the seed potato in the cut‐seed/sand combination. The relative amounts of these components in the seed potato also differed between treatments with disulfoton being the largest component of the cut‐seed/sand and smallest in the whole‐seed/loam. Disulfoton sulfoxide and sulfone were the major insecticidal components of the foliage and concentrations in the initial foliage (each ca. 10 ppm) were similar for both treatments. Sulfoxide concentrations in the foliage decreased more rapidly than the sulfone and the decrease in concentration of each of the components was similar for the two treatments.     

Dissipation of terbuthylazine,metolachlor, and mesotrione in soils with contrasting texture

ABSTRACT

This study evaluates the dissipation of terbuthylazine, metolachlor, and mesotrione at different depths in soils with contrasting texture. The field trial was conducted at the Padua University Experimental Farm, north-east Italy. The persistence of three herbicides was studied in three different soil textures (clay soil, sandy soil, and loamy soil) at two depths (0–5 and 5–15 cm). Soil organic carbon content was highest in the clay (1.10%) followed by loam (0.67%) and sandy soil (0.24%); the pH of soils was sub-alkaline. Terbuthylazine, metolachlor, and mesotrione were applied on maize as a formulated product (Lumax®) at a dose of 3.5 L ha^?1. Their dissipation in the treated plots was followed for 2 months after application. The concentrations of herbicides were analyzed by liquid chromatography-mass spectrometry. The dissipation of terbuthylazine, metolachlor, and mesotrione could be described by a pseudo first-order kinetics. Terbuthylazine showed the highest DT50, followed by metolachlor and mesotrione. Considering the tested soil, the highest DT50 value was found in clay soil for terbuthylazine and metolachlor, whereas for mesotrione there was no difference among soils. Significant differences were found between the two soil depths for terbuthylazine and metolachlor, whereas none were found for mesotrione. These results suggest that soil texture and depth have a strong influence on the dissipation of terbuthylazine and metolachlor, whereas no influence was observed on mesotrione because of its chemical and physical properties.     

中置曝气生物活性炭工艺中的微絮凝

利用新型炭滤-砂滤工艺对南方湿热地区微污染源水进行中试规模的微絮凝实验研究。结果表明,接触絮凝时间为2~5 min时,投加1.0 mg/L的PAC微絮凝效果最好。运行稳定后,砂滤器出水浊度≤0.1 NTU,对COD Mn的去除效果有一定改善,微型水生生物的种类和数量也较炭滤器有大幅度下降,其中双层砂滤的效果优于单层粗砂,但其水头损失增长较快。通过微絮凝,砂滤器对炭滤器反冲洗后初滤水能有较好处理效果,可有效简化运行工艺。同时可保证滤后水中铝含量满足《生活饮用水卫生标准》的要求。     

天然锰砂去除水中的砷

天然锰砂是一种廉价、高效的水处理用材料,但尚未用于水中砷的去除。实验研究了反应时间、砷形态、初始砷浓度、温度、溶液初始pH对吸附过程的影响。结果表明,天然锰砂对As(Ⅲ)的吸附能力大于As(Ⅴ)。25℃时,固液比为10 g/L的条件下,天然锰砂对初始浓度为5.0 mg/L的砷溶液吸附过程经72 h基本达到平衡,平衡时对As(Ⅲ)和As(Ⅴ)的去除率分别达到94.5%和85.9%。吸附过程符合Lagergren准一级反应动力学模型和假二级反应动力学模型。相比之下,假二级动力学模型拟合程度更高。对As(Ⅲ)和As(Ⅴ),45℃时的吸附量均大于25℃时。不同温度下,天然锰砂对As(Ⅲ)和As(Ⅴ)的吸附过程更符合Freundlich等温吸附模型。在溶液初始pH为3～10范围内,锰砂对砷的吸附能力受pH的影响较小。实验结果表明,天然锰砂是一种具有实际应用潜力的除砷材料。     

微絮凝深床层过滤去除无机营养物及典型金属离子

在分析了微絮凝深床层过滤机理的基础上,实验研究了以煤矸石燃后残渣为滤料的深床层对微污染矿井水中无机营养物及典型金属离子的去除效果。结果表明,对于微污染矿井水中的NH3-N及COD的去除率仅有20%～40%;对可形成微絮凝体的磷的去除率高达80%以上,对于矿井水中的铁、锰离子的去除率可达75%以上,而絮凝剂的适量加入,不会大幅增加出水中铝离子的含量;分析表明,煤矸石燃后残渣滤料具有良好的吸附、截留作用;对溶解性NH3-N及COD的去除以吸附及生物作用,对铁、锰离子的去除则是以形成絮体沉淀为主,同时金属离子的水合作用、溶度积等对其去除有一定的影响。     

Diagnosis of dissolved organic matter removal by GAC treatment in biologically treated papermill effluents using advanced organic characterisation techniques

Granular activated carbon (GAC) exhaustion rates on pulp and paper effluent from South East Australia were found to be a factor of three higher (3.62 cf. 1.47 kg m⁻³) on Kraft mills compared to mills using Thermomechanical pulping supplemented by Recycled Fibre (TMP/RCF). Biological waste treatment at both mills resulted in a final effluent COD of 240 mg L⁻¹. The dissolved organic carbon (DOC) was only 1.2 times higher in the Kraft effluent (70 vs. 58 mg L⁻¹), however, GAC treatment of Kraft and TMP/RCF effluent was largely different on the DOC persisted after biological treatment. The molecular mass (636 vs. 534 g mol⁻¹) and aromaticity (5.35 vs. 4.67 L mg⁻¹ m⁻¹) of humic substances (HS) were slightly higher in the Kraft effluent. The HS aromaticity was decreased by a factor of 1.0 L mg⁻¹ m⁻¹ in both Kraft and TMP/RCF effluent. The molecular mass of the Kraft effluent increased by 50 g mol⁻¹ while the molecular mass of the TMP/RCF effluent was essentially unchanged after GAC treatment; the DOC removal efficiency of the GAC on Kraft effluent was biased towards the low molecular weight humic compounds. The rapid adsorption of this fraction, coupled with the slightly higher aromaticity of the humic components resulted in early breakthrough on the Kraft effluent. Fluorescence excitation-emission matrix analysis of the each GAC treated effluent indicated that the refractory components were higher molecular weight humics on the Kraft effluent and protein-like compounds on the TMP/RCF effluent. Although the GAC exhaustion rates are too high for an effective DOC removal option for biologically treated pulp and paper mill effluents, the study indicates that advanced organic characterisation techniques can be used to diagnose GAC performance on complex effluents with comparable bulk DOC and COD loads.     

基本单分散气溶胶透过率测试中真实值的计算

通过对高效、超高效滤料透过率测试台工作原理的分析得到:利用基本单分散粒子作为气溶胶测得的透过率关系与滤料真正的透过率-粒径曲线有区别,实际上是所使用实验气溶胶的综合透过率。详细研究了真正透过率与实验透过率的关系、误差和偏离产生原因,最终提出了一种独特的计算方法,实现了根据实验得到的表观透过率-粒径关系,就可以计算出真实透过率-粒径曲线,并得到了采用较为理想的实验气溶胶测试出的真实透过率的实际验证,这将大大提高高效、超高效滤料性能测试台的精度,拓展了其应用范围,为高效滤料的过滤理论和应用研究提供了比较理想的测试手段。     

PVDF/PMMA与PVDF/TPU共混膜抗污染性能研究及应用

观察新型五孔PVDF共混改性纤维膜SEM形貌特征,采用逐级通量法测定PVDF/PMMA和PVDF/TPU共混改性膜的临界通量,研究在次临界和超临界通量下A(PVDF/PMMA)与B(PVDF/TPU)2种管式膜组件的过滤和抗污染性能,并在次临界通量下处理地表水。结果表明,PVDF共混改性膜具有优良的微观结构,且膜B性能较好;膜A、B的临界通量分别为12 L/(m2.h)和10 L/(m2.h);膜组件B比膜组件A抗污染性能好。次临界通量下膜组件的运行比超临界通量下的稳定。与采用单独超滤处理某市地表水相比,2种膜组件采用混凝+超滤工艺的运行处理效果更好,且膜组件B比膜组件A处理效果佳。     

丝光印染废碱液回用技术的研究

印染企业丝光机排出的废碱液,Na0H质量浓度为3%～5%,废水温度在50℃～70℃,色度>1000倍,SS>400mg/L,含较多棉纱线等,为探讨废碱液回收技术的合理性及可行性,本中试系统采用"滤网过滤+板框压滤+陶瓷膜过滤+蒸发浓缩"的耦合技术,对丝光机排放的废碱液进行预处理及浓缩,中试结果表明,该技术可达到废碱液100%回用,处理后的碱液浓度可达15%～25%,SS<30mg/L,色度<100倍,达到印染行业丝光工序回用的要求。     

电镀废水处理及回用工程实例

将某电镀废水原水按水质分类,分别进行沉淀、氧化等预处理,然后综合进行中和、生物接触氧化、沉淀等工艺,出水水质指标达到地方污水排放标准,对部分出水进行砂滤、活性炭吸附、膜过滤处理等深度处理后达到回用要求。结果表明,该方法对中小企业处理含氰及多种重金属的电镀废水是经济、可行的。