超高效气溶胶净化系统有效性现场检验研究

各类超高效气溶胶净化系统普遍存在的较为突出的问题是:缺乏系统工作有效性现场检测手段,难以判断系统防护是否失效。根据超高效滤料过滤特性和测试原理,并在分析了大气气溶胶对过滤效率测试影响的基础上,提出大气气溶胶背景下,基于粒数浓度测量和使用发生的高浓度单分散气溶胶作为实验气溶胶的净化系统防护有效性现场检验测试技术及系统组成,并进行了验证。     

曝气沉砂池除砂机理分析

针对曝气沉砂池小试装置模型,通过配砂实验对沉砂池除砂率进行统计分析,研究曝气强度与HRT对沉砂池除砂率的影响。实验结果表明,不同曝气强度下,随着HRT变化,除砂率逐渐上升,并最终趋于平衡状态;不同HRT下,曝气强度与除砂率近似呈现一定的线性关系,且随着曝气强度的增大,除砂率降低;在HRT小于1min时,砂粒的运行路径和沉降时间缩短,不利于砂粒的去除;在HRT大于1min时,其中1、3和4min,随着气水比的增加除砂率降低幅度相对较小,曝气所引起的横向环流在一定程度上有利于砂粒的沉降,而HRT为2min时,除砂率降幅却很大,这与砂粒在曝气沉砂池池体断面分布有关,即断面处旋转流速和水平流速的大小变化将影响砂粒的运动;相比曝气强度,HRT对除砂率的影响较大。     

陶瓷膜污染过程分析与膜清洗方法优化

采用膜孔径为50 nm的陶瓷膜错流过滤方式,对碱性高浓度有机洗涤废水进行9个周期的膜通量衰减及反向脉冲清洗再生实验研究.通过设计膜污染阻力构成实验,测算膜污染总阻力及其构成比例.实验结果表明,膜固有阻力比例较低,浓差极化污染较弱,Rt和Rc+Rirt污染阻力稳定性较高,膜堵塞形式兼有孔内堵塞和滤饼过滤;选择质量分数0.1％的稀盐酸和0.2％的草酸溶液膜清洗效果均较好,清洗时间为3 min,脉冲时间和频率为3 s/5 s.     

Risks of using membrane filtration for trace metal analysis and assessing the dissolved metal fraction of aqueous media--a study on zinc, copper and nickel

Membrane filtration is commonly performed for solid-liquid separation of aqueous solutions prior to trace metal analysis and when assessing “dissolved” metal fractions. Potential artifacts induced by filtration such as contamination and/or adsorption of metals within the membrane have been investigated for different membrane materials, metals, applied pressures and pre-cleaning steps. Measurements have been conducted on aqueous solutions including well-defined metal standards, ultrapure water, and on runoff water from corroded samples.Filtration using both non-cleaned and pre-cleaned filters revealed contamination and adsorption effects, in particular pronounced for zinc, evident for copper but non-significant for nickel. The results clearly show these artifacts to be non-systematic both for non-cleaned and pre-cleaned membranes. The applied pressure was of minor importance.Measurements of the labile fraction by means of stripping voltammetry clearly elucidate that membrane filtration followed by total metal analysis cannot accurately assess the labile or the dissolved metal fraction.     

微絮凝-直接过滤工艺用于东江流域典型印染废水回用的实验研究

以东莞地区某典型印染企业尾水为研究对象,针对东江流域饮用水源河流水质污染现状及纳污河流水质改善目标要求与企业对尾水回用的实际需求,进行了印染废水深度处理回用工艺的适用性研究.通过混凝烧杯实验,选用工业PACl、FeSO4、HPAC 3种药剂,对微絮凝-直接过滤集成工艺用于印染废水尾水深度处理后水质回用的可行性,进行了实...     

人工生物蓄水过滤系统对雨水的滞留与过滤功效

通过人工构建3个不同沙土配比的生物蓄水过滤系统,对人工系统滞留雨水时间和净化雨水的功效进行了研究。首先,根据自然降雨特点将雨水地表径流按照不同水量与进水时间引入系统,然后测定系统出水水量、时间、水质以及土壤湿度,比较植物层和整个系统滞留雨水径流的效果以及系统过滤雨水的功效。结果表明,(1)人工生物蓄水过滤系统有显著的滞留雨水的作用。其中植物层滞留雨水时间4.72~11.50 h,整个系统滞留雨水时间为5.17~13.80 h,人工系统比植物层滞留雨水时间显著延长,且进水量越大,差异越显著。(2)系统出水流速平缓,蒸发与植物蒸腾耗水量比例低于6%;壤土含量越高,滞留雨水时间越长。(3)经系统过滤,系统出水酸碱度平均增加0.81,氨氮含量平均降低0.42 mg/L。     

声凝并联合雾化预处理及其在过滤除尘中的应用

根据声凝并理论和雾化湿式除尘理论,建立了燃煤飞灰在声场联合雾化加湿作为预处理的过滤式除尘实验装置。分别在声场、雾化加湿、声场与雾化加湿相结合3种预处理条件下进行实验,确定合适的加湿量范围,得出不同条件下燃煤飞灰的去除效果。在声场联合雾化加湿条件下,分别研究了声压级和雾化加湿量对飞灰的去除率的影响。结果表明,声场和雾化加湿联合作用能有效提高燃煤PM2.5去除率。以声场联合雾化加湿作为预处理进行过滤除尘实验,结果表明,虽然对高效滤料的除尘效率提高作用有限,但是该预处理可减轻滤袋负荷,有效延缓压差增长,降低清灰频率。由于采用表面覆膜滤材,加湿量控制得当可避免产生"糊袋"现象。     

改性纤维球处理炼油废水的应用研究

通过用改性纤维球处理炼油废水的试验,对纤维球过滤技术的处理效果和反冲洗特性进行了详细的研究,试验结果表明,炼油废水经处理后,出水中油的含量小于4 mg/L、悬浮物含量小于6 mg/L,出水可达标排放,并且经过改性后的纤维球在含油废水处理中可以通过反冲洗再生并重复使用.     

GROUND-WATER RECHARGE THROUGH ACTWE SAND DUNES IN NORTHWESTERN NEVADA1

ABSTRACT: Most water-resouree investigations in semiarid basins of the Great Basin in western North America conclude that ground-water recharge from direct precipitation on the valley floor is negligible. However, many of these basins contain large areas covered by unvegetated, active sand dunes that may act as conduits for ground-water recharge. The potential for this previously undocumented recharge was investigated in an area covered by sand dunes in Desert Valley, northwestern Nevada, using a deep percolation model. The model uses daily measurements of precipitation and temperature th determine energy and moisture balances, from which estimates of long-term mean annual recharge are made. For the study area, the model calculated a mean annual recharge rate of as much as 1.3 inches per year, or 17 percent of the long-term mean precipitation. Model simulations also indicate that recharge would be virtually zero if the study area were covered by vegetation rather than dunes.     

铸型旧砂再生方法及系统设施选择

通过实例,针对某铸造分厂砂处理生产工艺落后,旧砂对车间、环境及产品质量的影响,提出了建立旧砂再生系统的技术改造方案,阐述了旧砂干法再生方法及系统设施选择,分析了砂处理后取得的环境效益和经济效益。可为中小型铸造厂提供借鉴。