全文获取类型
收费全文 | 221篇 |
免费 | 44篇 |
国内免费 | 41篇 |
专业分类
安全科学 | 89篇 |
废物处理 | 5篇 |
环保管理 | 34篇 |
综合类 | 93篇 |
基础理论 | 27篇 |
污染及防治 | 39篇 |
评价与监测 | 13篇 |
社会与环境 | 3篇 |
灾害及防治 | 3篇 |
出版年
2023年 | 2篇 |
2022年 | 16篇 |
2021年 | 5篇 |
2020年 | 10篇 |
2019年 | 10篇 |
2018年 | 12篇 |
2017年 | 12篇 |
2016年 | 14篇 |
2015年 | 15篇 |
2014年 | 17篇 |
2013年 | 19篇 |
2012年 | 18篇 |
2011年 | 17篇 |
2010年 | 10篇 |
2009年 | 15篇 |
2008年 | 12篇 |
2007年 | 11篇 |
2006年 | 10篇 |
2005年 | 9篇 |
2004年 | 9篇 |
2003年 | 10篇 |
2002年 | 8篇 |
2001年 | 4篇 |
2000年 | 4篇 |
1999年 | 5篇 |
1998年 | 5篇 |
1997年 | 5篇 |
1996年 | 2篇 |
1995年 | 3篇 |
1994年 | 3篇 |
1993年 | 3篇 |
1992年 | 1篇 |
1990年 | 1篇 |
1989年 | 1篇 |
1988年 | 1篇 |
1987年 | 1篇 |
1982年 | 1篇 |
1977年 | 1篇 |
1973年 | 1篇 |
1972年 | 2篇 |
1971年 | 1篇 |
排序方式: 共有306条查询结果,搜索用时 843 毫秒
281.
浮尘对冬小麦叶片光合作用及细胞膜透性的影响 总被引:2,自引:0,他引:2
我国是浮尘发生频繁的国家。浮尘作为一种灾害性天气不仅直接危害作物,而且通过减少直接辐射,减缓冰雪融化,减少河水流量,改变土壤性质等间接影响作物的生长发育。因此,深入研究浮尘对作物的影响具有重要意义。但目前,国内外的学者主要偏重研究人为粉尘和工业污染物对野生植物及绿化植物的影响,较少关注自然降尘对作物的影响;特别是在长期浮尘胁迫下冬小麦叶片的气孔导度、净光合速率、细胞质膜相对透性等生理指标的变化很少有研究。通过模拟降尘和盆栽试验,研究了拔节期和盛花期的降尘对冬小麦叶片温度(Tleaf)、叶绿素含量(Chl)、游离脯氨酸含量(Pro)、净光合速率(Pn)、气孔导度(Gs)、胞间CO2浓度(Ci)、细胞膜透性的影响(MP)。结果表明,降尘使拔节期和盛花期冬小麦的净光合速率分别下降52%和43.9%,差异均显著(P〈0.05);降尘还增大细胞膜透性,破坏了冬小麦自身调节系统,使拔节期和盛花期的叶绿素含量分别下降14.4%和20.4%,达到极显著差异(P〈0.01);降尘还使拔节期叶片的气孔导度下降到对照的26.9%(P〈0.05),同时叶面温度升高,脯氨酸含量增加38.2%。 相似文献
282.
烟气连续监测系统的相对准确度检测 总被引:2,自引:2,他引:0
阐述了HJ/T76—2001《固定污染源排放烟气连续监测系统技术要求及检测方法》标准中烟气连续监测系统的相对准确度计算和相对准确度计算中存在的问题。对存在问题中的重复性或复现性的假设、B类不确定度的忽略、标准分析方法平均值的采用和偏差检验进行了探讨。 相似文献
283.
Robert G. McLaren Peter A. Forsyth Edward A. Sudicky Joel E. VanderKwaak Franklin W. Schwartz John H. Kessler 《Journal of contaminant hydrology》2000,43(3-4)
Recent discovery of bomb-related 36Cl at depth in fractured tuff in the unsaturated zone at the Yucca Mountain candidate high-level waste (HLW) repository site has called into question the usual modeling assumptions based on the equivalent continuum model (ECM). A dual continuum model (DCM) for simulating transient flow and transport at Yucca Mountain is developed. In order to ensure properly converged flow solutions, which are used in the transport simulation, a new flow solution convergence criteria is derived. An extensive series of simulation studies is presented which indicates that rapid movement of solute through the fractures will not occur unless there are intense episodic infiltration events. Movement of solute in the environs of the repository is enhanced if the properties of the tuff layer at the repository horizon are modified from current best-estimate values. Due to a large advective–dispersive coupling between the matrix and fractures, the matrix acts as a major buffer which inhibits rapid transport along the fractures. Consequently, fast movement of solutes through the fractures to the repository depth can only be explained if the matrix–fracture coupling term is significantly reduced from a value that would be calculated on the basis of data currently available. 相似文献
284.
In his recent article on measuring the long-term trends in the real prices of primary commodities, Cuddington (2010) extends in several important respects our earlier efforts (Svedberg and Tilton, 2006) to correct real commodity price trends for biases in the Consumer Price Index and other deflators. First, he argues for a log-linear relationship between prices and time. Second, he proposes a simple and quick method for obtaining corrected price trends from the published but uncorrected estimates. Finally, he illustrates, for the case of copper and presumably for many other commodities as well, the difficulties of obtaining real price trends significantly different from zero when the log values of the price data contain a unit root, requiring the use of difference stationary models.We welcome these insights, which should improve and make easier efforts to estimate correctly real commodity price trends over the long run. We would stress, however, that it is still important to correct for the biases in inflation indices, notwithstanding the failure of difference stationary models to obtain long-run real price trends (both corrected and uncorrected) significantly different from zero. 相似文献
285.
本文主要探讨了化学防护服(CPC)的功能性测试过程,包括耐化学性能测试、整体性能测试、物理性能测试、人体工程学性能测试。评价CPC是否合格的前题是应该将它暴露在最糟糕的环境下,看它是否能够长时间的起到保护作用。化学防护中与暴露物体直接接触的特征决定了这一类服饰必须经过非常严格的测试才能被选择使用。由此可见性能测试的实用性,对于服装性能测试原理和过程的深刻理解有助于我们了解服装整体的防护性能,更好地做出选择。 相似文献
286.
为研究改性污泥作填埋场中间覆盖材料的长期性能,通过无侧限压缩试验和渗透试验,研究温度和渗滤液对污泥强度和渗透性能的影响。结果表明,温度升高,污泥的无侧限抗压强度下降,渗透系数增大;在自来水中浸泡一个月后,二者的渗透系数分别减小了14.3%和53.4%,污泥的无侧限抗压强度下降了14.3%,而在渗滤液中浸泡一个月后,污泥的无侧限抗压强度反而提高了91.1%。该改性污泥的强度和渗透性均满足作填埋场中间覆盖层的要求。 相似文献
287.
煤矿水文地质勘探中稳定流抽水试验确定水文地质参数讨论 总被引:2,自引:0,他引:2
<正>确的水文地质参数是准确预测矿井涌水量的基础。以实际抽水试验为基础,对比计算分析单孔抽水、一个观测孔和两个观测孔三种不同抽水试验方式下的水文地质参数,然后在考虑井损的情况下,对抽水孔的降深进行修正,以期得到更加精确的水文地质参数。结果表明,由于经验公式及井损的影响,使得单孔抽水所得参数误差及离散度较大,即使对降深进行修正后,单孔抽水依然得不到理想的结果。因此,建议采用两个观测孔的抽水试验方式来获取较为正确的水文地质参数。研究结果可为含水层水文地质参数计算及矿井涌水量预测提供理论依据,对矿井防排水系统设计和防治水措施制定具有重要现实意义。 相似文献
288.
《Process Safety and Environmental Protection》2014,92(6):739-749
Simultaneous investigation of environmental emissions and machining aspects of electrical discharge machining process is essential for achieving hygienic and efficient machining. The main objective of the present work is to experimentally investigate and analyze the aerosol emission rate and the material removal rate from a die sinking electrical discharge machining process for three commonly used work piece materials viz., tool steel, mild steel and aluminum using Taguchi methodology of Experimental Design in order to suggest suitable process conditions for green manufacturing. The aerosol emission profile of all workpiece materials was found to be closely related to the material removal profile. A significant variation in emission and material removal rate was observed for workpiece materials which may be accorded to the variation in melting and vaporization temperatures. It was also observed that majority of aerosol constituents evolved from workpiece materials and that the constituents with low melting points were having high relative concentration in the aerosol emitted. The study introduced a parameter, the relative emission rate for comparing the emission for various process parameters and workpiece–tool material combinations. The favorable machining parameters for each material were then identified by employing signal to noise ratio analysis of the relative emission rate. 相似文献
289.
为了增加煤层透气性、提高瓦斯抽采效率,选取七台河矿区进行液态CO2爆破煤层增透工业试验。研究液态CO2爆破过程中主管内高压气体P-T曲线,考察不同地应力下的液态CO2爆破有效影响半径和煤层透气性系数,监测爆破前后瓦斯抽采参数。试验结果表明:采用压缩气体与水蒸气容器爆破方法计算液态CO2爆破的当量为180 gTNT;爆破后瓦斯抽采浓度提高3.16倍,瓦斯抽采混合流量提高1.71倍;煤层液态CO2爆破有效影响半径随地应力的增加近线性减小,随爆破压力的增加非线性增加,确定液态CO2爆破时最佳爆破压力范围160~280 MPa;爆破前后对比,煤层透气性系数提升17.49~22.76倍。井下煤层液态CO2爆破技术的实施,有助于降低爆破成本、提高增透效果和瓦斯抽采利用率。 相似文献
290.
采用室内土柱试验,研究咸水中胶体迁移引起砂介质渗透性变化的特征,通过胶体迁移-沉积作用的分析对砂介质渗透性损失的机理进行了探讨.结果表明:砂介质渗透性随孔隙体积数变化的动态特征符合Boltzmann函数;砂介质渗透性总的损失率为37.4%;渗透系数的损失量随孔隙体积数的增加而增加.胶体在砂介质中的穿透曲线呈“S”型,其中的2个拐点将曲线分成开始穿透、快速穿透和平稳穿透3个阶段,但并没有完全穿透,其迁移过程中发生了沉积. 胶体沉积作用是砂介质渗透性降低的主要原因. 相似文献