雷达吸波涂层海洋大气环境适用性试验研究

目的 分析一种雷达吸波隐身涂层在海洋大气自然环境下性能的变化规律。方法 对12个月不同阶段涂层的常规物理性能和电性能进行检测,其中常规物理性能包括宏观形貌、金相形貌、微观性能、附着力、抗冲击强度和红外光谱。结果 从宏观形貌看,涂层明度和色差值呈上升趋势,12个月明度增加1.22,色差值增加2.91,颜色向绿色和蓝色发展,失光率先增大、后减小,最大失光率为9个月时的34%。涂层附着力和试验时间呈现非线性关系,6个月时,附着力降低了18%,12个月时增大了24%。涂层在2～18GHz的频率范围内,吸波曲线大体呈“U”形,最低反射率随时间向低频方向偏移。涂层金相形貌、微观性能、抗冲击强度和红外光谱特征总体变化不明显。结论 在1a内,自然海洋大气环境对雷达吸波隐身涂层常规物理性能和电性能产生了一定影响,但在试验时间相对较短情况下,海洋大气环境对涂层老化的影响作用尚未充分显示,需要结合更长周期的试验数据进一步分析。     

新型锌／铜／铝类水滑石的合成及对模拟印染废水吸附性能的研究

采用低饱和共沉淀法制得锌／铜／铝类水滑石化合物（Zn5CuAl2（OH）16CO3·xH2O）,在450℃焙烧得焙烧物,通过XRD ,FT－IR ,SEM和TG－DSC等手段对样品的结构、形貌和热稳定性进行了分析。将其焙烧物用于吸附模拟印染废水中的阴离子染料活性艳橙,结果表明,pH值在2～9,经吸附90 min ,其对印染废水的吸附性能最佳,染料去除率达96％以上。     

碘铈共掺杂纳米TiO_2的制备及可见光光催化性能

采用溶胶凝胶法制备了不同原料比例碘铈共掺杂纳米TiO2催化剂,运用X射线光电子能谱（XPS）,X射线衍射（XRD）,透射电镜（TEM）等检测手段对催化剂进行了初步表征.结果表明,经过450℃煅烧处理得到的TiO2、铈掺杂TiO2以及碘铈共掺杂TiO2催化剂均为锐钛矿相,掺杂的Ce和I原子可能以I—Ce—O及O—Ti—I等键合方式进入TiO2晶格内部,此外,I-Ce离子共掺杂能有效降低TiO2表面的电子-空穴对的复合.以染料罗丹明B（Rhodamine B,RhB）和无色小分子水杨酸（Salicylic acid,SA）为降解的目标化合物,发现碘铈共掺杂的最佳物质的量之比为nCe∶nI∶nTi=0.04∶0.05∶1,即I0.05Ce0.04TiO2催化剂在可见光照射下（λ〉420 nm）降解目标化合物其光化学活性明显优于单掺铈的TiO2催化剂和未掺杂的TiO2.该催化反应涉及到空穴氧化,并伴有羟基自由基（.OH）、超氧自由基（O2.-）及H2O2等氧化物种的产生.     

烟气脱硫剂制浆系统一体化设计及应用

石灰石粉制浆系统是石灰石-石膏湿法烟气脱硫工艺中脱硫剂浆液干式制备系统的一个主要部分。针对石灰石粉制浆系统传统设计的不足,提出了石灰石浆液罐与粉仓一体化设计的优化方案,具有节省投资、占地小、设计简单紧凑、系统可靠和寿命长的优点,尤其适合我国老小燃煤机组烟气脱硫改造工程。目前已成功应用于多个烟气脱硫工程。     

Water purification with sintered porous materials fabricated at 400℃ from sea bottom sediments

A sintering technology for preparing porous materials from sea bottom sediments was developed for use in water purification. The purpose of the present study was to develop methods for converting the sea bottom sediments dredged from Ago Bay into value-added recycled products. The sintered products fabricated at 400℃ were found to be very effective adsorbents for the removal of heavy metals.     

Impact of bias in predicted height on tree volume estimation: A case-study of intrinsic nonlinearity

Bias originating from intrinsic nonlinearity in nonlinear models is caused by excess curvature in the solution locus of parameter estimates derived from least squares procedures. Bias due to intrinsic nonlinearity varies according to sample size as well as model specification. This paper analyses consequences of fractionising data into smaller sub-samples. Based on measurements of stem diameter and total tree height from the first Danish national forest inventory, it is demonstrated how data splitting at random may cause the intrinsic nonlinear curvature to exceed the critical F-value. Application of a Taylor-series expansion shows that, for all practical purposes, the bias in predictions of individual tree volume (based on stem diameter and tree height) is negligible. To minimize residual variance, intrinsic curvature and, in turn, prediction bias, it is recommended that data be stratified according to site conditions, stand characteristics or other relevant criteria. Finally, the preferred model should exhibit close-to-linear behaviour.     

催化湿式氧化乐果农药废水及催化剂的研究

通过共沉淀法制备了用于湿式氧化乐果农药废水的Cu/Mn复合氧化物催化剂,研究了沉淀剂种类、沉淀温度、焙烧温度和活性组分配比等因素对Cu/Mn复合氧化物催化剂的活性及稳定性的影响,确定了最佳制备条件,利用BET比表面积测定和XRD对催化剂进行了表征。结果表明:优化条件制备的Cu/Mn复合氧化物催化剂催化湿式过氧化氢氧化处理乐果农药废水时,具有较高的催化活性和稳定性。催化剂用量以6 g/L,反应温度80℃,过氧化氢加入量为12.0 g/L,反应时间60 min,COD去除率为89.5%,活性组分溶出量较小。     

新型固定床生物膜反应器硝化性能的研究

本文以无纺布作为硝化反应器的填料 ,对其硝化负荷能力进行了探讨 ,同时对硝化过程中亚硝酸盐氮积累和影响氨氮去除的原因进行了分析。在NH3 N容积负荷为 1 .7kg/(m3·d)的情况下 ,可实现 98%以上的NH3 N去除率。溶解氧浓度为 4mg/L ,进水氨氮浓度为 30 0mg/L时硝化柱内开始出现亚硝酸盐氮积累 ,通过加大曝气量等措施可在一定程度上消除其影响。停止运行两个半月后 ,可在一周内基本恢复硝化功能。     

C9-AA水溶性石油树脂的制备及其阻垢性能

以乙烯生产过程中的副产物C9馏分和丙烯酸为原料,采用自由基溶液聚合,合成具有阻垢性能的C9-AA水溶性石油树脂。考察了引发剂AIBN和溶剂的加入量、C9-AA加入量、Ca^2＋浓度、循环冷却水pH和养护时间对C9-AA水溶性石油树脂阻垢性能的影响,并对其阻垢效果进行了评价。在Ca^2＋质量浓度小于或等于600mg／L、循环冷却水pH小于或等于9．3、C9-AA水溶性石油树脂加入量大于或等于15mg／L的条件下,C9—AA水溶性石油树脂对循环冷却水的阻垢率达到90％以上,其有效作用时间为60h。     

Monitoring the formation of trihalomethanes in the effluents from a shrimp hatchery

Formation of trihalomethanes (THM) was monitored at the Laboratório de Camarões Marinhos (LCM) from the Universidade Federal de Santa Catarina. THM could be present because chlorinated effluents from disinfection are discharged from the different hatchery rooms. THM quantification was done through an analytical methodology using Purge&;Trap coupled with a gas chromatograph equipped with an electron capture detector. Relative standard deviation (RSD), limit of detection (LOD) and limit of quantification (LOQ) for the methodology corresponded to the ranges of 8–17%; 0.01–0.03 μg L^?1 and 0.03–0.08 μg L^?1, respectively. Linear working range was of 0.1–8.0 μg L^?1 for all compounds. Enrichment and recovery method was applied to evaluate possible matrix effects and the results varied from 71.2% to 107.9%. LCM was monitored between August and December, 2004. This study showed that THM did not increase with the increase in postlarvae production and also that the aquatic life and the surrounding environment were not affected.