碱熔法生产二氧化锆污染的综合治理

采用新型反应器及胶凝除硅、直接酸溶重结晶、直接煅烧等技术对二氧化锆的生产工艺进行了改革 ,降低了原材料消耗及能耗 ,减少了废液排放量 ,并将回收的废物加工成副产品白炭黑 ,在生产过程中防治污染。     

铁锰复合氧化物包覆海砂的吸附除磷研究

利用铁锰复合氧化物包覆海砂制备了一种用于污水除磷的新型颗粒状吸附剂,并对其表面特性与磷吸附行为进行了研究.扫描电镜(SEM)分析结果表明,包覆后海砂颗粒表面凹凸不平且多孔,BET比表面积由0.06增至2.52 m2·g-1.磷吸附实验结果表明,包覆后海砂对磷的吸附能力显著提高,最大吸附容量为1.01~1.23 mg·g-1,优于多数文献报道的负载改性砂颗粒吸附剂;吸附动力学更符合准二级动力学方程,推测磷在包覆海砂表面发生了化学吸附;溶液p H对磷吸附有一定影响,离子强度则影响不大;共存阴离子对磷吸附影响的大小顺序为Si O2-3CO2-3F-SO2-4Cl-.     

沙尘媒质微波衰减特性研究*

目的研究沙尘媒质中微波衰减特性。方法根据随机媒质电磁波传播理论,给出了沙尘媒质中沿水平路径和沿地空路径的微波衰减和相移模型,与Sharief,Erdenekhuu和尹文言衰减模型计算结果进行比较和分析。结果衰减模型与Goldhirsh模型比较吻合,验证了其正确性。模型预测结果与Sharief模型结果一致。结论仿真结果验证了提出模型的有效性,模型计算方便,适用于不同频率。     

Empirical Estimation of Stream Discharge Using Channel Geometry in Low‐Gradient,Sand‐Bed Streams of the Southeastern Plains

Manning's equation is used widely to predict stream discharge (Q) from hydraulic variables when logistics constrain empirical measurements of in‐bank flow events. Uncertainty in Manning's roughness (n_M) is the major source of error in natural channels, and sand‐bed streams pose difficulties because flow resistance is affected by flow‐dependent bed configuration. Our study was designed to develop and validate models for estimating Q from channel geometry easily derived from cross‐sectional surveys and available GIS data. A database was compiled consisting of 484 Q measurements from 75 sand‐bed streams in Alabama, Georgia, South Carolina, North Carolina (Southeastern Plains), and Florida (Southern Coastal Plain), with six New Zealand streams included to develop statistical models to predict Q from hydraulic variables. Model error characteristics were estimated with leave‐one‐site‐out jackknifing. Independent data of 317 Q measurements from 55 Southeastern Plains streams indicated the model (Q = A_cR_H^0.6906S^0.1216; where A_c is the channel area, R_H is the hydraulic radius, and S is the bed slope) best predicted Q, based on Akaike's information criterion and root mean square error. Models also were developed from smaller Q range subsets to explore if subsets increased predictive ability, but error fit statistics suggested that these were not reasonable alternatives to the above equation. Thus, we recommend the above equation for predicting in‐bank Q of unbraided, sandy streams of the Southeastern Plains.     

Utilization of silica fume in concrete: Review of hardened properties

Several types of industrial byproducts are generated. With increased environmental awareness and its potential hazardous effects, utilization of industrial byproducts has become an attractive alternative to disposal. One such by-product is silica fume (SF), which is a byproduct of the smelting process in the silicon and ferrosilicon industry. Silica fume is very effective in the design and development of high strength high performance concrete.This paper covers the physical, chemical properties of silica fume, and its reaction mechanism. It deals with the effect of silica fume on the workability, porosity, compressive strength, splitting tensile strength, flexural strength, creep and shrinkage of concrete.     

Persistence of granular and EC formulations of chlorpyrifos in a mineral and an organic soil incubated in open and closed containers

Abstract

Samples of a mineral soil (Plainfield sand) and an organic soil (muck) were treated with granular and EC formulations of chlorpyrifos and incubated at 27±1°C and 65±5% RH in open and closed containers. Duplicate samples of each soil‐formulation‐container combination were analyzed for residual chlorpyrifos during a 23 wk period. The disappearance rates observed demonstrate that the relative importance of formulation and containment on overall persistence depends on soil type. For the mineral soil, disappearance was slower from closed containers and formulation had only a slight effect while, in the organic soil the granular formulation disappeared slower than the EC and there was little difference between open and closed containers. The relative importance of degradation and volatilization in the disappearance of chlorpyrifos from soil is discussed.     

Kinetic study of heterogeneous ozonolysis of alachlor, trifluralin and terbuthylazine adsorbed on silica particles under atmospheric conditions

To better understand the atmospheric behaviour of pesticides, heterogeneous ozonolysis of three herbicides (alachlor, terbuthylazine and trifluralin) adsorbed on silica particles were performed in a flow reactor. The experimental setup used in this study and previously validated (Pflieger et al., 2009) has been specially developed to investigate extremely slow reactivity. The pesticides were adsorbed on particles using a gas/solid adsorption equilibrium, in order to simulate atmospheric conditions. After exposure to ozone concentrations ranging from 5 to 41 ppm during 90 min to 6 h, the kinetics were calculated by comparing the initial and the remaining amounts of pesticides adsorbed on silica particles. This work offers the first results of heterogeneous ozonolysis of alachlor and trifluralin adsorbed on mineral particles. Although alachlor and terbuthylazine were expected to react with ozone, no degradation was observed which leads to a lifetime higher than 8 months towards ozonolysis (for 40 ppb of O₃). A significant degradation of trifluralin adsorbed on silica particles by heterogeneous ozonolysis was observed. The experimental data could be fit by both the Langmuir–Rideal and the Langmuir–Hinshelwood models resulting in atmospheric lifetimes (towards heterogeneous ozonolysis) of 40 and 32 days respectively (for 40 ppb of O₃). These results are discussed and compared to other studies.     

The characterization of total and leachable metals in foundry molding sands

Waste molding sands from the foundry industry have been successfully used as a component in manufactured soils, but concern over metal contamination must be addressed before many states will consider this beneficial use. Since there is little data available on this topic, the purpose of this study was to characterize total and leachable metals from waste molding sands. A total elemental analysis for Ag, Al, As, B, Ba, Be, Cd, Co, Cr, Cu, Fe, Mg, Mn, Mo, Ni, Pb, Sb, V, and Zn was conducted on 36 clay-bonded and seven chemically bonded molding sands. Total metal concentrations in the molding sands were similar to those found in agricultural soils. The leaching of metals (i.e. Ag, As, Ba, Be, Cd, Cr, Cu, Ni, Pb, Sb, and Zn) was assessed via the toxicity characteristic leaching procedure (TCLP), synthetic precipitation leaching procedure (SPLP), and ASTM water leach test. Based on the TCLP data, none of the 43 molding sands would meet the Resource Conservation and Recovery Act (RCRA) characteristic for toxicity due to high Ag, As, Ba, Cd, Cr, and Pb. Compared to the TCLP results, the metal concentrations were generally lower in the SPLP and ASTM extracts, which is likely related to the buffering capacity of the extraction fluids.     

灰砂砖砌体力学性能试验研究

通过对灰砂砖砌体的基本力学性能试验研究 ,揭示了其破坏特征及影响因素 ,取得了有关数据 ,并与文献 [1]计算值进行了比较 ,阐明灰砂砖可用于抗震设计的砌体房屋。     

Assessment of river water quality during snowmelt and base flow periods in two catchment areas with different land use

River water quality was evaluated with respect to eutrophication and land use during spring snowmelt and summer base flow periods in Abashiri (mixed cropland-livestock farming) and Okoppe (grassland-based dairy cattle farming), eastern Hokkaido, Japan. Water from rivers and tributaries was sampled during snowmelt and summer base flow periods in 2005, and river flow was measured. Total N (TN), NO₃–N, and Si concentrations were determined using standard methods. Total catchment and upland areas for each sampling site were determined with ArcGIS hydrology modeling software and 1:25,000-scale digital topographic maps. Specific discharge was significantly higher during snowmelt than during base flow. In both areas, TN concentrations increased, whereas Si concentrations decreased, with increased specific discharge, and were significantly higher during snowmelt. The Si:TN mole ratio decreased to below or close to the threshold value for eutrophication (2.7) in one-third of sites during snowmelt. River NO₃–N concentrations during base flow were significantly and positively correlated with the proportion of upland fields in the catchment in both the Abashiri (r = 0.88, P < 0.001) and Okoppe (r = 0.43, P < 0.01) areas. However, the regression slope, defined as the impact factor (IF) of water quality, was much higher in Abashiri (0.025) than in Okoppe (0.0094). The correlations were also significantly positive during snowmelt in both areas, but IF was four to eight times higher during snowmelt than during base flow. Higher discharge of N from upland fields and grasslands during snowmelt and the resulting eutrophication in estuaries suggest that nutrient discharge during snowmelt should be taken into account when assessing and monitoring the annual loss of nutrients from agricultural fields.