DMF降解菌MBYD-1的分离、鉴定及降解特性

从农药厂污水处理池的活性污泥中分离得到一株能以二甲基甲酰胺(DMF)为唯一碳、氮源生长的菌株MBYD-1.经形态观察、生理生化实验及16S rRNA基因序列分析,将菌株初步鉴定为假单胞菌属 (Pseudomonas sp.).菌株MBYD-1降解DMF的最适条件为:pH 7.0,30℃.当DMF浓度为400mg/L,接种量为2%时,菌株能在72h内将DMF完全矿化.底物广谱性实验表明,菌株MBYD-1能在甲酸盐和甲醛中很好地生长,在甲酰胺中的生长情况优于二甲胺.     

Detection and quantitation of trace levels of low molecular weight halocarbons (LMHs) associated with commercial sodium humate

Examination of vapor above commercial sodium humate and above 10wt% aqueous humate solution by gas chromatography (GC) revealed the presence of chloroform and trichloroethylene. Further examination of the aqueous humate by the purge and trap procedure confirmed the association of chloroform and trichloroethylene with the humate. GC/mass spectrometry analyses of methylene chloride extract of the humate established the association of LMHs with the humate. Improved headspace capillary GC technique showed that the humate contained not only chloroform, trichloroethylene but several other LMHs in the range 190 to 4000ng·kg^‐1.     

Possibilities and limitations of ecotoxicological testing of chemicals

This study concerns the polycyclic aromatic hydrocarbons (PAH's) emission from gasoline and diesel automobile engines.

The sampling procedure, the extraction and the analytical method are presented. Using the gas chromatography‐mass spectrometry technique it is possible to detect and quantify easily about 15 PAH's. Data obtained on exhaust particles collected from gasoline and diesel automobile engines are presented and discussed.     

Exposure and Health Effects of Cadmium

The results of a study of photocatalytic degradation of phenol using aqueous oxygenated TiO₂ (anatase) suspensions in a batch Pyrex photoreactor are reported. The influence on the photodegradation rate of various parameters as pH, phenol and TiO₂ content, oxygen partial pressure, anions present in the dispersions was investigated. A complete oxidation of phenol was observed. Intermediate compounds, catechol and quinone, were detected. It was observed that the photodegradation also proceeded with sunlight radiation. A mechanistic and kinetic model, which accounts for the results obtained, is given. Likely reasons for inactivity of the rutile modification for this reaction are also given.     

Toxic substances: Measures and measurements†

The formulation of a sound policy for environmental protection and toxic substances control requires knowledge of the presence and concentration of environmental contaminants. For this reason monitoring programs have been set up in the Netherlands for water, drinking water, and air pollution. The Netherlands system for air pollution, monitoring of the substances SO2, NOχ, CO, O₃ is now fully automated. Some examples will be given to show the acquisition and management and interpretation of air pollution measurements.

Various smaller projects, supported by the Department of Health and Environmental Protection include measurement of indoor air‐contaminants, contaminants in soil and hazardous waste sites, and contaminants in biotic samples such as for instance PCB's in eels and seals and mussels. Moreover a Coordinating Committee regularly collects measurements from various sources in the Netherlands regarding pesticide residues and contaminants in food.

For cost‐effective monitoring the accuracy of the measurements must be chosen with regard to the biological effect concentration of the pollutant. The necessity of proper control measurements to establish background levels and the necessity of ring‐tests to increase interlaboratory reproducibility is discussed. In cost‐effective monitoring the minimum number of measurements, which are necessary to check the effect of environmental protection measures, must be defined through proper sampling.     

Biochemical properties of beryllium potentially relevant to its carcinogenicity†

The carcinogenicity of beryllium to several animal species is well established and evidence exists which strongly suggests that this is the case in human exposure. In this review several biochemical properties of the metallocarcinogen are considered including, the causation of cell transformation, and infidelity of DNA synthesis, inhibition of cell division and enzyme induction, and interference with regulatory mechanisms controlling gene expression. These effects are discussed in relation to beryllium chemistry, cellular accumulation mechanisms and distribution to subcellular organdies and molecular targets. It is suggested that the ultimate location and interactions of the metal ion in cell nuclei and its selective inhibition of certain protein phosphorylation reactions in particular are the biochemical effects potentially most relevant to induction of beryllium carcinogenesis.     

Polycyclic aromatic hydrocarbons in surface sediments held in experimental mesocosms

Sediment was collected from three locations along a pollution gradient in Narragansett Bay and transplanted to controlled mesocosms. Total hydrocarbons and eleven individual polycyclic aromatic hydrocarbons (PAHs) were measured in these sediments over a period of 394 days. Total hydrocarbon concentrations increased in the “relatively uncontaminated”; (Rhode Island Sound) sediment that was held in the mesocosms, but did not change in the two other sediments. The concentrations of four PAHs: naphthalene, 2‐methyl naphthalene, 1‐methyl naphthalene and biphenyl, decreased in the “contaminated”; (Providence River) sediment during the experiment and the calculated half‐lives for these compounds were 287, 353, 321 and 333 days, respectively.     

The use of the embryo‐culture techniques in the research on the Teratogenic and Mutagenic properties of metals†

Actually, embryos can be cultured from the one‐cell stage up to the blastocyst stage, and their development can be easily monitored at any time: severe effects caused by toxic compounds are traduced by rapid embryonic death, less pronounced effects can be expressed by a lowered cleavage activity or by an arrest of the development from a particular stage. The system can be improved by transferring the embryos at the blastocyst stage in another more complete medium where they can “implant”; and form an inner cell mass with differentiated ectoderm and endoderm. Since last years, it has also become possible to culture postimplantation rodent embryos for short periods involving a number of particularly critical stages of organogenesis, such as the formation and closure of the anterior neuropore. Embryo‐culture also represents a useful system to study cytogenetic effects of chemicals which are often linked to lethal or teratogenic effects. These different possibilities are illustrated by examples of studies already performed with metals, and dealing with their teratogenic and/or cytogenetic effects on pre‐ and postimplantation rodents.     

Crystallization and X‐ray structure of 3,3’,4‐trichlorobiphenyl (PCB 35)∗

A method for the preparation of single crystals of PCB 35 suitable for single crystal X‐ray structure determination was developed. This method has already been proven suitable for 2,4'‐dichlorobiphenyl and may prove useful for other PCBs or related compounds. The crystals of PCB 35 are orthorhombic, spacegroup P2₁22₁ (a= 10.665(8), 6 = 3.825(3), c= 14.086(9) Å) and the structure was refined to R = 0.094 for 156 unique observed reflections and 43 parameters. Although the crystals were of poor quality, the structure determination unequivocally confirmed the substitution pattern of the biphenyl moiety by Cl atoms inferred previously from spectroscopic methods. The dihedral angle between the planes of the two phenyl rings is 33(2)°.     

Hazardous halogenated substances formed during combustion processes

The results of the emissions from combustion processes and/or from fire accidents show the risk to man and his environment and thus the need for strict legislation and critical analysis of unwanted compounds. These substances or their thermolysis products are often due to incomplete combustion or may result from the interaction of various substances.

In the following we report the formation of octachlorostyrene (OCS) and of high‐toxic substances such as polybrominated dioxins (PBrDD's), dibenzofurans (PBrDF's) by the combustion.

In order to determine a possible source of the non‐manufactured compound OCS, we conducted several model experiments in a combustion chamber at various temperatures from 400 °C to 800 °C. The thermolysis of chlorinated solvents like chloroform or of chlorinated aromatice like pentachlorobenzene produced—among other chlorinated substances—OCS as one of the major products.

Analogous combustion experiments with polyester plastics containing decabromodiphenylether as flame retardant and antimony trioxide as Synergist led to PBrDD's and PBrDF's. Here antimony trioxide seems to play an important role because in absence of this oxide, PBrDD's and PBrDF's were not found in our experimental conditions.