Carbon Sequestration Function of Check-Dams: A Case Study of the Loess Plateau in China

Check-dams are the most common structures for controlling soil erosion in the Loess Plateau. However, the effect of check-dams on carbon sequestration, along with sediment transport and deposition, has not been assessed over large areas. In this study, we evaluated the carbon sequestration function of check-dams in the Loess Plateau. The results indicate that there were approximately 11 000 check-dams distributed in the Loess Plateau, with an estimate of the amount of sediment of 21 × 10⁹ m³ and a soil organic carbon storage amount of 0.945 Pg. Our study reveals that check-dams in the Loess Plateau not only conserve soil and water but also sequester carbon.     

生物炭修复Cd,Pb污染土壤的研究进展

随着矿产开采、冶炼等工业活动以及污水灌溉、施用污泥和劣质化肥等农业活动的进行,Cd,Pb等有害重金属不断进入农业环境中,对农田、菜地等造成污染。生物炭作为重要的土壤改良剂,在对Cd,Pb污染土壤的修复中表现出巨大的潜力。从生物炭的特性及制备、修复效果及其影响因素、修复机理等方面,对近年来国内外有关生物炭修复Cd,Pb污染土壤的研究成果和现状进行了总结,并对生物炭修复Cd,Pb污染土壤的发展前景和未来研究方向进行了展望。     

用于石油污染土壤降解的高效降解菌的筛选及其降解条件优化

经过富集、分离优选出高效石油降解菌L-1,根据形态观察和生理生化特征初步鉴定为琼氏不动杆菌;采用单因素花盆实验模拟微生物原位修复并对其降解条件进行优化。结果表明,将高效石油降解菌应用于修复石油污染土壤,适宜接种量、表面活性剂浓度、CNP比、翻耕频率分别为15%、0.1%、100∶10∶1和1 d 1次;在该降解条件下修复28 d,可达到16.80%的石油降解率,远远高于土著微生物6.92%的降解率。     

低温硝基苯降解菌选育及在土壤修复中的应用

从硝基苯污染地下水中筛选出一株以硝基苯为唯一碳源和氮源的低温、高效降解菌,命名为XJ菌;初步鉴定XJ菌为革兰氏阴性微小短杆细菌、恶臭假单胞菌属,降解硝基苯遵循部分还原降解途径;在10℃下培养96 h,XJ菌对硝基苯的降解去除率达到91.1%,其中约有67.1%的硝基氮素转变成了氨氮。在10℃下利用XJ菌修复硝基苯污染土壤,修复时间为96 h时,硝基苯去除率达到85.7%,XJ菌密度及微生物脱氢酶活性保持较高的水平。本研究可为低温下硝基苯污染土壤的生物修复提供参考。     

Evaluating and reducing a model of radiocaesium soil-plant uptake

An existing model of radiocaesium transfer to grasses was extended to include wheat and barley and parameterised using data from a wide range of soils and contact times. The model structure was revised and evaluated using a subset of the available data which was not used for model parameterisation. The resulting model was then used as a basis for systematic model reduction to test the utility of the model components. This analysis suggested that the use of 4 model variables (relating to radiocaesium adsorption on organic matter and the pH sensitivity of soil solution potassium concentration) and 1 model input (pH) are not required. The results of this analysis were used to develop a reduced model which was further evaluated in terms of comparisons to observations. The reduced model had an improved empirical performance and fewer adjustable parameters and soil characteristic inputs.     

Sorption of selenate on soils and pure phases: kinetic parameters and stabilisation

This study was conducted to identify the principle selenate carrier phases for two selected soils, by comparing their reactivity with selenate to that of pure phases of the solids. Silica, calcium carbonate, aluminium hydroxide, goethite, bentonite and humic acid were selected as the main soil carrier phases. Comparisons were made first on the parameter values obtained with the best fit of a kinetic sorption model which can discriminate instantaneous sorption from kinetically limited sorption. Then comparisons were made of the ability for each solid to stabilise selenate by measuring the ratio of the partition coefficient for sorption (Kd_sorption) over that of the desorption (Kd_desorption). Kinetics and stabilisation were used to help elucidate the nature of interactions with the test solid phases for a large range of selenate concentrations. The experiments were conducted over 165 h in batch reactors, the solid being isolated from the solution by dialysis tubing, at two pH (5.4 and 8) and three selenate concentrations (1 × 10⁻³, 1 × 10⁻⁶ and 1 × 10⁻⁸ mol L⁻¹). The results obtained showed that only aluminium hydroxide can sorb selenate throughout the studied pH range (pH 5.4 to 8.0). The sorption capacity on this mineral was high (Kd_sorption > 100 to 1 × 10⁴ L kg⁻¹) and the selenate was mainly stabilized by the formation of inner sphere complexes. The sorption on goethite occurred at pH 5.4 (Kd_sorption 52 L kg⁻¹), mainly as outer sphere complexes, and was null at pH 8. On silica, a weak sorption was observed only at pH 5.4 and at 165 h (Kd_sorption 4 L kg⁻¹). On bentonite, calcium carbonate and humic acid no significant sorption was observed. Concerning the two soils studied, different behaviours were observed for selenate. For soil Ro (pH 5.4), Kd_sorption was low (8 L kg⁻¹) compared to soil Bu (pH 8) (70 L kg⁻¹). The sorption behaviour of selenate on soil Ro was mainly due to outer sphere complexes, as for goethite, whereas for soil Bu the sorption was mainly attributed to inner sphere complexes followed by reduction mechanisms, probably initiated by microorganisms, in which no steady state was reached at the end of the 165 h experiments. The sorption of selenate decreased when concentrations reached 1 × 10⁻³ mol L⁻¹, due to solid saturation, except for aluminium hydroxide. Reduction of selenate seemed also to occur on goethite and soil Ro, for the same concentration, but without preventing a decrease in sorption. Thus, this work shows that the comparison of selenate behaviour between soil and pure phases helps to elucidate the main carrier phases and sorption mechanisms in soil.     

Depth profile of ²³⁶U/²³⁸U in soil samples in La Palma, Canary Islands

The vertical distribution of the ²³⁶U/²³⁸U isotopic ratio was investigated in soil samples from three different locations on La Palma (one of the seven Canary Islands, Spain). Additionally the ²⁴⁰Pu/²³⁹Pu atomic ratio, as it is a well establish tool for the source identification, was determined. The radiochemical procedure consisted of a U separation step by extraction chromatography using UTEVA^® Resin (Eichrom Technologies, Inc.). Afterwards Pu was separated from Th and Np by anion exchange using Dowex 1x2 (Dow Chemical Co.). Furthermore a new chemical procedure with tandem columns to separate Pu and U from the matrix was tested. For the determination of the uranium and plutonium isotopes by alpha spectrometry thin sources were prepared by microprecipitation techniques. Additionally these fractions separated from the soil samples were measured by Accelerator Mass Spectrometry (AMS) to get information on the isotopic ratios ²³⁶U/²³⁸U, ²⁴⁰Pu/²³⁹Pu and ²³⁶U/²³⁹Pu, respectively. The ²³⁶U concentrations [atoms/g] in each surface layer (∼2 cm) were surprisingly high compared to deeper layers where values around two orders of magnitude smaller were found. Since the isotopic ratio ²⁴⁰Pu/²³⁹Pu indicated a global fallout signature we assume the same origin as the probable source for ²³⁶U. Our measured ²³⁶U/²³⁹Pu value of around 0.2 is within the expected range for this contamination source.     

The bioaccumulation of Molybdenum in the earthworm Eisenia andrei: influence of soil properties and ageing

Mo bioaccumulation in the earthworm Eisenia andrei was determined after 28 d exposure in ten different European field soils (pH 4.4-7.8) and an artificial soil, freshly spiked with Na₂MoO₄ at concentrations between 3.2 and 3200 mg Mo kg⁻¹ dry soil. Three field soils were also tested after ageing for 11 months. Earthworm Mo concentrations generally levelled off at high exposure levels but in most soils showed a (nearly) linear increase with increasing soil concentrations in the lower, non-toxic range (below EC10 or NOEC for reproduction effects). Bioaccumulation (BAF) and Bioconcentration factors (BCF) were calculated as the ratio of earthworm concentration to soil and estimated porewater concentrations, respectively. BAFs (0.35-3.44) and BCFs (1.31-276) did not seem much affected by soil concentration, suggesting that earthworms are not capable of regulating their internal Mo concentrations. BAF was best predicted by ammonium oxalate-extractable iron (Fe_ox) and phosphor (P_ox) contents of the soils.     

Enhanced retention of linuron, alachlor and metalaxyl in sandy soil columns intercalated with wood barriers

A study has been made of the effect a reactive barrier made of pine (softwood) or oak (hardwood) wood intercalated in a sandy soil column has on the retention of linuron, alachlor and metalaxyl (pesticides with contrasting physicochemical characteristics). The leaching of pesticides has been carried out under a saturated flow regime and breakthrough curves (BTCs) have been obtained at flow rates of 1 mL min⁻¹ (all pesticides) and 3 mL min⁻¹ (linuron). The cumulative curves in the unmodified soil indicate a leaching of pesticides >80% of the total amount of compound added. After barrier intercalation, linuron leaching decreases significantly and a modification of the leaching kinetics of alachlor and metalaxyl has been observed. The theoretical R factors increased ∼2.6-3.3, 1.2-1.6-fold, and 1.4-1.7-fold and the concentration of the maximum peak decreased ∼6-12-fold, 2-4-fold and 1.2-2-fold for linuron, alachlor and metalaxyl, respectively. When considering the three pesticides, significant correlations have been found between the theoretical retardation factor (R) and the pore volume corresponding to the maximum peaks of the BTCs (r = 0.77; p < 0.05) or the total volume leached (r = −0.78; p < 0.05). The results reveal the efficacy of reactive wood barriers to decrease the leaching of pesticides from point sources of pollution depends on the type of wood, the hydrophobicity of the pesticide and the adopted water flow rate. Pine was more effective than oak in decreasing the leaching of hydrophobic pesticide linuron or in decreasing the maximum peak concentration of the less hydrophobic pesticides in soils. Efficacy of these wood barriers was limited for the least hydrophobic pesticide metalaxyl.     

The dissipation rates of trichlorfon and its degradation product dichlorvos in cabbage and soil

The residual levels and dissipation rate of trichlorfon, and its degradation product, dichlorvos, in cabbage crops and the soil in which these were grown, were determined by gas chromatography at two geographically distant experimental sites, one in Kunming and one in Beijing, China. Trichlorfon was applied at two dosages (900 g ai ha⁻¹ and 1350 g ai ha⁻¹). Maximum final residues of trichlorfon in soil and cabbage were 1.23 mg kg⁻¹ and 1.81 mg kg⁻¹ respectively at Kunming, and 0.35 mg kg⁻¹ and 0.70 mg kg⁻¹ respectively at Beijing. However, the final residues of dichlorvos in both cabbage and soil was only 0.04 mg kg⁻¹ at Kunming, and only 0.03 mg kg⁻¹, or “not detectable”, at Beijing. The mean half-life of trichlorfon in cabbage was 1.80 d with a dissipation rate of 90% over 5 d, while that in soil was 3.05 d with a dissipation rate of 90% over 14 d at one experimental site. The dissipation rates of trichlorfon and its degradation product dichlorvos at the two experimental sites were different, suggesting that degradation of these pesticides was affected by local soil characteristics and climate. When applied at both the recommended dosage and at 1.5 times this, no detectable residues of either trichlorfon or dichlorvos were found in soil or cabbage at harvest. Although trichlorfon can easily degrade into dichlorvos, which is highly toxic to humans and other animals, the observed low residual levels of dichlorvos suggest that trichlorfon is safe when applied at the recommended dosage.