Fenton法处理垃圾渗滤液的参数优化及反应动力学模型

采用Fenton法处理垃圾渗滤液,研究反应时间、初始浓度、pH、Fenton试剂用量对垃圾渗滤液TOC去除率的影响。研究结果表明,最优反应条件是反应时间30 min,初始pH为3.0,初始[H2O2]0=7 310 mg/L,最佳[H2O2]/[Fe2+]摩尔比为5,反应温度为室温,此时渗滤液的TOC去除率达到70.3%。渗滤液矿化过程符合一级反应动力学,并建立了符合该渗滤液的反应动力学模型。     

利用水泥处理垃圾渗滤液生物处理出水的研究

利用水泥的表面吸附和水化反应性质处理垃圾渗滤液生物处理出水可以取得很好的效果,COD的去除率可达69.5%.处理效果与水灰比、反应时间密切相关,低水灰比和较长反应时间对COD的去除更为有利.对处理前后水样的COD和TOC分析表明,水泥对非TOC贡献的COD有很强的去除效果.     

Optimizing electron spin resonance detection of hydroxyl radical in water

The parameters affecting the electron spin resonance (ESR) detection of hydroxyl free radical in water are studied and optimized. The hydroxyl radical is generated by the Fenton reaction with iron (II) ammonium sulfate and hydrogen peroxide reacting in a phosphate buffer using N-tert-butyl-alpha-phenylnitron as the spin trap. The concentrations of Fe²⁺, H₂O₂, and phosphate buffer are the parameters studied. The Taguchi method and the orthogonal experiment design were used to evaluate the effects of these parameters on the ESR signal intensity. By the analysis of the signal-to-noise ratio and the analysis of variance, the order of importance of the various parameters on the hydroxyl radical formation is determined for optimal ESR detection of hydroxyl radical. The results will help the development of water purification technologies using hydroxyl free radical as a green oxidant.     

负载型TiO2膜太阳光光催化降解活性深蓝K-R的研究

采用抛物线槽型反应装置,研究了玻璃弹簧和微珠负载型TiO2膜太阳光催化降解活性深蓝K-R,结果表明,由于玻璃弹簧具有良好的光透距离,脱色性能显著优于玻璃微珠,玻璃弹簧为载体,水溶液浓度为15mg/L,pH为3,流速为20mL/s,太阳光强度在1200 μW/cm2以上,光降解6h时,脱色率达到96%; 该降解反应可用一级反应动力学方程进行描述,反应速率常数（K）与光强I的关系为：K∝I1.92。     

纳米零价铁在应用中存在的问题及提高反应活性的方法

纳米零价铁对多种污染物质均有较好的去除效果,在污染的水体、土壤及底泥中被广泛研究与应用。前人对纳米零价铁的制备、在污染治理各方面的应用、作用的机理等方面进行了较为详细的总结,针对纳米零价铁在应用中存在的问题虽有提及,但少有人集中进行整理。本文主要针对纳米零价铁在环境治理方面存在的问题进行论述并对提高其反应活性的常用方法进行了总结,以期为纳米零价铁实际应用领域的深入研究提供借鉴并拓展新的思路。     

超声波-铁粉协同降解五氯酚

通过超声波-铁粉联合体系协同降解废水中的五氯酚(PCP).实验结果表明:降解120 min后,PCP去除率可达90.4％;在该体系中铁粉被逐渐腐蚀成Fe2+,随降解时间的延长,Fe2+浓度逐渐增加;体系中的Fe2+可以促进·OH的产生,并且可以与超声空化作用下产生的H2O2发生Fenton试剂氧化反应降解PCP;超声波...     

石灰湿法脱硫过程反应机理的研究

采用模拟烟气对石灰湿法脱硫过程反应机理进行研究 ,研究表明 ,石灰湿法脱硫过程反应机理不仅与脱硫液初始和终点pH值有关 ,而且还与烟气中SO2 浓度密切相关     

水中六氯苯的高级氧化降解机理及其动力学探讨

采用UV、O3、UV/O3高级氧化法对水中六氯苯(HCB)的降解效果及机理进行了研究.结果表明, UV本身对HCB的去除贡献率不大, HCB可被O3、UV/03快速降解,即UV相似文献   

Nanoencapsulation of hexavalent chromium with nanoscale zero-valent iron: High resolution chemical mapping of the passivation layer

Solid phase reactions of Cr(Ⅵ) with Fe(0) were investigated with spherical-aberration-corrected scanning transmission electron microscopy(Cs-STEM) integrated with X-ray energy-dispersive spectroscopy(XEDS). Near-atomic resolution elemental mappings of Cr(Ⅵ)–Fe(0) reactions were acquired. Experimental results show that rate and extent of Cr(Ⅵ) encapsulation are strongly dependent on the initial concentration of Cr(Ⅵ) in solution. Low Cr loading in nZⅥ(1.0 wt%) promotes the electrochemical oxidation and continuous corrosion of n ZⅥ while high Cr loading(1.0 wt%) can quickly shut down the Cr uptake. With the progress of iron oxidation and dissolution, elements of Cr and O counter-diffuse into the nanoparticles and accumulate in the core region at low levels of Cr(Ⅵ)(e.g., 10 mg/L). Whereas the reacted n ZⅥ is quickly coated with a newly-formed layer of 2–4 nm in the presence of concentrated Cr(Ⅵ)(e.g., 100 mg/L). The passivation structure is stable over a wide range of pH unless pH is low enough to dissolve the passivation layer. X-ray photoelectron spectroscopy(XPS) depth profiling reconfirms that the composition of the newly-formed surface layer consists of Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxides with Cr(Ⅵ) adsorbed on the outside surface. The insoluble and insulating Fe(Ⅲ)–Cr(Ⅲ)(oxy)hydroxide layer can completely cover the n ZⅥ surface above the critical Cr loading and shield the electron transfer. Thus, the fast passivation of nZⅥ in high Cr(Ⅵ) solution is detrimental to the performance of nZⅥ for Cr(Ⅵ) treatment and remediation.     

臭氧氧化法处理焦化废水生化出水的反应动力学简

对臭氧氧化去除焦化废水生化出水COD的反应动力学及其影响因素进行了实验研究,结果表明,在臭氧投加量为8.50 mg/min,反应温度为20℃和初始pH为10.61条件下,对COD的降解符合表观一级反应动力学模型,其相关系数R²=0.9991,表观反应速率常数k_Abs=1.01×10^-3 s^-1。该条件下,臭氧氧化对COD的降解主要来源于高活性羟基自由基的强氧化作用。在不同的臭氧投加量（4.25~12.75 mg/min）、不同的反应温度（10~40℃）和不同的初始pH（3.76~12.53）下,COD的降解也同样遵循一级反应动力学规律。随着臭氧投加量的增大,COD降解的表观反应速率常数从（0.554×10^-3） s^-1增加到（1.06×10^-3） s^-1;随着反应温度的升高,表观反应速率常数从（0.427×10^-3） s^-1增加到（1.40×10^-3） s^-1,温度越高反应速率提高的幅度却越小;在初始pH3.76~10.61范围内,表观反应速率常数从（0.218×10^-3） s^-1增加到（1.01×10^-3） s^-1,在初始pH为12.53时表观反应速率常数下降到（0.857×10^-3） s^-1。