贵州省红枫湖饮用水源地微囊藻毒素含量与水体中氮、磷含量等的相关性

2008年6~9月对贵州省红枫湖饮用水源地A、B、C采样点及取水口采样,研究了水体中微囊藻毒素即总藻毒素(total microcystin RR和total microcystin LR,TMC-RR、TMC-LR),胞外藻毒素(extracellular microcystin RR和extracellular microcystin LR,EMC-RR、EMC-LR)和胞内藻毒素(intracellular microcystin RR和intracellular microcystin LR,IMC-RR、IMC-LR)含量及相关的TN、TP、NH4-N、NO2-N、COD、Ch1a、pH等理化指标的变化情况,讨论了理化指标与藻毒素含量之间的相互关系。结果表明藻毒素在时间及空间上分布不均,无明显规律性。藻类高发期间藻毒素以胞内毒素为主要存在形式,去除藻毒素保障饮用水安全最重要的是去除饮用水源水中的藻类。相关性分析表明藻毒素含量与pH、NO2-N、Ch1a具有统计学意义上的相关性,综合回归分析的结果,pH是影响藻毒素的重要因子,因此贵州省喀斯特弱碱性特殊水环境与藻毒素产生的环境条件值得各方面高度关注。     

纳米TiO_2-Al_2O_3负载CuMnO_x对甲苯的催化燃烧

研究采用改进的溶胶-凝胶法制备了TiO2-Al2O3复合载体,并用浸渍法制备CuMnOX/TiO2-Al2O3催化剂,通过对甲苯废气催化燃烧的实验,分别考察了Cu-Mn负载量、Cu/Mn摩尔比、焙烧温度及载体对催化剂制备过程及催化剂活性的影响。实验结果表明:活性组分负载量25%,铜锰活性组分的配比Cu:Mn=1:2,焙烧温度500℃是浸渍法制备CuMnOX/TiO2-Al2O3催化剂较佳的工艺条件;XRD衍射图谱表明,500℃下铜锰尖晶石的存在是催化剂催化活性优良的主要原因;由复合载体制备的CuMnOX/TiO2-Al2O3催化剂比单一载体制备的CuMnOX/Al2O3催化剂具有更高的甲苯转化率,其T99比单一载体要低20℃以上。     

低分子量有机酸对岩源磷释放的实验研究

低分子量有机酸是微生物和植物根系分泌物中重要的组成部分.采用浸泡实验比较了4种常见低分子量有机酸(草酸、酒石酸、柠檬酸、苹果酸)对巢湖北岸东部富磷地层中岩源磷的释放量,并对浸提后的部分残渣进行磷的赋存形态分析.结果表明,当有机酸浓度小于5mmol·L-1时,柠檬酸的释磷量最大;大于5mmol·L-1时,草酸和酒石酸的释磷量最大,此时释磷量与有机酸的浓度具有一定的线性关系,其增加趋势远大于浓度小于5mmol·L-1时的增加趋势,而其中草酸和酒石酸又远大于柠檬酸和苹果酸.在有机酸溶液终止pH≥4时,有机酸溶液终止pH与释磷量有较好的线性关系.在50mmol·L-1相同浓度时,草酸对各赋存形态磷转化作用均最大,酒石酸次之.而4种酸对有机磷释放率最大,均高达97%以上,对闭蓄态磷的释放率最小.     

纳米铁系材料与反硝化细菌复合去除地下水硝酸盐氮研究

采用不同液相还原法制备了纳米Fe、纳米Fe/Ni和油酸钠包覆型纳米Fe粒子,并将其与反硝化细菌复合应用于地下水中硝酸盐氮的去除研究中.分别考察了不同纳米铁系材料与反硝化细菌复合体系去除硝酸盐氮的反应速率及对脱氮产物生成的影响.同时,从核糖核酸(RNA)水平考察了不同纳米铁系材料对反硝化细菌的影响.结果表明,纳米Fe/Ni复合体系脱氮速率最快,6d内对硝酸盐氮的去除率可达到100%,最终产物主要为氨氮,占体系总氮的69%;而纳米Fe和油酸钠包覆型纳米Fe复合体系9d可将硝酸盐氮100%去除,氨氮的转化率分别为52%和16%.另外,从反应前后反硝化细菌总RNA浓度的变化情况看,纳米Fe/Ni复合体系、纳米Fe复合体系和油酸钠包覆型纳米Fe复合体系的反硝化细菌总RNA浓度分别降低了93%、40%和34%,可见3种纳米铁系材料对反硝化细菌毒性大小顺序为:纳米Fe/Ni纳米Fe油酸钠包覆型纳米Fe.     

Catalytic performance of Fe3O4-CoO/Al2O3 catalyst in ozonation of 2-(2,4-dichlorophenoxy)propionic acid, nitrobenzene and oxalic acid in water

Fe3O4-CoO/Al2O3 catalyst was prepared by incipient wetness impregnation using Fe(NO3) 3·9H2O and Co(NO3) 2·6H2O as the precursors,and its catalytic performance was investigated in ozonation of 2-(2,4-dichlorophenoxy) propionic acid(2,4-DP) ,nitrobenzene and oxalic acid.The experimental results indicated that Fe3O4-CoO/Al2O3 catalyst enabled an interesting improvement of ozonation eciency during the degradation of each organic pollutant,and the Fe3O4-CoO/Al2O3 catalytic ozonation system followed a radical-type mechanism.The kinetics of ozonation alone and Fe3O4-CoO/Al2O3 catalytic ozonation of three organic pollutants in aqueous solution were discussed under the mere consideration of direct ozone reaction and OH radical reaction to well investigate its performance.In the catalytic ozonation of 2,4-DP,the apparent reaction rate constants(k) were determined to be 1.456×10-2 min-1 for ozonation alone and 4.740×10-2 min-1 for O3/Fe3O4-CoO/Al2O3.And O3/Fe3O4-CoO/Al2O3 had a larger Rct(6.614×10-9) calculated by the relative method than O3 did(1.800×10-9) ,showing O3/Fe3O4-CoO/Al2O3 generated more hydroxyl radical.Similar results were also obtained in the catalytic ozonation of nitrobenzene and oxalic acid.The above results demonstrated that the catalytic performance of Fe3O4-CoO/Al2O3 in ozonation of studied organic substance was universal to a certain degree.     

黄海鳀鱼中痕量金属浓度与体长的关系

测定了在黄海采集的各种体长的鳀鱼(Engraulis japonicus)中6种痕量金属(Zn、Cu、Fe、Al、Mn和Sr)和3种主要元素(C、N和P)的浓度.除Zn浓度在4～5倍内变动外,其余5种痕量金属浓度的变动范围均接近或超过一个数量级;并且,这6种金属均显示出了浓度随体长增长而下降的趋势.对于3种主要元素,N和P的含量也与体长存在负相关关系,而C却显示出了强烈的正相关关系.聚类分析表明,Zn和Cu在鳀鱼内的浓度变化较为接近,可能验证了这两种金属与生物体内新陈代谢活动较为密切的性质;而其余4种金属的浓度变化规律更为接近,可能反映了陆源输入的影响.     

基于重要度的系统可靠性分配方法

将系统的可靠性分配理论与故障树分析方法相结合,提出按故障树中各个基本事件(元件)的重要度大小进行可靠性分配的新方法.该方法可靠度的分配过程分两步:首先按可靠性再分配原理将系统的可靠度分配到各个最小割集;然后将需要调整可靠度的最小割集看成一个子系统,将最小割集的可靠度按基本事件重要度的大小分配到各个基本事件,即所谓二次分配模型.该方法不仅适用于仅有串、并联的简单系统,而且能够解决具有桥联结构的复杂系统的可靠性分配问题.     

侧流化学磷回收强化生物除磷的模拟预测与试验验证

为了强化污水中生物除磷作用,本研究通过模拟预测与实验室试验验证了厌氧上清液侧流化学磷沉淀与回收对强化生物除磷的促进作用.模拟预测与试验结果表明,在进水COD/P=37.5工况下,当侧流比增加至30%时,通过化学磷沉淀（调节pH＞9.0）可使出水中TP浓度从碳源抑制时的＜6.0 mg·L-1（以P计）下降至≤1.0 mg·L-1（以P计）,同时可回收进水中P负荷的64%.经验证与校正后的TUD数学模型模拟预测有着与试验结果近乎一致的效果.因此,数学模拟技术完全有可能取代中间试验过程而直接将小试结果放大至工程应用.     

Performance of a diesel engine with water emulsified diesel prepared with optimized process parameters

An attempt has been made to produce stable water–diesel emulsion with optimal formulation and process parameters and to evaluate the performance and emission characteristics of diesel engine using this stable water–diesel emulsion. A total of 54 samples were prepared with varying water/diesel ratio, surfactant amount and stirring speed and water separation was recorded after 24 and 48 hr of emulsification. The recorded data were used in artificial neural network (ANN)-particle swarm optimization (PSO) technique to find the optimal parameters to produce water–diesel emulsion for engine testing. The predicted optimal parameters were found as 20% water to diesel ratio, 0.9% surfactant and 2200 rpm of stirrer for a water separation of 14.33% in one day with a variation of 6.54% against the actual value of water separation. Water–diesel emulsion fuel exhibited similar fuel properties as base fuel. The peak cylinder gas pressure, peak pressure rise rate and peak heat release rate for water–diesel were found higher as compared to diesel at medium to full engine loads. The improved air-fuel mixing in water–diesel emulsion enhanced brake thermal efficiency (BTE) of engine. The absorption of heat by water droplets present in water–diesel emulsion led to reduced exhaust gas temperature (EGT). With water–diesel emulsion fuel, the mean carbon monoxide (CO), unburned hydrocarbon and oxides of nitrogen (NO_x) emissions reduced by 8.80, 39.60, and 26.11%, respectively as compared to diesel.     

毛竹遗态 Fe2O3／Fe3O4／C 复合材料对水中锑（III）的吸附研究

以毛竹遗态Fe2 O3／Fe3 O4／C复合材料为吸附剂,锑（III ）初始含量、溶液初始pH值、吸附剂投加量以及吸附剂粒径为影响因素开展吸附影响研究。结果表明,随着锑（III ）初始浓度的升高,毛竹遗态Fe2 O3／Fe3 O4／C复合材料对锑（III ）的吸附量逐渐增加;初始溶液pH为7时,对锑（III ）的吸附效果最好,吸附量为4．7821 mg／g;块状吸附剂对水中锑（III ）的去除率和吸附量与粉末状吸附剂吸附效果相当。