Effect of NOM characteristics on brominated organics formation by ozonation

In this study, organic fractions, namely, humic acid, fulvic acid, hydrophobic base and neutral, and hydrophilic acid, base, and -neutral, were extracted from source water. First, the characteristics of the organic fractions, such as carboxylic acidity, phenolic acidity, ultraviolet absorbance, and aromatic content, were analyzed. Further, a systematic study was carried out to the by-products obtained when organic fractions, to which various amounts of bromide had been added, were oxidized with ozone. Samples after ozonation were analyzed for several brominated organics. The results indicate that the characteristics of the aquatic organic matter, including carboxylic/phenolic acidity, aromatic/aliphatic content, and ultraviolet absorbance, appear to affect the formation of halogenated organics. In general, hydrophobic organics having higher phenolic acidity, aromatic content, and ultraviolet absorbance have higher ozone consumption and produce higher concentrations of brominated organics than hydrophilic organics. It was also found that humic acid demonstrated the highest bromoform (CHBr(3)), dibromoacetic acid (DBAA), and 2,4-dibromophenol (2,4-DBP) formation, whereas hydrophilic neutral produced less CHBr(3) and 2,4-DBP than the rest of the organic fractions but produced the highest amount of dibromoacetone (DBAC) and dibromoacetonitrile (DBAN).     

The ecological effects of trichloroacetic acid in the environment

Trichloroacetic acid (TCAA) is a member of the family of compounds known as chloroacetic acids, which includes mono-, di- and trichloroacetic acid. The significant property these compounds share is that they are all phytotoxic. TCAA once was widely used as a potent herbicide. However, long after TCAA's use as a herbicide was discontinued, its presence is still detected in the environment in various compartments. Methods for quantifying TCAA in aqueous and solid samples are summarized. Concentrations in various environmental compartments are presented, with a discussion of the possible formation of TCAA through natural processes. Concentrations of TCAA found to be toxic to aquatic and terrestrial organisms in laboratory and field studies were compiled and used to estimate risk quotients for soil and surface waters. TCAA levels in most water bodies not directly affected by point sources appear to be well below toxicity levels for the most sensitive aquatic organisms. Given the phytotoxicity of TCAA, aquatic plants and phytoplankton would be the aquatic species to monitor for potential effects. Given the concentrations of TCAA measured in various soils, there appears to be a risk to terrestrial organisms. Soil uptake of TCAA by plants has been shown to be rapid. Also, combined uptake of TCAA from soil and directly from the atmosphere has been shown. Therefore, risk quotients derived from soil exposure may underestimate the risk TCAA poses to plants. Moreover, TCE and TCA have been shown to be taken up by plants and converted to TCAA, thus leading to an additional exposure route. Mono- and di-chloroacetic acids can co-occur with TCAA in the atmosphere and soil and are more phytotoxic than TCAA. The cumulative effects of TCAA and compounds with similar toxic effects found in air and soil must be considered in subsequent terrestrial ecosystem risk assessments.     

微量元素对柠檬酸废水发酵回用的影响

本文研究了微量元素Cu2 、Fe2 、Zn2 、Mn2 、Mg2 和PO3-4 对柠檬酸中和废水发酵的影响。在经过“碱沉淀—离子交换法 (AIE法 )”处理后的废水培养基中分别加入 1× 1 0 -8g/mlMn2 、1× 1 0 -7g/mlZn2 、1× 1 0 -6 g/mlMg2 、1× 1 0 -5g/mlCu2 和 1 .5× 1 0 -2 g/mlPO3-4使产酸依次提高 2 .8%、9.0 %、1 0 .5 %、8.3%、7.2 %和 3.4 %。Fe2 的加入降低了柠檬酸产量。     

巯基改性壳聚糖复合材料的制备及其用于高容量去除水中Hg(Ⅱ)

摘  要  壳聚糖(CS)因其无毒害、可降解性、成本低等特点而在众多高分子材料中脱颖而出,但稳定性和选择性较差,从而限制了其在重金属吸附中的应用。以巯基丙酸 (MPA) 为改性剂,以1-乙基-(3-二甲基氨基丙基)碳酰二亚胺(EDC) 为活化剂,制备了CS-MPA复合材料,使用单一变量法优化制备条件。结果表明,最优制备参数为：改性时间6 h,温度20 ℃,pH=6,m_(CS:MPA:EDC)为1∶0.8∶1,制备得到的 CS-MPA在酸性条件下对Hg(II)依旧保持较高去除效率。在复合材料表面引入巯基后出现了多层堆叠的不规则形态,比表面积增大。CS-MPA对Hg(II)的吸附在 360 min 内可达到平衡,以单层吸热的化学反应为主,25 ℃时理论最大吸附容量推测为 833.3 mg·g⁻¹。吸附机理主要是材料上的软碱(—SH和—NH₂)与软酸 Hg(II)之间发生的螯合反应,其次为酰胺基的结合作用。CS-MPA对 Hg(II)有较高的吸附选择性;且经过5次的吸附-解吸循环后,去除率仍保持在较高水平。以上研究结果表明 CS-MPA对Hg(II)的去除效果较好,可为废水中Hg(II)的去除与回收提供参考。     

H2O2处理酸性大红GR染料废水的研究

通过对废水pH值、H2O2用量、催化剂用量、反应时间、反应温度等工艺条件的考察,确定了H2O2催化氧化处理酸性大红染料废水的最佳工艺条件pH 4、H2O2用量6 mL/L、催化剂用量3 g/L、反应时间100 min、反应温度70℃.在该条件下,COD和色度的去除率分别为76.7%和99.4%;通过反应前后的紫外-可见光光谱分析表明,H2O2催化氧化处理酸性大红GR染料废水有比较好的效果,为该工艺处理酸性大红GR染料废水提供了科学依据.     

模拟酸雨对磷酸二氢钾钝化污染土壤Cu、Cd、Pb和P释放的影响

以磷酸二氢钾(PDP)钝化后的重金属污染土壤为研究对象,通过室内土柱淋溶实验,考察在pH为3.5、4.5和5.6的模拟酸雨作用下土壤Cu、Cd、Pb和P的释放特征。结果表明:PDP处理较对照处理显著增加了淋出液中pH、电导率(EC)和总有机碳(TOC)含量,但不同pH模拟酸雨对对照和PDP处理淋出液pH、EC和TOC含量影响较小。对照处理中,正磷酸盐含量维持在较低水平(0.02~0.13 mg·L-1);PDP处理下,正磷酸盐含量在1~3 L和4~12 L分别是《地表水环境质量标准》(GB 3838-2002)五类水标准(总磷含量0.4 mg·L-1)的55.1~819倍和9.46~46.6倍,对地表水表现出较大的富营养化风险。PDP处理较对照处理显著降低了淋溶初期淋出液中的Cu、Cd和Pb含量,但是随模拟酸雨pH降低,对照和PDP处理的土壤淋出液中Cu、Pb含量均未表现出显著差异。因此,PDP处理能够显著钝化污染土壤中的Cu、Cd和Pb,但需关注酸雨淋溶下过量磷释放对地表水富营养化的潜在风险。     

超声和无机酸浸提猪粪中的重金属

对比研究了无机酸及超声对猪粪中重金属Cu、Zn和Mn的去除效果,并对处理前后猪粪中重金属形态变化进行分析。结果表明:无机酸浸提优化条件下Cu、Zn和Mn的浸出率分别为43.24%、76.28%和78.91%;超声协同无机酸浸提优化条件下Cu、Zn和Mn的浸出率分别为39.6%、76.3%和79.9%;2种浸提方式均能显著降低猪粪中重金属有机结合态含量。     

电厂低负荷下V-W/TiO2基NH3-SCR催化剂的低温改性

在不改变工业催化剂制备工艺的基础上,通过改性提高工业V-W/TiO2催化剂的低温活性。实验采用浸渍法,通过添加磷酸以及氧化铈来改性工业V-W/TiO2催化剂,探讨了新型低温SCR催化剂的脱硝活性。并通过比表面积测试（BET）,X射线衍射实验（XRD）,吡啶红外实验,程序升温还原（H2-TPR）等技术对催化剂理化性能进行表征。研究结果表明,1%磷酸添加量使催化剂表面的B酸以及弱酸含量大量增加,使催化剂向低温端降低了30 ℃;同时,在添加1%磷酸的基础上,添加不同含量氧化铈,提高催化剂的氧化还原性,发现添加8%氧化铈,使催化剂氧化还原性能显著增强,转化温度向低温再次降低了40 ℃。通过添加磷酸和氧化铈,使V-W/TiO2催化剂80%转化温度从280 ℃降至220 ℃,同时具备了高抗硫抗水性。     

采用Design-Expert分析多因素对电路板湿法拆解的影响与优化设计

废旧印刷电路板元器件拆解技术的研究是电子废弃物有效利用的重点环节。通过采用Design-Expert 8.0.6软件,对拆解过程中氟硼酸浓度,双氧水浓度和时间对铅、锡焊料的溶出率的影响趋势进行研究,得出最终优化实验方案为在双氧水浓度为0.5 mol·L-1、氟硼酸浓度为2.5 mol·L-1、反应时间为35 min的条件下铅、锡的溶出率分别为90.66%和99.91%,可视为铅、锡完全溶解并实现脱焊。该方法实现了电子元器件与印刷电路板的快速分离,将为电子废弃物的资源化提供理论支持和应用支撑。     

西部某机械加工企业酸洗场地环境调查与污染特征分析

以西北高原地区某铁塔厂酸洗车间为重点区,对场地开展系统的环境调查,结果表明：该场地以重金属锌污染为主要污染因子,场地内土壤Zn浓度范围13.68~68 800 mg·kg-1,局部区域土壤pH异常、土壤Fe含量和Cl-浓度升高现象;土壤Zn污染垂向迁移深,多数点位Zn污染（Zn含量超过200~500 mg·kg-1）深度达10 m以上,少数点位污染深度达15 m以下,其中北区酸池5 m以内、南区酸池3 m以内和下水管道及两侧区域3~10 m深度范围内为重污染;场地土壤pH异常范围与锌污染范围一致,土壤Cl-浓度和Fe浓度与Zn浓度具有相关性,可作为判断土壤锌污染程度和范围的辅助因子;现场速测的Zn含量与实验室总量测定结果一致性强,在pH异常区域的现场速测pH值与实验室测定结果的一致性较好,现场速测结果可作为污染表征的基础依据。推测酸池泄漏、含重金属洗液长期下渗和工业废水的直接排放为场地污染主要原因。