锅炉烟气脱硫技术发展综述

在调查研究的基础上，论述国内外烟道气脱硫技术的发展与前景，提出开发生产适合我国国情的烟气脱硫技术势在必行。还简要介绍了最为普遍的石灰／石灰石法脱硫基本原理。     

Spatial variations in daily average CO2 concentrations above wetland surface of Xianghai National Nature Reserve, China

Horizontal and vertical variations of daily average CO2 concentration above the wetland surface were studied in Xianghai National Nature Reserve of China in August, 2000. The primary purpose was to study spatial distribution characteristics of CO2 concentration on the four levels of height(0.1 m, 0.6 m, 1.2 m and 2 m) and compare the differences of CO2 concentration under different land covers. Results showed that daily average CO2 concentration above wetland surface in Xianghai National Natural Reserve was lower than that above other wetlands in northeast China as well as the worldwide average, suggesting that Xianghai wetland absorbed CO2 in August and acted as“sink” of CO2. The horizontal variations on the four levels of height along the latitude were distinct, and had the changing tendency of“decreasing after increasing” with the increase of height. The areas with obvious variations were consistent on different levels of height,and those with the highest variations appeared above surface of shore, sloping field, Typha wetland and Phragmites wetland; the vertical variations were greatly different, with the higher variations in Phragmites wetland and Typha wetland, and the lands near the shore and the sloping field with the lower variations. Spatial variations of daily average CO2 concentrations above wet!and surface were affected by surface qualities and land covers.     

SiO_2-TiO_2纳米管的制备及其光催化性能的研究

文章采用水热法制备SiO2-TiO2纳米管,通过扫描电镜(SEM)和透射电镜(TEM)考察了该纳米管的结构形态,并用X-射线衍射考察其晶体结构。实验结果表明所制得的纳米管是锐钛晶型,其两端开口,具有多层管壁;管径为8nm左右,管壁厚1～2nm。光催化降解酸性橙Ⅱ实验表明:SiO2-TiO2纳米管光催化速率比TiO2纳米管高出10%。这可能是因为Si元素的存在增大了钛纳米管的比表面积,同时SiO2的存在能降低光生电子和空穴的复合率。     

海水环境下玻璃纤维增强复合材料力学性能演化规律研究

目的 研究海水环境下海流能发电机组叶片用玻璃纤维复合材料力学性能的变化规律.方法 在实验室内通过海水浸泡试验、拉伸试验、弯曲试验以及剪切试验,测定叶片用玻璃纤维树脂基复合材料的吸水特性,以及在人工海水介质中各项力学性能参数的演变规律.结果 随着浸泡时间的增加,玻璃纤维树脂基复合材料吸水率先逐步增大、后趋于稳定,总吸水率约0.075％.抗拉强度呈先降低、后提高、又降低的趋势,抗拉强度最高可超过1100 MPa,最小值约为940 MPa.弹性模量和弯曲强度呈逐渐降低的趋势,弹性模量降幅约9.5％,弯曲强度降幅约为30％.弯曲模量变化起伏不定,变化幅度在15％以内.材料剪切强度呈先增大、后降低的趋势,最小值为189 MPa,较初始值高10 MPa.剪切模量呈先降低、后提高的现象,在浸泡28 d时,剪切模量最小,为16.4 GPa.结论 玻璃纤维增强树脂基复合材料经过长期海水浸泡后,拉伸及抗剪切性能略有降低,但降幅不大,抗弯性能下降明显,需要在叶片结构设计和强度计算时,充分考虑抗弯性能衰减的负面影响.     

新型负载型纳米TiO_2光催化降解苯酚的试验研究

以岩棉为载体制备一种新型负载型纳米TiO2,对有机污染物苯酚的降解效果较好。岩棉对苯酚有一定的吸附作用。经过120min的处理,苯酚基本上被完全降解。流速对降解率的影响较大,本试验选择流速为5mL/min。初始浓度越小,苯酚的降解效果越好。通入O2和加入适量H2O2均有利于苯酚的降解,且少量的H2O2可使苯酚的降解率大大提高。苯酚在pH=4.5时降解效果最好。     

用水基表面活性剂乳液回收废白土中蜡的界面张力研究

通过测定液体与废白土粉末之间的接触角及液体与蜡之间的液液界面张力，对水基表面活性剂乳液的溶剂及配方进行了优选，得到最佳的水基面活性剂乳液的组成为：质量分数０．２％的十二烷基苯磺酸钠＋体积分数为２．５％的乙醇＋体积分数为２５％的混合烃（正己烷＋苯，等体积）＋体积分数为７２．５％的水。实验证明，用该水基表面活性剂乳液处理废白土，蜡的回收率可达８０％，同时不破坏白土的颗粒结构。     

一种新型滑动集电材料的研制及性能研究

利用粉末冶金 /挤压的方法制作了一种新型的Cu C滑动集电材料 ,并对该材料的机械物理、摩擦磨损性能进行了检测 ,结果证明该材料具有较高的抗拉强度、适中的表面硬度、较低的电阻率、优良的摩擦磨损性能 ,是一种较为优良的电力机车滑板材料。其性能测试结果和铁道部标准要求相比 ,优于铁道部标准要求。     

半干法喷射烟气脱硫试验研究

介绍了半干法喷射烟气脱硫试验 ,研究了钙硫比、雾化水量、进口SO2 浓度、湿度等主要因素对脱硫率的影响规律 ,对布袋除尘器的辅助脱硫也进行了研究。结果将有助于改进半干法脱硫技术 ,并为进一步的工业应用提供了参考数据。     

味精废水处理研究

味精废水具有浓度高、粘性大、pH值低、SS含量高等特点 ,其中SO42 及NH3 N含量高 ,使味精废水处理难度大。用Ca(OH) 2 中和味精废水 ,从而找出味精废水进入生化段的最佳条件     

Photodegradation of acetochlor in water and UV photoproducts identified by mass spectrometry

The sunlight photodegradation half-lives of 20 mg/L acetochlor were 151, 154 and 169 days in de-ionized water, river water and paddy water, respectively. When exposed to ultraviolet (UV) light, acetochlor in aqueous solution was rapidly degraded. The half-lives were7.1, 10.1, and 11.5 min in de-ionized water, river water and paddy water, respectively. Photopreduets of acetochlor were identified by gas chromatography/mass spectrometry(GC/MS) and found at least twelve photoproducts resulted from dechlorination with subsequent hydrtrxylation and cyclization processes. The chemical structures of ten photoproducts were presumed on the basis of mass spectrum interpretation and literature data. Photoproducts are identified as 2-ethyl-6-methylaniline; N, N-diethylaniline ; 4, 8-dimethyl-2-oxo- 1,2,3,4- tetrahydroquino-line; 2-oxo-N-(2-ethyl-6-methylphenyl)-N-(ethoxymethyl) acetamide; N-(ethoxymethyl)-2‘-ethyl-6‘-methylformanilide; 1-hydroxyaeetyl-2-ethoxyl-7-ethylind ole; 8-ethyl-l-ethoxymethyl-2-oxo-1, 2, 3, 4-tetrahydroquinoline; 4, 8-dimethyl-l-ethoxymethyl-2-oxo-1, 2, 3, 4-tetrahydroquinoline; 2-hydroxy-2‘-ethyl-6‘-methyl-N-(ethoxymethyl) acetanilide and a compound related to acetochlor. The other two photoproducts were detected by GC/MS although their chemical structure was unknown.