SCAR处理城市生活污水的效能及其微生物群落动态分析

利用强化循环厌氧反应器(SCAR)处理模拟城市生活污水,研究不同负荷条件下的反应器运行特征、污泥特性及微生物种群结构.结果表明,水力停留时间(HRT)为6 h可以作为反应器高效运行的关键控制参数,该条件下污水化学需氧量(COD)去除率达到75%以上.随着反应器容积负荷的逐渐提高,颗粒污泥中辅酶F420和产甲烷活性(SMA)逐渐增加,胞外聚合物(EPS)含量也不断提高,其中紧密黏附EPS(TB-EPS)含量的增加尤其明显.厌氧颗粒污泥性状和反应器对污染物的去除效率同时受到污泥负荷和HRT的影响,微生物的群落结构及其在反应器中的空间分布也受到污泥负荷的影响,不同代谢特征微生物在反应器不同空间位置的相对丰度随着污泥负荷的调整而改变.     

低温条件IASBR处理养猪沼液脱氮性能研究

以实际养猪沼液为研究对象,考察分步进水间歇曝气序批式生物反应器(IASBR)在低温条件下的脱氮性能.结果表明:IASBR反应器的硝化性能临界水温为10℃,水温低于10℃时硝化性能急剧下降,水温10℃以上时氨氮去除率达到90%以上,且水温15℃以上氨氮负荷极限可达到0.30 kg·m~(-3)·d~(-1);低碳氮比(COD/TN)1.7±0.3条件下,反硝化性能临界水温为20℃,20℃以上时TN去除率可保持在80%以上,最高达90%,20℃以下时脱氮效率明显降低,出现亚硝态氮积累现象.此外,IASBR反应器脱氮除磷效率高,温度对TOC和TP去除率的影响不敏感.不排泥条件下,进水COD/TN为3.1±0.4时,TN去除率高达90%以上,TOC和TP去除率分别高达83.6%±3.9%和58.5%±17.8%;随后COD/TN降低至1.7±0.3后,TN去除率仍高达80%以上,TOC和TP去除率仅略有降低分别为77.3%±4.6%、53.1%±10.1%.     

两相厌氧工艺的研究进展

为了了解两相厌氧工艺的研究状况,对两相厌氧反应器及相分离方法进行了综述,并指出了今后两相厌氧工艺的研究方向.     

含锌废水处理技术的研究进展

综述了传统的物理化学法和生物法处理含锌废水的原理,系统阐述了其研究进展.微生物固定技术是一种新兴而有效的生物处理技术,尤其是硫酸盐还原菌固定化技术,将厌氧活性污泥包埋,构建稳定高效的微生物体系,以加强其抗毒性和处理效率.因此,在含锌废水处理方面具有很大的发展潜力,有望得到广泛应用.     

Emergency shutdown of fluidized bed reaction systems

With several industrial applications of fluidized bed technology recently commercialized worldwide, it becomes essential to develop safe operation methods for fluidized bed reaction systems (FBRSs) to prevent any influence on their process values, which lead to accidents. To preventing any disaster or malfunction in an FBRS, an emergency shutdown system (ESD) is initiated, closing the reaction system in case of any abnormality by effectively isolating the flammable gas. However, an ESD is also prone to the “inactivation problem,” in which in the case of failure it initiates the emergency shutdown, even when the operating conditions of the reaction system are abnormal. It is also vulnerable to a “malfunction problem,” where the emergency shutdown is performed even when the operating conditions of the reaction system are normal. In this study, these problems were solved by investigating a reaction system through the monitoring of appropriate parameters and setting up of trigger levels, which reflect the uniqueness of an FBRS using an ESD. The parameters were identified by analyzing the scenario leading to an accident. The trigger levels were determined as the points at which the loss is smaller in the presence of an ESD, as compared to the value of the loss function in the presence or absence of an ESD. Furthermore, the ESD design model was applied as a case study in the ammoxidation process of propylene. The results showed that an ESD can prevent an approximately 8 billion yen of loss due to accidents in plant operations, against an investment of 200 million yen.     

Degradation of polyacrylamide (PAM) and methane production by mesophilic and thermophilic anaerobic digestion: Effect of temperature and concentration

• PAM degradation in thermophilic AD in comparison with mesophilic AD. • PAM degradation and its impact on thermophilic and mesophilic AD. • Enhanced methane yield in presence of PAM during thermophilic and mesophilic AD. • PAM degradation and microbial community analysis in thermophilic and mesophilic AD. Polyacrylamide (PAM) is generally employed in wastewater treatment processes such as sludge dewatering and therefore exists in the sludge. Furthermore, it degrades slowly and can deteriorate methane yield during anaerobic digestion (AD). The impact or fate of PAM in AD under thermophilic conditions is still unclear. This study mainly focuses on PAM degradation and enhanced methane production from PAM-added sludge during 15 days of thermophilic (55°C) AD compared to mesophilic (35°C) AD. Sludge and PAM dose from 10 to 50 g/kg TSS were used. The results showed that PAM degraded by 76% to 78% with acrylamide (AM) content of 0.2 to 3.3 mg/L in thermophilic AD. However, it degraded only 27% to 30% with AM content of 0.5 to 7.2 mg/L in mesophilic AD. The methane yield was almost 230 to 238.4 mL/g VSS on the 8th day in thermophilic AD but was 115.2 to 128.6 mL/g VSS in mesophilic AD. Mechanism investigation revealed that thermophilic AD with continuous stirring not only enhanced PAM degradation but also boosted the organics release from the sludge with added PAM and gave higher methane yield than mesophilic AD.     

UASB-SBR组合工艺处理畜禽养殖废水的研究

近年来,随着中国畜禽养殖业的快速发展,落后的养殖模式和污染防治设施,使畜禽养殖污染日趋严重,畜禽养殖污染已居农业污染源之首,已成为中国环境污染的重要因素,对环境质量乃至人体健康都会产生不良影响。文中采用UASB—SBR组合工艺处理畜禽养殖废水,通过试验探讨SBR反应器启动方法及最佳运行模式,同时研究UASB反应器的启动方法。结果表明,SBR运行的最佳模式为进水0.5 h、反应8 h、沉淀1 h、出水0.5 h、闲置14 h。经过一段时间的启动,UASB和SBR反应器均成功启动,UASB—SBR组合工艺在处理畜禽养殖废水时可获得稳定的处理效果,COD、氨氮、总磷等出水水质均达到《畜禽养殖业污染物排放标准》(GB18596-2001)要求,为畜禽养殖废水处理的工程化应用提供了参考依据。     

ABR反应器的碱度变化及调控研究

研究了折流厌氧反应器(ABR)运行中碱度的变化情况及其与ABR各格室中VFA、pH和COD变化之间的关系.结果表明,碱度沿程变化与反应器的VFA浓度变化密切相关,碱度和pH值的最低点出现在VFA浓度最高点.碱度条件是通过pH值影响系统的运行.ABR沿程碱度和pH值变化都存在一个先降低后上升的过程.碱度控制一般以保证ABR沿程最低pH值不低于6.0为准,6.5以上为佳.进水碱度的下限与反应器的进水浓度密切相关.在低负荷COD条件下[3.7 kg/(m³·d)],保持ABR运行良好的最低碱度为800 mg/L.     

矿物材料对餐厨垃圾厌氧消化的影响研究

在试验的基础上研究了3种矿物材料膨润土、斜发沸石、粉煤灰对富含钠离子的餐厨垃圾厌氧消化过程的影响.结果表明,在发酵温度为35℃、底物固含量(TS)为10%、添加物用量为1%(质量分数,以消化底物计)时,膨润土、沸石粉、粉煤灰对含盐餐厨垃圾的厌氧发酵消化液中的钠离子具有良好的吸附性能,吸附率分别为13.75%、10.11%、7.99%.在未使用无机矿物的情况下,当钠离子浓度为3000～4000mg·L-1时,含盐餐厨垃圾的的厌氧消化过程受到Na 离子的明显抑制.从产气量分析,3种矿物材料均能明显促进餐厨垃圾的厌氧消化过程,与空白对照试组相比,膨润土、斜发沸石、粉煤灰分别使产气量提高了131%、82%和45%.三者对甲烷气产量的促进影响强弱顺序是,膨润土＞斜发沸石＞粉煤灰.初步讨论了这3种矿物材料提高餐厨垃圾厌氧消化甲烷产量的作用机理.     

污泥生物处理的研究与应用

污泥生物处理技术包括污泥前置及后置的处理。污泥前置处理可以通过微生物自身的新陈代谢和微生物种群之间捕食作用,以及对工艺和反应器的改良来实现污泥减量。污泥后置生物处理是指污泥消化,可以使用高温-中温共相厌氧消化和蛋形污泥消化器对污泥进行减量;这些方法从不同侧面反应了目前污泥生物处理研究现状以及最新进展。