利用原生质体诱变技术筛选脱落酸高产菌株

以葡萄孢属TB-3菌株为出发菌株制备其原生质体．在纤维素酶浓度为20g／L,蜗牛酶浓度为3g／L的酶解系统中,25℃酶解3h,其原生质体制备数可达67×105mL-1,在KYM上的再生率为46．1％,在KPDA上的再生率为33．6％,经过3轮原生质体紫外线诱变后回复再生,及对大量再生突变株进行发酵筛选,获得高产稳定株TB－3H8,其发酵液中ABA的质量浓度可达1．4g／L     

UV254nm+185nm光照降解气态甲苯的实验研究

研究了波长为254nm+185nm紫外光照射下,甲苯初始浓度、停留时间、相对湿度、O2浓度等因素对甲苯光降解效率的影响.通过定量UV254nm+185nm光照下体系中O3的产生浓度变化,以及降解过程中中间产物苯和苯甲醛的变化趋势,讨论了甲苯在UV254nm+185nm照射下降解机理.结果表明,甲苯去除率随着O2含量、停留时间的增加而升高;随着初始浓度的增加而降低.与湿度的关系为先急剧升高然后缓慢增加,而后降低,最佳相对湿度在40%~50%.当甲苯初始浓度为16.1mg/m3,O2含量为20%,相对湿度为40%时,体系对甲苯的降解效率为82.2%,降解速率为0.44mg/(m3·s),产生的O3浓度为131.13mg/m3,中间产物苯和苯甲醛的浓度分别为0.086,0.135mg/m3.在反应体系中,甲苯可吸收185nm波长紫外光直接降解,但主要被体系中产生的自由基氧化降解.     

The stable isotope signature of methane emitted from plant material under UV irradiation

Recent experiments have shown that dry and fresh leaves, other plant matter, as well as several structural plant components, emit methane upon irradiation with UV light. Here we present the source isotope signatures of the methane emitted from a range of dry natural plant leaves and structural compounds. UV-induced methane from organic matter is strongly depleted in both ¹³C and D compared to the bulk biomass. The isotopic content of plant methoxyl groups, which have been identified as important precursors of aerobic methane formation in plants, falls roughly halfway between the bulk and CH₄ isotopic composition. C3 and C4/CAM plants show the well-established isotope difference in bulk ¹³C content. Our results show that they also emit CH₄ with different δ¹³C value. Furthermore, δ¹³C of methoxyl groups in the plant material, and ester methoxyl groups only, show a similar difference between C3 and C4/CAM plants. The correlation between the δ¹³C of emitted CH₄ and methoxyl groups implies that methoxyl groups are not the only source substrate of CH₄.Interestingly, δD values of the emitted CH₄ are also found to be different for C3 and C4 plants, although there is no significant difference in the bulk material. Bulk δD analyses may be compromised by a large reservoir of exchangeable hydrogen, but no significant δD difference is found either for the methoxyl groups, which do not contain exchangeable hydrogen. The δD difference in CH₄ between C3 and C4 plants indicates that at least two different reservoirs are involved in CH₄ emission. One of them is the OCH₃ group, the other one must be significantly depleted, and contribute more to the emissions of C3 plants compared to C4 plants. In qualitative agreement with this hypothesis, CH₄ emission rates are higher for C3 plants than for C4 plants.     

Influences of working pressure on properties for TiO2 films deposited by DCpulse magnetron sputtering

TiO2 films were deposited at room temperature by DC pulse magnetron sputtering system.The crystalline structures,morphological features and photocatalytic activity of TiO2 films were systematically investigated by X-ray diffraction (XRD),atomic force microscopy and ultraviolet spectrophotometer,respectively.The results indicated that the working pressure was the key deposition parameters influencing the TiO2 film phase composition at room temperature,which directly affected its photocatalytic activity.With increasing the working pressure,the target self-bias decreases monotonously.Therefore,low temperature TiO2 phase (anatase) could be deposited with high working pressure.The anatase TiO2 films deposited with 1.4 Pa working pressure displayed the highest photocatalytic activity by decomposition of Methyl Orange solution,which the degradation rate reached the maximum (35%) after irradiation by ultraviolet light for 1 h.     

一种新型石墨电极的制备及其对苯酚的去除

为了探索一种对有机废水处理有效、廉价、来源广泛、环境友好的电极,以石墨、环氧树脂、固化剂和丙酮为原料,研究制备了一种新型石墨电极 (NGE). 分别采用热水浸泡、乙醇溶液回流、丙酮回流、超声-丙酮回流以及电化学法对制备的石墨电极进行预处理,前三者效果较差,超声-丙酮回流可改善处理效果,但不够理想,电化学法可取得满意的效果.苯酚降解的UV光谱分析表明,尽管商品石墨电极 (CGE) 比NGE具有更高的苯酚氧化效率,但其电解液积累大量的苯醌,而NGE电解液中苯醌积累量少,并且电解过程中逐渐降低. NGE比CGE具有更好的TOC去除效果,两者TOC去除率分别为40%和31%. SEM分析结果表明,CGE被严重腐蚀,NGE无明显变化,表现出良好的稳定性.     

紫外光降解反应器去除氯苯气体模型的建立与应用

从光化学反应过程出发,基于线性光源球面辐射能量分布（LSSE）,以反应器内部空间的辐射能吸收密度、空塔停留时间、进口浓度等为主要参数,建立了气相环境中紫外光化学反应器去除氯苯的数学模型.结果表明,建立的模型能很好地模拟和预测紫外光化学反应器对氯苯气体的去除性能.氯苯气体的紫外光化学反应表现出一级反应动力学的特征.该模型包含了紫外光降解反应器设计的主要参数,同时被用于预测了反应器在不同进口浓度和不同空塔停留时间条件下的出口氯苯浓度,进而获得不同进口浓度达标排放所需要的最小空塔停留时间,为气相污染物的紫外光降解反应器的设计与运行提供了重要的理论指导.     

颗粒物对紫外线灭活二级出水中粪大肠菌的影响

用低压紫外线照射具有相同颗粒物粒径分布的一系列水样,把实验结果带入二重动力学模型进行计算,评价自然状态下颗粒物对粪大肠菌的保护作用. 结果表明,二级出水中的大部分粪大肠菌都与颗粒物交连在一起;在颗粒物<10⁵ C·mL^-1时,颗粒物的增加会明显降低紫外线对二级出水中粪大肠菌的灭活率,但当颗粒物>10⁵ C·mL^-1时,这种影响不明显.从二重动力学模型的计算结果来看,对于不同颗粒物浓度的水样,难灭活的微生物所占的比重很小且比较稳定,大多数与颗粒物结合的粪大肠菌都较易被紫外线灭活.     

紫外线消毒后微生物的光复活特性及其评价方法

随着紫外线消毒技术应用的日益广泛,污水紫外线消毒后微生物的光复活特性值得关注。文章综述了光复活的机理、具有光复活能力的微生物种类、影响光复活的因素以及光复活的评价方式等,以期为系统研究光复活提供参考。具有复活能力的微生物种类较多,主要和体内所含光复活酶相关。影响光复活的因素涉及微生物、污水特性、紫外线系统及光复活条件四方面。评价光复活的方式至今没有统一标准。光复活及其对污水消毒的影响有待进一步深入研究。     

不同高级氧化法对水中低浓度药物甲硝唑降解过程的比较

采用UV、H₂O₂、UV/H₂O₂、Fenton、UV/Fenton和UV/TiO₂方法,对水中低浓度的药物甲硝唑进行降解。通过HPLC和UV-Vis光谱得到的甲硝唑去除率。详细讨论了Fe²⁺、TiO₂和H₂O₂的初始浓度以及溶液的初始pH值对降解效率的影响。结果表明,UV/Fenton和UV/TiO₂ 2种系统对水中低浓度甲硝唑均有很好的去除效果,但前者的光催化效率更高。在甲硝唑浓度=6 μmol/L,H₂O₂和Fe²⁺的初始浓度分别为0.5 mg/L和2.94 μmol/L,pH=4的条件下,UV/Fenton方法对甲硝唑水溶液光催化的最佳效率为95.8%。     

土壤渗滤对有机微污染物去除性能研究

采用土壤柱试验研究了土壤渗滤对再生水中有机微污染物的去除性能。结果表明,土壤柱对再生水中的DOC、UV₂₅₄、总氮和总磷有较好的去除效果,并具有较高的抗冲击负荷的能力;土壤表层10 cm厚度对DOC的去除起主要作用;UV₂₅₄和AOX在土壤表层10 cm厚度降解效果不明显,随着深度增加去除率逐渐升高;液相色谱有机碳探测(LC-OCD)检测结果表明,土壤柱对溶解性有机物质的去除主要体现在对多糖物质的降解上,其次是有机酸类,对腐殖质也有一定的去除作用。