电气石和微生物对水溶液中铅吸附研究

论文探讨了电气石、不同微生物、以及电气石与枯草芽孢杆菌(Baccillus subtilis,简写B.subtilis)联合对Pb2+的吸附效果。研究表明,溶液pH=5时,电气石吸附效率比B.subtilis高7.9％,当溶液pH值升到55时,B.subtilis和电气石对Pb2+的吸附效率均升高,但B.subtili...     

西辽河流域沙土的氨氮解吸行为研究

采用小型回填式土柱淋溶实验方法研究了西辽河流域沙土的氨氮解吸行为。结果表明,西辽河流域沙土的氨氮解吸行为符合Langmuir和Freundlich解吸等温式;沙土氨氮解吸比率Dr在0.44～0.99之间,平均为0.75,解吸迟滞性指数TⅡ在0.05～0.65之间,平均为0.29,沙土对氨氮的解吸迟滞性较强,解吸可逆性较弱。被吸附的氨氮解吸淋失的环境风险较小;沙土氨氮解吸比率Dr与土壤有机质含量、粘粒含量和粗粘粒含量呈极显著负相关,影响程度顺序为:有机质含量>粗粘粒含量>粘粒含量;解吸分配系数k和解吸迟滞性指数与土壤有机质含量分别呈极显著和显著正相关,与粘粒含量和粗粘粒含量没有相关性;草地、农田和林地结构由于土壤有机质和团聚体含量较高,氨氮解吸迟滞性较强,氨氮流失的环境风险较小,沙荒地结构氨氮流失的环境风险较大。     

磁性膨润土材料吸附处理印染废水研究

针对目前膨润土在应用中的一些问题,对膨润土进行磁性能改性,通过共沉淀法制备磁性膨润土颗粒,并对其进行了X射线衍射和磁性能表征分析.以阴离子染料OrangeⅡ为目标化合物,研究了磁性膨润土材料对OrangeⅡ废水的吸附效果,并探讨了主要工艺参数如阳离子表面活性剂的质量浓度、pH、温度等对染料去除率的影响.结果表明:阳离子...     

粉煤灰对混合染料的吸附性能研究

以燃煤废弃物粉煤灰作为吸附剂,对活性红23和分散蓝56混合染料溶液进行吸附性能研究.实验结果表明:粉煤灰优先吸附离子型的活性染料,混合溶液中对活性红23的吸附能够在30 min达到平衡,而对分散蓝56的吸附则需要150 min才能够达到平衡,吸附动力学符合准二级吸附模型.在弱酸性环境中粉煤灰对分散染料的脱色高于碱性环境...     

粉煤灰基质复合滤料吸附Mn^2＋试验研究

以粉煤灰基质复合滤料为吸附材料,通过单因素和正交实验相结合的实验方法,考察了吸附滤料投加量、吸附时间、原水初始浓度、振荡频率、温度等因素对除锰效果的影响。从单因素实验可知：随着滤料质量的增大,Mn2＋去除率在开始时增长幅度较大,后来逐渐趋于平缓。在正交实验中固定滤料投加量为300 g/L,发现在锰离子的吸附过程中,吸附时间的影响最大,随后分别是原水浓度和温度,振荡频率的影响程度最小。     

对羟基联苯在黄河兰州段底泥上的吸附行为

为研究典型有机污染物在黄河兰州段的吸附规律及影响因素,以黄河兰州段的底泥为供试样品,选择对羟基联苯(phydroxy biphenyl,PHB)为代表性有机污染物,采用批量实验法研究了底泥对PHB的吸附动力学和热力学特征及其影响因素.结果表明,黄河兰州段底泥对PHB吸附动力学的最优模型为准二级动力学模型,吸附热力学过程更符合单分子层吸附的Langmuir等温吸附模型(R20.974),在25~45℃温度范围内,PHB在黄河兰州段底泥上的吸附平均自由能(E)在0.913~1.00 k J·mol~(-1)之间,吸附过程中,ΔGθ和ΔHθ均小于0,ΔSθ均大于0,表明黄河兰州段底泥对PHB的吸附过程主要是物理吸附,属于自发放热过程且体系的混乱度是增加的.分析黄河兰州段底泥对PHB吸附影响因素的结果表明,粒径越小,黄河底泥对PHB的吸附量越大;PHB的初始质量浓度越高,黄河底泥对PHB的吸附量越大;当p H在4.23~7.00之间时,吸附量随pH升高而缓慢下降,当pH7.00时,吸附量随pH升高急剧下降,且在pH=10.3附近,吸附量几乎为零;体系中离子强度增大,PHB吸附量增大,但当离子强度到一定值时,由于竞争吸附作用,会抑制底泥对PHB的吸附,造成吸附量的下降.     

Removal of phosphate from wastewater using alkaline residue

Alkaline residue(AR) was found to be an efficient adsorbent for phosphate removal from wastewater. The kinetic and equilibrium of phosphate removal were investigated to evaluate the performance of modified alkaline residue. After treatment by NaOH(AR-NaOH), removal performance was significantly improved, while removal performance was almost completely lost after treatment by HCl(AR-HCl). The kinetics of the removal process by all adsorbents was well characterized by the pseudo second-order model. The Langmuir model exhibited the best correlation for AR-HCl, while AR was effectively described by Freundlich model. Both models were well fitted to AR-NaOH. The maximum adsorption capacities calculated from Langmuir equation were in following manner: AR-NaOH AR AR-HCl. Phosphate removal by alkaline residue was pH dependent process. Mechanisms for phosphate removal mainly involved adsorption and precipitation, varied with equilibrium pH of solution. For AR-HCl, the acid equilibrium pH( 6.0) was unfavorable for the formation of Ca-P precipitate, with adsorption as the key mechanism for phosphate removal. In contrast, for AR and ARNaOH, precipitation was the dominant mechanism for phosphate removal, due to the incrase on pH( 8.0) after phosphate removal. The results of both XRD and SEM analysis confirmed CaHPO4·2H2O formation after phosphate removal by AR and AR-NaOH.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

桑枝基吸附剂的制备及其对阴离子染料的吸附

为了废弃桑枝的资源化,利用3-氯-2-羟丙基三甲基氯化铵(CTA)对桑枝进行醚化改性制备桑枝基吸附剂,通过正交实验优化了吸附剂的制备条件。采用制备的吸附剂吸附水中阴离子染料日落黄,研究了pH值、吸附剂投加量、吸附时间和吸附温度对吸附效果的影响,测定了日落黄在吸附剂上的吸附等温线。结果表明,制备吸附剂的最佳工艺条件为CTA与桑枝粉的质量比为0.5,NaOH与桑枝粉的质量比为1.0,微波功率为300 W,反应时间为3 min。制备的吸附剂对质量浓度为50 mg/L的日落黄的最大吸附去除率达92.0%。日落黄在吸附剂上的等温吸附线可用Langmuir方程和Freundlich方程来描述,饱和吸附容量为18.21 mg/g,吸附易于进行。吸附速率数据可以用准二级吸附动力学方程拟合,说明日落黄在吸附剂上的吸附以化学吸附为主。     

普光气田含硫污水尾气处理工艺应用与优化

针对中国石化普光气田产出水属于典型的含硫污水,密闭处理系统中产生大量高含硫尾气,论述了尾气处理工艺中存在的问题,优化了单一的生物除硫、活性炭吸附工艺,增加了一级碱洗、氧化除硫工艺,实现尾气达标排放。