可发性聚苯乙烯废水处理工程的设计与运行

介绍了采用中和混凝 水解酸化 生物接触氧化 化学除磷工艺对可发性聚苯乙烯 (EPS)废水的处理工艺。在废水中的CODCr、TP、SS、NH3 N分别为 194 0mg L、112mg L、5 92mg L、2 3 6mg L的条件下 ,废水经过处理后 ,出水CODCr、TP、SS、NH3 N分别为 70mg L、0 38mg L、2 6mg L、0 32mg L ,均可达到《污水综合排放标准》中的一级标准 ,废水中CODCr、TP、SS、NH3 N的平均去除率分别为 96 4 %、99 3%、95 6 %、98 6 %。     

生化-砂滤-光催化氧化处理苎麻脱胶废水

根据苎麻脱胶废水的水质特点 ,选择了水解酸化 -接触氧化 -砂滤 -光催化氧化处理工艺 ,结果表明 ,出水水质达到了GB8978 1996二级排放标准 ,大部分指标达到了一级排放标准。该工艺具有针对性强、占地面积少、运行稳定、处理费用低、操作管理方便、无二次污染等优点 ,值得推广应用     

A2/O工艺处理氨纶废水的应用研究

介绍了采用厌氧-缺氧-接触氧化(即A2/O)组合工艺处理氨纶生产废水的流程和设计参数,通过近半年的调试数据,反应季节对A2/O组合工艺处理氨纶生产废水的影响和可行性。提出运行过程中需要控制的参数,提供设计和运行参考。     

高级氧化技术强化皮革废水生化处理效果初探

皮革废水中含大量难降解有机物,导致常规好氧生化处理速率低、效果差.实验考察了在Us(超声波)、UV(紫外光)、US/Fenton、UV/Fenton等高级氧化技术强化作用下的生化处理效果,结果表明,在相同水质和实验条件下,废水经Us、UV处理30min后可使后续生化反应速率显著提高,分别反应8h、24h后的COD去除率即可达到直接经微生物处理48h后达到的48%,但延长反应时间至48h对COD去除率没有明显提高;Fenton试剂强化US、UV的处理效果要高于单独Us、UV工艺,经30min预处理,随后在微生物作用下分别反应4h和8h即可达到45%和51%的COD去除率,同时延长反应时间也能使最终COD去除率明显提高,反应48h后,COD去除率可分别提高至64%和72%.     

硫酸厂淤泥中SRB的选育及特性研究

从硫酸厂废水淤泥中分离筛选出了一株 SRB,其菌体形态呈弧状或细杆状 ,成熟细胞大小 0 .4～ 0 .6× 3 .0～ 5 .0μm,摇摆式运动 ,单极生鞭毛 ,芽孢染色阴性 ,革兰氏染色阴性 ;最适生长 p H6.0～ 6,5 ;适量氧气不会影响细菌生长 ,菌体内含过氧化氢酶。本文还探讨了该类细菌的分离培养方法 ,考察了分离菌部分生理生化特征及对硫酸盐还原能力 ,优化了培养基配方 ,并初步鉴定分离菌为脱硫弧菌     

Fulvic acid removal by nanoparticle TiO2 using a submerged membrane photocatalysis reactor

The degradation of fulvic acid（FA） by nanoparticle TiO2 in a submerged membrane photocatalysis（SMPC） reactor was studied. In this reactor, photocatalytic oxidation and membrane separation co-occured. The continuous air supplier provided O2 for the photocatalytical reaction and mixed the solution through an airflow controller. The particle TiO2 could automatically settle due to gravity without particle agglomeration so it could be easily separated by microfiltration（MF） membrane. It was efficient to maintain high flux of membranes. The effects of operational parameters on the photocatalytic oxidation rate of FA were investigated. Results indicated that photocatalyst at 0.5 g/L and airflow at 0.06 m^3/h were the optimum condition for the removal of fulvic acid, the removal efficiency was higher in acid media than that in alkaline media. The effects of different filtration duration on permeate flux rate of MF with P25 powder and with nanoparticle TiO2 were compared. Experimental results indicated that the permeate flux rate of MF was improved and the membrane fouling phenomenon was reduced with the addition of nanoparticle TiO2 catalyst compared with conventional P25 powder. Therefore, this submerged membrane photocatalysis reactor can faciliate potential application of photocatalytic oxidation process in drinking water treatment.     

Characterization of sulfide oxidation and optimization of sulfate production by a thermophilic Paenibacillus naphthalenovorans LYH-3 isolated from sewage sludge composting

The sulfur-containing odor emitted from sludge composting could be controlled by sulfide oxidizing bacteria, yet mesophilic strains show inactivation during the thermophilic stage of composting. Aimed to investigate and characterize the thermotolerant bacterium that could oxidize sulfide into sulfate, a heterotrophic strain was isolated from sewage sludge composting and identified as Paenibacillus naphthalenovorans LYH-3. The effects of various environmental factors on sulfide oxidation capacities were studied to optimize the sulfate production, and the highest production rate (27.35% ± 0.86%) was obtained at pH 7.34, the rotation speed of 161.14 r/min, and the inoculation amount of 5.83% by employing Box-Behnken design. The results of serial sulfide substrates experiments indicated that strain LYH-3 could survive up to 400 mg/L of sulfide with the highest sulfide removal rate (88.79% ± 0.35%) obtained at 50 mg/L of sulfide. Growth kinetic analysis presented the maximum specific growth rate µ_m (0.5274 hr⁻¹) after 22 hr cultivation at 50°C. The highest enzyme activities of sulfide quinone oxidoreductase (0.369 ± 0.052 U/mg) and sulfur dioxygenase (0.255 ± 0.014 U/mg) were both obtained at 40°C, and the highest enzyme activity of sulfite acceptor oxidoreductase (1.302 ± 0.035 U/mg) was assessed at 50°C. The results indicated that P. naphthalenovorans possessed a rapid growth rate and efficient sulfide oxidation capacities under thermophilic conditions, promising a potential application in controlling sulfur-containing odors during the thermophilic stage of sludge composting.     

利用光合细菌处理养猪场污水的试验研究

采用煤渣作为填料 ,光合细菌培养物作为挂膜菌的生物接触氧化法 ,对养猪场污水处理进行了试验研究 ,结果表明 :CODCr,NH3 N ,NO-2 N ,S2 - 的平均去除率分别达到 89 3% ,80 1 % ,90 6% ,82 4% ;水中光合细菌数从580个 /mL增加到 4 8× 1 0 4 个 /mL ,达到了废水资源化的目的。     

Au/ZnO催化剂的表征及常温常湿 条件下CO氧化性能研究

常温下考察了焙烧温度、金含量及水分对Au/ZnO催化剂上CO氧化性能的影响 ,并在常湿条件下考察了ZnO上CO氧化活性同温度的关系。结果表明 ,金的存在极大地提高了催化剂CO的氧化活性。另外焙烧温度和金含量对Au/ZnO催化剂的活性和稳定性均有较大影响 ,在常温常湿条件下 ,2 4 0℃焙烧的 2 %Au/ZnO催化剂 ,可连续反应 1 750h保持CO完全转化。XRD结果表明 ,锌的化学状态对催化剂的稳定性有较大的影响 ,氧化锌较碳酸锌表现出较高的稳定性。     

生物除磷机理及试验研究

介绍了生物除磷机理、生物除磷系统的积磷细菌、生物除磷所需的环境条件。SBR法除磷的试验研究表明,应用SBR活性污泥系统进行除磷,需要一定的厌氧条件;且须在厌氧阶段进行充足的曝气。试验结果证明,SBR法在时间上控制的灵活性非常适合生物除磷的环境条件。厌氧与好氧相结合,能够提高磷的去除率或降低出水磷的浓度,磷的去除率可达90%左右。