Comparison of UV-based advanced oxidation processes for the removal of different fractions of NOM from drinking water

This study examined the effectiveness for degradation of hydrophobic (HPO), transphilic (TPI) and hydrophilic (HPI) fractions of natural organic matter (NOM) during UV/H₂O₂, UV/TiO₂ and UV/K₂S₂O₈ (UV/PS) advanced oxidation processes (AOPs). The changing characteristics of NOM were evaluated by dissolved organic carbon (DOC), the specific UV absorbance (SUVA), trihalomethanes formation potential (THMFP), organic halogen adsorbable on activated carbon formation potential (AOXFP) and parallel factor analysis of excitation–emission matrices (PARAFAC-EEMs). In the three UV-based AOPs, HPI fraction with low molecular weight and aromaticity was more likely to degradate than HPO and TPI, and the removal efficiency of SUVA for HPO was much higher than TPI and HPI fraction. In terms of the specific THMFP of HPO, TPI and HPI, a reduction was achieved in the UV/H₂O₂ process, and the higest removal rate even reached to 83%. UV/TiO₂ and UV/PS processes can only decrease the specific THMFP of HPI. The specific AOXFP of HPO, TPI and HPI fractions were all able to be degraded by the three UV-based AOPs, and HPO content is more susceptible to decompose than TPI and HPI content. UV/H₂O₂ was found to be the most effective treatment for the removal of THMFP and AOXFP under given conditions. C1 (microbial or marine derived humic-like substances), C2 (terrestrially derived humic-like substances) and C3 (tryptophan-like proteins) fluorescent components of HPO fraction were fairly labile across the UV-based AOPs treatment. C3 of each fraction of NOM was the most resistant to degrade upon the UV-based AOPs. Results from this study may provide the prediction about the consequence of UV-based AOPs for the degradation of different fractions of NOM with varied characteristics.     

Catalytic oxidation effect of MnSO4 on As(III) by air in alkaline solution

The catalytic oxidation effect of MnSO₄ on As(III) by air in an alkaline solution was investigated. According to the X-ray diffraction (XRD), scanning electron microscope-energy dispersive spectrometer (SEM-EDS) and X-ray photoelectron spectroscopy (XPS) analysis results of the product, it was shown that the introduction of MnSO₄ in the form of solution would generate Na_0.55Mn₂O₄·1.5H₂O with strong catalytic oxidation ability in the aerobic alkaline solution, whereas the catalytic effect of the other product MnOOH is not satisfactory. Under the optimal reaction conditions of temperature 90°C, As/Mn molar ratio 12.74:1, air flow rate 1.0 L/min, and stirring speed 300 r/min, As(III) can be completely oxidized after 2 hr reaction. The excellent catalytic oxidation ability of MnSO₄ on As(III) was mainly attributed to the indirect oxidation of As(III) by the product Na_0.55Mn₂O₄·1.5H₂O. This study shows a convenient and efficient process for the oxidation of As(III) in alkali solutions, which has potential application value for the pre-oxidation of arsenic-containing solution or the detoxification of As(III).     

镧、铈对厌氧颗粒污泥产甲烷的Hormesis效应及其动力学研究

间歇培养条件下研究了单一稀土元素镧(La3 )和铈(Ce3 )在不同浓度水平下对厌氧颗粒污泥活性及其动力学行为的影响.结果表明,La3 和Ce3 对厌氧颗粒污泥比产甲烷活性有促进作用的浓度范围均为0.01～0.1 mg·L-1,促进作用浓度峰值均为0.05mg·L-1,最大促进百分比分别为10.35%和20.79%;La3 和Ce3 对SMA(比甲烷活性)的半抑制浓度分别为5mg·L-1和1000mg·L-1,La3 较易对污泥产生抑制作用.米-门方程可以用来描述厌氧消化过程中甲烷发酵阶段的动力学行为,稀土元素La3 和Ce3 投加至反应系统后,提高了甲烷发酵过程的动力学常数Vmax和半饱和常数Ks.     

皮革和毛皮加工废水处理技术

采用混凝沉淀-酸化水解-悬挂链曝气-生物接触氧化组合工艺处理皮革和毛皮加工生产废水。实验结果表明;进水COD为2400mg/L,处理后出水COD≤100mg/L,去除率≥95.8%。各项水质指标均稳定地达到了GB8978-96污水综合排放一级标准。     

Promotional effect of cobalt doping on catalytic performance of cryptomelane-type manganese oxide in toluene oxidation

The cryptomelane-type manganese oxide (OMS-2)-supported Co (xCo/OMS-2; x = 5, 10, and 15 wt.%) catalysts were prepared via a pre-incorporation route. The as-prepared materials were used as catalysts for catalytic oxidation of toluene (2000 ppmV). Physical and chemical properties of the catalysts were measured using the X-ray diffraction (XRD), Fourier transform infrared spectroscopic (FT-IR), scanning electron microscopic (SEM), X-ray photoelectron spectroscopy (XPS), and hydrogen temperature-programmed reduction (H₂-TPR) techniques. Among all of the catalysts, 10Co/OMS-2 performed the best, with the T_90%, specific reaction rate at 245°C, and turnover frequency at 245°C (TOF_Co) being 245°C, 1.23 × 10⁻³ mol_toluene/(g_cat·sec), and 11.58 × 10⁻³ sec⁻¹ for toluene oxidation at a space velocity of 60,000 mL/(g·hr), respectively. The excellent catalytic performance of 10Co/OMS-2 were due to more oxygen vacancies, enhanced redox ability and oxygen mobility, and strong synergistic effect between Co species and OMS-2 support. Moreover, in the presence of poisoning gases CO₂, SO₂ or NH₃, the activity of 10Co/OMS-2 decreased for the carbonate, sulfate and ammonia species covered the active sites and oxygen vacancies, respectively. After the activation treatment, the catalytic activity was partly recovered. The good low-temperature reducibility of 10Co/OMS-2 could also facilitate the redox process accompanied by the consecutive electron transfer between the adsorbed O₂ and the cobalt or manganese ions. In the oxidation process of toluene, the benzoic and aldehydic intermediates were first generated, which were further oxidized to the benzoate intermediate that were eventually converted into H₂O and CO₂.     

接触氧化-电解工艺处理印染废水

主要介绍了采用生物接触氧化 电解工艺处理印染废水的设计及运行情况。处理系统运行结果表明 :当进水CODCr、BOD5和色度分别为 764 5mg L、2 63 7mg L和 42 0倍时 ,系统出水CODCr、BOD5和色度分别为 160 5mg L、48 9mg L和 12倍 ,去除率分别为 79%、81 5 %和 97 1%。该工艺运行稳定 ,操作控制方便     

全程自养脱氮工艺的研究

以悬浮填料床作为全程自养脱氮反应器，用不含有机碳的合成氨氮废水进行反应器的启动。系统的氨氮和总氮去除率分别达80％和60％左右。通过批式实验对全程自脱氮做进一步的研究。结果表明，通过控制反应器中DO的浓度，可以控制氨氧化和反硝化的比率；当DO为0.8mg/L时，氨氮几乎完全转化为氮气，氨氧化和反硝化在此时达到了动态平衡；在低DO情况下，氨氮和亚硝氮同时存在，氨氮和总氮的转化率都大幅度的提高，说明氨氮可以亚硝氮为电子受体，在无外加有机碳源的情况下进行反硝化。     

MAP法处理氨氮废水最佳条件的研究

MAP法是一种比较新颖有效的处理氨氮的方法，该方法是通过化学沉淀的方式使废水中的氨氢浓度降到很低。而且沉淀反应不受温度、水中毒素的限制。由单项试验以及正交实验的方法对MAP法处理氨氮废水的工艺进行优化研究，结果表明，在pH=8.5，反应时间为3h,Mg:N:P=1:3:1.0:1.1时为较佳反应条件；氨氮的去除率随着反应时间的增加而增加，随着Mg:N比值的增加而增加。     

氧化塘处理高速公路服务区污水技术初探

提出并试验研究了氧化塘处理高速公路服务区污水的方法，所得结果可用于高等级公路服务区及管理区污水处理。     

长炼第二污水处理场氧化沟工艺运行小结

臭伯尔氧化沟池容大，停留时间长，运行稳定，对氧化沟污泥培养及开工运行进行了小结，并结合运行过程中的几个问题进行了分析和探讨。