A~2/O工艺厌氧池有机物降解动力学模型对比研究

试验考察了东阿县污水处理厂一期A2/O工艺厌氧池去除有机污染物效能,当进水ρ(COD)为548.3 mg/L时,厌氧池平均去除率达78.7%。同时探讨了几种常见数学模型模拟厌氧池去除有机物规律情况,根据实际工程监测数据确定有机底物降解动力学常数,得出Grau模型、Stover-kincannon模型和改进的Monod模型较适合模拟厌氧池去除有机物的规律,并对模型进行了检验。     

酸化液对厌氧释磷好氧吸磷速率的影响研究

采用序批式试验研究了酸化液对聚磷菌厌氧释磷好氧吸磷速率的影响。同一活性污泥混合液中聚磷菌的释磷潜力相当,混合液中挥发性脂肪酸越多则越有利于激发聚磷菌的释磷潜能。酸化液投加量越大,对应的混合液中聚磷菌的平均释磷速率也越大。当酸化液投加量为30 mg/L(以TOC计)时,聚磷菌的平均释磷速率达0.137 mg/(mg.d),是未投加酸化液工况的3.26倍。聚磷菌厌氧释磷过程中,活性污泥的MLVSS值逐渐增大,而MLSS值却不断减小,这是由聚磷菌释磷反应过程中聚磷颗粒和糖原的消耗,以及PHB的生成而产生的。碳源充足与否,对聚磷菌的平均好氧吸磷速率影响不大,研究各工况中,聚磷菌的平均吸磷速率在0.129~0.160 mg/(mg.d)内。碳源越充足,则聚磷菌在好氧吸磷反应持续的时间越长,因此,具有更强的超量吸磷能力。酸化液投加量为20 mg/L时(以TOC计),聚磷菌在好氧吸磷结束时,出水的SP浓度能减少到0.5 mg/L以下。     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Effect of anaerobic digestion on the high rate of nitritation, treating piggery wastewater

Laboratory reactors were operated by using piggery wastewater and the effluent of anaerobic digester from piggery wastewater plants to study the effect of anaerobic digestion on nitritation rate.     

成渝经济区矿产资源开发对其生态环境影响评价

文章以成渝经济区为研究区,根据成渝经济区矿产资源开发和生态环境特点,综合运用RS和GIS技术,结合研究区矿产资源总体规划、生态功能区划、生物多样性保护、自然保护区、水源涵养、土壤保持、生态脆弱区分区等数据,采用空间图层叠加法,分析矿产资源开发利用对生态环境的影响,进一步分析了未来矿产资源的开发对区域主要生态屏障的水源涵养、土壤保持、生物多样性保护等生态功能的影响,并提出针对性的生态环境保护对策措施。     

成都地铁4号线施工期环境影响分析及对策

文章分别从施工噪声及振动环境、大气环境、水环境等方面分析了成都地铁4号线一期工程施工期对环境的影响,指出了上述几个方面对环境要素的影响范围及程度,并提出了对噪声振动源集中布置、合理安排作业时间、工地内定期洒水防尘、施工污废水分类处理排放等防治对策,最后从工程实施全过程的角度提出了加强环境管理的具体措施。     

基于生态系统的水环境压力分区指标体系构建

为了科学合理的完成水环境压力分区,构建水环境压力分区指标体系是其关键和基础.鉴于水环境压力涉及因素的系统性.相互联系性,从生态系统的角度考虑选取水环境压力分区指标十分必要;由于水环境压力涉及方面的相互联系性,其表征指标之间往往存在信息量的重叠,为了避免信息的重复表达,减少不必要的工作量,同时避免冗余指标带来的干扰,需对...     

控制游离氨实现单级自养生物脱氮的研究

通过实时调控SBR反应器内的游离氮浓度的控制策略,实现以亚硝化作用和厌氧氨氧化作用协同的单级自养生物脱氮工艺.实验分成亚硝酸菌富集和厌氧氨氧化菌混合接种2个阶段,SBR内的温度始终保持在(31±2)℃.亚硝酸菌富集阶段,pH值稳定在7.8左右,通过调节进水氩氮浓度(56～446 mg·L-1)实现FA浓度的变化,从而实...     

矿山固体废物的环境影响与综合利用

环境保护和自然资源的合理利用是人类社会可持续发展的基础。矿山固体废物对环境的影响可归纳为污染环境、破坏生态及诱发地质和工程灾害等三个方面。矿山固体废物也是一种可利用的自然资源,目前的利用途径主要有回收利用有用元素,工业原料、回填材料、能源发电、农用肥料和土壤改良剂等。     

丽江古城水环境质量变化趋势浅析

通过对丽江古城2002年～2010年水环境质量情况及变化趋势的分析,找出水质不断下降的原因,提出了古城水环境保护的相应对策和措施。