活性污泥3号模型对实际工艺的模拟与分析

将活性污泥3号模型(ASM3)与Takács二沉池模型以及反应池流态模型相结合,构建了活性污泥系统模型,并采用Visual Basic 6.0语言编写了计算机模拟程序.将此程序应用于分段进水A/O脱氮工艺中试工艺,分别对其进行了稳态模拟和动态模拟,并取得了与实测值较为接近的结果.同时利用模型分析了运行控制参数对出水水质的影响,模拟结果与实际状况吻合.     

反硝化聚磷机理试验

通过实验研究缺氧反硝化聚磷 ,揭示DPB细菌在厌氧和缺氧交替环境下的厌氧释磷、缺氧反硝化吸磷及CODCr变化规律。结果表明 ,DPB细菌在缺氧条件下可利用NO-3 作最终电子受体进行吸磷 ,其吸磷效果及反硝化速率高于常规脱氮除磷工艺。     

An innovative approach to minimize excess sludge production in sewage treatment using integrated bioreactors

The present investigation deals with an application of integrated sequential oxic and anoxic bioreactor(SOABR) and fluidized immobilized cell carbon oxidation(FICCO) reactor for the treatment of domestic wastewater with minimum sludge generation. The performance of integrated SOABR-FICCO system was evaluated on treating the domestic wastewater at hydraulic retention time(HRT) of 3 hr and 6 hr for 120 days at organic loading rate(OLR)of 191 ± 31 mg/(L·hr). The influent wastewater was characterized by chemical oxygen demand(COD) 573 ± 93 mg/L; biochemical oxygen demand(BOD5) 197 ± 35 mg/L and total suspended solids(TSS) 450 ± 136 mg/L. The integrated SOABR-FICCO reactors have established a significant removal of COD by 94% ± 1%, BOD5 by 95% ± 0.6% and TSS by 95% ± 4% with treated domestic wastewater characteristics COD 33 ± 5 mg/L; BOD59 ± 0.8 mg/L and TSS 17 ± 9 mg/L under continuous mode of operation for 120 days. The mass of dry sludge generated from SOABR-FICCO system was 22.9 g/m~3. The sludge volume index of sludge formed in the SOABR reactor was 32 mL/g and in FICCO reactor it was 46 mL/g. The sludge formed in SOABR and FICCO reactor was characterized by TGA, DSC and SEM analysis. Overall, the results demonstrated that the integrated SOABR-FICCO reactors substantially removed the pollution parameters from domestic wastewater with minimum sludge production.     

折流式水解反应器处理印染废水温影响研究

在水温为5℃、9．7℃、14．9℃、19．7℃、23．5℃和31．1℃6种温度的条件下，应用折流式水解反应器对印染废水进行水解试验研究。结果表明，提高水温可增大COD、色度及UVA254的去除效率，相应的ORP值变小，pH值升高，水解程度加深。水温5℃时，水解效果较差；水温在10—23．5℃内，水解效果相对较好，31．1℃水解效果最好，研究结果能为工程应用提供一定的参考。     

缺氧-SBR法-混凝法工艺处理垃圾渗滤液的试验研究

采用缺氧 -SBR法 -混凝沉淀复合工艺对城市垃圾渗滤液进行处理 ,确定缺氧、SBR法和混凝的最佳运行参数。结果表明 ,通过该系统处理后 ,COD总去除率达到 91.2 % ,NH3 N去除率达 90 .4 % ,取得较好的去除有机物和脱氮效果     

利用亚硝酸盐的反硝化除磷菌及影响因素

反硝化聚磷菌(DPB)是一类能够在厌氧状态下释磷,缺氧存在硝酸盐(NO3-)或亚硝酸盐(NO2-)的情况下聚磷,并同时反硝化的聚磷菌。实验证明:传统A2/O工艺缺氧段污泥确实存在利用亚硝酸盐的反硝化聚磷菌,PO、PON和PONO各占聚磷菌的40.7%、38.5%,20.8%。最佳的进水C/N/P为16∶4∶1且COD<200mg/L;pH值为7～7.5。聚磷菌在ORP<-80mV开始吐磷,在ORP值在-150mV左右能较好地吐磷,投加亚硝盐使ORP>-80mV,开始反硝化聚磷。     

Sustainable water management for green infrastructure

正The water is the most important component in the ecosystems responsible for energy flow and mass transport.The water also plays an important role for human existence.However,the constructed infrastructures such as roads,buildings,railways,drainage systems,etc.give negative impacts to the ecosystem such as deteriorating the water quality and     

Effects of shear force on formation and properties of anoxic granular sludge in SBR

This paper reports the effects of shear force on anoxic granular sludge in sequencing batch reactors （SBR）. The study was carried out in two SBRs （SBR1 and SBR2） in which sodium acetate （200mg COD·L^-1） was used as the sole substrate and sodium nitrate （40 mgNO3-N·L^-1） was employed as the electron acceptor. The preliminary objective of this study was to cultivate anoxic granules in the SBR in order to investigate the effects of shear force on the formation of anoxic granular sludge and to compare the properties of anoxic sludge in the SBR. This study reports new results for the values of average velocity gradient, a measure of the applied shear force, which was varied in the two SBRs （3.79 s^-1 and 9.76 s^-1 for SBR1 and SBR2 respectively）. The important findings of this research highlight the dual effects of shear force on anoxic granules. A low shear force can produce large anoxic granules with high activity and poor settling ability, whereas higher shear forces produce smaller granules with better settling ability and lower activity. The results of this study show that the anoxic granulation is closely related to the strength of the shear force. For high shear force, this research demonstrated that： 1） granules with smaller diameters, high density and good settling ability were formed in the reactor, and 2） granular sludge formed faster than it did in the low shear force reactor （41days versus 76 days）. Once a steady-state has been achieved, the nitrate and COD removal rates were found to be 98% and 80%, respectively. For low shear force, such as was applied in SBR1, this research demonstrated that： 1） the activity of anoxic granular sludge in low shear force was higher than that in high shear force, 2） higher amount of soluble microbial products （SMPs） were produced, and 3） large pores were observed inside the larger granules,which are beneficial for nitrogen gas diffusion. Electron microscopic examination of the anoxic granules in both reactors showed that the morphology of the granules was ellipsoidal with a clear outline. Coccus and rod-shaped bacteria were wrapped by filamentous bacteria on the surface of granule.     

Practical consideration for design and optimization of the step feed process

Based on the anoxic/oxic (A/O) step feed process, a modified University of Cape Town (UCT) step feed process was developed by adding an anaerobic zone and adjusting sludge return pipeline. Performance evaluation of these two types of processes was investigated by optimizing operational parameters, such as the anaerobic/anoxic/oxic volumes, internal recycle ratios, and sludge retention times, for removal of chemical oxygen demanding (COD), nitrogen, and phosphorus. Results showed high removal efficiencies of COD of (85.0±1.7)%, ammonium of (99.7±0.2)%, total nitrogen (TN) of (85.5±1.7)%, phosphorus of (95.1±3.3)%, as well as excellent sludge settleability with average sludge volume index of (83.7±9.5) L·mg^-1 in the modified UCT process. Moreover, (61.5±6.0)% of influent COD was efficiently involved in denitrification or phosphorus release process. As much as 35.3% of TN was eliminated through simultaneous nitrification and denitrification process in aerobic zones. In addition, the presence of denitrifying phosphorus accumulating organisms (DNPAOs), accounting for approximately 39.2% of PAOs, was also greatly beneficial to the nitrogen and phosphorus removal. Consequently, the modified UCT step feed process was more attractive for the wastewater treatment plant, because it had extremely competitive advantages such as higher nutrient removal efficiencies, lower energy and dosages consumption, excellent settling sludge and operational assurance.     

基于模糊神经网络的A2/O工艺出水氨氮在线预测模型

采用厌氧/缺氧/好氧污水处理系统(A2/O)对人工合成污水进行处理,并利用人工神经网络(ANN)模型和自适应模糊人工神经网络(ANFIS)模型对A2/O处理污水的过程进行仿真模拟.在MATLAB环境下,选取可在线监测的水力停留时间(HRT)、进水pH值(pH)、好氧池溶解氧(DO)和混合液回流比(r)作为输入参量,系统出水氨氮浓度(NH4+eff)为输出量,建立在线预测模型.结合自适应模糊C均值聚类算法,确定ANFIS模型的模糊规则数及最优运行参数,对实验数据进行仿真预测.结果表明,与ANN模型相比,ANFIS模型的仿真输出值与实际值的拟合程度更高,相对误差在6.45%之内,平均绝对百分比误差(MAPE)为2.8%,均方根误差(RMSE)为0.1209,相关系数(R)达0.9956.模型训练过程中所得到的三维曲面图,可直观的反映各因素与出水氨氮浓度之间的非线性函数关系,为A2/O系统的高效稳定运行提供指导.