节能减排 实现钢铁企业可持续发展

通过对钢铁行业消耗水资源及产生污染情况进行分析，阐述了目前钢铁行业为节能减排而采取的管理、技术、污染治理措施，以达到减少废水外排量、降低污染物浓度、降低新水消耗的目的，对钢铁行业废水回用中尚存和潜在的工艺、设计问题进行了讨论，同时提出了通过清洁生产、优化工艺结构来解决问题的措施和建议，确立了企业近期和长期的节能减排任务目标。     

高压变频技术在70 t电弧炉除尘系统中的应用

提出运用高压变频技术实现电弧炉除尘风机变频调速的工艺.在70 t ABB电弧炉烟气治理运用中,以温度为调速系统主要控制参数,设计工频和变频两套系统,实现除尘风机的转速按工艺要求调节,其功率因数从0.83提高到0.97,除尘系统节电60%,冶炼工况同时也得到改善.表明该工艺具有广阔的应用前景.     

Use of Streamflow Data to Estimate Base Flow/Ground‐Water Recharge For Wisconsin1

Abstract: The average annual base flow/recharge was determined for streamflow‐gaging stations throughout Wisconsin by base‐flow separation. A map of the State was prepared that shows the average annual base flow for the period 1970‐99 for watersheds at 118 gaging stations. Trend analysis was performed on 22 of the 118 streamflow‐gaging stations that had long‐term records, unregulated flow, and provided aerial coverage of the State. The analysis found that a statistically significant increasing trend was occurring for watersheds where the primary land use was agriculture. Most gaging stations where the land cover was forest had no significant trend. A method to estimate the average annual base flow at ungaged sites was developed by multiple‐regression analysis using basin characteristics. The equation with the lowest standard error of estimate, 9.5%, has drainage area, soil infiltration and base flow factor as independent variables. To determine the average annual base flow for smaller watersheds, estimates were made at low‐flow partial‐record stations in 3 of the 12 major river basins in Wisconsin. Regression equations were developed for each of the three major river basins using basin characteristics. Drainage area, soil infiltration, basin storage and base‐flow factor were the independent variables in the regression equations with the lowest standard error of estimate. The standard error of estimate ranged from 17% to 52% for the three river basins.     

隧道排污量估算与治污效果预测

通过隧道排污量和排污效果的简单分析，指出了其排污治理过程中应注意的有关事项，如进 行人口控制，改善居民的生活方式，提高环境保护意识和治理技术等，所述分析方法可供其它类似 工程参考。     

榆神矿区矿井水零排放可行性分析

针对榆神矿区给排水现状，分析矿区给排水关系和矿井水的利用途径，并提出矿井水零排放的技术、管理对策，达到减少新水索取，实现零排放。     

Toluene decomposition performance and NOx by-product formation during a DBD-catalyst process

Characteristics of toluene decomposition and formation of nitrogen oxide (NOx) by-products were investigated in a dielectric barrier discharge (DBD) reactor with/without catalyst at room temperature and atmospheric pressure. Four kinds of metal oxides, i.e., manganese oxide (MnOx), iron oxide (FeOx), cobalt oxide (CoOx) and copper oxide (CuO), supported on Al₂O₃/nickel foam, were used as catalysts. It was found that introducing catalysts could improve toluene removal efficiency, promote decomposition of by-product ozone and enhance CO₂ selectivity. In addition, NOx was suppressed with the decrease of specific energy density (SED) and the increase of humidity, gas flow rate and toluene concentration, or catalyst introduction. Among the four kinds of catalysts, the CuO catalyst showed the best performance in NOx suppression. The MnOx catalyst exhibited the lowest concentration of O₃ and highest CO₂ selectivity but the highest concentration of NOx. A possible pathway for NOx production in DBD was discussed. The contributions of oxygen active species and hydroxyl radicals are dominant in NOx suppression.     

福建省生产废水和生活污水污染物排放的驱动力及其时空分异

采用对数平均迪氏指数方法,区分生产和生活两个体系,构建时空分解分析模型,追踪了福建省9个设区市2011—2019年水污染物排放变化的关键驱动力及其贡献的时空差异.结果显示：研究期内福建省工业废水污染物排放持续减少,并且各驱动力贡献的区域差距明显变小,趋于平衡;生活污水污染物排放量仍保持高位,各驱动力贡献的区域差距基本保持不变.其中,经济规模扩张是福建省水污染物排放的主导驱动力,主要源于福州、厦门、泉州经济赶超发展影响;城镇化发展对区域生活污水污染物排放的驱动影响表现为增排效应,以福州和厦门尤为显著;工业化发展对区域工业废水污染物排放的影响效应由正驱动逐渐转变为负驱动,这主要归功于三明和泉州产业结构调整优化的拉动 效应;技术效应一直是福建省水污染物排放控制的重要驱动力,但部分地区已逐渐步入生活污染物技术减排攻坚期.     

CuSnZr三元催化剂应用于NTP强化催化脱硫过程的特性

为高效地在低温下处理大量低浓度电解铝烟气, 采用浸渍法制备了Sn Zr型金属氧化物并添加Cu作为助剂的催化剂, 并首次测试了它在低温等离子体(NTP)技术上的脱硫效果, 结果表明负载了20wt% Cu老化温度为40℃的催化剂表现出最佳的脱硫性能.并对强化之后的催化剂进行了表征, 与新鲜的催化剂对比, X射线衍射分析(XRD)结果表明放电对催化剂晶型基本不产生影响; 扫描电子显微镜(SEM), 氮吸附和脱吸(BET)表明放电会使催化剂的吸附脱附能力与孔道结构有较大提升; X射线光电子光谱(XPS)也表明放电会使催化剂表面元素价态变化, 从而使其氧化还原性能改变, 反应路径发生偏向; 催化剂性能理论计算表明铜含量的上升会导致催化剂能带结构改变, 更好利用于激发气体.     

自然通风排热量的近似计算法

采用“假设密闭绝热空间法”,计算工业厂房的自然通风排热量。实践证明,此方法是可行的。     

THE DISCHARGE OF SEDIMENT IN CHANNELIZED ALLUVIAL STREAMS1

ABSTRACT: Approximately 400 million cubic feet of channel sediments have been delivered to the Mississippi River from the Obion-Forked Deer River system in the last 20 years. The discharge of sediment from these channelized networks in West Tennessee varies systematically with the stage of channel evolution. Variations in yields over time reflect the shifting dominance of fluvial and mass-wasting processes as the networks adjust to lower energy conditions. Maximum bed-material discharges occur during the initial phases of degradation (Stage III). In contrast, yields of suspended-sediment peak during the threshold stage (Stage 1V: large-scale mass wasting) as sediments are delivered from main-channel banks and tributary beds. Suspended-sediment yields then decrease as aggradation (Stage V) becomes the dominant trend in the main channels, but remains relatively high through restabiliza-tion (Stage VI) because of continued degradation and widening in the tributaries. Bed-material discharges decrease from the degradation stage (III) to Stage V, and increase again during restabiliza-tion (Stage VI) because secondary aggradation increases gradients and incipient meandering serves to rework bed sediments. This secondary maxima in bed-material discharge is analogous to those described previously as complex, or oscillatory, response. The trends of sediment production and transport described from these rejuvenated networks are in agreement with experimental and theoretical results of earlier investigations.