水力条件对复合人工湿地处理城市受污染河水效果的影响

通过对水力负荷、水力停留时间等水力条件的控制,观察其对复合垂直上行流人工湿地处理城市受污染河水效果的影响.一年多来的运行结果表明:水力条件对复合垂直上行流人工湿地去除其他污染物的影响显著,但对总氮去除的影响不大.水力停留时间的延长可提高总磷、氨氮、COD的去除效果;随着水力负荷的增加,总磷、氨氮、COD去除率都有所增加...     

浅谈对热电企业的环境监督管理

对热电企业的环境监管工作是环保部门的重要职责,根据在对热电企业日常监管中遇到的问题,论述了监管的常用方法,包括监督企业环境管理落实情况、核查企业环保数据真实性及重视群众对企业的监督,并就相关工作展开了具体讨论。     

Environmental assessment of garden waste management in the Municipality of Aarhus, Denmark

An environmental assessment of six scenarios for handling of garden waste in the Municipality of Aarhus (Denmark) was performed from a life cycle perspective by means of the LCA-model EASEWASTE. In the first (baseline) scenario, the current garden waste management system based on windrow composting was assessed, while in the other five scenarios alternative solutions including incineration and home composting of fractions of the garden waste were evaluated. The environmental profile (normalised to Person Equivalent, PE) of the current garden waste management in Aarhus is in the order of −6 to 8 mPE Mg⁻¹ ww for the non-toxic categories and up to 100 mPE Mg⁻¹ ww for the toxic categories. The potential impacts on non-toxic categories are much smaller than what is found for other fractions of municipal solid waste. Incineration (up to 35% of the garden waste) and home composting (up to 18% of the garden waste) seem from an environmental point of view suitable for diverting waste away from the composting facility in order to increase its capacity. In particular the incineration of woody parts of the garden waste improved the environmental profile of the garden waste management significantly.     

燃煤电厂袋式除尘器滤料耐氧化性能试验研究

燃煤电厂锅炉烟气中含有SOx和NOx,会氧化腐蚀滤料。试验研究了燃煤电厂布袋除尘器滤料断裂强力与运行时间的关系。结果表明,滤料在酸性环境中会被氧化同时断裂强力下降,但断裂强力下降后均会出现反弹,后处理工艺可提高滤料的抗氧化性能,但会降低滤料的断裂强力。     

Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

生物滴滤塔处理模拟甲硫醚废气

在常温条件下,采用生物滴滤塔处理模拟甲硫醚废气,考察了气体空床停留时间(EBRT)、容积负荷、喷淋密度及营养液pH对生物滴滤塔性能的影响。实验结果表明:当EBRT为90 s、进气甲硫醚质量浓度为150 mg/m~3、喷淋密度为0.65 m~3/(m~2·h),营养液pH为6.8时,甲硫醚去除率为90%;容积负荷高于15 g/(m~3·h)时,对生物滴滤塔的性能产生抑制作用;EBRT为90 s及60 s时,最佳喷淋密度分别为0.56~0.65 m~3/(m~2·h)及0.65~0.75 m~3/(m~2·h);降解甲硫醚的微生物对pH的变化较敏感,最适营养液pH为6~7。     

Assessing the long-term supply risks for mineral raw materials—a combined evaluation of past and future trends

This paper develops a method for identifying and assessing long-term supply risks for mineral raw materials. The method is based on a combined evaluation of past and future supply and demand trends. By analysing raw material boom and bust cycles over the past 50 years, we have quantified indicators and defined benchmarks for identifying critical market situations. By applying the method, risks for supply shortage may be identified at an early stage. In addition, a numerical evaluation model has been developed for better comparison between various mineral raw materials. Compared to other assessment methods this method uses specific benchmarks for each raw material to better assess supply risks. The method is embedded within a systematic and comprehensive analytical approach.     

交通荷载作用下饱和软粘土孔压-应变分析模型

针对交通荷载的作用特点设计了循环三轴试验,进而对交通荷载作用下饱和软粘土的动力特件进行厂研究.结果表明:循环荷载作用下,饱和软粘土存在临界循环应力比,采用孔压曲线所得到的临界循环应力比要小于采用应变曲线所得到的临界循环应力比.当土样不存在初始剪应力时,随着循环次数的增加,土样的应力-应变关系曲线近似原点对称,但随着初始剪应力的增大,应力-应变关系曲线逐渐表现为一系列平行曲线,峰值孔压与循环孔压幅值均逐渐减少;同时,轴应变的发展加快,但循环应变幅值逐渐减小.当循环应力比小于临界循环应力比时,对于同一初始剪应力,不同循环应力比下的孔压比-动应变曲线近似集中在同一条曲线上.通过对试验数据进行回归分析,得到了交通荷载作用下饱和软粘土残余孔压-累积塑性应变关系模型.     

高土石坝震害与抗震措施评述

目前,我国西部地区正建或拟建一大批高土石坝,这些高坝都位于地震高烈度区,做好抗震设计非常重要。本文总结了地震荷载作用下土石坝常见的几种破坏形式,包括地震永久变形、滑坡失稳、液化、防渗体破坏、次生破坏;针对这些破坏形式,总结了地震高烈度区高土石坝的抗震措施,包括预留超高、坡脚压重、坝顶加固、抗液化措施、防渗体处理等;提出了现阶段高土石坝抗震的计算方法和抗震措施存在的缺点和不足,并对我国今后的高土石坝抗震稳定研究提出了建议。     

Sustainability of silicon feedstock for a low-carbon society

We need to ensure the sustainable management of advanced materials, such as purified silicon, that contribute to a low-carbon society. Because a drastic increase in the demand for photovoltaic (PV) systems is tightening the supply of silicon for PV cells, the sustainability of silicon feedstock needs to be explored. For this purpose, a material flow analysis of silicon in Japan from 1996 to 2006 is presented in this paper. Our analysis finds that rapid growth in demand for polycrystalline silicon (pc-silicon) and single crystalline silicon (sc-silicon) has changed the structure of the purified silicon supply. The strong demand for purified silicon for solar cells is responsible for this change. While off-grade silicon obtained as a by-product of electronic-grade silicon (EG-Si) covered the demand for solar sells before 2000, pc-silicon is currently produced independently for solar cells via an energy-intensive process. Analysis of the resource effective-use index (REI), which indicates how effectively purified silicon is used, shows progress in the effective use of pc- and sc-silicon. REI analysis indicates that the effective use of pc-silicon is reaching a maximum, while the effective use of sc-silicon is advancing, with a corresponding increase in price. To ensure a sustainable supply of silicon feedstock, this paper proposes four solutions: (1) production of solar-grade pc-silicon by a less costly and less energy-consuming method; (2) reduction in the amount of crystalline silicon per watt in solar cells; (3) acceleration of the development and deployment of other solar cell types; and (4) reuse and recycling of solar cells in the future.