活性污泥与生物膜复合工艺处理石化废水的研究

实验研究了活性污泥与生物膜复合工艺(HP)对石化废水的处理效果,并与活性污泥工艺(ASP)进行对比研究.结果表明,HP对石化废水中COD的去除效果略好于ASP,而对NH3-N的去除效果明显优于ASP.另外,两种工艺对硫化物和油的去除效果类似.提高进水负荷时,HP表现出较强的耐冲击负荷能力.以2L/h连续运行时,石化废水...     

Combined use of molecular biology taxonomy, Raman spectrometry, and ESEM imaging to study natural biofilms grown on filter materials at waterworks

DNA-based population analysis was applied in combination with Raman spectrometry and Environmental Scanning Electron Microscopy for the characterisation of natural biofilms from sand and activated carbon filters operated for a long term at a municipal waterworks. Whereas the molecular biology polymerase chain reaction combined with denaturing gradient gel electrophoresis approach provides a deeper insight into the bacterial biofilm diversities, Raman spectrometry analyses the chemical composition of the extracellular polymer substances (EPS), microorganisms embedded in EPS as well as other substances inside biofilm (inorganic compounds and humic substances). Microscopy images the spatial distribution of biofilms on the two different filter materials. In addition, bacterial bulk water populations were compared with biofilm consortia using the molecular fingerprint technique mentioned.Population analysis demonstrated the presence of more diverse bacterial species embedded in a matrix of EPS (polysaccharides, peptides, and nucleic acids) on the sand filter materials. In contrast to this, activated carbon granules were colonised by reduced numbers of bacterial species in biofilms. Besides α-, β-, and γ-Proteobacteria, a noticeable specific colonisation with Actinobacteria was found on activated carbon particles. Here, the reduced biofilm formation came along with a decreased EPS synthesis. The taxonomy profiles of the different biofilms revealed up to 60% similarity on the same filter materials and 32% similarity of different materials. Similarity of adherent communities from filter materials and bulk water populations from the filter effluent varied between 36% and 58% in sand filters and 6–40% in granular activated carbon filters.The biofilm investigation protocols are most crucial to subsequent acquisition of knowledge on biofilm dynamics and bacterial contributions to transformation or adsorption processes in waterworks facilities.     

含磁粉生物反应器处理苯酚废水

采用含磁粉生物反应器对质量浓度为120～350 mg/L的苯酚模拟废水进行强化生物处理.实验结果表明:添加适量磁粉可使废水中DO提高约10%;与不含磁粉生物反应器比较,含磁粉生物反应器工艺使填料挂膜时间缩短1～2 d,填料上附着微生物量增多;质量浓度为350 mg/L的苯酚模拟废水在20 h内的苯酚去除率可达80%,降解时间缩短了10 h.初步分析了添加磁粉提高生物反应器处理废水效率的机理.实验证实了含磁粉生物反应器工艺的合理运用是强化处理含酚废水的有效途径.     

膜生物反应器中生物膜的生长特性

实验采用经甲苯培养驯化而成的单一假单胞菌菌种,通过分析平板式生物膜反应器内,不同阶段假单胞细菌生物膜干重、厚度、活性生物量和生物种群分布的变化,研究生物膜特性与降解效率之间的关系。实验结果表明,在挂膜初期生物膜迅速生长,生物量以及生物膜干重增长很快,有利于甲苯及营养物质的传输,降解效率也快速提升。随着生物膜的生长,生物量及干重也逐步增加,厚度逐渐增加使传质阻力不断增大,生物膜上层微生物的有机底物供应不足,使生物膜上层结构稀疏,最终维持一个甲苯的总传输量与生化降解量的平衡,生物量的生长与衰亡也达到动态平衡,形成了一个较高且稳定的降解效率。     

两种AHLs信号分子对生物膜法养殖污水处理条件下水体内环境的影响

为提高生物膜法处理养殖污水的效果,对不同信号分子条件下的生物膜处理情况进行研究。在室内循环水养殖系统中,设定3个实验组和1个对照组,分别添加乙醇、C6-HSL、N-3-oxo-C8-HSL和蒸馏水,并在模拟过程中取样分析。实验结果表明,3个实验组附着基上的生物量明显多于对照组,尤其是添加N-3-oxo-C8-HSL组产生的生物量约为对照组的6倍;经添加C6-HSL和N-3-oxo-C8-HSL处理的养殖水体中,亚硝酸盐最终浓度比对照组低28.6%,但无机磷浓度稍高。数据因子分析结果表明,实验过程中(9～27 d),添加AHLs信号因子C6-HSL和N-3-oxo-C8-HSL两组养殖水体内环境的总体得分较高,说明养殖水体的内环境处于较好状态。     

序批式生物膜反应器挂膜启动实现短程硝化

常温条件下(20～25℃),以模拟的人工配水为研究对象,采用序批式生物膜反应器(SBBR),在初期挂膜的基础上,笔者运用两种不同的挂膜方式即重新加入新泥和不加新泥而加大进水COD浓度来实现生物膜的快速启动。实验表明,2种挂膜启动通过14 d的培养与富集,NH4+-N与COD的处理效果都能分别达到85%和75%以上。将剩余污泥排尽后,采用第1种挂膜方式的反应器通过连续间歇曝气,达到了比较好的短程硝化效果。调整溶解氧,并且通过先下降后上升曝气量的方式,能进一步提高亚氮的出水。最终在DO为3.6 mg/L时,亚氮的积累率能达到平均74%左右,达到了比较好的亚硝化效果。而第2种挂膜方式培养的生物膜则以好氧反硝化菌为主,去除的氨氮由同化作用和培养的好氧反硝化菌去除,以后者为主。通过比较可以看出,为了实现短程硝化,第1种挂膜方式比第2种更具有优越性,有利于硝化菌种的生长和亚氮的积累,而第2种方式则有利于培养好氧反硝化菌。     

三级生物接触氧化除油生化池的生物膜特性

将生物接触氧化技术用于油田稠油污水的处理,在三级串联运行的生物接触氧化池中,生物膜特性主要由生物膜上原油成分决定。在沿水流方向上,生物膜上易降解原油组分含量降低,难降解组分含量上升,第一级生化池中的生物膜厚度和优势菌种数量明显超过第二级和第三级,藻类主要生长在一级生化池的后部和二、三级生化池中的生物膜上,原生动物出现在二级和三级生化池生物膜上,而后生动物只出现在三级生化池生物膜上。     

Removal of tetrabromobisphenol A by conventional activated sludge, submerged membrane and membrane aerated biofilm reactors

The goal of this study was to compare removal efficiencies of tetrabromobisphenol A (TBBPA) using typical wastewater treatment technologies, and to identify the most significant mechanisms of removal. Two types of municipal wastewater reactors were studied: a full-scale conventional activated sludge (CAS) reactor with tertiary treatment; and three pilot-scale membrane bioreactors (MBRs) having different sludge retention times (SRTs). All four reactors were fed the same influent. A third reactor type, a membrane aerated biofilm reactor (MABR) was fed tap water, ammonia, and TBBPA. TBBPA in municipal influent ranged from 1 to 41 ng L⁻¹ (n = 10). The CAS effluent had an average TBBPA concentration of 0.7 ± 1.3 ng L⁻¹ (n = 3). Effluent concentrations from the MBRs were an average of 6 ± 6 ng L⁻¹ TBBPA (n = 26). Significant TBBPA removal was observed in the MABR throughout the 5 week of study (p ? 0.05). Removal of TBBPA from wastewater treatment was found to be due to a combination of adsorption and biological degradation. Based on experimental results, nitrification is likely a key process therein. No significant relationship between removal of TBBPA and SRT was identified (p ? 0.05).     

散堆填料对海水脱硫吸收系统性能影响的实验研究

在海水烟气脱硫中试实验台上进行了填料形式、填料高度变化对脱硫效率和系统压降影响规律的实验研究;研究中将喷淋空塔和分别填装A型、B型、C型3种填料的吸收塔进行了综合性能对比,并进行了填料高度分别为0.6、1.2和1.8 m的对比实验。结果表明,填料塔的脱硫效率高于喷淋空塔;当空塔气速为3 m/s时,填装C型填料的吸收塔的综合性能最优;当空塔气速小于2.5 m/s时,填装A型填料的吸收塔的综合性能最优;在满足相同脱硫效率的指标下,虽然增加填料高度降低了海水喷淋量,并且系统压降出现一定比例下降,但是在工程设计中必须综合考虑塔高、填料支架载荷等因素选择合适的填料堆积高度。     

不同填料载体生物膜对微囊藻毒素的去除效果

利用自行设计的生物膜培养装置,通过对4种不同填料载体进行连续曝气循环培养生物膜,对湖水中的溶解态微囊藻毒素(MCs)的去除作用进行了研究。结果表明,填料载体上生物膜从形成到稳定大约需要3周;生物膜形成后对MCs的去除效率由高到低的顺序是:颗粒活性炭柱>多密孔球型滤料柱>塑料悬浮填料柱>陶瓷滤球柱。在实验水质条件下,当水力停留时间(HRT)=5 h,进水MCs浓度为21.5～47.25μg/L时,颗粒活性炭、多密孔球型滤料柱对MCs的去除率最高可达100%,塑料悬浮填料柱对MC-LR和MC-RR的去除率分别为70%和88%。当HRT=2.5 h时,塑料悬浮填料柱对MC-RR的去除率为MC-LR的2倍。生物膜对MCs的降解效果随温度(5～20℃)和溶解氧的升高而增加。塑料悬浮填料作为合适的生物膜挂膜填料载体对水源水的生物预处理具有良好的应用前景。