两相厌氧工艺的研究进展

为了了解两相厌氧工艺的研究状况,对两相厌氧反应器及相分离方法进行了综述,并指出了今后两相厌氧工艺的研究方向.     

Selecting Species for Marine Assessment of Radionuclides Around Amchitka: Planning for Diverse Goals and Interests

Considerable attention has been devoted to selecting bioindicator species as part of monitoring programs for exposure and effects from contaminants in the environment. Yet the rationale for selection of bioindicators is often literature-based, rather than developed with a firm site-specific base of data on contaminant levels in a diverse range of organisms at different trophic levels in the same ecosystem. We suggest that this latter step is an important phase in the environmental assessment process that is often missing. In this paper we address the problem of how to select a wide range of species representing different trophic levels that serve as a basis for selecting a few species suitable as bioindicators. We illustrate this with our assessment of radionuclides on Amchitka Island, Alaska. We propose a multi-stage process for arriving at the list of available species that includes review of literature, review by experts experienced in the area, review by interested and affected parties, selection of trophic levels or groups for analysis, arraying of possible species, and selection of species within each trophic level group for sample collection. We first had to identify all likely species, then narrow our focus to those we could collect and analyze. In all cases, review includes suggestions for possible target species with justifications. While this method increases the up-front costs of developing bioindicators for an ecosystem, it has the advantage of providing information for selection of species that will be most informative in the long run, including those that are the best bioaccumulators, thus providing the earliest warning of any potential environmental consequences. Further, the recognition that a range of stakeholder's needs and interests should be included increases the utility for public-policy makers, and the potential for continued usage to establish long-term trends.     

生物还原-化学沉淀法自烟气中的SO2制备ZnS

采用生物还原—化学沉淀法自烟气中的SO2制备ZnS,将含有Zn(OH)2杂质的粗品ZnS通过化学提纯制得高纯度ZnS。实验结果表明,采用NH4C l-NH3.H2O混合液对含有Zn(OH)2杂质的粗品ZnS进行提纯的优化条件为:每500m g粗品ZnS加入NH4C l与NH3.H2O摩尔比为1∶1、两组分浓度均为3.0m o l/L的10mLNH4C l-NH3.H2O混合液。X射线衍射分析表明,提纯后的产物粉末全部为ZnS,其纯度与ZnS标准试样相当。     

稠油废水生物处理主要影响因素分析

有机聚合物和石油烃类物质是稠油废水中的主要污染物.应用辽河油田锦采污水处理厂稠油废水中筛选分离出的菌株B0501,分析其在稠油废水生物处理过程中对废水COD_Cr的去除作用,研究了不同温度,pH,水力停留时间以及添加氮、磷营养盐等条件下微生物对废水COD_Cr去除的影响.结果表明:稠油废水中投加的外源微生物B0501提高了废水中COD_Cr的去除率;接种后,废水在30 ℃,pH为7.5,水力停留时间为216 h,添加氮、磷营养盐(ρ(氮)/ρ(磷)为5.63)的条件下,废水COD_Cr去除率大幅度提高,其ρ(COD_Cr)满足国家污水综合排放一级标准(GB 8798-1996).经形态观察和生理生化反应鉴定,菌株B0501为液化金杆菌(Aureobaterium liquefaciens).      

曝气生物滤池快速启动和活性保持性能研究

研究了两级曝气生物滤池处理生活污水时各级的快速启动和在低负荷下活性保持的能力,考察了出水中主要污染物和生物滤池内生物量随时间的变化情况。结果表明,碳氧化生物滤池从低负荷恢复时,所需要的时间与活性保持时的负荷大小有关,负荷越小,所需要的时间越长。在极端情况下,恢复时间接近一次完全启动的时间,因此碳氧化生物滤池的低负荷维持并没有太大的实际意义。而硝化生物滤池在低负荷下活性保持良好,重新启动仅需要完全启动1/10的时间,这就有可能以低成本实现硝化生物滤池的活性保持。     

改良型Carrousel氧化沟工艺生物脱氮除磷效果研究

为了提高改良型Carrousel氧化沟工艺污水处理厂的脱氮除磷效果,结合某污水处理厂3年的运行实践,讨论了该工艺的处理效果,生物脱氮除磷原理及影响出水效果的因素.分析表明将DO控制在0.3～0.7 mg/L范围内,能够使出水中的TN浓度低于20 mg/L;在氧化沟中发生的同步硝化反硝化反应(SND)对总氮的去除的贡献占总系统脱氮的66%;该系统剩余污泥的含磷率为3.0%,生物细胞中平均含磷量可达细胞干重的4.2%;总磷去除率与污泥龄具有很好的线性关系,加大污泥排放量可以提高除磷效果.     

曝气生物滤池Biostyr处理微污染水源

采用曝气生物滤池Biostyr对浙江省T市某水厂微污染水源水进行生物预处理,现场试验研究表明:在气水比为2∶1,滤速6m/h,水温24～32℃的运行条件下,其对水中各污染物的平均去除率为:高锰酸盐指数24.1%,氨氮81.7%,亚硝酸盐氮79.9%,浊度49.0%。完全能达到生物预处理目的。     

操作条件对超滤膜运行经济稳定性能的影响

采用正交实验的方法对棕榈油生产废水二级处理出水的超滤工艺条件进行考察和优化,并用膜通量衰减系数、平均跨膜压差及产水量各自加权相加所得综合指标来表征不同超滤操作条件下膜运行的经济稳定性能。正交试验结果表明,减小膜表面流速和产水率,提高处理废水温度均有利于系统经济稳定地运行;各运行参数对综合指标影响的大小顺序为:膜表面平均流速>产水率>温度;在保证出水质量的前提下,最佳组合操作条件为膜表面平均流速0.7m/s,产水率80%,废水温度30℃。     

好氧颗粒污泥在生物强化除磷中的应用

结合近年来好氧颗粒污泥的最新研究成果,分析了好氧颗粒污泥的物理、化学、生物学、结构特征,并从生物除磷、反硝化除磷和沉淀作用三方面对好氧颗粒污泥除磷现象进行探讨。旨在为好氧颗粒污泥在生物强化除磷中的实际应用提供理论知识。     

生物膜填料塔SO2废气净化性能研究

采用生物膜填料塔净化SO2废气,研究结果表明:当气体流量从100L/h增加到300L/h时,SO2净化效率由86.4%下降到73.2%;生化去除量随着入口SO2气体浓度的升高而增大;随着温度的升高,SO2净化效率和生化去除量都随之提高,且20℃以上时,净化效率可达90.9%以上,生化去除量可达75 mg/L·h以上,更利于微生物降解SO2.